• 한국항만학회지
• /
• 제6권2호
• /
• pp.43-64
• /
• 1992

This study discusses the interacting with deep water waves approaching from deep water based on the linear wave theory and steep sloping sea bottom floor by the numerical procedure. The results of particular interest are particle velocity and acceleration in x, y, z direction wave height amplification factor reflection coefficient and dimensionless pressure distribution on the steep sloping bottom with respect to the various incident wave angle. The wave loads relative to various bottom slopes, incident wave angles and wave periods on submerged breakwater and pipe are represented in comparison with mild sloping bottom the wave load parameters on the steep sloping bottom seemed to be influenced by variation of incident wave angle. In general the particle velocities and accelerations in x, y, z directions on the steep sloping bottom represented larger value or about two than those on the mild sloping bottom according to incident wave angle. However, the wave height amplification factors did not show distinct difference, but the slight variation with respect to the various incident angle showed on mild sloping bottom. The reflection coefficient increased with respect to increase of the incident angle on the steep sloping bottom the results also indicate that the very steep sloping beach produces a rather substantial amount of reflection as we expected. No significant variation of wave pressure was shown on the steep sloping bottom but it represented a certain amount of variation on the mild sloping bottom according to the various incident wave angle. The analysis at the OTEC site also showed similar results.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2010년도 춘계학술대회 논문집
• /
• pp.872-879
• /
• 2010

High rock-fill embankment is relatively flexible, which makes crest of embankment subject to excessive amplification in displacement due to earthquake loading. To overcome problems related with site response in high embankment, it is essential to evaluate shear-wave velocity profile of the embankment with improved accuracy and reliability. In this aspect, an experimental research was performed to answer how to perform surface-wave tests and to analyze measurements at an embankment site with a sloping ground surface. Unlike flat ground surface, sloping ground may hamper and slow down propagation of surface waves due to multiple reflections and refractions in embankment. To figure out this reasoning for the effect of multiple reflections and refractions due to sloping surface, surface wave tests were performed at a reservoir embankment of Chung-Song in North KyeongSang Province. Parameters involved in surface wave tests at non-flat surface, including source directionality, geometry-related constraint and frequency components in source function, were investigated using field measurements.

• 한국농촌건축학회논문집
• /
• 제14권1호
• /
• pp.57-66
• /
• 2012

This study focuses on the applicability of hill housing design in accordance with topographic characteristics on sloping sites. The urgency for housing still exists but hill sites have to be planned by gradual development using 'all available land' within any particular community. However, there is a reaction towards being more closely involved with nature and landscape. Sloping and hill sites must be developed by intelligent and sensitive planning, integrating the existing environmental factors. The results of this study are as follows : 1. The conditions of location are regarded as the concepts of spactial configuration. It should be developed on the basis of awareness that nature and human beings exist together. 2. It is inevitable that the development of the hill housing should be performed prefer to the topographic characteristics. 3. Planning elements of ecological residental blocks which are possible for constructing on the hill site can be developed and applied, on the basis of geographical characteristics, by housing types.

• Coupled systems mechanics
• /
• 제1권1호
• /
• pp.59-78
• /
• 2012

The available analytical methods of analysis for laterally loaded piles in level ground cannot be directly applied to such piles in sloping ground. With the commercially available software, the simulation of the appropriate field condition is a challenging task, and the results are subjective. Therefore, it becomes essential to understand the process of development of a user-framed numerical formulation, which may be used easily as per the specific site conditions without depending on other indirect methods of analysis as well as on the software. In the present study, a detailed three-dimensional finite element formulation is presented for the analysis of laterally loaded piles in sloping ground developing the 18 node triangular prism elements. An application of the numerical formulation has been illustrated for the pile located at the crest of the slope and for the pile located at some edge distance from the crest. The specific examples show that at any given depth, the displacement and bending moment increase with an increase in slope of the ground, whereas they decrease with increasing edge distance.

• 한국농공학회:학술대회논문집
• /
• 한국농공학회 2003년도 학술발표논문집
• /
• pp.571-574
• /
• 2003

Three sediment traps were placed at the toe of sloping fields in the alpine belt of Korea and sediment removal efficiency was estimated. Soil texture of the site was sandy soil and 5 runoff and sediment events were observed during 2002. Sediment was largely affected by both the amount and intensity of rainfall. Especially, rainfall intensity seemed to have profound effect on sediment yield from sloping sandy fields. Sediment removal of the sediments ranged widely from 266 kg/ha to 16,974 kg/ha depending on tillage method, slope and slope length, and amount and intensity of rainfall. Sediment removal efficiency was estimated to be more than 98.8%. It was suggested that rational combination of sediment trap and drainage channel might well contribute to control sediment discharge from alpine sloping fields.

• 농업과학연구
• /
• 제37권3호
• /
• pp.435-449
• /
• 2010

Soils in the sloping uplands in Korea are subject to intensive land use with high input of agrochemicals and are vulnerable to soil erosion. Development of the environmentally sound land management strategy is essential for a sustainable production system in the sloping upland. This report addresses the status of upland agriculture and the best management practices for the uplands toward the sustainable agriculture. More than 60% of Korean lands are forest and only 21% are cultivating paddy and upland. Uplands are about 7% of the total lands and about 62% of the uplands are in the slopes higher than 7%. Due to the site-specificity of the upland, many managerial and environmental problems are occurring, such as severe erosion, shallow surface soils with rocky fragments, and loadings of non-point source (NPS) contaminants into the watershed. Based on the field trials, most of the sloping uplands were classified as Suitability Class III-V and the major limiting factor was slope and rock fragments. Due to this, soils were over-applied with N fertilizer, even though N rate was the recommendation. This resulted in decreases in yield, degradation of soil quality and increases in N loading to the leachate. Various case studies drew management practices toward sustainable production systems. The suggested BMP on the managerial, vegetative, and structural options were to practice buffer strips along the edges of fields and streams, winter cover crop, contour and mulching farming, detention weir, diversion drains, grassed waterway, and slope arrangement. With these options, conservation effects such as reductions in raindrop impact, flow velocity, runoff and sediment loss, and rill and gully erosion were observed. The proper management practice is a key element of the conservation of the soil and water in the sloping upland.

• 대기
• /
• 제25권4호
• /
• pp.591-600
• /
• 2015

We have analyzed wind and eddy covariance data collected within roughness sublayer over sloping terrain. The study site is located on non-flat terrain with slopes in both south-north and east-west directions. The surface elevation change is smaller than the height of roughness element such as building and tree. This study examines the directional wind shear for data collected at three levels in the lowest 10 m in the roughness sublayer. The wind direction shear is caused by drag of roughness element and terrain-induced motions at this site. Small directional shear occurs when wind speed at 10 m is strong and wind direction at 10 m is southerly which is the same direction as upslope flow near surface at this site during daytime. Correlation between vertical shear of lateral momentum and lateral momentum flux is smaller over steeply sloped surface compared to mildly sloped surface and lateral momentum flux is not down-gradient over steeply sloped surface. Quadrant analysis shows that the relative contribution of four quadrants to momentum flux depends on both surface slope and wind direction shear.

• 한국환경복원기술학회지
• /
• 제1권1호
• /
• pp.95-101
• /
• 1998

In order to seek a efficiency of site cooperation and slope stabilization in a rock sloping work, it would rather take into consideration, in its importance, a concurrent performance of civil works and landscaping works than give any part a special priority. It can enable us to achieve an expanded scope of landscaping works and improvement of slope scenery via this sort of cooperation. However, this can not be achieved without assurance on the slope stabilization and scenic view of the project owner, and further via this cooperation, environmentally familiar works can be performed, becoming natural environment and minimizing damages on surrounding scenery and environment. It is foreseeable that improvement of functions of civil equipment, introduction of technology and development of landscaping materials can facilitate an improvement in the betterment of slope scenery. Landscaping related parties need to enhance their understanding of rock sloping and scenic view based on knowledge on the fundermental understanding of slope stabilization and on the base rock characteristics.

• Ecology and Resilient Infrastructure
• /
• 제4권3호
• /
• pp.180-185
• /
• 2017

광산 활동에 의해 오염된 농경지의 복원은 개량제 처리와 복토를 기반의 미량원소 안정화 기법으로 진행되고 있다. 최근 복원된 부지 중 경사 농경지에서 토양 유실 문제가 대두되고 있다. 본 연구에서는 4종의 개량제 (벤토나이트, 석회, 유기물, 제강슬래그)를 다양한 비율로 단일 또는 복합처리 한 후 입단 형성의 효율을 평가했다. 복토재는 점토함량이 다른 3가지 토양 (A 토양=9.4%, B토양=14.7%, C 토양=21.2%)을 대상으로 했다. 단일처리 결과, A 토양은 유기물 5%, B와 C 토양은 석회 5%가 각 토양의 대조구에 비해 입단 형성이 가장 효과적이었다. 9가지 복합처리구 중에서 A 토양은 유기물 3% + 석회 1%, B와 C 토양은 유기물 1% + 석회 3% 처리구의 입단 형성이 가장 높았다 (A 토양=30.4%, B 토양=25.0%, C 토양=36.5%). 현장처리를 위해 각 복토재 (A 토양=0.045, B 토양=0.051, C 토양=0.054)와 국내 농경지의 평균 (0.032) 토양침식인자 차이만큼을 개량제에 의한 목표 입단 형성량으로 설정하였다(29.1% 입단형성). 비용편익을 고려한 최적 개량제 선정한 결과 A와 B 토양은 석회 3%, C 토양은 석회 5%가 가장 적합 했으며, 이를 통한 경사진 복원된 경사 농경지에서 토양 유실을 효과적이고 경제적으로 저감할 것으로 예측된다. 본 연구에서 석회 처리에 의한 토양 알칼리도 상승은 고려하지 않았다.

• Journal of Biosystems Engineering
• /
• 제5권1호
• /
• pp.33-42
• /
• 1980

This study was carried out to investigate the actual environmental paddy storage conditions in conventional Korean farm warehouses. The paddy storage conditions by the locations and sizes of warehouses were figured out. The effectiveness of the small insulated box for storing paddy was also examined. Observations were made at sixteen different warehouses located in Moonsan-Myeon, Jinyandg-gun, Gyungnam Province from July lst to September 28 th, the period which was considered to be the worst for storing grains. The results are as follows ; 1. the average temperatures of rough rice and air inside the warehouse were 0.9 and 0.7$^\circ$ higher than the outside air temperature. 2. The average relative humidity in warehouses was 1.5percent higher than that of the atomosphere. This fact resulted in the increased moisture content of grains. Therefore, the ventilation for equalizing the relative humidity of inside and outside of warehouses was required. 3. The dry matter of stored rough rice was decreased by 1.1 percent in average druing the observation period. In order to reduce the dry matter loss, application of new grain storing method ;hermetic storage or filling inert gas storage, was highly recommended. 4. Environmental conditions for storing rough rice in a warehouse located in a sloping site are, in general , better than those of a warehouse located in a flat site. But as far as the dry matter of rough rice was concerned, above situation is not always satisfactory. Because it is fairly frequent to observe the higher rate of moisture absorption by grains stored in a warehouse located in a sloping site. 5. Environmental conditions for storing rough rice in a large-scale warehouse were better than those in a small size warehouse. Therefore, it is advisible for farmers to store their grins in the large-scale warehouses commonly used by villagers. 6. It was undesirable to store rough in a insulated box.