• 한국신재생에너지학회:학술대회논문집
• /
• 2009.06a
• /
• pp.357-360
• /
• 2009

The present study focused on the segmented cell which has the similar performance to unaltered (not segmented) cell in real operating condition. Many literatures have been made the segmented cell to observe the behavior of local current density distribution in the single cell. However, it has been lack of scheme to segment the cell in that the detailed interpretation of segmenting in analytic point of view was insufficient. Hence, the basic idea of segmenting was introduced to determine the component to be segmented in anode side of unit cell. The electrical contact/bulk resistance was measured by using four wire/probe method through each part of cell components including MEA, GDL, Bipolar Plate and Current Collector. Electron transport mechanism was predicted by comparing resistance values which were obtained from the experiment. As a result, this offered a great benefit to segment the cell efficiently. With this method further experiments would be conducted in research areas which require current density distribution at the same operating condition as unaltered cell.

• Korean Journal of Materials Research
• /
• v.14 no.5
• /
• pp.368-373
• /
• 2004

To improve the conventional cathode-supported tubular solid oxide fuel cell (SOFC) from the viewpoint of low cell power density, expensive fabrication process and high operation temperature, the anode-supported tubular solid oxide fuel cell was investigated. The anode tube of Ni-8mol% $Y_2$O$_3$-stabilized $ZrO_2$ (8YSZ) was manufactured by extrusion process, and, the electrolyte of 8YSZ and the multi-layered cathode of $LaSrMnO_3$(LSM)ILSM-YSZ composite/$LaSrCoFeO_3$ were coated on the surface of the anode tube by slurry dip coating process, subsequently. Their cell performances were examined under gases of humidified hydrogen with 3% water and air. In the thermal cycle condition of heating and cooling rates with $3.33^{\circ}C$/min, the anode-supported tubular cell showed an excellent resistance as compared with the electrolyte-supported planar cell. The optimum hydrogen flow rate was evaluated and the air preheating increased the cell performance due to the increased gas temperature inside the cell. In long-term stability test, the single cell indicated a stable performance of 300 mA/$\textrm{cm}^2$ at 0.85 V for 255 hr.

• Korean Journal of Animal Reproduction
• /
• v.18 no.4
• /
• pp.299-307
• /
• 1995

The goal of cell stem cell technology is to produce a viable and genetically normal animal. To achieve this goal various laboratories have followed 2 different pathways beginning with either the culture of 1) single or pooled ICMs grown with or without a feeder layer or 2) single or pooled 16-20 cell stage embryos grown with a feeder layer. Also, thus far embryonic cell cultures or lines have been established by several methods including loose suspension culture for short-term cultures and more commonly murine or bovine fibroblast feeder layers for long-term culture. Pluripotent lines have been derived from 16-cell through blastocyst inner cell mass stages. The efficiency of establishing cell lines and cell proliferation apper to be affected by the number of cells or embryos starting the line. Most attempts to produce offspring from long term STO cell feeder layer cultured ICM or morulae derived ES cells have resulted in pregnancy failure in the first trimester when ES cells were used in cuclear transfer or have failed to retain ES cells in the progeny produced by chimerization. The exception is 1 chimeric fetus from use of morula ES cells in the chimerization with early embryonic cells. There is much to be learned yet about ES cell culture requirements for maintenance of totipotency. If bovine ES cell lines loose imprinting pattern and totipotency with long-term culture and passage as suggested for mouse ES cells, we may be limited to the use of short-term cultures for multiplication of embryos and efficient production of transgenic animals. No bovine ES cell system has yet met all of the criteria indicated for a totipotent ES cell line.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.29 no.12 s.243
• /
• pp.1615-1620
• /
• 2005

We present a novel flow-rate independent cell counter using a fixed control volume between double electrical sensing zones. The previous device based on the single electrical cell sensing in a given flow-rate requires an accurate fluid volume measurement or precision flow rate control. The present cell counter, however, offers the flow-rate independent method for the cell concentration measurement with counting cells in a fixed control volume of $22.9{\pm}0.98{\mu}{\ell}$. In the experimental study, using the RBC (Red Blood Cell), we have compared the measured RBC concentrations from the fabricated devices with those from Hemacytometer. The previous and present devices show the maximum errors of $20.3\%\;and\;16.1\%$, which are in the measurement error range of Hemacytometer (about $20\%$). The present device also shows the flow-rate independent performance at the constant flow-rates ($5{\mu}{\ell}/min$ and $10{\mu}{\ell}/min$) and the varying flow-rate (4, 2, and $4{\mu}{\ell}/min$). Therefore, we demonstrate that the present cell counter is a simple and automated method for the cell concentration measurement without requiring an accurate fluid measurement and precision flow-rate control.

• Journal of Electrical Engineering and Technology
• /
• v.11 no.2
• /
• pp.367-376
• /
• 2016

This paper presents a cell balancing method for a single switch flyback converter with a multi-winding transformer. The conventional method using a flyback converter with a multi-winding transformer is simple and easy to control, but the voltage of each secondary winding coil might be non-uniform because of the unequal effective turn-ratio. In particular, it is difficult to control the non-uniform effect using turn-ratios because secondary coil has a limited number of turns. The non-uniform secondary voltages disturb the cell balancing procedure and induce an unbalance in cell voltages. Individual cell control by adding a switch for each cell can reduce the undesirable effect. However, the circuit becomes bulky, resulting in additional loss. The proposed method here uses the conventional flyback converter with an adjustment made to the output filters of the cells, instead of the additional switch. The magnitude of voltage applied to a particular cell can be reduced or increased according to the adjusted filter and the selected switching frequency. An analysis of the conventional converter configuration and the filter design method reveals the possibility of adequate cell balancing control without any additional switch on the secondary side.

• Journal of the Korean Electrochemical Society
• /
• v.4 no.2
• /
• pp.65-69
• /
• 2001

The potential change, and the crossover of alcohol in a liquid-feed solid polymer electrolyte fuel cell operating at atmosphere and room temperature was investigated. Alcohol crossover was generated from all the alcohol by using the fuel. The single-cell property of direct methanol fuel cell was higher than that of other alcohol species as $31mW/cm^2$ at 0.23 V at 4.5M of methanol.

• Journal of Chest Surgery
• /
• v.47 no.2
• /
• pp.185-188
• /
• 2014

Lobectomy with mediastinal node dissection has been standard treatment for non-small cell lung cancer (NSCLC). Nowadays, video-assisted thoracoscopic surgery (VATS) is gaining acceptance as an alternative treatment option, given the quality-of-life benefits that it confers. For the VATS procedure, most surgeons create two or three ports with a utility incision of 3 to 5 cm. However, with acquired skill and instrumentation advances, single-incision thoracoscopic surgery has emerged over time. Here, we report the case of an 86-year-old female with NSCLC treated by single-incision segmentectomy.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.11
• /
• pp.2298-2304
• /
• 2015

In this paper, we provide a new approach which optimizes the vertical tilting angle of the base station for multi-cell multiple-input single-output (MISO) downlink active antenna systems (AAS). Instead of the conventional optimal algorithm which requires an exhaustive search, we propose simple and near optimal algorithms. First, we represent a large system approximation based vertical beamforming algorithm which is applied to the average sum rate by using the random matrix theory. Next, we suggest a signal-to-leakage-and-noise ratio (SLNR) based vertical beamforming algorithm which simplifies the optimization problem considerably. In the simulation results, we demonstrate that the performance of the proposed algorithms is near close to the exhaustive search algorithm with substantially reduced complexity.

• Genomics & Informatics
• /
• v.8 no.4
• /
• pp.201-205
• /
• 2010

The H1 histone family, member N, testis-specific (H1FNT) is exclusively expressed in the testis, and had its possible role for sperm chromatin formation. The purpose of this study is to investigate any genetic association of H1FNT gene with male infertility, especially at the promoter region. We examined the promoter single nucleotide polymorphisms (SNP) of H1FNT gene which is located within transcription factor binding site for its association with male infertility. The statistical analysis showed that the -1129A>T polymorphism was present at a statistically significance in male infertility (p=0.0059 and 0.0349 for hetero and risk type, respectively). The dual-luciferase promoter assay was performed to examine the polymorphic effect of this promoter SNP by the cloning of promoter region (1700bp fragment) into pGL3-basic vector. In our plasmid based reporter system, there is no big difference between wild and risk type. In conclusion, H1FNT -1129A>T promoter SNP is statistically significant with male infertility, especially with subfertile (non-azoospermia) group. Further analysis of its functional polymorphic effect in vivo may provide the biological significance of testis-specific histone with spermatogenesis.

• Applied Microscopy
• /
• v.8 no.1
• /
• pp.1-8
• /
• 1978

The aim of this research was to discover the action mechanism of various antituberculosis agents (isoniazid, paraaminosalicylic acid and streptomycin) which act on Mycobacteria tuberculosis hominis $H_{37}R_v$ and also to study the relationship of ultrastructural changes and the growth pattern in Mycobacterium tuberculosis hominis. The ultrastructural change was observed with an electron microscope while the growth pattern was studied through in vitro culture. The results are summarized as follows: 1. The ultrastructural changes found in the group treated only with isoniazid were the loss of nuclear materials and the appearence of electron dense granules. 2. In the group treated with paraaminosalicylic acid, thickening of nuclear filaments and meso some arrangement disorders were observed. 3. In the group treated with streptomycin, the ribosome particles appeared indistinct and the cytoplasm was denaturalized. 4. In the group cross treated with all three agents, all the ultrastructural changes mentioned above could be observed in the cell just as they appeared in the single treated groups. 5. In all of the single and in the crossly treated group, there were no significant changes note in the cell wall or cytoplasmic membranes of any of the cells observed. 6. In the cultural data in vitro, through the crossly treated group and single treated group. growth was observed in 3-5 weeks of culture.