• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.9
• /
• pp.1704-1709
• /
• 2016

In this paper, we propose efficient uplink data transmission method in ultra dense wireless networks as in intra-aircraft, where large-scale APs and wireless sensors are deployed. In the ultra dense wireless networks, a performance degradation is inevitable due to the inter-AP interference. However, the performance degradation can be avoided if a scheduling algorithm can estimate the amount of interference caused by each wireless sensor and reflects it. SGIR (Signal-to-Generating Interference Ratio) based scheduling algorithms is a typical example. Unfortunately, the scheduling algorithms based on the interference caused by wireless sensors necessarily yield large scale exchange of information through backhaul which connects APs. Therefore, we, in this paper, propose a novel scheme which can dramatically reduce the amount of information which are exchanged through backhaul connection. Monte-Carlo simulation results show that the proposed scheme can reduce the amount of backhaul traffic by 27% without loss of data transmission rate.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.30 no.4
• /
• pp.37-46
• /
• 2002

The main purpose of this research is to discuss the urban heat island which will be caused by urbanization, especially by the construction of new town on a wide green zone. Over the last ten years, five new towns have been developed around the Seoul metropolitan area. However these new towns become bedroom communities and create traffic problems between Seoul and its surrounding areas because of an increase in population and a lack of roads and other infrastructures. The construction of another such new town is under consideration in the Pan-gyo area. But it is important that Pan-gyo remains a wide green zone. Many studies show that green space can play an important role in improving urban eco-meteorological, ameliorative capability and air hygiene. The objective of this study is to analyze the urban heat islands of Bund-Dang Si which was constructed in 1996 and of the Pan-Gyo area planned as new town. To investigate the local thermal environment and its negative effects caused by change of the land use type and urbanization we used LANDSAT TM images for extraction of urban surface temperature according to change of land use over 15 years. These data were analyzed together with digital land use and topographic data. As a study result, we found that the thermal island of this area from 1985 to 1999 rapidly increased with a difference of mean temperature of more than 12'E. Before construction of Bun-Dang Si the temperature of this area was the same as the forest, but during the new town construction in 1991, an urban heat island developed. The temperature of forest with a size of over 50% of the investigation area was lowest, which leads us to conclude that the forest cools the urban and its surroundings. The mean temperature of the residential and commercial area is more than +4.5$^{\circ}C$ higher then forest, so this method of land use is the main factor increasing the urban heat island. Urban heat islands and green space play an important role in urban wind systems, i.e. Thermal Induced Air Exchange and Structural Wind Circulation, because of their special properties with regard to energy balance between constructed urban and land. The skill to allocate land use types in urban areas is a very important planning device to reduce air pollution and induce the fresh cold air from green space. An urban climatic experiment featuring a numerical wind simulation study to show the air corridor will be published in a following research paper.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.2
• /
• pp.23-30
• /
• 2017

In the AEC(Architecture, Engineering and Construction) industry, BIM(Building Information Modeling) technology not only helps design intent efficiently, but also realizes an object-oriented design including building's life cycle information. Thus it can manage all data created in each building stage and the roles of BIM are greatly expanded. Contractors and designers have been trying to adopt BIM to design competitions and validate it for the best result in various aspects. Via the computational simulation which differs from the existing process, effective evaluation can be done. For this process, a modeling guideline for each kind of BIM tool and a validation system for the confidential assessment are required. This paper explains a new process about design evaluation methods and process using BIM technologies which follow the new paradigm in construction industry through complement points by an example of a competition activity of the Korea Power Exchange(KPX) headquarter office. In conclusion, this paper provides a basic data input guideline based on open BIM for automatic assessment and interoperability between different BIM systems and suggests a practical usage of the rule-based Model Checker.

• Journal of Intelligence and Information Systems
• /
• v.17 no.3
• /
• pp.187-201
• /
• 2011

KOSPI200 index is the Korean stock price index consisting of actively traded 200 stocks in the Korean stock market. Its base value of 100 was set on January 3, 1990. The Korea Exchange (KRX) developed derivatives markets on the KOSPI200 index. KOSPI200 index futures market, introduced in 1996, has become one of the most actively traded indexes markets in the world. Traders can make profit by entering a long position on the KOSPI200 index futures contract if the KOSPI200 index will rise in the future. Likewise, they can make profit by entering a short position if the KOSPI200 index will decline in the future. Basically, KOSPI200 index futures trading is a short-term zero-sum game and therefore most futures traders are using technical indicators. Advanced traders make stable profits by using system trading technique, also known as algorithm trading. Algorithm trading uses computer programs for receiving real-time stock market data, analyzing stock price movements with various technical indicators and automatically entering trading orders such as timing, price or quantity of the order without any human intervention. Recent studies have shown the usefulness of artificial intelligent systems in forecasting stock prices or investment risk. KOSPI200 index data is numerical time-series data which is a sequence of data points measured at successive uniform time intervals such as minute, day, week or month. KOSPI200 index futures traders use technical analysis to find out some patterns on the time-series chart. Although there are many technical indicators, their results indicate the market states among bull, bear and flat. Most strategies based on technical analysis are divided into trend following strategy and non-trend following strategy. Both strategies decide the market states based on the patterns of the KOSPI200 index time-series data. This goes well with Markov model (MM). Everybody knows that the next price is upper or lower than the last price or similar to the last price, and knows that the next price is influenced by the last price. However, nobody knows the exact status of the next price whether it goes up or down or flat. So, hidden Markov model (HMM) is better fitted than MM. HMM is divided into discrete HMM (DHMM) and continuous HMM (CHMM). The only difference between DHMM and CHMM is in their representation of state probabilities. DHMM uses discrete probability density function and CHMM uses continuous probability density function such as Gaussian Mixture Model. KOSPI200 index values are real number and these follow a continuous probability density function, so CHMM is proper than DHMM for the KOSPI200 index. In this paper, we present an artificial intelligent trading system based on CHMM for the KOSPI200 index futures system traders. Traders have experienced on technical trading for the KOSPI200 index futures market ever since the introduction of the KOSPI200 index futures market. They have applied many strategies to make profit in trading the KOSPI200 index futures. Some strategies are based on technical indicators such as moving averages or stochastics, and others are based on candlestick patterns such as three outside up, three outside down, harami or doji star. We show a trading system of moving average cross strategy based on CHMM, and we compare it to a traditional algorithmic trading system. We set the parameter values of moving averages at common values used by market practitioners. Empirical results are presented to compare the simulation performance with the traditional algorithmic trading system using long-term daily KOSPI200 index data of more than 20 years. Our suggested trading system shows higher trading performance than naive system trading.

• Journal of KIISE:Information Networking
• /
• v.34 no.1
• /
• pp.62-72
• /
• 2007

Mobile Virtual Private Network (MVPN) provides VPN services without geographical restriction to mobile workers using mobile devices. Coexistence of Mobile IP (MIP) protocol for mobility and IPsec-based VPN technology are necessary in order to provide continuous VPN service to mobile users. However, Problems like registration failure or frequent IPsec tunnel re-negotiation occur when IPsec-based VPN Gateway (GW) and MIP are used together. In order to solve these problems, IETF proposes a mechanism which uses external home agent (x-HA) located external to the corporate VPN GW. In addition, based on the IETF proposal, a mechanism that assigns x-HA dynamically in the networks where MN is currently located was also proposed with the purpose to reduce handover latency as well as end-to-end delay. However, this mechanism has problems such as exposure of a session key for dynamic Mobility Security Association (MSA) or a long latency in case of the handover between different networks. In this paper, we propose a new MVPN protocol in order to minimize handover latency, enhance the security in key exchange, and to reduce data losses cause by handover. Through a course of simulation, the performance of proposed protocol is compared with the existing mechanism.

• Journal of Broadcast Engineering
• /
• v.14 no.2
• /
• pp.134-143
• /
• 2009

In this paper, we propose a new relay selection algorithm for a two-way multiple relay channel. In the two-way multiple relay channel, two users exchange information with each other via multiple relays. The relays use a decode-and-forward or amplify-and-forward protocol, and exploit the combining process of the received packets to reduce the required channel resources. In the multiple relay network, diversity gain is achieved as the number of relays increases, and various schemes are proposed. In this paper, we propose a single best relay selection scheme based on instantaneous channel conditions. First of all, relays obtain the instantaneous channel state information in the handshaking process, and a single best relay is selected in a distributed methods prior to data transmissions. The relay selection metric is proposed so that the end-to-end channel condition is evaluated based on the intantaneous channel state informations. Simulation results show that the proposed relay selection algorithm achieve the increased throughput and diversity order when the number of potential relays is increased.

• Journal of KIISE:Information Networking
• /
• v.31 no.5
• /
• pp.532-543
• /
• 2004

Mobile Ad hoc NETworks (MANET) consist of mobile nodes which are usually powered by battery Approaches for minimizing power consumption have been proposed for all network layers and devices. IEEE 802.11 DCF (Distributed Coordination Function), a well-known medium access control protocol for MANETS, also defines a power save mode operation. The nodes in power save mode periodically repeat the awake state and the doze state in synchronized fashion. When all nodes are in the awake state, the exchange the announcements for the subsequent message transmission with neighbors. The nodes that send or receive the announcements stay awake for data transmission, and others go into the dole state. The previous works for enhancing the power save mode operation have focused on shortening the duration of the awake state. We observed that the longer sleeping period results in seriously long delivery latency and the consequent unnecessary power consumption as well, because the packets can move forward only one hop for a fixed interval. In this paper, we propose an improved protocol for the power save mode of IEEE 802.11 DCF, which allows the flooding packets to be forwarded several hops in a transmission period. Our approach does not reduce the duration of compulsory awake period, but maximizes its utilization. Each node propagates the announcements for next flooding to nodes of several hops away, thus the packets can travel multiple hops during one interval. Simulation results of comparison between our scheme and the standard show a reduction in flooding delay maximum 80%, and the unicasting latency with accompanying flooding flows near 50%, with slight increase of energy consumption.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.35 no.2
• /
• pp.501-514
• /
• 2015

Earthwork is a basic operation for all forms of civil works and affects construction time, cost and productivity. It is a mechanized operation that needs various construction equipment as a group and uses a lot of fuel for construction equipment. But, the problem is that earthwork operation is usually performed by equipment operator's heuristic and intuition, which can cause low productivity, high fuel consumption, and high carbon dioxide emission. As one of solutions for this problem, the fleet management system for construction equipment is suggested for effective earthwork planning, optimal equipment allocation, efficient machine operation, fast information exchange, and so forth. The purpose of this research is to suggest core methods for developing the equipment fleet management system. The methods include 3D solid parametric model generation, soil distribution using Cctree data structure, equipment fleet construction and equipment fleet operation. A simulation test is performed to verify the effectiveness of the equipment fleet management system in terms of equipment operating ratio, fuel usage, and $CO_2$ emission.

• Applied Chemistry for Engineering
• /
• v.31 no.5
• /
• pp.575-580
• /
• 2020

In this study, we simulated an amine regeneration process with heat-stable salts removal unit. We derived the optimal operating conditions considering the flow rate of waste, the removal rate of heat-stable salts, and the loss rate of MDEA (methyl diethanolamine). In the amine regeneration process that absorbs and removes acid gas, heat-stable salt impairs the absorption efficiency of process equipment and amine solution. An ion exchange resin method is to remove heat-stable salts through neutralization by using a strong base solution such as NaOH. The acid gas removal process was established using the Radfrac model, and the equilibrium constant of the reaction was calculated using Gibbs free energy. The removed amine solution is separated and flows to the heat-stable salts remover which is modeled by using the Rstoic model with neutralization reaction. Actual operation data and simulation results were compared and verified, and also a case study was conducted by adjusting the inflow mass of removal unit followed by suggesting optimal conditions.

• The KIPS Transactions:PartC
• /
• v.15C no.4
• /
• pp.273-280
• /
• 2008

In WSN(Wireless Sensor Network) many routing algorithms such as LEACH, PEGASIS and PEDEP consisting of sensor nodes with limited energy have been proposed to extend WSN lifetime. Under the assumption of perfect fusion, these algorithms used convergecast that periodically collects sensed data from all sensor nodes to a base station. But because these schemes studied less energy consumption for a convergecast as well as fairly energy consumption altogether, the minimum energy consumption for a convergecast was not focused enough nor how topology influences to energy consumption. This paper deals with routing topology and energy consumption for a single convergecast in the following ways. We chose major WSN topology as MSC(Minimum Spanning Chain)s, MSTs, PEGASIS chains and proposed LECSEN chains. We solved the MSC length by Linear Programming(LP) and propose the LECSEN chain to compete with MST and MSC. As a result of simulation by Monte Carlo method for calculation of the topology length and standard deviation of link length, we learned that LECSEN is competitive with MST in terms of total energy consumption and shows the best with the view of even energy consumption at the sensor nodes. Thus, we concluded LECSEN is a very useful routing topology in WSN.