• The KSFM Journal of Fluid Machinery
• /
• v.10 no.1 s.40
• /
• pp.56-63
• /
• 2007

Because the mixing efficiency is influenced remarkably by varying the geometrical configurations, the study of flow characteristics inside the mechanical agitator is very important to improve the performances. The draught tube in the agitator makes intermixing between the screw and tube by interrupting radial flow, and it makes circulation region in a mixing chamber. In general, the helical screw agitator with a draught tube (HSA) is proved more efficient to mix than the others. Consequently, such as the shapes of helical screw, number of pitches and the variation of angular velocity are the main parameters for improving the capacity of HSA. And also the suspension of the solid particles in the agitator can be determined these parameters. The rate of solids suspension in the mixing chamber was quantified with a statistical average value, of. Numerical analyses were carried out, using a commercial CFD code, Fluent, to obtain the velocity, pressure and particle distributions under steady, laminar flow and no-slip conditions. Results are graphically depicted with various parameters.

• Korea-Australia Rheology Journal
• /
• v.16 no.3
• /
• pp.109-115
• /
• 2004

Comparisons in shear behaviour are made between aqueous suspensions of a laterite ore and aqueous suspensions of pure goethite ($\alpha$-FeOOH), following prior papers in which the rheologies of the two mineral suspensions were characterized individually. Drawing comparisons is appropriate because the ore sample was about 65% goethite and it was originally thought that the pure goethite might serve as a model of the more complex laterite. Viscosity measurements of the two suspensions show that, at the same solids fraction, the goethite suspensions were more viscous by an order of magnitude, even though the goethite particles had much smaller aspect ratios. Similarly, yield stresses for the goethite suspensions were at least an order of magnitude higher. The most significant difference was in transient behaviour. Time-dependent effects were investigated by subjecting a fluid to a step change or a ramp sequence in shear rate, and measuring the resulting shear stress over time. In most cases, transient behaviour could not be detected in the goethite suspensions, whereas stresses in the laterite suspensions relaxed over periods of order 10 seconds. The disparate results indicate that a goethite suspension is a poor model of a laterite slurry.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2000.10a
• /
• pp.196-203
• /
• 2000

In this study, the evaluation method of diffusion characteristics of Suspended Soli&SS) and the generation limit(source and thick) are investigated, which is significantly affecting on marine examined by construction works such as dredging and reclamation. Dispersion characteristics of SS is examined by hydraulic tests and numerical works in consideration with the Pusan Port. Hydraulic model test was performed in 2-D wave flume to find the limit wave conditon of re-suspension of solid as well as the time dependent characteristics of settlement The results obtainded in the study are as follows; 1) The quantituative evaluation af SS is the basic parameter of marine environmental impact assessment in related with the port development The SS increases as the water content of sea bed solid increases and the density decreases. 2) The sea bed solid in Sinsundai area, Pusan Port has the water content range of 83~157% 3) The ratio of suspension velocity against settlement velocity is about 0.25 and SS concentration converges as the wave heigh. 4) The SS increases 2 time when time step increases 3 time(10 sec to 30 sec) in numerical simulation It means that the effect of the time step should be checked in detail to stable. The diffusion The diffusion coefficient are Affiected senstively in the dispersion process while sea ved friction coefficinet have not strong relation in the simulated area

• Bulletin of the Korean Chemical Society
• /
• v.26 no.7
• /
• pp.1083-1089
• /
• 2005

Most experimental studies available in the literature on filtration are based on observed average zeta potential of particles (usually 10 measurements). However, analyses of data using the average zeta potential alone can lead to misleading and erroneous conclusions about the attachment behavior because of the variation of particle zeta potentials and the heterogeneous distribution of the collector surface charge. To study characteristics of zeta potential, zeta potential distributions (ZPDs) of silica particles under 9 different chemical conditions were investigated. Contrary to many researchers’ assumptions, most of the ZPDs of silica particles were broad. The solids concentration removal was better near the isoelectric point (IEP) as many researchers have noticed, thus proper destabilization of particles is very important to achieve better particle removal in particle separation processes. While, the mean zeta potential of silica particles at a given coagulant dose was a function of particle concentration; the amount of needed coagulant for particle destabilization was proportional to the total surface charge area of particles in the suspension.

• Membrane Journal
• /
• v.13 no.2
• /
• pp.65-72
• /
• 2003

This study was focused on the investigation of filtration characteristics of membrane-coupled fermentor system for dissolved organics recovery from liquid organic sludge. On the filterability of MF over the range of $0.1{\sim}5 {\mu}m,$ the magnitude of total membrane resistance ($R_t$) is ranged as follows in the order; $0.1 {\mu}m>0.2{\mu}m>0.5 >1{\mu}m>2{\mu}m>5{\mu}m$. The cake layer resistance ($R_c$) occupied about 68~88% of total resistance with fermented sludge. Permeation flux decline was mainly attributed to the $R_c$, which was formed by a strong deposition from physico-chemical interactions of solids on membrane surface. Higher suspended solids (SS) concentration of suspension caused lower permeation flux. However, there was not a proportion relation beyond a certain SS concentration. The cross-flow velocity on the membrane surface was faster, which resulted in the higher permeation flux and also more efficient with low trans membrane pressure (TMP) in viewpoint of energy efficiency. The appropriate pH of suspension was over the range of 5.0~6.0 for dissolved organics recovery as well as the permeation flux. It is possible f3r bacteria to be separated perfectly with $0.1{\mu}m\; and \;0.2{\mu}m$ membrane pore size. Based on experimental results, most appropriate membrane pore size for the recovery is believed to around $1{\mu}m$.

• Resources Recycling
• /
• v.27 no.6
• /
• pp.30-37
• /
• 2018

A series of experiment was conducted to evaluate basic performances of low-pH, anti-washing grouts incorporating gypsum which applied for reinforcing underwater cavities in limestone- grounds. Various types of mix proportions were designed and the fluidity, strength and environmental impact of these mixtures were evaluated. The flowability was evaluated under two conditions, i.e., flows without and with pressing, respectively. Strength was measured for the hardened mixtures fabricated under conditions of air and water injections. The environmental impacts including the pH of the suspension and the suspended solids concentration for the mixtures were evaluated. The low pH of fresh mixture suspension, below than 10, was achieved by incorporation of gypsum. The mix proportions of cement-quartz powder-gypsum binders and chemical agents resulted in mortar natural flow 7-10 cm and uniaxial compressive strength 4 MPa were derived.

• Korean journal of food and cookery science
• /
• v.11 no.2
• /
• pp.113-118
• /
• 1995

A preferable mixing ratio of a six-vegetable juice was suggested in this study. The vegetables used for preparation of mixed vegetable juice were carrot(Ct), cabbage(Cg), pear(Pr), cucumber(Cr), celery (Cy) and dongchimi(Di). The characteristics of pH, titratible acidity, reducing sugar, turbidity, solids, color and acceptability were compared to determine the mixing ratio. The vegetables showed a wide ranHe of pH of 3.70-6.01, acidity of 28.92 uv~74.40 nd and reducing sugar of 1.20ft~ 12.69fo. Celery juice showed the higest suspension stability and "b" value and the lowest values in Hunter "L" and "a" values among the 6 vegetable juice. The preferable mixing ratio of two-vegetable juice selected were Ct-Di(1 : 4), Cg-Pr(1 : 3) and Cr-Cy(3 : 1). From the various ratio of the three of biary mixtures of Cg-Pr(1 : 3): Ct-Di(1 : 4): Cr-Sy(3 : 1), two ratio of 5.0 : 2.5 2.5(V-6A) and 6.0 : 2.0 : 2.0(V-6B) were suggested as the most prefered six-vegetable juice. Pear, dongchimi and cucumber were found to be influential on the preference. The pH and titratible acidity of the two juices with different ratios were in the range of 4.92~4.98 and 36.g∼37.4 ml, respectively.

• Journal of Aquaculture
• /
• v.5 no.1
• /
• pp.93-108
• /
• 1992

This study was conducted to understand the variation of suspended matters in coastal waters of Cheju Island. Water sampling was carried out at 22 stations along the coast of this island from March 1988 to November 1989. Analyzed and/or observed items were water temperature, salinity, total solids (TS), total dissolved solids (TDS), volatile suspended solids (VSS), and fixed suspended solids (FSS). Inter-relationships between wind velocity, precipitation and total suspended solids (TSS) were also investigated. More windy days prevail in winter season (December, January and February) in Cheju Island. Thirty-six points seven percent of total windy days of a year appeared in this season. The rate of windy days in spring was $27.3\%$ and those in summer and fall were $17.9{\%}$ each. From February to July, the heaviest precipitation was observed in the southeastern area and that from August to January was observed in the eastern part of this island. TS and TDS were firmly related with the fluctuation of salinity. Therefore, there were higher in spring and lower in summer. The highest TSS (7.73 $mg/{\ell}$) was observed in February and was the lowest (4.73 $mg/{\ell}$) in September. Annual mean value of TSS was 6.3$mg/{\ell}$. The highest VSS (2.03 $mg/{\ell}$) was observed in July and lowest (1.42 $mg/{\ell}$) in September. The percentage of VSS per 755 was $30.6{\%}$ in average that was not much higher level compared to the other polluted areas. This value became higher in summer (av. $34.17{\%}$) and lower in winter (av. $24.2{\%}$). Fluctuation of TSS was mainly related with the freshwate. discharge, tidal action, and re-suspension of bottom sediments by the wind waves. Therefore, TSS concentration was low in summer and hish in winter.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.6
• /
• pp.719-726
• /
• 2009

One of the alternative runoff management measures is on-site runoff mitigation, such as rainwater retention tank and infiltration facilities especially the latter that is possible to manage simultaneously runoff quality and quantity as a perspective of water-cycle. This study was conducted to develop a particle separator, inclined-pipe settling system, that could improve particle removal efficiency of road runoff as a pre-treatment device of stormwater infiltration. Solid particles larger than $100{\mu}m$ are separated by simple sedimentation; however, the significant amount of pollutants with a diameter less than $100{\mu}m$ remain in suspension. Without any treatment in that case of the runoff into infiltrate, groundwater would be deteriorated and also infiltration rate would be decreased by clogging. Therefore, we suggest optimal design parameters (inclined angle, pipe length, and surface loading rate) of inclined-pipe settling system which can be designed to effectively remove particles diameter smaller then $70{\mu}m$. Thus, the results showed TSS removal efficiency more than 80% with a particle diameter between $20{\mu}m$ and $70{\mu}m$, 100% above particle diameter $70{\mu}m$ for the inflow rate $0.018 m^3/m^2{\cdot}hr$ with pipe inclined at angle $15^{\circ}$.

• KSBB Journal
• /
• v.15 no.4
• /
• pp.366-369
• /
• 2000

The soluble paclitaxel was found in the supernatant of the plant cell cultures of Taxus chinensis, The percentage of soluble paclitaxel depends on paclitaxel concentration in bioreactor. As paclitaxel concentration decreases the percentage of soulbe paclitaxel increases. it is therefore important to develop a new process for the recovery of soluble paclitaxel. The use of hydrophobic resin HP20 gives nearly perfect recovery of paclitaxel in supernatant. The resin was more effective in treatment of th cell and debris free filtrate probably because of the reduced solids content In this case 3 g.l resin and 1 day reaction were enough for recovery the soluble paclitaxel in medium.