• Korean Chemical Engineering Research
• /
• 제48권4호
• /
• pp.462-469
• /
• 2010

기체와 액체가 만나는 2상 공정들은 화학공학, 생명화학공학, 환경공학, 식품공학 등에 두루 존재한다. 위와 같은 공정의 최적화를 위해서는 거품의 움직임과 형태에 대한 정확한 파악이 필요하다. 액체 내부에서 거품의 움직임은 액체의 밀도, 점도, 표면장력과 거품의 크기와 속도에 영향을 받는다. 본 논문에서는 고점도 실리콘 오일 내부에서의 거품의 움직임과 형태를 관찰하였다. 또한 국외 논문 및 저서에서 정립된 거품의 에너지 수지 식, 항력계수와 변형계수를 이용하여 거품의 종말속도, 항력계수, 변형계수, 형태를 예측해 보고 이를 실험결과와 비교해 보았다. 실험 결과 거품의 속도는 점도가 낮을 경우가 더 빨랐고, 거품의 항력계수는 점도가 클 때 더 컸다. 거품의 형태는 점도가 클 때 덜찌그러진(구형에 가까운) 형태였다. 실험결과와 국외 논문 및 저서에서 정립된 항력계수와 변형계수를 이용한 예측결과를 비교해 본 결과 Batchelor가 제시한 이론이 가장 정확한 예측을 하는 것으로 나타났다. Batchelor가 제시한 거품의 에너지 수지식, 항력계수와 변형계수를 사용하여 예측한 거품의 2차원 측면 형태는 실험에서 관찰된 거품의 2차원 측면 형태와 유사하였다.

• 한국전기전자재료학회논문지
• /
• 제27권12호
• /
• pp.847-851
• /
• 2014

The characteristics of dielectric constant and $tan{\delta}$ of low viscosity silicone oils with changing degree of polymerization were investigated. The result shows dipole loss mechanism at low temperature range. The dielectric loss in the range of low frequencies are predominantly of ionic nature with temperature increase. The peak of dielectric loss is the detrapping of the electrons which is were trapped in the localized level of the silicone oils at the frequency of 30 kHz. The increase of ionic conduction is attributed to the presence of ionizable oxidation products and their increased dissociation feature. The activation energy ${\Delta}H$ and dipole moment ${\mu}_d$ were increased whit increasing degree of polymerization.

• Journal of Electrical Engineering and Technology
• /
• 제1권4호
• /
• pp.528-533
• /
• 2006

Electrical discharges may occur in gas, liquid as well as solid insulating materials. This paper describes the investigation results on the discharges in air, silicone oil and low density polyethylene (LDPE) using needle plane electrode system under AC voltage of 50 Hz. The experimental results showed that for discharge in air (corona), discharge pulses were concentrated around the peak of applied voltage at negative half cycle. For silicone oil positive as well as negative discharges were observed which concentrated around the peak of applied voltage. The positive pulse number was smaller but the magnitude was higher than that of negative discharge. Discharges in void took place at wider range of phase of applied voltage. The unbalance in pulse number and magnitude similar to that of oil discharges were observed. For electrical treeing in LDPE, the discharges were spread before the zero cross of the applied voltage up to the peak at both positive and negative half cycles. The discharge pulse sequence analysis indicated that the PD occurrence in air, oil and void were strongly affected by the magnitude of applied voltage. However, for electrical treeing it was observed that the discharge occurrence was strongly affected by the time derivative of the applied voltage (dv/dt).

• 조명전기설비학회논문지
• /
• 제25권8호
• /
• pp.39-47
• /
• 2011

The motion of a conductive spherical particle under uniform electric field is investigated in order to find a suitable method for removing the conducting solid impurities contained in liquid plastic. When the positive dc voltage applied to the upper electrode, the vertical up-and-down motion of a charged particle by electrostatic force is observed by a charge-coupled device (CCD) camera or a high-speed video camera. The experimental data of the static threshold voltage by which the particle starts to move toward the counter electrode in air or silicone oil are in good agreement with theoretical value. When the applied voltage is larger than the static threshold voltage, the particle motion pattern in silicone oil consists of four stages: upward motion, stopping at the upper electrode, downward motion and stopping at the lower electrode. The stopping motion on the electrode is thought to be caused by the liquid flow accompanied by the particle motion. The particle charge calculated by integrating the pulse current, which is generated by the charge exchange between the electrode and the particle, is approximately 0.1~0.25 times of the theoretical value. This study is expected to help understand the electric properties of microparticles in oil circuit breaker (OCB) and oil transformer and improve their performance and longevity.

• 한국응용과학기술학회지
• /
• 제12권1호
• /
• pp.29-34
• /
• 1995

Silicone softner(SSN-3) for permanent press(PP) finish was prepared by blending beef tallow hardened oil for Improving softness, water, the emulsion, which was synthesized from pentaerythritol monostearate as a softening component and silicone oil KF-96 as a lubricating component. The prepared SSN-3 and the PP finishing resin were applied to PP finishing cotton broad cloth and P/C gingham samples using one bath method. The properties such as crease recovery, tear strength, bending resistance test were tested. The samples treated with SSN-3 and PP finishing resin have improved properties, compared with nontreated samples, those treated only with PP finishing resin, those treated with commercial PP finishing softners and PP finishing resin. Also from the bending resistance test, the two kinds of fabric samples treated with SSN-3 of 3% showed grade 5 and these were good enough in feeling.

• 한국공작기계학회:학술대회논문집
• /
• 한국공작기계학회 2002년도 춘계학술대회 논문집
• /
• pp.451-456
• /
• 2002

This paper describes the properties of Temperature-Viscosity characteristics of hydrous and anhydrous ER fluids containing starch and titanium particle in silicone oil. ER effects arise from electrostatic forces between the starch particles and titanium particles dispersed in the electrically insulating silicone oil induced when electric field is applied. ER fluids under electric field have been found to provide resonable estimates of ER fluid viscosity variation characteristics. Yield shear stress of the ER fluids were measured on the couette cell type rheometer as a function of electric fields. The outer cup is connected to positive electrode(+) and bob becomes ground(-). The electric field is applied by high voltage DC power supply. In this experiment shear rates were increased from 0 to 200/equation omitted/ in 2 minutes.

• 전기학회논문지
• /
• 제57권10호
• /
• pp.1812-1817
• /
• 2008

A cooling system for microelectronics is becoming more important as its surface heat density is projected to reach that of the sun surface. The existing technologies using natural and forced convection are limited to solve the problems. Recently, an electrohydrodynamic driven flow is studied as one of the means to cope with this problems. A new method, utilizing a needle-centered nozzle electrode, has been proposed and investigated. The I-V characteristics of the nozzle electrode for deionized water and silicone oil were significantly different from that of without liquid, which might be due to the liquid drop covered on the nozzle tip by the EHD force acting near the needle tip. Results showed that the liquid pumping rate and flow efficiency of the nozzle electrode were very high, especially for the silicone oil. Theoretical analysis also showed the effectiveness of the needle electrode centered in the ceramic nozzle, which, however, can be a means as a liquid pump.

• 한국미생물·생명공학회지
• /
• 제20권5호
• /
• pp.583-587
• /
• 1992

본 연구는 농용항생제인 kasugamycin의 생산을 위하여 S.kasugaensis의 배양조건 및 배지조성을 고찰하였다. Kasugamycin 발효시 최적 탄소원 및 질소원은 각각 soybean oil과 soybean flour였다. 배지 최적온도는 28'C, 최적 pH는 6.6이었다. 본 배양의 최적 접종 상태는 64-68시간 배양한 전배양액으로 접종하였으며, 발효중 물의 첨가는 생산성의 증가를 나타냈으나 소포제로서 silicone coil 첨가는 별 영향을 관찰할 수가 없었다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.332-333
• /
• 2006

The properties of a cable Insulate capacity between surfaces with the variation of the interfacial breakdown, the addition of silicon oil, the variation of pressure and interfacial roughness were investigated. The Insulate trouble of a power cable is out of the interfacial parts, which breakdown the insulate breakdown capacity in a power cable. In this study, the analysis of electric field and the phenomenon of interfacial breakdown were reported by varying the surfaces condition of silicon rubber, XLPE used for connection materials of a power cable.

• Tribology and Lubricants
• /
• 제25권3호
• /
• pp.176-181
• /
• 2009

Aminated polyacrylonitrile as the new organic disperse phases of the anhydrous ER fluid has been synthesized and ER effect of the suspension composed of aminated polyacrylonitrile in silicone oil investigated. The suspension showed a typical ER response (Bingham flow behavior) upon application of an electric field. The shear stress for the suspension exhibited the dependence with a factor equals to 1.6 power on theelectric field. The current density and the conductivity of the of aminated polyacrylonitrile suspension increase with the electric field intensity and moreover the conductivity of the suspension is about 8 order of magnitude higher than that of the silicone oil. On the basis of the the results, aminated polyacrylonitrile suspension showed the ER flow behavior upon application of the electric field due to the polarizability of the branched amine polar group of the aminated polyacrylonitrile particles.