• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.63 no.3
• /
• pp.125-130
• /
• 2014

This paper is research result for a development of solar cell silicon ingot glowing(SCSIG) PWM converter system for 120[kW] 3[kA]. The system include 3-phase AC-DC rectifier diode converter of input voltage AC 460[V] and 60[Hz], DC-AC single phase full bridge PWM inverter of high frequency, AC-DC single-phase full wave rectifier using center-tapped of transformer for low voltage 50[V] and large current 3,000[A], carbon resistor load 0.2 [$m{\Omega}$]. PWM switching frequency for IGBT inverter control set 15KHz. The suggested researching contents are designed data sheets of power converter system, PSIM simulation, operating characteristics and analysis results of developed SCSIG system.

• Journal of Power Electronics
• /
• v.14 no.6
• /
• pp.1281-1292
• /
• 2014

Photovoltaic (PV) solar systems with series-connected module integrated converters (MICs) are receiving increased attention because of their ability to create high output voltage while performing local maximum power point tracking (MPPT) control for individual solar panels, which is a solution for partial shading effects in PV systems at panel level. To eliminate the partial shading effects in PV system more effectively, sub-MICs are utilized at the cell level or grouped cell level within a PV solar panel. This study presents the results of a series-output-connection MPPT (SOC-MPPT) controller for sub-MIC architecture using a single sensor at the output and a single digital MPPT controller (sub-MIC SOC-MPPT controller and architecture). The sub-MIC SOC-MPPT controller and architecture are investigated based on boost type sub-MICs. Experimental results under steady-state and transient conditions are presented to verify the performance of the controller and the effectiveness of the architecture.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08b
• /
• pp.1330-1332
• /
• 2007

We have newly developed transflective LCDs with a specific sub-pixel and the single cell gap structure. In our structure, the overall transmittance and reflectance has become higher than typical transflective LCDs. Furthermore, it can simplify the fabrication process of the transflective LCDs.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.743-746
• /
• 2006

We have demonstrated a transflective liquid crystal display (LCD) with a single cell gap in a patterned vertically aligned mode. In our configuration, the different electrode structure in a transmissive and a reflective part was suggested to compensate an optical path difference of each region. As the result, the similar electro-optic characteristic of each region was obtained which results in an enhanced performance of the device. Moreover, suggested technique can be highly effective to realize the practical transflective LCD due to the simple fabrication process.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.04b
• /
• pp.27-28
• /
• 2009

This paper suggests a autonomous linear Li-ion battery charger which can safely distribute power between an external power source(AC adapter, auto adapter, or USB source), battery, and the system load. Depending on an external power source's capability, the charger selects proper charging-mode automatically. The charger IC designed and fabricated on Dongbu HITEC's $0.35{\mu}m$ BCD process with layers of one poly and three metals.

• Asian Pacific Journal of Cancer Prevention
• /
• v.17 no.7
• /
• pp.3065-3069
• /
• 2016

Single nucleotide polymorphism (SNP) detection has been used extensively for genetic association studies of diseases including cancer. For mass, yet accurate and more economic SNP detection we have optimized tetra primer amplification refractory mutation system polymerase chain reaction (ARMS PCR) to detect three SNPs in the cytochrome P450 2E1 (CYP2E1) gene locus; i.e. rs3813865, rs2070672 and rs3813867. The optimization system strategies used were (1) designing inner and outer primers; (2) determining of their optimum primer concentration ratios; and (3) determining of the optimum PCR annealing temperature. The tetra primer ARMS PCR result could be directly observed using agarose gel electrophoresis. The method succesfully determined three SNPs in CYP2E1 locus, the results being consistent with validation using DNA sequencing and restriction fragment length polymorphisms (RFLP).

• Proceedings of the KIPE Conference
• /
• 2010.07a
• /
• pp.152-153
• /
• 2010

This paper presents the design of a low-input-voltage step-up converter. Such circuits can be useful for single fuel cell to generate less than 0.7V. Important issues to design it are physical volume, efficiency and start-up method. In this paper, we propose a step-up converter with a simple start-up circuit. The operation of proposed circuit is presented and the experimental results are provided to verify the feasibility of the proposed technique.

• Proceedings of the Korean Society of Toxicology Conference
• /
• 2001.10a
• /
• pp.107-107
• /
• 2001

In the present study, the protective effect of Scutellaria baicalensis against DNA damage in HL-60 cells exposed to $^{60}$ Co ${\gamma}$-rays was evaluated using micronuclei formation and alkaline single cell gel electrophoresis (SCGE, comet assay). The frequency of micronuclei was decreased in groups treated with water extract (P＜0.01), polysaccaride fraction (P＜0.01) and methanol fraction (P＜0.01) before/after exposure to 200 cGy of ${\gamma}$-rays.(omitted)

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.08a
• /
• pp.72-75
• /
• 2003

Effects of delay and panel temperature on the discharge time lag and the controllability of weak discharge mode were studied under single cell driving circumstances of ac PDP. It was found that sufficient number of priming particle is necessary for inducing weak discharge in ramp voltage driving. Discharge time lag was reduced dramatically under elevated panel temperature condition It is speculated that decrement of discharge time lag at the high temperature is related to the reduction of diffusion loss of charged particles during the after glow.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2017.07a
• /
• pp.388-389
• /
• 2017

본 논문에서는 효율적인 에너지 관리를 위해 리튬이온 배터리를 적용 능동 셀 밸런싱 시스템 BMS에 대해 제안하였다. 제안된 방법은 다수의 셀과 하나의 커패시터로 구성된 SSC(Single Switched Capacitor) 방식에서 사용되는 커패시터를 리튬이온 배터리로 변경하여 적용한 것이다. SSC 방식은 커패시터의 방향성으로 인하여 홀수 번째와 짝수 번째의 배터리에 대해 별도의 스위치를 설치하여야 하며 조작이 복잡하다는 단점을 가지고 있었다. 이러한 단점을 보완하여 커패시터를 리튬이온 배터리로 대체하여 셀의 순서에 상관없이 적용이 가능한 셀 밸런싱 방법을 제안하였다. 제안된 방법의 효율성은 BMS를 구현하여 실험 하였다. 실험 결과 셀 밸런싱이 기존의 SSC 방식보다 개선되어 효율성이 입증되었다.