• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.35 no.4
• /
• pp.897-905
• /
• 2015

This research suggested the traffic signal calculation model of active transit signal priority using a shockwave model. Using this signal priority timing optimization model, the shockwave area is computed under the condition of Early Green and Green Extension among active transit signal priority techniques. This study suggested the speed estimation method of backward shockwave using average travel time and intersection passing time. A shockwave area change is calculated according to signal timing change of transit signal priority. Moreover, this signal timing calculation model could determine the optimal signal priority timings to minimize intersection delay of general vehicles. A micro simulation analysis using VISSIM and its user application model ComInterface was applied. This study checked that this model could calculate the signal timings to minimize intersection delay considering saturation condition of traffic flow. In case studies using an isolated intersection, this study checked that this model could improve general vehicle delay of more over ten percentage as compared with equality reduction strategy of non-priority phases. Recently, transit priority facilities are spreading such as tram, BRT and median bus lane in Korea. This research has an important significance in that the proposed priority model is a new methodology that improve operation efficiency of signal intersection.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.1
• /
• pp.1-9
• /
• 2009

OFDM(Orthogonal Frequency Division Multiplexing) system is robust to frequency selective fading and narrowband interference in high-speed data communications. However, an OPDM signal consists of a number of independently modulated subcarriers and the superposition of these subcarriers causes a problem that can give a large PARR(Peak-to-Average Power Ratio). PTS(Partial Transmit Sequence) scheme can reduce the PAPR by dividing OFDM signal into subblocks and then multiplying the phase weighting factors to each subblocks, but computational complexity for selecting of phase weighting factors increases exponentially with the number of subblocks. Therefore, in this paper, MG-PSO(Modified Greedy algorithm-Particle Swarm Optimization) algorithm that combines modified greedy algorithm and PSO(Particle Swarm Optimization) algorithm is proposed to use for the phase control method in PTS scheme. This method can solve the computational complexity and guarantee to reduce PAPR. We analyzed the performance of the PAPR reduction when we applied the proposed method to telecommunication systems.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.2
• /
• pp.177-186
• /
• 2012

In this paper, we propose a design method that the crosstalk of probe connector pins satisfy the limitation of -30 dB. The parameters(inductance and capacitance) were extracted in the grid-structured probe connector pin system, and it is shown that the new parameters are easily calculated with increasing ground pin numbers using the previously calculated parameters. In addition, the crosstalk reduction algorithm by employing more grounds around the signal pin has been suggested, and it is confirmed that the suggested method is quite effective especially for the reduction of inductive couplings. Finally, we suggested the correlation between the pitch and the length of the pins to satisfy the crosstalk limitation of -30 dB with the given number of ground pins, which will be quite useful when design a probe connector pin system.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.36C no.5
• /
• pp.38-47
• /
• 1999

We have designed a 16bit adder which reduces the power consumption at each level of architecture, logic and transistor. The conventional ELM adder has a major disadvantage which makes glitch in the G cell when the particular input bit patterns are applied, because of the block carry generation signal computed by the input bit pattern. Thus, we propose a low power adder architecture which can automatically transfer each block carry generation signal to the G cell of the last level to avoid glitches for particular input bit patterns at the architecture level. We also use a combination of logic styles which is suitable for low power consumption with static CMOS and low power XOR gate at the logic level. Futhermore, The variable-sized cells are used for reduction of power consumption according to the logic depth of the bit propagation at the transistor level. As a result of HSPICE simulation with $0.6\mu\textrm{m}$ single-poly triple-metal LG CMOS standard process parameter, the proposed adder is superior to the conventional ELM architecture with fixed-sized cell and fully static CMOS by 23.6% in power consumption, 22.6% in power-delay-product, respectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.12A
• /
• pp.1340-1348
• /
• 2004

In this paper, we propose a PAPR-minimized sequence mapping scheme that achieves the minimum Peak-to-Average Power Ratio (PAPR) and the minimum amount of computations for the OFDM system. To reduce the PAPR, the mapping table is created with information about block index and symbol patterns of the lower signal power. When the input data sequence comes, it performed division by the block length to find the quotient and remainder. The symbol pattern of the lower signal power can be found in terms of the block index as the quotient in the mapping table and transmitted with remainder as the side information to distinguish and recover the original data sequence in the receiver. The two methods with the proposed mapping scheme are proposed in this paper. One is with mapping table to recover the O%M signal in both transmitter and receiver. The other is with mapping table only in transmitter to reduce the load and the complexity in the mobile system. We show that this algorithm provides the PAPR reduction, the simple processing and less computational complexity to be implemented for the multi-carrier system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.12 s.115
• /
• pp.1189-1198
• /
• 2006

We analyze the radiated emission and mutual coupling problem from a single microstrip transmission line and double signal traces with various ground patterns. In this paper, it is shown that the reduction of the radiated emission from the signal traces can be accomplished by using the novel and compact patterns on the ground planes in a specific frequency band. The accuracy and validation of radiation mechanism from the transmission line on a novel ground plane are evaluated and explained by using a commercially available software and experiment, respectively.

• Journal of Korea Multimedia Society
• /
• v.9 no.3
• /
• pp.296-306
• /
• 2006

We proposed the algorithm for the quantization noise reduction based on variable filter adaptive to edge signal in MPEG postprocessing system. In our algorithm, edge map and local modulus maxima in the decoded images are obtained by using 2D Mallat wavelet tilter. And then, blocking artifacts in inter-block are reduced by Gaussian LPF that is variable to filtering region according to edge map. Ringing artifacts in intra-block are reduced by 2D SAF according to local modulus maxima. Experimental results show that the proposed algorithm was superior to the conventional algorithms as regards PSNR, which was improved by 0.04-0.20 dB, and the subjective image quality.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2008.10a
• /
• pp.693-696
• /
• 2008

The systems for mobile communication services of fourth generation use OFDM (Orthogonal Frequency Division Multiplexing) scheme that ran transmit large amounts of data to support the multimedia services, and consist of several types of cell, such as Macro Cell, Pico Cell, Femto Cell to improve the qualify of service. According to subdivision of communication region, superposition of cells in co-channel different from conventional single cell is used, but it cause inter band interference between systems. In particular, an OFDM signal consists of a number of independently modulated subcarriers, and superposition of these subcarriers causes a problem that ran give a large PAPR. Increased PAPR induces signal distortion passing through components such as power amplifier so that inter band interference is caused by out-of-band spectrum radiation. In order to minimize the inter band interference, this paper applies PAPR reduction scheme and analyzes the out-of-band spectrum radiation when the signal passes through nonlinear components such an power amplifier.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2002.10a
• /
• pp.904-907
• /
• 2002

Optical disk drive device is improved in rotating speed for faster data reading. In the case of CD-ROM, rotating speed is over 10000 rpm in the practical use. As a result of high rotating speed, unexpected effects as like increasing disk fluctuation and acoustic noise are raised by the air friction on the rotating disk and the eccentricity of rotating parts. The overall acoustic noise of running CD-ROM could be classified into two different characterized noise. The first is the structural-borne noise which is generated from vibrating solid body. By the reason, the signal of structural borne noise has very similar to the signal of surface vibrating one. It has dense noise energy at specific frequency region. The other is the air-borne noise which is generated from turbulence or vortex caused by friction between disk and air. The signal of air-borne noise has no dominant peak point at acoustic pressure-frequency domain. The noise energy is widely distributed while comparatively high and large frequency region. The structural-borne noise could be reduced by reducing vibration of structure and in addition it's target reducing frequency is narrow. However the air-borne noise reduction is effectively needed of enclosing method for the noise source located near the disk surface because it is difficult to define target frequency point. In this study, the acoustic noise at driving CD-ROM is classified by the sides of it's character and tried to reduce the overall acoustic noise.

• Journal of Broadcast Engineering
• /
• v.13 no.5
• /
• pp.565-573
• /
• 2008

This paper proposes noise reduction methods to improve the channel estimation performance in Equalization On-Channel Repeater (E-OCR) for Terrestrial-Digital Multimedia Broadcasting (T-DMB) system. In the E-OCR for T-DMB system, the channel estimation is performed by the pilot signal extraction and the channel coefficient estimation. Since the performance of the channel estimation highly depends on the estimated channel coefficients whose accuracy is associated with the received signal-to-noise ratio (SNR), it is important to reduce noise existing at the estimated channel coefficients. To reduce such noise components, various noise reduction methods of the estimated channel coefficients based on the M -point weighted moving average are proposed. Computer simulations show that the proposed methods improve the estimation performance by more than 2 to 3 dB in terms of the symbol error rate after equalization.