• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.25 no.11
• /
• pp.123-129
• /
• 2011

In terrestrial wireless optical communication links, atmospheric effects including turbulence, absorption and scattering have significant impact on the system performance. Based on the analysis of transmission in atmospheric channel concerning 830[nm] wavelength diode laser beam, performance of free space optical (FSO) link utilizing Galilean optics as a laser beam transmitting and receving optics, PIN photodiode as a detecting device. In this paper we designed optical link equation for received optical power and we analyze the atmospheric effects on the signal to noise ratio (SNR) and bit error rate (BER) of an terrestrial FSO system. We show that the possible communication distance for BER=$10^{-9}$ in proposed adverse atmospheric conditions.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.87-90
• /
• 2007

In cooperative communication systems, the source terminal transmits signal to the destination terminal with the aid of partner terminals. Therefore, the source terminal obtains extra spatial diversity gain. As a result, its performance is enhanced in term of higher achievable transmission rate, the larger coverage range, and the lower bit-error-rate (BER). Space-time codes (STCs) have been applied to cooperative communication systems in distributed fashion, in which the signal is spatially time exploited to obtain gains analogous to those provided by STCs. In this work, we consider the application of orthogonal Space-time Block Codes (OSTBCs) to the cooperative communication systems to further achieve higher diversity gain. The advances of the proposed approach are verified via computer simulations.

• The Journal of the Acoustical Society of Korea
• /
• v.13 no.5
• /
• pp.40-50
• /
• 1994

In this paper, the sensitivity compensation method for three-dimensional acoustic intensity probe in the higher frequency range has been studied. The measurement error in the higher frequency range is generated from the phase mismatch between microphone's signals of the probe. If the wavelength of sound signal measured is less than those of the distance between microphones of the probe, that is, the higher frequency of the sound signal, the bigger measurement error is generated. In this study, we proposed the compensation methods for one-dimensional acoustic intensity probe with two-microphones, and the efficiency of those methods were investigated by numerical calculation of computer. It was most effective method to compensate the phase mismatch between microphone for the acoustic intensity probe was investigated for the sound estimated. and the efficiency of this method in a three-dimensional probe was investigated for the sound wave travelling in the arbitrary direction by numerical calculation of computer. In this result, the efficiency was proved that, for the measurement error of 1dB or less with the three-dimensional probe of 60mm space, the frequency should be less than 1.2kHz without the error compensation method, but the frequency increased up to 2.8kHz with the error compensation method.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.6
• /
• pp.51-60
• /
• 2011

Researches on indoor localization using the wireless sensor network have been actively carried out to be used for indoor area where GPS signal is not received. Computationally efficient WCL(Weighted Centroid Localization) algorithm is shown to perform relatively well. However, to get the best performance for WCL all the anchor nodes must send signal with power to cover 96% of the network. The fact that outside the transmission range of the fixed nodes drastic localization error occurs results in large mean error and deviation. Due to these problems the WCL algorithm is not easily applied for use in the real indoor environment. In this paper we propose SRS(Succesive Region Setting) algorithm which sequentially reduces the estimated location area using the signal strength from the anchor nodes. The proposed algorithm does not show significant performance degradation corresponding to transmission range of the anchor nodes. Simulation results show that the proposed SRS algorithm has mean localization error 5 times lower than that of the WCL under free space propagation environment.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.31 no.9
• /
• pp.64-74
• /
• 2003

This paper proposes a new autonomous stationkeeping system suitable for geostationary satellite and conducts computer simulation to verify the proposed algorithm. The proposed onboard system receives pseudo-range signal from ground equipments located at two different position with long baseline, determines the orbit error in realtime and generates orbit control commands. For minimized onboard stationkeeping logic and better reliability, the orbit controller is designed to generate control signal to have the orbit roughly follow predetermined reference range data which is generated through ground based computer simulation. The reference range data is assumed to be uploaded with time tag. A simple orbit controller is proposed which combines the reference $\Delta$V and feedback control signal. Finally, the performance of the proposed system is verified through the computer simulations.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.39 no.3
• /
• pp.225-231
• /
• 2011

The satellite clock anomalies, one of the abnormal signal factors of the GPS satellites, can have a significant impact on the GPS measurements. However, it can be difficult to detect the anomalies of the satellites clock before the range of the satellites clock error becomes bigger than the range of the other factors, due to the measurement including error of the orbit, ionosphere delay, troposphere delay, multipath and receiver clock. In order to perform quick and accurate detection by minimization of critical range in anomalies of the satellites clock, this paper suggested a solution to detect precise anomalies of the satellites clock after application of carrier smoothing filter from measurement by dual-frequency and adjustment of errors which can be occurred by other factor and the receiver clock errors. The performance of the proposed method was confirmed by comparing to the satellite clock biases which are provided by IGS.

• International Journal of Aeronautical and Space Sciences
• /
• v.10 no.2
• /
• pp.117-124
• /
• 2009

In the environment where various and complicated threat signals exist, RWR (Radar Warning Receiver), which can warn pilot of the existence of threats, has long been a necessary electronic warfare (EW) system to improve survivability of aircraft. The angle of arrival (AOA) information, the most reliable sorting parameter in the RWR, is measured by means of four-quadrant amplitude comparison direction finding (DF) technique. Each of four antennas (usually spiral antenna) of DF unit covers one of four quadrant zones, with 90 degrees apart with nearby antenna. According to the location of antenna installed in helicopter, RWR is subject to signal loss and interference by helicopter body and structures including tail bumper, rotor blade, and so on, causing a difficulty of detecting hostile emitters. In this paper, the performance degradation caused by signal interference by tail rotor blades has been estimated by measuring amplitude video signals into which RWR converts RF signals in case a part of antenna is screened by real tail rotor blade in anechoic chamber. The results show that corruption of pulse amplitude (PA) is main cause of DF error. We have proposed two algorithms for resolving the interference by tail rotor blades as below: First, expand the AOA group range for pulse grouping at the first signal analysis phase. Second, merge each of pulse trains with the other, that signal parameter except PRI and AOA is similar, after the first signal analysis phase. The presented method makes it possible to use RWR by reducing interference caused by blade screening in case antenna is screened by tail rotor blades.

• Journal of Power Electronics
• /
• v.10 no.3
• /
• pp.285-292
• /
• 2010

This paper presents a current mode integrated control technique (CM-ICT) using a modified voltage space vector modulation (MSVM) for Z-source inverter (ZSI) fed induction motor drives. MSVM provides a better DC voltage boost in the dc-link, a wide range of AC output voltage controllability and a better line harmonic profile. In a voltage mode ICT (VM-ICT), the outer voltage feedback loop alone is designed and it enforces the desired line voltage to the motor drive. An integrated control technique (ICT), with an inner current feedback loop is proposed in this paper for the purpose of line current limiting and soft operation of the drive. The current command generated by the PI controller and limiter in the outer voltage feedback loop, is compared with the actual line current, and the error is processed through the PI controller and a limiter. This limiter ensures that, the voltage control signal to the Z-source inverter is constrained to a safe level. The rise and fall of the control signal voltage are made to be gradual, so as to protect the induction motor drive and the Z-source inverter from transients. The single stage controller arrangement of the proposed CM-ICT offers easier compensation. Analysis, Matlab/Simulink simulations, and experimental results have been presented to validate the proposed technique.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.9
• /
• pp.8-12
• /
• 2008

In this paper, we proposes a D-STTD(Double-Space Time Transmit Diversity) communication system with AMC scheme and analyzes its performance using simulation experiments. The AMC scheme selects an optimal channel coding rate and modulation scheme based on the channel response data for signal transmission, creating a balance between error rate and throughput to improve the overall system throughput and transmission quality. The D-STTD scheme complements the conventional STTD(Space Time Transmit Diversity) scheme, yielding about twice the throughput. The simulation results show that the probability of selecting a high MCS(Modulation and Coding Scheme) level increased as the SNR(Signal to Noise Ratio) improved. Furthermore, the D-STTD communication system with AMC scheme provided a more uniform throughput distribution throughout the entire SNR range compared to its counterpart which did not apply AMC scheme. Also, the maximum throughput of the D-STTD communication system with AMC scheme was twice that of a conventional AMC communication system or a STTD communication system with AMC scheme.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.45 no.9
• /
• pp.757-765
• /
• 2017

GNSS (Global Navigation Satellite System) Position Accuracy depends on pseudo-range measurement and DOP (Dilution Of Precision) which indicates about navigation satellite geometry. Pseudo-Range has many error sources such as satellite clock, orbit, ionosphere, troposphere, multipath and so on. For the improvement of the accuracy, user can use corrected pseudo-range in DGPS (Differential Global Positioning System), which is one of the relative positioning methods. But, stationary station is needed in relative positioning. In case of DOP, Signal reception environment is important. If receiver sets in the center of city, it could be interrupted reception by buildings. This environment leads to decrease the number of visible satellites and to increase DOP. This paper proposes the concept of GNSS positioning with virtual satellites which have usable VRM (Virtual Range Measurement). Via virtual satellites and VRM, users could get an accurate position. Especially referred virtual satellites constellation has an effect on vertical error.