• International Journal of Naval Architecture and Ocean Engineering
• /
• 제12권1호
• /
• pp.691-698
• /
• 2020

In this study, the effects of hydrodynamic interceptors on a high-speed vessel were investigated to identify the operating principle based on experiments. Model tests were performed using a high-speed towing carriage. The resistance, trim and rise of Center of Gravity (CG) of the high-speed vessel were measured for various ship speeds and interceptor heights. As the interceptor height increased, the trim and rise of CG were reduced. In order to quantitatively analyze these phenomena, the pressure at the stern bottom was measured using tactile sensors. The reliability of the measured results from the tactile sensors was verified through repeat tests. The pressure on the stern bottom increased in proportion to the interceptor height, as the interceptor partially blocked the flow there. Then, the trim was reduced. However, as the ship speed increases, the pressure at the location close to the interceptor decreases when the interceptor height is small, leading to increased trim. Therefore, the interceptor height for running attitude control should be carefully determined considering multiple factors in the operating condition of the high-speed planing hull.

• 한국가구학회지
• /
• 제19권2호
• /
• pp.111-115
• /
• 2008

An experiment was conducted to know ultra-pure distilled water penetration depth through large vessel, small vessel, latewood fiber and earlywood fiber in longitudinal direction of Castanea crenata. In heartwood, latewood fiber transported water more than large and small vessel. While in sapwood, small vessel conduction depth was found the highest. Penetration depth of water after 15.0 seconds, no significant difference was observed among earlywood fiber, latewood fiber and earlywood vessel. Whilst in heartwood, no statistical difference was observed among earlywood fiber, latewood fiber and earlywood vessel. At the beginning, the speed of water penetration was high and then gradually decreased.

• 해양환경안전학회지
• /
• 제21권6호
• /
• pp.784-789
• /
• 2015

본 연구는 소형 고속정의 운항한계를 검토하기 위하여 수행되었다. 일반적으로 내항성능의 검토는 선형의 결정 단계 전에 이루어지지만 본 연구는 선박의 건조가 완료된 후에 이루어졌다. 검토 결과, 종동요, 수직 및 수평가속도, 슬래밍의 운동성능은 특정한 조우각을 제외하고는 만족하였으나 갑판침수의 경우에는 해석을 수행한 모든 조건에서 만족하지 않았다. 이것은 대상선박의 크기가 소형이기 때문에 선박의 속도나 파도와의 조우각보다는 해상상태가 설정한 내항성능 기준의 만족 여부에 더 큰 영향을 미쳤기 때문으로 보인다.

• 한국가구학회지
• /
• 제19권1호
• /
• pp.91-96
• /
• 2008

This paper investigates the penetration of essential oil into radial and longitudinal directions of Castanea crenata. Present study was performed to know the essential oil penetration depth in radial and longitudinal direction of Castanea crenata. Essential oil penetration depth was found higher in longitudinal direction than in radial direction and it was about 53 times high at 15.0 second of penetration. In early wood, fiber conducted oil more than that of large vessel. In heartwood, fiber had played an important role for the conduction of oil. But in sapwood, small vessel conducted oil deeper than wood fiber, which was also significantly different from large. On the other hand, large vessel in heartwood had statistically lower penetration depth than that of fiber and small vessel. At the beginning of penetration the speed was high and gradually decreased in course of time.

• 한국항해학회지
• /
• 제1권1호
• /
• pp.45-62
• /
• 1977

The advanced researches of the ship's motion in the seaway can predict the heaving, pitching and slamming of ship's motion. The researches as of today are that of displacement type such as a small typical fishing boat and U, UV and V bow ship forms under low speed. In recent day, the study of behaviours of high speed planning boat in the regular waves has been carried out by Bessho [5]. The calculation about behaviours of a high speed vessel in the longitudinal regular waves is calculated by Ordinary Strip Method in this paper. The data of the results were discussed and compared with Bessho's results. The conclusions deduced from this study are as follow, (1) The acceleration of motion calculated by the O.S.M. is similar with Bessho's data for the Fn 0.5 (2) The amplitudes of the behaviours of motions take peak at 1.0<λ/L<1.4.

• 한국항해학회지
• /
• 제3권2호
• /
• pp.1-19
• /
• 1979

The advanced researches of the ship's motion in the seaway can predict the heaving, pitching and slamming of ship's motion. The researches as of today are that of displacement type such as a small typical fishing boat and U, UV and V bow ship forms under low speed. In recent day, the study of behaviours of high speed planning boat in the regular waves has been carried out by Bessho [5]. The calculation about behaviours of a high speed vessel in the longitudinal regular waves is calculated by Ordinary Strip Method in this paper. The data of the results were discussed and compared with Bessho's results. The conclusions deduced from this study are as follow, (1) The acceleration of motion calculated by the O.S.M. is similar with Bessho's data for the Fn 0.5 (2) The amplitudes of the behaviours of motions take peak at 1.0<λ/L<1.4.

• 수산해양기술연구
• /
• 제35권2호
• /
• pp.147-155
• /
• 1999

본 연구에서는 8톤급 어선의 복원력 분석이 이루어졌다. 복원력 분석은 안정성과 관련이 있어, 선박의 기본설계시 중요한 항목중 하나이고, 각국 선급에서 규정을 준수하도록 하고 있다. 파랑중 어선의 전복현상은 파랑 및 바람에 의한 외력과 파랑중 선박의 브로우칭 (broaching) 현상과 복원력 변화가 어우러져 발생한다. 본 연구에서는 전복 -현상에 대한 분석을 하기 전에 필요한 파랑중복원력 분석이 수행되었다. 파도와의 만남 주파수가 0이 되는 선속과 파장의 관계가 구해졌다. 본 연구에서 택한 어선의 경우 선박의 길이와 비슷한 파장을 가지는 파도와 같은 방향으로 가면 만남 주파수가 작아짐 을 알 수 가 있었다. 이런 경우 위험한 상황이 발생할 가능성이 있다. 복원팔의 계산 결과 파정에 선박이 위치하고 있을 때, 복원력 감소가 상당히 발생하였음을 알 수가 있었다 파정에 오래 머물지 않도록 하는 운항 지침이 있어야 하겠다 전체적으로 본 연구에서 택한 어선을 대형 화물선보다 복원력 변에서는 유리한 것으로 판단되는데, 선체가 작아 상대적 으로 높은 파도를 만날 가능성이 많다. 앞 절에서 여러 가지 경우에 대한 계산 결과를 보았다. 김윤수(1994)는 대형화물선에 대하여 복원력 변화를 계산하였는데, 파도에 의한 복원력변화가 심하였다. 위의 그립을 보면 H/Lw=0.025에서 GZ 곡선의 최대 값이 1/2 이하로 줄어듦을 알 수 있다. 그러나 본 어선의 결과인 Fig. 6 과 7을 보면 변화가 대형화물선과 비교하며 작음을 알 수 있다. 이 것의 원인은 중앙단면의 형상 때문인 것으로 판단된다. 대형화물선의 경우 방형 비척계수 (뚱뚱함을 나타내는 계수)가 큰데 반하여, 본 어선은 방형 비척계수가 작고 측면에 차인을 두어 부력중심의 변화가 커서 복원력이 많이 작아지지 않는 것으로 판단된다. 앞으로 파도와 비슷한 속도와 방향으로 항주하는 어선의 동역학적인 안정성에 대한 분석이 이루어져야 하겠다.

• 해양환경안전학회지
• /
• 제27권4호
• /
• pp.538-549
• /
• 2021

본 연구에서는 Froude 수 1.0으로 운항하는 길이 약 10m 급 소형 고속선박의 에너지 효율 설계를 위해 선미부에 트림 탭을 부착하였고, 선저 면과의 각도에 따른 항주자세와 저항성능의 변화를 살펴보았다. 성능 해석은 CFD 해석을 통해 수행되었으며, 축척에 의한 영향을 보기 위해 모형선과 실선에 대해 각각 해석을 수행 후 두 결과로부터 예측된 실선의 성능을 비교하였다. 나선에 대한 해석 결과는 두 결과가 전반적으로 유사하였고, 트림 탭이 부착된 경우 선저 면과의 각도가 동일할 때 자세 변화량이 달라 전 저항의 차이로 이어졌지만 자세에 따른 저항 변화 경향은 유사하였다. 이로부터 축척 효과가 있더라도 저항 저감 경향으로부터 최적 항주자세를 찾을 수 있으나, 트림 탭에 의한 자세 변화와 실선 주위 유동의 특성을 알기 위해서는 실선에 대한 직접적인 해석이 필요함을 알 수 있다.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2005년도 후기학술대회논문집
• /
• pp.214-215
• /
• 2005

Naval equipments are installed and used for naval vessel with different environmental conditions comparing to the commercial vessel, for example, high engine power per ship displacement size, severe vibration and shock due to high running speed and explosion from naval gun's bombardment and underwater weapons. Therefore, those equipments must be installed on shipboard with small spaces, high ambient temperature around engine room and which are required be fabricated with high resistances of vibration, shock and heat resources. But in case of commercial vessel, the performances of their recent equipments naval have been improved continuously due to the technology development of domestic shipbuilding and shipboard equipment industries, together with the related fundamental industries i.e, metal, steel and electronic industries, to an international level since 1970. With these results, it became possible to unify the specifications of shipboard equipments for the commercial and military vessels(Dual-Use). In this study, vibration and shock test standards for the commercial and military vessels will be compared and reviewed technically.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제8권5호
• /
• pp.442-455
• /
• 2016

The resistance and seakeeping performance of a high-speed monohull vessel were investigated through a series of model tests in a towing tank. The hull had a slender wave-piercing bow, round bilge, and small deadrise angle on stern. Tests on the bare hull in calm water were first conducted and tests on spray rails followed. The spray rails were designed to control the flow direction and induce a hydrodynamic lift force on the hull bottom to reduce trim angle and increase rise of the hull. The maximum trim of the bare hull was $4.65^{\circ}$ at the designed speed, but the spray rails at optimum location reduced trim by $0.97^{\circ}$. The ship motion in head seas was examined after the calm water tests. Attaching the rails on the optimum location effectively reduced the pitch and heave motion responses. The vertical acceleration at the fore perpendicular reduced by 11.3%. The effective power in full scale was extrapolated from the model test results and it was revealed that the spray rails did not have any negative effects on the resistance performance of the hull, while they effectively stabilized the vessel in calm water and waves.