• Journal of Environmental Science International
• /
• v.32 no.9
• /
• pp.627-634
• /
• 2023

Tire wear particles(TWPs), regarded as a microplastic, is generated in significant quantities each year and exist in various spaces and have a negative impact on the surrounding environment. Particularly, roadside environments fall within the direct influence of TWPs, necessitating proactive investigation for contamination management and response. Therefore, this study aimed to investigate the soil acidity and electrical conductivity(EC) and TWPs in the roadside soil of six sites based on traffic volume. The analysis revealed that the soil in all sites exhibited subacidity, and there were no significant differences in EC. Microscopic and FT-IR analysis revealed the presence of microscopic particles in soil samples that exhibited common visual characteristics of TWPs. In the road with the highest traffic volume, 48,300 TWPs were detected per unit area. Furthermore, a proportional relationship between traffic volume and TWPs particles was established. However, influences other than traffic volume on TWPs particle count within the soil were observed. Therefore, for the management of TWPs contaminated roadside soil, a proactive response is necessary in areas with high traffic volumes. However, in order to effectively address the factors contributing to the generation and dispersion of TWPs, further research is required with a multidimensional approach.

• Journal of Soil and Groundwater Environment
• /
• v.7 no.4
• /
• pp.77-86
• /
• 2002

Surfactant enhanced in-situ soil flushing was performed to remediate the soil and groundwater at an oil contaminated site, where had been used as a military vehicle repair area for 40 years. A section from the contaminated site (4.5 m $\times$ 4.5 m $\times$ 6.0 m) was selected for the research, which was composed of heterogeneous sandy and silt-sandy soils with average $K_d$ of 2.0$\times$$10^{-4}$cm/sec. Two percent of sorbitan monooleate (POE 20) and 0.07% of iso-prophyl alcohol were mixed for the surfactant solution and 3 pore volumes of surfactant solution were injected to remove oil from the contaminated section. Four injection wells and two extraction wells were built in the section to flush surfactant solution. Water samples taken from extraction wells and the storage tank were analyzed on a gas-chromatography (GC) for TPH concentration in the effluent with different time. Five pore volumes of solution were extracted while TPH concentration in soil and groundwater at the section were below the Waste Water Discharge Limit (WWDL). The effluent TPH concentration from wells with only water flushing was below 10 ppm. However, the effluent concentration using surfactant solution flushing increased to 1751 ppm, which was more than 170 times compared with the concentration with only water flushing. Total 18.5 kg of oil (TPH) was removed from the soil and groundwater at the section. The concentration of heavy metals in the effluent solution also increased with the increase of TPH concentration, suggesting that the surfactant enhanced in-situ flushing be available to remove not only oil but heavy metals from contaminated sites. The removal efficiency of surfactant enhanced in-situ flushing was investigated at the real contaminated site in Korea. Results suggest that in-situ soil flushing could be a successful process to remediate contaminated sites distributed in Korea.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.27 no.3
• /
• pp.63-74
• /
• 2019

This study carried out a human risk assessment of Cu, Pb, Zn and Ni contained in soil contaminated by improperly buried heavy metal wastes in railway sites. The purpose of the human risk assessment is to derive the need for soil remediation and factors that should be considered during soil remediation. Risk assessment was performed in accordance with the Environment Ministry's Risk Assessment Guidelines. The results of the human risk assessment of contaminated heavy metal soil contaminated by improperly buried waste in the railway site were presented after the process of determining exposure concentration, calculating exposure, and determining carcinogenic hazards. The heavy metal content of soil is 621.3 Cu mg/kg, 2,824.5 Pb mg/kg, 1,559.1 Zn mg/kg and 45 Ni mg/kg, which is the exposure concentration of the target contaminant. The results of human exposure according to exposure pathways were high in the order of soil outdoor dust >soil ingestion >soil contact, and Pb >Zn >Cu >Ni were higher in order of contaminant. The carcinogenic and noncarcinogenic risks of soil contaminated with heavy metal waste were higher than the allowable carcinogenic risks (TCR> $10^{-6}$) and the risk index (Hi < 1.0) suggested by USEPA. Therefore, the site needs to be remediated.

• Korean Journal of Soil Science and Fertilizer
• /
• v.43 no.3
• /
• pp.384-389
• /
• 2010

Outbreak of contagious diseases to livestock animals is becoming prevalent worldwide and consequently, tremendous numbers of the infected or culled stocks are buried on the ground as the most common disposal method. The buried animals can generate a wide range of detrimental components such as leachate, nutrient salts, and pathogenic bacteria, consequently contaminating the surround environment. This implies that regular investigations are required to monitor any possible detrimental environmental aspect occurred around burial sites. Therefore, the current study was conducted to investigate whether the soil and groundwater nearby the burial sites had been contaminated by the substances originated from the burial sites, which can be applied for the establishment of the ideal burial site construction design and post management scheme. For this, two different burial sites located in Cheonan and Pyeongtaek were selected. Cheonan and Pyeongtaek sites were constructed in 2004 and 2008, respectively and both contained dead poultry infected by avian influenza (AI). Soil and groundwater samples were collected around the sites followed by determination of the nutrient concentrations and bacteria (Salmonella, Camphylobacter, and Bacillus) existence in both soil and groundwater. Some of the soil samples showed higher EC, $NH_4$-N, $NO_3$-N concentration compared to those of the background (control) soils. Also the concentration of $NH_4$-N in some of the groundwater samples appeared to exceed the USEPA guideline value for drinking water (10 mg $L^{-1}$). These results indicated that the soil and groundwater were influenced by the burial site originated nutrients. In the soil, Bacillus was isolated in most soil samples while there were no detections of Salmonella and Camplylobacter. Due to the Bacillus existing mainly as a spore in the soils, it was considered that the frequent detection of Bacillus in the soil samples was attributed to the nutrients originated from the burial sites.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.09a
• /
• pp.395-398
• /
• 2003

Geosynthetic Clay Liners(GCLs) have been widely used as hydraulic barrier in landfills and remediation projects of contaminated sites. The aim of this research is to modify GCLs for effective removal of contaminants. We perform the free swell test, hydraulic conductivity test, and contaminants (TCE, hexavalent chromium, and nitrate) removal test on the bentonite-ZVI mixture with various ZVI content. As the ZVI content increased, contaminants removal efficiencies and swell volume increased, and hydraulic conductivity decreased.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.381-384
• /
• 2004

To know the occurrence and distribution of MTBE in groundwater, the analysis of groundwater around petroleum spill area was executed. The groundwaters of the 4 study sites are severely contaminated with MTBE and has the highest values of 650mg/L. The plume length of MTBE is longer than that of BTEX in D site and it is caused by the high solubility and low sorption capacities of MTBE.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 1999.10a
• /
• pp.19-22
• /
• 1999

A microbial consortium derived from a gasoline-contaminated sites was enriched on toluene in 100-mL serum bottle and was found to degrade benzene(B), toluene(T), ethylbenzene(EB), and xylenes(X). Studies conducted to determine the temperature effects and BTEX concentration on BTEX degradation. The results indicated that lowering temperature significantly decreased BTEX degradation rates and varing the BTEX concentration also changed substrate degradation patterns.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.7
• /
• pp.1233-1241
• /
• 2000

The purpose of this study is to see the remediability and pilot system operating condition on diesel contaminated areas. Air permeability(k) and trend of gas phase ($O_2/CO_2/VOCs$) concentration to determine the remediation rate of the contaminated sites are very important. So we tested air permeability and trend of gas phase concentration. Throughout soil vapor extraction(SVE) and bioventing hybrid pilot test on different conditions, the range of air permeability(k) was 1985~1194 darcy. The tests result in soil vapor extraction and bioventing hybrid system was appropriate on this test sites, and the suitable injection air flow rate was $3.5m^3/hr$.

• Korean Journal of Environmental Biology
• /
• v.24 no.1 s.61
• /
• pp.38-45
• /
• 2006

Ecological characteristics of microbial populations inhabiting heavy metal polluted soil were investigated. The samples were collected from 293 sites around an factory and industry at Gyeoungsangbuk-do. We measured the contents of seven heavy metal elements (Cd, Cu, As, Hg, Pb, $Cr^{6+}$, CN), seven sites have been seriously contaminated by mercury and chrome. A quantitative evaluation of microbial populations in mercury and chrome contaminated soil was examined by using plate count method. Bacterial numbers in polluted soil samples ranged from $7.4X10^5\;to\;9.3X10^7\;cfu\;g^{-1}$, about $10\sim100$ fold less than the count for the unpolluted soil. Moulds were not detected in chrome polluted soil. The log values of actinomycetes of each contaminated soil samples were log ranged from 6.18 to 7.52. The ratio of actinomycetes was similar to unpolluted soil. The investigation showed actinomycetes to be the major microbial population inhabiting the mercury and chrome polluted soil. Thirty-one isolates among the total isolates were examined for antibacterial activity. These isolates were identified based on a phylogenetic analysis using 16S rRNA gene nucleotide sequences, they were categorized in three major phylogenetic groups, belong to the Streptomyces (6 strains), Saccharopolyspora (3 strains), Nocardiodes (1 strain). On the phylogenetic tree, the clade consisting of five isolates were distantly related to all of the established Streptomycetes genera, indicating the possibility as members of new species.

• Journal of Environmental Science International
• /
• v.8 no.2
• /
• pp.197-204
• /
• 1999

The extent of heavy metal pollution in agricultural in soils near the abandoned mine land site was investigated using their concentrations from the 47 sampling sites in B mine. Samples were prepared using 0.1N HCI - Korean Standard Methods - and then analysed for Cd, Cu, Pb, As and Cr by Inductively Coupled Plasma Spectrometer. In addition, soil and mine tailing samples were sequentially extracted to investigate the chemical speciation of heavy metals in them. The soils in the vicinity of mining area are highly contaminated by heavy metals ranging up to 5.96mg Cd/kg, 253.3mg Cu/kg, 76.7mg Pb/kg, and 15.45 mg As/kg, according to the analysis of Korean Standard Methods. The heavy metal levels by the sequential extraction are much higher than its level by Korean Standard Methods, and little correlated with each other. Based on the results, it is suggested that the As pollution in agricultural soils near the AMLS should be dealt as of prior significance in establishing reclamation strategies for the area.