• Journal of Environmental Science International
• /
• v.23 no.6
• /
• pp.1061-1066
• /
• 2014

This study has cross checked the change of internal sludge-recycle in Anaerobic-Digestion, and researched about not only the improvement of Bio-gas production from the digested sludge but also the efficient method of sludge minimization. Ultimate object of the study is to reduce the amount of sludge by the improved efficiency of contact with the organic-matter and the microbes in Anaerobic-Digestion. The sludge-recycle fluidized sludge layer and raised the activity of the sludge, the optimal sludge-recycle ratio, VS and COD removal ratio were 1,000%, 28.2% and 27.7%, respectively. Through these results of this study, it may be of use to treat waste sludge by the sludge-recycle ratio in terms of minimization and circulation of resources.

• Journal of the Korean Society of Industry Convergence
• /
• v.15 no.3
• /
• pp.83-86
• /
• 2012

This study have cross checked the change of internal sludge-recycle in Full-scale Anaerobic-Digestion, and researched about not only the improvement of Bio-gas production from the digested sludge but also the efficient method of sludge minimization. Ultimate aim of the study is to reduce the amount of sludge by the improved efficiency of contact with the organic-matter and the microbes in Anaerobic-Digestion. The sludge-recycle fluidized sludge layer and raised the activity of the sludge, The sludge-recycle ratio of optimum was 500%, VS and COD removal ratio respectively appeared with 67.8% and 70.4%. Through these result of this study, it may be positive view to treat waste sludge by the sludge-recycle ratio in terms of minimization and circulation of resources.

• Journal of Environmental Science International
• /
• v.22 no.11
• /
• pp.1383-1388
• /
• 2013

The pilot plant experiment was performed to investigate phosphorus and nitrogen removal from domestic wastewater by MLE process combined with aluminum corrosion reactor. When operating 0.5Q and 1Q to internal recycle and sludge recycle in the MLE process, the effluent $COD_{Mn}$ concentration of internal recycle 0.5Q were higher than internal recycle 1Q, the removal efficiency rates of $NH_3$-N in the internal recycle 0.5Q were was higher than internal recycle 1Q. Denitrification rates were about 86.8% in internal recycle and sludge recycle 0.5Q. When operating 0.5Q to internal recycle and sludge recycle in the MLE process, the removal efficiency rates of total nitrogen was the highest. The removal efficiency rates of total phosphorus was about 91.5% in the aluminum corrosion reactor.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.8 no.1
• /
• pp.69-75
• /
• 1988

Two rational formulae depicting the relationships between sludge ages and recycle flow rates have been developed to determine sludge wasting volumes at a particular sludge age. A sensitivity analysis shows that the recycle ratio is the most important variable to be measured as accurately as possible in determining the sludge wasting volume to maintain a particular sludge age when the system is controlled by wasting recycled sludge. On the other hand, the final clarifier solids capturing capacity is the most important variable to be measured when the system is operated by wasting mixed liquor.

• Journal of Korean Society on Water Environment
• /
• v.20 no.1
• /
• pp.42-47
• /
• 2004

This study was accomplished to develope an advanced wastewater treatment process using high MLSS in anoxic tank aimed to improve nutrient removal and to reduce wasting sludge. It was operated with 4 Modes with varing solid concentration and internal recycle ratios. Mode I, II, III was operated 1.0~1.5% MLSS concentration at anoxic tank with 50% sludge recycle rate, however, each internal recycle rate were 100%, 200%, 300% and Mode IV was operated 1.5~2.0% MLSS concentration at anoxic tank with 50% sludge recycle rate and 100% internal recycle rate. The COD removal efficiency didn't show any big difference from Mode I to IV. The average COD removal rate was over than 90%. The T-N removal rate was 73%, the highest rate in all mode. The 36% of SCOD is used for the denitrification and phosphorus release in the anoxic tank. Specific denitrification rate was 3.5mg $NO_3{^-}-N/g$ Mv/hr and denitrification time was 0.7hr. As MLSS concentration is higher in anoxic tank as denitrification time would be shorter. The T-P removal rate was average 70%. The phosphorus release accomplished from the anoxic tank because the anaerobic condition was prevalent in the anoxic due to the prompt completion of denitrification. Sludge production was 0.28 kgVSS/kg $BOD_{removed}$ under the 1.5% MLSS and 17 day SRT. It is prominent result which has 40% sludge reduce comparing with traditional activate sludge system.

• Journal of Environmental Science International
• /
• v.2 no.4
• /
• pp.317-324
• /
• 1993

Effluent recycling effect on UASB reactor performances is known as an important operational factor. In the present study, the possibility of intermittent recycle in UASB process for saving the power consumption was examined at different organic loading and various operational modes in recycle time period. The organic removal efficiencies of the reactors operated with the intermittent effluent recycle were considerably higher compared to those without the effluent recycle. In the intermittent recycle mode, the organic removal efficiencies slightly decreased as the non-recycle time period in the operational mode increased. Proper ratio of recycle and non-recycle time period in the mode seemed to be required to prevent the produced biogas from accumulation in the sludge bed, which caused dead zone in the reactor and sludge loss when the gas was escaped from the bed at the certain pressure.

• Journal of the Korean GEO-environmental Society
• /
• v.10 no.7
• /
• pp.125-133
• /
• 2009

Wastewater sludge had normally filled up in land before revising the law of waste material management in 2003, which does not permit landfill of organic sludge in Korea. After the law, most sludge has been littered in the ocean up to now. However, due to the London Convention 96 Protocol, littering sludge in the ocean will also be prohibited after 2011. This Protocol makes countries find out new methods to treat wastewater sludge. There is no exception in Korea too. Many researchers have urgently try to find out better ways to treat sludge. One of ways is to make sludge recycle energy and the success of it depends on drying method. Specifically, it really depends how to make sludge dry ecologic friendly and economic efficiently. Therefore, wastewater sludge produced in Youngdong was analyzed to make it energy resources in this study. The sludge was tested to analyze the drying and chemical characteristics of it by irradiating microwave. In the result, it is sure that the sludge has little heavy metals as like as others in country side. High calories, 3370 Kcal, shows that it has good potential to be recycle energy. Moreover, weight deduction of the sludge vs. time shows long S-curve and has same deduction ratio. Specifically, S-curve can be divided by three sections based on the curvature points. There are steady state reduction ratio of weight and approximately 80% of weight duction in the second section. This results can be used to estimate the amount of sludge reduction in the full-scale microwave dryer. Drying capacity of microwave shows approximately 1.0 kg/kw/hr. It makes sure that sludge recycle energy has the potential of economic efficiency too.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1999.10a
• /
• pp.39-39
• /
• 1999

Membrane separation technology has become a more attractive technology on waste water treatment and water recycle in recent years. On this application, membrane does not take main part of treatment, such as decomposition or handling of organic matter in the waste water, but it is very important supporting method in the total system. Activated sludge is most popular method as main part. In the system , membrane works as a separator to obtain clear water after biological treatment, by which the permeate could be released, recycled or applied to further additional treatment, instead of conventional sedimentation, coagulation and sand filtration. We would like to introduce our system cases for waste water treatment and water recycle, in which membrane separation technology works. In most of cases, membranes are applied to solid- liquid separation of activated sludge. Our experiences will be introduced as following items.

• Journal of Environmental Science International
• /
• v.4 no.5
• /
• pp.509-516
• /
• 1995

The treatment performances of anaerobic-aerobic activated sludge process were investigated under various operation conditions. The treatment system proposed in this study gave a relatively stable performance against hourly change of the flow rate and showed a satisfactory removal of nitrogen and phosphorus compounds under experimental conditions. The recycle ratio of mixed liquor from aerobic to anaerobic region and peak coefficient primarily controlled the extent of nitrogen removal. The recycle ratio had the optimum values which were determined by the microbial activities of nitrification and denitrification. The behavior of the treatment unit could be simulated by using the kinetic equations and reactor models which considered the treatment units as complete mixing tanks.

• Journal of Environmental Science International
• /
• v.4 no.5
• /
• pp.123-123
• /
• 1995

The treatment performances of anaerobic-aerobic activated sludge process were investigated under various operation conditions. The treatment system proposed in this study gave a relatively stable performance against hourly change of the flow rate and showed a satisfactory removal of nitrogen and phosphorus compounds under experimental conditions. The recycle ratio of mixed liquor from aerobic to anaerobic region and peak coefficient primarily controlled the extent of nitrogen removal. The recycle ratio had the optimum values which were determined by the microbial activities of nitrification and denitrification. The behavior of the treatment unit could be simulated by using the kinetic equations and reactor models which considered the treatment units as complete mixing tanks.