• Journal of the Korean Ceramic Society
• /
• v.37 no.2
• /
• pp.117-121
• /
• 2000

Er-doped sodiumborosilicate glass films for waveguides amplifier were fabricated by Aerosol Flame Deposition(AFD) method. Al2O3 was added to sodium borosilicate glass films to suppress the formation of crystalline phase and control the refractive index. the formation of crystalline phase was suppressed above Al2O3 of 6 wt%. As the amount of Al2O3 increased from 2 to 12 wt% the refractive index of glass films increased lineary from 1.4595 up to 1.4710. After the core of 77SiO2-15B2O3-8Na2O＋6 wt%Al2O3＋8wt%Er2O3 was coated on the buffer layer of 77SiO2-15B2O3-8Na2O＋6 wt%Al2O3, the core was etched by reactive ion etching. The absorption spectrum of 3 cm waveguide amplifier showed two peaks of 1530 and 1550 nm.

• Journal of the Korean Ceramic Society
• /
• v.36 no.9
• /
• pp.946-953
• /
• 1999

The etching characteristics of Er-doped sodium borosilicate glass film for the planar optical waveguides were investigated using reactive ion etching. The etch rate decreased as the pressure in creased but increased as the RF power increased. The etch rate increased as the flow rate C2F gas and the amount of O2 addition increased but decreased over critical point (C2F6 7,5 accm O2 20%) The etch rate was 180${\AA}$/min under C2F6 7.5 sccm O2 20% RF power 270 W, pressure 150 mTorr. With this optimum etching condition and subsequent heat treatment at 975$^{\circ}C$ for 30 minutes planar optical waveguides having improved sidewall roughness were fabricated successfully.

• The Korean Journal of Ceramics
• /
• v.1 no.2
• /
• pp.96-100
• /
• 1995

Recently, alumina/glass composites have been applied as a substrate material for hybrid IC and LSI multi-chip packaging. In this study, the characterization of sodium borosilicate glasses containing NaF and $AlF_3$ and the preparation of the resulted glass/alumina composites have been examined and the effect of the addition of fluorides on the thermal. and dielectric properties of the sintered composites have been studied. The sintering temperature of specimens was lowered by about 100-$150^{\circ}C$ by the addition of fluorine compared with the specimens without fluorine. The specimens containing fluorine showed slightly lower dielectric constants than those of the specimens without fluorine.

• Journal of the Korean Vacuum Society
• /
• v.17 no.6
• /
• pp.481-486
• /
• 2008

The different degrees of blackening were observed at the inner surface of borosilicate, soda-lime, and aluminosilicate glass tubes having different sodium (Na) contents. The sodium contents ($Na_2O$) within the borosilicate, soda-lime, and aluminosilicate glass tubes were found to be 4%, 14%, and 0.06%, respectively. The degree of blackening was shown to increase as the sodium content within the glass of the fluorescent lamp containing Ne+Ar+Hg gas mixture. Higher degree of blackening was observed from the inner surface of the glass tube coated with $Y_2O_3$. The blackening was found to be originated from the amalgam of $NaHg_2$ generated by the chemical reaction between the mercury ions within the discharge gas and sodium within the glass tube during operation.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08a
• /
• pp.367-370
• /
• 2007

An EEFL with the sodium free alumino-silicate glass of high K and low $tan{\delta}$, has been investigated. As compared with borosilicate and the soda-lime EEFLs, the luminous efficiency as well as the pinhole stability of new EEFLs improves remarkably without blackening of $NaHg_2$.

• Journal of the Korean Ceramic Society
• /
• v.26 no.4
• /
• pp.521-531
• /
• 1989

The dependence of the chemical durability of simulated waste glasses containing the simplified waste similar to the SRP waste on compositions of host glasses, amounts of waste loading, and kinds of leachants has been investigated as a basic study on the waste immobilization through vitrification. The maximum limit of the amount of waste loading for glassforming with the host sodium borosilicate glasses selected in this study was 50wt%. The chemical durability of waste glasses whose host glass belonged to the immiscible composition region was much higher than that of waste glasses whose host glass belonged to the miscible composition region. The former waste glass showed lower chemical durability in deionized and silicate waters than in brine, while the latter glass showed the lowest chemical durability in deionized and silicate waters than in brine, while the latter glass showed the lowest chemical durability in silicate water. It was also observed that the total leaching rates in brine were noticeably small in comparison with those in other solutions. The composition of the host borosilicate glass which was suitable for the treatment of the waste through vitrification was found to be 25 Na2O-5B2O3-70SiO2(wt.%).

• Korean Journal of Materials Research
• /
• v.8 no.8
• /
• pp.693-698
• /
• 1998

The effects of $AI_{2}$$O_{3}$ and the ratio of $Na_2O/B_2O_3$ on the phase separation and optical properties of sodium borosilicate glass film fabricated by AFD(Aerosol Flame Deposition) were investigated. When AI,O, of 6wt% was added to $66SiO_2-27B_2O_3-7Na_2O$ the clear glass film without any crystallization was produced under air-quenching condition after consolidation. As the amount of $AI_{2}$$O_{3}$ increased from 1.5 to 6.0 wt% the refractive index linearly increased from 1.4610 to 1.4701, and the difference of TE and TM mode causing by residual stress in film increased gradually. However, the difference of TE and TM mode to reveal birefringence could be minimized by annealing below the glass transition temperature after consolidation and air quenching. On the other hand. as the ratio of $Na_2O/B_2O_3$ increased the refractive index and birefringence of glass film tended to increase, but the measurement of their values were not available at over the critical ratio of $Na_2O/B_2O_3$, because of the cloudiness due to crystallization. The phase separation was greatly accelerated with increasing the ratio of $Na_2O/B_2O_3$.

• Journal of the Korean Ceramic Society
• /
• v.25 no.2
• /
• pp.173-183
• /
• 1988

Effects of oxide additives such as MoO3, MnO2 ZrO2 and Fe2O3 on the phase separation and the chemical durability of sodium borosilicate glasses which are the host of waste glasses have been investigated as the basic study on the nuclear-waste immobilization through vitrification. MoO3 and MnO2 were found to be phase separation promotors which increased the temperature as well as catalyzed nucleation and growth for the phase separation of the 10Na2-O-3OB2O3-6OSiO2 (wt%) parent glass within the immiscibility region. The glasses had the interconnected phase-separated structure as the amount of addition increased. On the other hand, ZrO2 and Fe2O3 were inhibitors which showed the reverse effects to the above promotors. It was also found that addition of MoO3 could cause the phase separaton of the 20Na2O-10B2O3-70SiO2(wt%) glass even within the miscibility region. Addition of ZrO2 and Fe2O3 increased the chemical durability of the parent glass within the immiscibility region. Within the miscibility region, however, the addition of 1.96 wt % of MoO3 increased the chemical durability considerably, while MnO2 had little effects.

• Journal of the Korean institute of surface engineering
• /
• v.34 no.3
• /
• pp.240-246
• /
• 2001

The possibility of using a glass block with the composition of sodium borosilicate as starting materials for GRIN glass was examined from the view points of the phase separation of the matrix glass, the effects of leaching and the heating conditions for a porous structure, and the change in the refractive index. Glass specimens with similar compositions were prepared in the form of porous glass using a phase-separation technique. An examination of the heating and leaching conditions and the microstructure dependence of these conditions was made.; Specimens with porous structure were obtained when the heat treatment and leaching conditions were fixed at $540^{\circ}C$ for 30hrs and in a 0.3N$ H_2$$SO_4$ solution at $100^{\circ}C$, respectively. The resultant specimens had some important features on the GRIN glass.; the depth of the gradient and the change in refractive index (Δn) were 4mm and 0.015~0.02, respectively.

• Journal of the Korean institute of surface engineering
• /
• v.28 no.5
• /
• pp.259-266
• /
• 1995

In order to manufacture an attractive waste glass for the permanent and secure disposal of high-level radioactive waste, the complex composition of the simulated nuclear waste glass PNL-7668 was simplified to a composition of sodium borosilicate glass. The substitutions of $Fe_2O_3$ and $Al_2O_3$ were added to examine on the leaching characteristics of simulated nuclear waste glass with variable composition. The leach tests for these glasses were performed according to 'MCC-1, Static Leach Test Procedure' in acid and basic solution. In this study, for the $Al_2O_3$-containing glasses, Na ion release from these glasses was higher in acid solution than in basic solution. As the content of $Fe_2O_3$ was increased in glasses, Na ion release was increased in acid solution, in spite of decrease of amount of total mass diminution.