• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.49 no.1
• /
• pp.46-51
• /
• 2004

The film coated snap bean (Phaseolus vulgaris) seeds with five different coating materials treated with 3% increase in seed weight were planted at sandy loam soil controlled moisture content of 18, 19, 20 and 21 %. The oxygen diffusion rate (ODR) was calculated from the different moisture content soil. The number of normal seedlings, seedling vigor, and seedling capability in field (seed vigor x dry matter weight) were observed at 9 days after planting and compared to the changes of ODR. The germination rate and ODR were sharply decreased simultaneously in the seeds planted at 21 % soil moisture content. Seedling emergence did not occur at all as the soil moisture content increased above 22 %. Hence this value should be considered as the threshold of soil moisture content for seedling emergence. An ODR value under 20% did not influence the percent emergence significantly. The certain difference observing in the emergence at the same ODR was not related clearly to the condition of soil. So it can be assumed that the limit of soil moisture content for the emergence of snap bean was approximately 20%. The value of 18% soil moisture content may be considered as the optimum for snap bean emergence. There was close relationship between the mean value of ODR in different soil moisture contents and the emergence. The germination rates of the seeds coated with the different materials were quite different when the seeds were planted at 21 % soil moisture. Dry weight of the seedlings from film coated seeds was decreased slightly, but the germination rates were not much different from the non-treated control under relatively higher soil moisture content (21 %). Major factor lowering emergence rate was oxygen stress while film coating act as a minor constraint for snap bean sown in excess soil moisture condition.

• Journal of Environmental Science International
• /
• v.4 no.1
• /
• pp.1-12
• /
• 1995

The assessment for a degree of drought has been carried out based on the soil moisture index in Korea. The soil moisture index(Im) was calculated assuming of constant evapotranspiration until wilting point as Im = w2/wf $.$100. The soil moisture content(W2) at the final of a period is obtained from W2 : Pe + Wl - E, here the effective precipitation amount is Pe, evapotranspiration E, and the soil moisture content at the beginning of a period is Wl. The filed capacity(Wf), as a mean value of fine sandy loams, was reduced to 92 mm/ft when we accept the wilting point and the available soil moisture content of 42 mm/ft, respectively. The drought begins in Korea when the soil moisture index drops to less than 50%. The value coincides the isoline of 11 or more consecutive days without measureable precipitation. The soil moisture index frequently drops in the northern part of Youngnam area and Honam area so that both areas are well known as the areas of drought. Key word : Droughts, Soil Moisture Index.

• Journal of Biosystems Engineering
• /
• v.2 no.1
• /
• pp.25-32
• /
• 1977

This experiment was conducted in order to find out the drawing performance of a two-wheel tractor under different levels of the soil moisture and hardness, so as to obtain some basic data for improving their drawing performance. With fairly homogeneous soil, 5 levels of soil moisture contents (8, 13, 17, 20 and 23%) and 3 levels of soil hardness (0 , 2 and 4kg/$cm^2$) were selected for this experiment.The summerized results are as follows ;1. The draft force, on the hard soil (hardness ; 4kg/$cm^2$), had a distinct tendency to decrease with the increasing soil moisture. On the medium soil (hardness ; 2 kg/$cm^2$), and the soft soil (hardness ; 0kg$cm^2$), the draft force showed the highest when the moisture contents were within the range of 16-19%.But the maximum draft force, on the soft soil, was higher than that on the medium soil by 10 %. 2. The driving axle torque increased with increasing soil by 10 %. 3.The values of horizontal distance between the soil reaction point and axle shaft were within the range of 0~10cm , and it had the tendency to increase with the increasing soil moisture. Also, it s value was the largest on the hard soil and the smallest on the soft soil. 4.The tractive efficiency decreased with the increasing soil moisture. On the hard soil, the average value of tractive efficiency was higher than that on the medium soil by 19.0% and that on the soft soil was lower than that on the medium soil. 5.The traction ratio were within the range of 30 ~45%, and their changing tendency with respect to the soil moisture was similar to that in the case of the draft force. 6. The travel resistance ratio tended to increased with increasing soil moisture, and the highest value was found on the soft soil, and the lowest on the hard soil.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.26 no.3
• /
• pp.81-89
• /
• 1984

To examine the moisture adsorption and permeability characteristics, weathered granite soils of different degrees of weathering, cultivated upland soils and sands of Han-river were sampled. The results are as follows: 1. In case that the mother rock was same, the pF values under same moisture content decreased according as the grain size of soil became finer by the weathering process. 2. In case that the mother rock was different, the pF value varied by the behavior of clay minerals, and the cultivated upland soils showed more sensitive reaction than sands and fresh granite soils. 3. The pF value changed by the difference of primary moisture content and also influenced by soil structure, testing method and etc. 4. The pF value and compaction curve had close relation, however under same moisture content, the pF value decreased by the increment of density. 5. The permeability depend on the available void ratio between the soil particles according to the degree of weathering, and the pF value of available void water between the soil particles which related directly to permeability was about 3.3 except the void water holded in the soil particles. 6. As the above, the pF value and permeability were differentiated by degree of weathering, primary moisture content, density and etc. Therefore it is considered unreasonable to define uniformly by soil texture.

• The Korean Journal of Ecology
• /
• v.5 no.2_3
• /
• pp.123-131
• /
• 1982

The growth and the resistance of Amorpha fructicosa L. under water control was experimented in frames out of doors. The plant grew in a wagner's pot under water control. The soil moisture content was controlled at 5%, 10%, 15% and 20%. The growth of leaf, stem and root in the groups of 5% and 10% soil moisture content were different from values in the groups of 15% and 20%. The T/R ratio in the groups of 5% and 10% soil moisture content were different from the ratio in the groups of 15% and 20% soil moisture content. The T/R ratio of former was lower than the latter, but the C/F ratio of the former was higher than the latter. RGR and NAR of Amorpha fructicosa decreased in 5% and 10% soil moisture content but increased in 15% and 20% soil moisture content during growing period. The maximum values of RGR and NAR were respectively 0.089 and 0.080 at 20% soil moisture content. The highest value of LAR was 1.560 at 5% soil moisture content. RGR and NAR were comparatively affected by soil moisture content.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.45 no.5
• /
• pp.77-84
• /
• 2003

Recent advances in remote sensing techniques provide the potential for monitoring soil color as well as soil moisture conditions at the spatial and temporal scales required for detailed local modeling efforts. Soil moisture as well as soil color is a key feature used in the identification and classification of soils. Soil spectral reflectance has a direct relationship with soil color, as well as to other parameters such as soil moisture, soil texture. and organic matter. We evaluate the influence of seven soil properties, soil color and soil moisture, on soil spectral reflectance. This paper presents the results obtained from the ground-truth spectral reflectance measurements in the 300-1100 nm wavelength range for various land surfaces. The results suggest that the reflectance properties of soils are related to soil color, soil texture, and soil moisture. Increasing soil moisture content generally decreases soil reflectance which leads to parallel curves of soil reflectance spectra across the entire shortwave spectrum. We discuss the relationships between the soil reflectance and the Munsell Soil Color Charts which contain standard color chips with colors specified by designations for hue, value, and chroma.

• Geomechanics and Engineering
• /
• v.29 no.1
• /
• pp.13-23
• /
• 2022

Peat soil has the characteristics of high moisture content, large void ratio and low shear strength. In this study, unconfined compressive strength and SEM tests are conducted to investigate the effects of ultrahigh moisture content, cement content, organic content and pH value on the strength of solidified peat. As an increase in the cement content and curing period, the failure mode of solidified peat soil changes from ductile failure to brittle failure. The influence of moisture content on the strength of solidified peat is greater than the cement content. As cement content increases from 10% to 30%, strength of solidified peat at a curing age of 28 days increases by 161%~485%. By increasing water content by 100%, decreases of solidified peat at a curing age of 28 days is 42%~79%. Compared with the strength of solidified peat with a pH value of 5.5, the strength of peat with a pH value of 3.5 reduces by 10% ~ 46%, while the strength of peat with a pH value of 7.0 increases by 8% ~ 38%. It is recommended to use filler materials for stabilizing peat soil with moisture content greater than 200%. Because of small size of clay particles, clay added in the cement solidified peat can improve much higher strength that that of sand.

• Journal of Korea Water Resources Association
• /
• v.54 no.2
• /
• pp.81-91
• /
• 2021

Synthetic Apreture Radar (SAR) is attracting attentions with its possibility of producing high resolution data that can be used for soil moisture estimation. High resolution soil moisture data enables more specific observation of soil moisture than existing soil moisture products from other satellites. It can also be used for studies of wildfire, landslide, and flood. The SAR based soil moisture estimation should be conducted considering vegetation, which affects backscattering signals from the SAR sensor. In this study, a SAR based soil moisture estimation at regions covered with various vegetation types on the middle area of Korea (Cropland, Grassland, Forest) is conducted. The representative backscattering model, Water Cloud Model (WCM) is used for soil moisture estimation over vegetated areas. Radar Vegetation Index (RVI) and in-situ soil moisture data are used as input factors for the model. Total 6 study areas are selected for 3 vegetation types according to land cover classification with 2 sites per each vegetation type. Soil moisture evaluation result shows that the accuracy of each site stands out in the order of grassland, forest, and cropland. Forested area shows correlation coefficient value higher than 0.5 even with the most dense vegetation, while cropland shows correlation coefficient value lower than 0.3. The proper vegetation and soil moisture conditions for SAR based soil moisture estimation are suggested through the results of the study. Future study, which utilizes additional ancillary vegetation data (vegetation height, vegetation type) is thought to be necessary.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.11 no.4
• /
• pp.1783-1790
• /
• 1969

It is one of the most economical method of soil stabilization works to compact soil, which increases soil density artificially. Compaction effort is to lessen void of soils, and consequently its aim is to enlarge friction and cohesion force, and reduce permeability of soil. Factors in compaction effort are moisture content, grain size, grain size distribution, physical properties, compaction method and temperature of soils etc. The results obtained in this study on the effects that grain size, gradation and physical properties influence upon compaction effort for 20 samples under the constant compaction method, are summarized as follows: 1. The bigger the maximum dry density is, the smaller the optimum moisture content is, on the other hand, the smaller the maximum dry densityis, the bigger the optimum moisture content is, ingeneral. 2. The coarser the grain size is, the bigger the maximum dry density is, and the optimum moisture content becomes small, and dry density-moisture content curve has the sharp peak, generally. Also, the finer the grain size is the smaller the maximum dry density is, and the optimum moisture content shows the big value, and dry density-moisture content curve has the dull peak. 3. The maximum dry density shows the biggest value on the sample to be about 15% of particles finer than No. 200 sieve. The more the percent passing of No. 10 sieve increase, the smaller the maximum dry density is. Soils which have uniformity coefficient less than 5 in particles larger than 0.074mm hardly show dry density-moisture content curve. 4. There is a relation which is ramax＝2.3948-0.0376 Wopt between the maximum dry density and the optimum moisture content, namely, the maximum dry density is increased in proportion to decrease of the optimum moisture content. 5. There are relations to be the straight lines which the maximum dry density decrease, on the other hand, the optimum moisture content increase in accordance with enlargement of Atterberg Limit(LL, PL, PL) in compacted soils.

• Journal of Environmental Science International
• /
• v.4 no.5
• /
• pp.427-435
• /
• 1995

In order to discuss the differences among the SMP(Surface Moisture Availability Parameter), by previous researchers on the basis of their own theoretical and empirical background, we assessed the SMP according to the soil types and volumetric soil water contents. The results are as follows. There are differences among all the five SMAPs. There's a tendency that the larger grain size, the higher value of parameters. And they divided into two groups for their value: one group has parameters with exponential function and the other with cosine and linear function. The maximum difference between the two groups appears when the volumetric soil water contents are 0.07m3m-3 for sand, 0.l1m3m-3 for loam, 0.12 for clay, and 0.13m3m-3 for silt loam. So, these differences must be considered when we estimate the surface evaporation rate. From field data, the paddy field soil around Junam reservoir is classified as a silt has high wetness, 0.56. So, the parameter obtained from the field measurement is much higher than that of Clapp and Hornberger(1978)'s Table. This study treated the SMP for a certain point of time in winter season. But if we measured the soil water contents continuously, we could obtain better time-dependent parameter. Key words : SMAP(Surface Moisture Availability Parameter), Paddy field, Volumetric soil water content, Evaporation, Capillary potential.