• Journal of Environmental Health Sciences
• /
• v.2 no.1
• /
• pp.5-9
• /
• 1975

For analysis of Xanthene dyes according to the developing solvent and adsorbent was applied to Thin-layer chromatography with silicagel and cellulose plate. Silicagel chromato-plate used were prepared under different condition of activation. Using eight developing solvent, the influence of the condition for activation upon the separation of Xanthene dyes was investigated. The results are shown in Table 3. Methyl ethyl ketone+Acetone+$H_2O$ (10:0.1:0.4) mixture and n-butanol+Ammonia water (4:1) mixture gave clear separation for Xanthene dyes, including Fluorescein, Erythrosine Rhodamin B, Eosine, Rose bengale, phloxine and Acid red those Rf values decrease in the described ordor. Methyl ethyl ketone+Acetone+$H_2O$ (10:0.1:0.4) was applied to two adsorbents which were purchased from different manufactures. The results of Chromatograms are obtained Figure 6.

• Journal of environmental and Sanitary engineering
• /
• v.14 no.4
• /
• pp.35-40
• /
• 1999

For application of a yellow pigment as food additives, stability of a water-soluble yellow pigment from Bacillus sp. PY123 was investigated. The yellow pigment from Bacillus sp. PY123 was purified with pH treatment, activated carbon and silica gel column chromatography. The partial purified yellow pigment appeared only one spot on silica gel TLC after 12 evaporation and under irradiation of UV 253nm at dark room. Rf value of the pigment was measured at 0.04 and 0.12 with development of a solvent mixture (Butanol : Acetic acid : water = 4 :1:5) and a solvent mixture (Isopropanol : Ammonia : Water = 9 :1: 2), respectively, The partial purified pigment appeared a white fluorescence under UV365nm irradiation. The partial purified yellow pigment had a main peak and a minor peak on HPLC using 20mM phosphate buffer(pH 7.0) at 1ml/min flow rate. The partial purified pigment was stable at heat treatment, acidic pH, oxide-reductants and surfactants.

• Journal of Powder Materials
• /
• v.22 no.4
• /
• pp.260-265
• /
• 2015

Spherical fine cobalt powders were fabricated by new liquid reduction method. Commercial cobalt sufate heptahydrate was used as raw material. Also ethylene glycol was used as solvent and hydrazine-sodium hypophosphite mixture was used as reduction agent for the new liquid reduction method. A plate shaped cobalt powders with an approximately 300 nm were prepared by a traditional wet ruduction method using distilled water as solvent and hydrazine. Spherical fine cobalt powders with an average size of $1-3{\mu}m$ were synthesized by a new liquid reduction method in 0.3M cobalt sulfate and 1.5M hydrazine-0.6M sodium hypophosphite mixture at 333K.

• Clean Technology
• /
• v.24 no.1
• /
• pp.15-20
• /
• 2018

Hexafluoropropyleneoxide ($C_3F_6O$, HFPO) is highly expensive and it may be used as a raw material for the synthesis of various fluorine based compounds. Currently, extractive distillation method has gained considerable attention to collect the HFPO from a mixture of HFPO / hexafluoropropylene ($C_3F_6$, HFP). Optimized operating conditions are studied using a theoretical method for the extraction process. Among available solvents for the purification process, the use of 1,1-dichloro-1-fluoroethane exhibits a high purity of HFPO as a top product and minimize the required heat duty. Since the boiling point of the solvent increases as the pressure in the column increases, the enhanced extractive capability of the solvent led to the high purity of HFPO at the high pressure.

• Macromolecular Research
• /
• v.15 no.5
• /
• pp.403-411
• /
• 2007

Monodisperse micron-sized polystyrene (PS) spheres were successfully obtained using a single stage soap-free emulsion method in aqueous media mixed with ethanol (co-solvent) containing NaCI as the electrolyte. The optimum conditions for preparing the monodisperse PS microspheres, using soap-free emulsion polymerization in a water/ethanol mixture with an electrolyte, were studied. The presence of the co-solvent and electrolyte controlled the particle dispersion stability during the polymerization. The microspheres formed using PS, with a weight-average diameter of $2.6{\mu}m$, coefficient of variation of 5.3% and zeta potential of -15.1 eV, were successfully obtained in the presence of 0.1 wt% NaCI, 10 wt% monomer, 0.1 wt% initiator and 95/5 (g/g) of a water/ethanol mixture reacted at $70^{\circ}C$ for 24 h.

• Journal of Microbiology and Biotechnology
• /
• v.14 no.5
• /
• pp.932-937
• /
• 2004

In situ extraction by organic solvent was studied in order to improve the recovery yield of hydrocarbon from the culture of Botryococcus braunii, a green colonial microalga. When the solvent mixture of octanol as an extractive solvent and n-octane as a biocompatible solvent was added to a two-phase column, the algal growth was seriously inhibited, even at a low concentration of polar octanol. Therefore, a two-stage cell-recycle extraction process was proposed to improve the contact area between the organic phase and the aqueous phase. The hydrocarbon recovery with in situ cell-recycle extraction showed a three-fold increase (57% of cell) in yield over that with two-phase extraction. In addition, over 60% of the hydrocarbon could be recovered without serious cell damage by downstream separation when this process was applied to the culture broth after batch fermentation.

• Carbon letters
• /
• v.15 no.3
• /
• pp.187-191
• /
• 2014

This study reports on the influence of N-butyl-N-methylpyrrolidinium tetrafluoroborate ($PYR_{14}BF_4$) ionic liquid additive on the conducting and interfacial properties of organic solvent based electrolytes against a carbon electrode. We used the mixture of ethylene carbonate/dimethoxyethane (1:1) as an organic solvent electrolyte and tetraethylammonium tetrafluoroborate ($TEABF_4$) as a common salt. Using the $PYR_{14}BF$ ionic liquid as additive produced higher ionic conductivity in the electrolyte and lower interface resistance between carbon and electrolyte, resulting in improved capacitance. The chemical and electrochemical stability of the electrolyte was measured by ionic conductivity meter and linear sweep voltammetry. The electrochemical analysis between electrolyte and carbon electrode was examined by cyclic voltammetry and electrochemical impedance spectroscopy.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1994.10a
• /
• pp.62-63
• /
• 1994

The membrane technology is more convenient and economical way in the separation field than conventional technology such as distillation, extration, crystallization, and so on. Therefore, membrane are used as efficient tools for the separation and concentration of molecular mixture in many industrial area. Although the polymeric membrane have various advantage, they have disadvantages as well. One of them is a poor resistance to organic solvent. Therefore, organic solvent resistant membranes were prepared by soluble polyimide. prepared by phase inversion method. The membranes were The homogeneous polymer solutions were obtained by the two different method ; the one is that the polymer sythesized was completely dissolved in a solvent to prepare a membrane casting solution, the other is that a membrane casting solution was prepared by the unit process from the viscose solution of polymerization.

• Natural Product Sciences
• /
• v.25 no.2
• /
• pp.150-156
• /
• 2019

Conventional extraction of oil and azadirachtin, a botanical insecticide, from Azadirachta indica involves defatting the seeds and leaves using hexane followed by azadirachtin extraction with a polar solvent. In order to simplify the process while maintaining the yield we explored a binary extraction approach using Soxhlet extraction device and hexane and ethanol as non-polar and polar solvents at various ratios and extraction times. The highest oil and azadirachtin yields were obtained at 6 h extraction time using a 50:50 solvent mixture for both neem leaves (44.7 wt%, $720mg_{Aza}/kg_{leaves}$) and seeds (53.5 wt%, $1045mg_{Aza}/kg_{leaves}$), respectively.

• Journal of the Korean Magnetic Resonance Society
• /
• v.24 no.4
• /
• pp.96-103
• /
• 2020

A new NMR method to monitor solvent-localized NMR signals in the two-phase liquid system is suggested. This method based on intermolecular single-quantum coherence (iSQC). Here, we exploited the feature of the local action of distant dipolar field (DDF) effect in order to filter out specific NMR signals dissolved in different solvents. This solvent specific iSQC spectroscopy was carried out on a model two-phase liquid system (D-glucose in water/palmitic acid in chloroform), and showed solvent-localized NMR signals. We believe our approaches might be useful in metabolic analysis such as two-phase liquid extraction scheme for labile chemical species.