• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.8
• /
• pp.3697-3705
• /
• 2011

There is the temporal correlation of the video sequence between the motion vector of current block and the motion vector of previous block. In this paper, we propose a new prediction search algorithm for block matching using the temporal and spatial correlation of the video sequence and local statistics of neighboring motion vectors. The proposed ANBA(Adaptive Neighboring-Block Search Algorithm) determines the location of a better starting point for the search of an exact motion vector using the point of the smallest SAD(Sum of Absolute Difference) value by the predicted motion vectors of neighboring blocks around the same block of the previous frame and the current frame and use a previous motion vector. Simulation results show that PSNR(Peak-to-Signal Noise Ratio) values are improved up to the 1.06dB as depend on the video sequences and improved about 0.01~0.64dB over MVFAST and PMVFAST.

• Journal of the Korean Chemical Society
• /
• v.41 no.6
• /
• pp.292-298
• /
• 1997

An ICP(Inductively Coupled Plasma) emission spectrometer was developed with an axially viewed ICP source incorporated by a 5-turned induction coil and a torch, outer quartz tube of which was 50 mm longer than that used in conventional ICP/AES(Inductively Coupled Plasma Atomic Emission Spectrometry). The Optimization of the system has been performed in terms of the determination of signal-to-noise ratio and background intensity at various rf powers, sample flow rates, argon gas flow rates and cut-off gas flow rates. The spectro-analytical characteristics of the spectrum obtained between 200 and 500 nm was revealed to be similar compared with a vertically viewed ICP source. The detection limit of Pb(Ⅱ) at 220.35 nm was 11 ppb which was 5 times lower than that obtained with a vertically viewed ICP source.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.17 no.4
• /
• pp.262-269
• /
• 1997

An eddy current probe ($8{\times}1$ multiple-element, surface scan) was successfully designed and fabricated at the KEPRI using the impedance equivalent circuit theory. The probe is intended for the detection of circumferential deformations (cross-section view) of the heat exchanger tubing that can occur due to corrosion, erosion, and denting. Optimum design parameters providing the highest sensitivity and signal-to-noise ratio, such as the coil dimensions, electrical characteristics, and test frequencies, were determined based on initial laboratory experiments conducted on the test specimen (SS304 tubing: OD : 9.68mm, wall-thickness : 0.47mm) containing artificial flaws (e.g., dents and corroded surface on tube OD) using the available Zetec-made probe. Using this parameters, a new probe was made and tested on an unknown specimen. The result indicated that the new probe is capable of detecting the circumferential deformation with the error of ${\pm}0.2%$ (0.022mm) of the tube O.D.

• Journal of IKEEE
• /
• v.15 no.3
• /
• pp.198-204
• /
• 2011

In this letter, another analytical approach for the opportunistic amplify-and-forward (OAF) relay systems is proposed over Rayleigh fading channels. Based on set-operation at the selected relay node, its selection probability as the best relay is derived and then, the probability density function (PDF) of the received instantaneous signal-to-noise ratio (SNR) is expressed as a more tractable form in which the number of summations and the length of each summation are specified. Then, the average error rate, outage probability, and average channel capacity are obtained as approximated closed-forms. Simulation results are finally presented to validate that the proposed analytical expressions can be a unified frame work covering all Rayleigh fading channel conditions. Furthermore, it is confirmed that OAF schemes can outperform the other non-selective schemes on the average error rate, outage probability, and average channel capacity.

• Journal of the Korea Society of Computer and Information
• /
• v.19 no.8
• /
• pp.45-54
• /
• 2014

In this paper, we proposed an effective quality improvement scheme of magnified image using the surface characteristics in image. If the surface in image is estimated as simple convex surface or simple concave surface, the interpolated value can be calculated to have the surface characteristics by using the other method in the proposed scheme. The calculated value becomes the interpolated pixel value inmagnified image. So, themagnified image reflects the surface characteristics of the real image. If the surface is not estimated as simple convex surface or simple concave surface, the interpolated value is calculated more accurately than bilinear interpolation by using the method of the proposed scheme. The PSNR values of the magnified images using the proposed schemes are greater than those of the magnified images using the previous interpolation schemes.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.49 no.4
• /
• pp.509-515
• /
• 2016

At the first time in South Korea, the state of the art acoustic systems were mounted on the R/V Tamgu 21. The acoustic systems are an EK80 broadband echosounder (18, 38, 70, 120, 200 and 333 kHz) which has two beam modes such as continuous wave (narrowband) and frequency modulation (broadband), an ME70 multibeam echosounder (70-120 kHz), and a SH90 sonar (111.5-115.5 kHz). Acoustic data from broadband mode have a very short range resolution, a large detection range, a high signal to noise ratio, and a wide and consecutive frequency response. In ME70, each individual beam consisted in a multibeam plays a role as a spilt beam. The first trial of the cutting edge acoustic system installed on the R/V Tamgu 21 was conducted from 15 Feb to 29 Feb 2016 in East Sea, South Sea and East China Sea. The properties of the acoustic systems were elucidated and exploratory results from three systems were exhibited. Lastly, issues which should be considered and future research plan are mentioned.

• Journal of radiological science and technology
• /
• v.38 no.4
• /
• pp.429-435
• /
• 2015

The purpose of this study was to prospectively estimate the effectiveness of multi-transmit parallel technique in reduced FOV(Field of View) less than 26 cm. Homogeneity, SNR(signal to noise ratio) and acquisition time were measured and compared by setting FOV less than 26cm on the T1 and T2 weighted images using ACR phantom. The multi-transmit parallel technique resulted in significantly faster image acquisition by 46.8 % in T1 weighted images and 18.9% in T2 weighted images. The homogeneity and SNR values had no significant difference between pre and post application of the multi-transmit parallel technique. In conclusion, this study demonstrates the feasibility of multi-transmit parallel technique in FOV less than 26cm with a rapid acquisition and maintained image quality.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.7
• /
• pp.1677-1688
• /
• 1998

In this paper, we analyze the performance of a DS-CDMA system employing adaptive adaptive array antenna technology at base-station. For the analysis the receiving architecture of a multiple team adaptive base-station array antenna is proposed as a major system omponent, and signal to interference and noise ratio(SINR) on the proposed architecture is developed. We show that the perfomance enhancement of the CDMA system is represented as great reduction of interfreence by employing an array antenna capable of resolving the angular distribution of the mobile users as seen at the ase-station. The energy associated with each mobile or a group of mobiles is thus confined within the addressed volume, greatly reducing the amount of co-channel interference experienced from and by neighboring co-channel cells. In order to ascertain the benefits of such an antenna, a theoretical approach, which eis based on the conventional and proposed antenna systems in a typical mobile radio environment, is adopted. Finally computer simulation results show the insight into how the adaptive array antenna operates when used in conjunction with DS-CDMA and illustrate the potential benefits in the SINR point of view.

• Journal of Convergence for Information Technology
• /
• v.7 no.5
• /
• pp.83-88
• /
• 2017

This paper describes the azimuth accuracy test of phase comparison direction finding method using F-16 fighter scale-down model. When the antennas are placed on the bottom of a fighter, reflection signals caused by an aircraft structure arises and an azimuth error occurs. In this research, the F-16 fighter scale-down model was made to 5:1, and five antennas were placed on the bottom of the model, then the radio waves of emitters were received by the antennas in the $0-360^{\circ}$ azimuth angles. The accuracy test was performed by numerically analyzing the phases of the radio waves received by the five antennas. The azimuth error of the phase comparison direction finding with scale-down model was measured to be less than $0.5^{\circ}$ when the signal noise ratio was larger then 0dB, and it could be very useful for the design of the phase comparison direction finding method of the fighter.

• Journal of the Korea Society of Computer and Information
• /
• v.13 no.7
• /
• pp.99-108
• /
• 2008

For video compression, we have to consider two performance factors that are the search speed and coded video's quality. In this paper, we propose an enhanced fast block matching algorithm using the spatial correlation of the video sequence and the center-biased characteristic of motion vectors(MV). The proposed algorithm first finds a predicted motion vector from the adjacent macro blocks of the current frame and determines an exact motion vector using the cross pattern and a flat hexagon search pattern. From the performance evaluations, we can see that our algorithm outperforms both the hexagon-based search(HEXBS) and the cross-hexagon search(CHS) algorithms in terms of the search speed and coded video's quality. Using our algorithm, we can improve the search speed by up to 31%, and also increase the PSNR(Peak Signal Noise Ratio) by at most 0.5 dB, thereby improving the video quality.