• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.2
• /
• pp.67-72
• /
• 2015

Power grid techniques are distributed over general power systems ranging from power stations to power transmission, power distribution, and users. To monitor and control the elements and performance of a power system in real time in the extensive area of power generation, power transmission, wide-area monitoring (WAM) and control techniques are required (Sattinger et al. 2007). Also, to efficiently operate a power grid, integrated techniques of information and communication technology are required for the application of communication network and relevant equipment, computing, and system control software. WAM should make a precise power grid measurement of more than once per cycle by time synchronization using GPS. By collecting the measurement values of a power grid from substations located at faraway regions through remote communication, the current status of the entire power grid system can be examined. However, for GPS that is used in general national industries, unexpected dangerous situations have occurred due to its deterioration and jamming. Currently, the power grid is based on a synchronization system using GPS. Thus, interruption of the time synchronization system of the power system due to the failure or abnormal condition of GPS would have enormous effects on each field such as economy, security, and the lives of the public due to the destruction of the synchronization system of the national power grid. Developed countries have an emergency substitute system in preparation for this abnormal situation of GPS. Therefore, in Korea, a system that is used to prepare for the interruption of GPS reception should also be established on a long-term basis; but prior to this, it is required that an evaluation technique for the time synchronization performance of a GPS receiver using an atomic clock within the power grid. In this study, a monitoring system of time synchronization based on GPS at a power grid was implemented, and the results were presented.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.11
• /
• pp.2131-2138
• /
• 2011

GPS is vulnerable to jamming because of extremely low signal power. Many anti-jamming techniques are studied for complement this vulnerability. Anti-jamming techniques using array antenna are most effective technique and these techniques are required the DOA estimates. MUSIC algorithm and Root-MUSIC Algorithm are typical algorithms used in DOA estimation. Two algorithms have different characteristics, so the choice of an algorithm may depends on many factors such as the environment and the system requirements. The analysis and performance comparison of both algorithms is necessary to choose the best method to apply. This paper summarizes the theory of MUSIC and Root-MUSIC algorithms. And this paper extends both algorithm to estimate two-dimensional angles. The software simulator of both algorithms are implemented to evaluate the performance. Root-MUSIC algorithm has the computational advantage on ULA. MUSIC algorithm is applicable to any antenna array. MUSIC shows better estimation performance when number of array element is small while the computational load of MUSIC is much higher than Root-MUSIC.

• Journal of Advanced Navigation Technology
• /
• v.17 no.2
• /
• pp.157-164
• /
• 2013

In the presence of spoofing signal the GPS signal having the same PRN with the spoofer is hard to be acquired since the power of spoofing signal is usually stronger than that of GPS signal. If a spoofing signal exists for the same PRN, there are double peaks in two-dimensional space of frequency and code phase in acquisition stage. Using double peak information it is possible to detect spoofing signal and acquire GPS information through separate channel tracking. In this paper we introduce an anti-spoofing method using double peak detection, and thus can acquire GPS navigation data after two-channel tracking for the same PRN as the spoofing signal.

• Journal of the Korean Society for Aviation and Aeronautics
• /
• v.19 no.2
• /
• pp.23-28
• /
• 2011

Michibiki is the first QZSS satellite, which was launched by a H-IIA rocket departing from the Tanegshima in Japan on 11 September, 2010 and now operated successfully. This paper presents the results obtained from processing of the L1 C/A signal transmitted from the QZSS satellite. The acquisition and tracking are performed by the L1 software receiver implemented by ETRI. The signal processing results show that QZSS L1 C/A signal is normally processed through the tracking loop results of FLL, PLL, and DLL, the EPL correlator output, and the C/No output. Finally, the paper demonstrates that the QZSS satellite could be used in the navigation system together with the GPS satellite in Korea.

• Journal of the Korean Society for Aviation and Aeronautics
• /
• v.19 no.4
• /
• pp.6-11
• /
• 2011

Launch of the first Quasi-Zentih Satellite System (QZSS) satellite, dubbed Michibiki, took place September 11, 2010 and technical and application verification of the satellite is being carried out. This paper presents the results obtained from processing of the L5 signal transmitted from the QZSS satellite. The QZSS L5 signal is collected in ETRI, Korea. And then, the acquisition and tracking are performed by the L5 software receiver implemented by ETRI. The tracking loop of FLL, PLL, and DLL, the EPL correlator output, and the C/No output results show that the QZSS L5 signal is normally processed. Finally, the paper demonstrates that the QZSS L5 signal could be used as GPS satellite based augmentation system in Korea as well as Japan.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.17 no.1
• /
• pp.21-32
• /
• 1999

Mapping and precise point determination by photogrammetry have been shown to be an economic solution. But control points are necessary to determine the exterior orientation parameters. Although the number of required control points has been reduced based on extended bundle adjustment and reinforced cross-strip, the ground survey is a significant factor of whole expenses in photogrammetry. The status of GPS-photogrammetry with kinematic DGPS-positioning to overcome this disadvantages, is now steadly progressive since the first possibility has been proved. The completed satellite configuration, powerful receiver function and upgraded software for kinematic DGPS-positioning have extensively improved the accuracy of combined bundle adjustment. So the research for the operational use of GPS-photogrammetry is absolutely necessary. The presented test field was designed for identification of subsidences in a coal mining area, flown with 60％ sidelap and cross strips. Just with 6 control points and combined block adjustment instead of the traditionally used 21 horizontal and 81 vertical control points the same ground accuracy has been reached. The accuracy of kinematic GPS-positioning and combined block adjustment was independent upon the distance of the ground reference station. It also has been showed that the special model for the systematic error correction in the combined block adjustment.

• Journal of Advanced Navigation Technology
• /
• v.15 no.1
• /
• pp.32-38
• /
• 2011

In this paper, code and carrier tracking error which resulted from spoofing signal was analyzed by simulation. For a start, the types of spoofing signals and methods were classified. For the simulation, search spoofing method is assumed because a perfect position and velocity are not generally informed to spoofing device. In most cases, the tracking error is increased but a complete deception does not happen because of the inherent anti-spoofing characteristics of the GPS signal.

• Journal of KIISE:Software and Applications
• /
• v.36 no.6
• /
• pp.462-470
• /
• 2009

We propose a wearable system to help the visually impaired persons for walking safely to destination. If a user selects a destination, the system guides the user to destination with position data from GPS receiver and shortest path algorithm. At the same time, after acquiring complex spatial structures in front of the user with ultrasonic sensors, we categorize them into several predefined patterns, and determine an avoidance direction by estimating the patterns. As a result, visually impaired persons can arrive at destination safely and correctly without others help.

• Proceedings of the KSRS Conference
• /
• 2003.11a
• /
• pp.384-386
• /
• 2003

GPS observation has been performed at Khon Kaen in northeast Thailand to investigate the Precipitable Water Vapor (PWV) change since August 2001 by using a Trimble 4000SSi receiver. The data obtained in the period from March to June in 2002 were processed by using CAMIT software to obtain the Zenith Tropospheric Delay (ZTD) at every one hour referring to some IGS stations around Thailand. We estimated the Zenith Hydrostatic Delay (ZHD) at every three hours with barometer data at Khon Kaen of Thai Meteorological Department, The Zenith Wet Delay (ZWD) was obtained by subtracting ZHD from ZTD and PWV can be calculated from ZTD. The results obtained shows that PWV changes with a large amplitude in March and April before the monsoon onset, and also we can see steep PWV increases before rain and decreases after rain. In May and June after the onset, the PWV is almost constant to be 60 to 70 mm, but there is a semi-diurnal change which has high PWV values at about 8 and 20 o'clock in local time.

• Journal of Positioning, Navigation, and Timing
• /
• v.5 no.3
• /
• pp.109-118
• /
• 2016

The present paper proposes a method that can estimate a roll rate of spinning vehicles utilizing GPS receivers. The proposed method analyzes a relation between received signal and correlation value and utilizes a phenomenon that received signal power that changes according to a signal incident direction affects a correlation value. That is, a roll-rate estimation method using zero crossing detection method for correlation value, which has sinusoidal periodicity according to rotations of vehicles, is proposed. A correlation value in real environments experiences a jitter so that the proposed method includes a pre-processing filter and detection threshold setting way is also considered to reduce the effect of received signal power. In order to verify the operation of the proposed method and analyze the performance, a signal generator and software-defined receiver (SDR) are designed. The signal generator generates intermediate frequency (IF) signal by taking the rotation of vehicles, antenna gain, and signal power into consideration, and a correlation value is acquired by taking the generated IF signals into consideration. Using the generated correlation value, the operation of the proposed roll rate estimation method is verified and the performance is analyzed.