• The Journal of Engineering Geology
• /
• v.19 no.2
• /
• pp.235-250
• /
• 2009

Environmental elements such as B, Br, and Sr in groundwater from Bukahn-myeon, Yeongcheon, Gyeongbuk Province, were investigated in order to know their origin with emphasis on hydrochemistry. pH ranges from 7.37 to 8.39. B content is 0.41${\sim}$4.62 mg/L with an average 1.74 mg/L and Br content is 0${\sim}$3.24 mg/L with an average 2.22 mg/L, and Sr content is 0.93${\sim}$8.64 mg/L with an average 2.76 mg/L. The water types plotted by the Piper diagram are different but mostly $Ca-HCO_3$. Some constituents contributing to EC are Na, $SO_4$, Cl with high determinative coefficients($R^2$) of 0.85, 0.70, 0.90, respectively. The coefficients($R^2$) of Cl to Na, K, $SO_4$ are 0.54, 0.68, 0.53, respectively. It should be noted that there are high cocfficients($R^2$) of B-Sr and $Sr-SO_4$ with 0.65, 0.64, respectively. The Cl/Br ratios are 5.21${\sim}$30.70 due to significant depletion of Cl. The $SO_4/Cl$ ratios are 1.32${\sim}$27.24 with an average of 5.92, ascribed to abundant introduction of $SO_4$ or significant depletion of Cl. Chemical speciation calculated shows that B exists mostly as $H_3BO_3$ with less $H_2BO^-_3$ and Br exists as only $Br^-$. Sr exists mostly as $Sr^2$ with less $SO_4$. Saturation index represents that goundwater is supersaturated with respect to barite, kaolinite, illite, K-mica, and smectite while it is slightly undersaturated with respect to silica, gypsum, anhydrite, talc, chrysotile, feldspar, kaolinite, illite, K-mica, and smectite. The saturation index of celestine is -2.23${\sim}$-0.13 indicating more Sr can be incorporated into groundwater. Groundwater is still much undersaturated to halite. It is likely that the origin of S and Sr was related to the Yucheon volcanic rocks. Br might be originated from the local geological features with introduction of anthropogenic matters.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 1999.10a
• /
• pp.95-96
• /
• 1999

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.3 no.4
• /
• pp.309-317
• /
• 2005

A study on the separation of $^{99}Tc,\;^{94}Nb,\;^{55}Fe,\;^{90}Sr\;and\;^{59/63}Ni$ in various radioactive wastes discharged from nuclear power plants has been performed for a use in their quantification which is indispensible for the evaluation of the radionuclide inventory Ni was recovered along with Ca, Mg, Al, Cr, Ti, Mn, Ce, Na, K, and Cu through the sequential separation procedure of Re(as a surrogate of $^{99}Tc$), Nb, Fe and Sr by anion exchange and Sr-Spec extraction chromatography. In this research, chemical separation of Ni from the co-existing elements was investigated by cation exchange and Ni-Spec extraction chromatography. Precipitation behaviour of Ni and the co-existing elements with dimethylglyoxime(DMG) was investigated in ammonium $citrate/ethanol-H_2O$ and tartaric $acid/acetone-H_2O$ in order to purify separated Ni fractions and to prepare $^{59/63}Ni$ source for the radioactivity measurement using a gas proportional counter. Recovery of Ni separated through ion exchange chromatographic separation procedure was $92.1\%$ with relative standard deviation of $0.9\%$. In addition, recovery of Ni with DMG in the tartaric $acid/acetone-H_2O$ was $85.6\%$ with relative standard deviation of $1.9\%$.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2005.06a
• /
• pp.121-128
• /
• 2005

A study on the selective separation of $^{99}Tc,\;^{94}Nb,\;^{55}Fe,\;^{90}Sr$ and $^{59}Ni(^{63}Ni)$ from various radioactive wastes discharged from the nuclear power plants in Korea is being performed for use in their quantifications which are indispensible for the evaluation of the radionuclide inventory. Separation behaviour of Ce, Ca, Mg, Al, Cr, Ti, Mn and Cu recovered along with Ni during the separation of Re (as a surrogate of $^{99}Tc$), Nb, Fe and Sr by anion exchange and Sr-Spec extraction chromatography was investigated by cation exchange and Ni-Spec extraction chromatography using synthetic radioactive waste dissolved solutions containing matrix elements such as Re, Nb, Fe, Sr, Ni, B, Na, K, Ce, Co, Ca, Mg, Al, Zn, Cr, Pb, Cd, Mo, Mn, Cu, Zr, Ti and U. To purify the Ni fraction recovered and prepare a radionuclide source available for gas proportional counting, an application of the Ni precipitation procedure with dimethylglyoxime in the medium of ammonium citrate and tartaric acid solutions as a masking agent for co-existing metal ions was described in detail.

• Nuclear Engineering and Technology
• /
• v.7 no.3
• /
• pp.213-222
• /
• 1975

Immobilization of the second-cycle radioactive liquid wastes from a Purex process was developed with the blown asphalt (manufactured by Kukdong Shell Oil Company Ltd) to eliminate the possibility that the radioactive materials will be redispersed into the environment. Attempts to incorporate these wastes directly into the asphalt martrices without any pretreatment were not successful, as it was observed that the sulphuric acid in the waste oxidised the asphalt. Hence, the waste was treated with caustic soda and made alkaline prior to bituminization, so that it was found that this pretreatment made the waste compatible to the asphalt matrices. The pure blown asphalt samples irradiated with doses of 4.0$\times$10$^{7}$ rad showed no evidence of volume increase. The suitable temperature for incorporation of the alkaline wastes into blown asphalt was 180-20$0^{\circ}C$. The Products containing 50 wt% salts represented the following good properties viz., volume reduction (about 1.4), homogeneity, teachability etc. During the period of 131 day $s^{l37}$Cs from products containing 40wt% salts was leached at rates ranging from 2.70$\times$10-4 to 8.27$\times$10-4g/cm2_day but the rate for $^{90}$ Sr was lower by one to two orders of magnitude by distilled water. The leaching rates for $^{137}$ Cs and $^{90}$ Sr by sea water were slightly lower than by distilled water. Both of the leaching rates decreased with increasing pH.H.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.263-266
• /
• 2001

In this paper, we investigated dielectric properies for BST thin films that was deposited on MgO/Si substrates using RF magnetron sputtering. In here, MgO film was used to perform that a diffusion b arrier between the BST film and Si substrate and a buffer layer to assist the BST film growth. A d eposition condition for MgO films was RF Power of 50W, substrate temperature of room temperature and the working gas ratio of Ar:O$_2$ were varied from 90:10 to 60:47. Finally we manufactured the cap acitor of Al/BST/MgO/Si/Al structure to know electrical properties of this capacitor through I-V, C-V measurement. In the results, C-V aha racteristic curves was shown a ferroelectric property so we measured P-E. A remanent poliazation and coerceive electric field was present 2$\mu$C/cm$^2$ and -27kV/cm respectively at Ar:O$_2$=90:10. And a va clue of dielectric constant was 86 at Ar:02=90:10.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.4
• /
• pp.133-140
• /
• 2006

The growth characteristics and properties of large size $SrAlF_5$ single crystals are described and compared with those of $BaMgF_4$. Transmission spectra in the vacuum ultraviolet wavelength region indicate a high transparency of $SrAlF_5$ (about 90% without considering surface reflection loses) down to 150 nm, on contrast to the optical loses observed for $BaMgF_4$. The ferroelectric character of $SrAlF_5$ is evidenced by the reversal of the spontaneous polarization in a hysteresis loop. The higher potential of $SrAlF_5$ in comparison with $BaMgF_4$ for the realization of all-solid-state lasers in the ultraviolet wavelength region by the quasi-phase matching (QPM) technique is pointed out. $SrAlF_5$, besides a higher grade of transparency, shows a nonlinear effective coefficient similar to that of quartz and uniaxial nature, on contrast to the one order smaller nonlinear coefficient and biaxial character of $BaMgF_4$. The refractive index of $SrAlF_5$ from the ultraviolet to the near-infrared wavelength region is measured by the minimum deviation method. The Sellmeier and Cauchy coefficients are obtained from the fits to the curves of the ordinary and extraordinary refractive indices, and the grating period for the first order QPM is estimated as a function of the wavelength. The poling periodicity for 193 nm SHG from 386 nm is $4{\mu}m$.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.11 no.5
• /
• pp.231-237
• /
• 2001

Etch rates up to 120 nm/min for $Ta_{2}O_{5}$ were achieved in both $SF_{6}/Ar$ and $Cl_{2}/Ar$ discharges. The effect of ultraviolet (UV) light illumination during ICP etching on $Ta_{2}O_{5}$ etch rate in those plasma chemistries was examined and UV illumination was found to produce significant enhancements in $Ta_{2}O_{5}$ etch rates most likely due to photoassisted desorption of the etch products. The effects of ion flux, ion energy, and plasma composition on (Ba, Sr)$TiO_3$ etch rate were examined and maximum etch rate ~90 nm/min was achieved in $Cl_{2}/Ar$ ICP discharges while $CH_{4}/H_{2}/Ar$ chemistry produced extremely low etch rates (${\leq}10\;nm/min$) under all conditions.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.50 no.10
• /
• pp.504-508
• /
• 2001

The$(Sr_{1-x}Ca_x)TiO_3$(SCT) thin films are deposited on Pt-coated electrode $(Pt-TiN /SiO_2Si)$ using RF sputtering method at various deposition temperature. The crystallinity of thin films was increased with increased of deposition temperature n the temperature range of 200~500 $[^{\circ}C]$. The capacitance changes almost linearly in temperature ranges of -80~+90$[^{\circ}C]$. All SCT thin films used in the study the phenomena of dielectric relaxation with the increase of frequency, and the relaxation frequency is observed above 200[kHz]. V-I characteristics of SCT thin films show the increasing leakage current with the increases of deposition temperature.

• Journal of the Korean Ceramic Society
• /
• v.31 no.2
• /
• pp.227-233
• /
• 1994

The Bi-Sr-Ca-Cu-O thin films were deposited by RF-magnetron sputtering method on Si(P-111) wafer without a buffer layer and annealed at various temperatures in oxygen atmosphere. The temperature dependence of electrical resistance, the microstructure of intermediate phase, and the surface morphology of films were examined by four probe method, XRD, and SEM, respectively. The chemical composition and the depth profile of the films were determined by ESCA spectra. Thin films annealed at $600^{\circ}C$ and $700^{\circ}C$ in oxygen atmosphere showed onset temperatures of 90 K and 85K, and Tc(zero) of 22K and 31K, respectively. The sample annealed at $700^{\circ}C$ had the highest volume fraction of superconducting phase and showed smooth microsturcture. In ESCA spectra, the thin films were homogeneous with depth.