• Current Industrial and Technological Trends in Aerospace
• /
• v.9 no.1
• /
• pp.158-164
• /
• 2011

Check valves developed for aerospace applications and commercially available for the applications are investigated. The examples include the ones for launch vehicles, SSME (Space Shuttle Main Engine) and GSE (Ground Support Equipment) purges developed by NASA, requiring high reliability, and the ones by KARI. Also the commercial ones for room and cryogenic temperatures by major valve US companies. Relations of design factors such as seal materials and spring rate to principal performances like operating temperature/pressure and cracking pressure are explained. Then potential operational problems such as chatter and contaminations are explained. Also, filters, fittings for end connections and cleanliness requirements for the applications are considered.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2006.06b
• /
• pp.367-372
• /
• 2006

The objective of this study is to develop the alternative of the container transport vehicle of new type for the purpose of the increase of terminal productivity. In order to develop the alternatives, we analyze the technical specification of existing transport vehicles such as YT(Yard Trailer), S/C(Straddle Carrier), SHC(Shuttle Carrier), AGV(Automated Guided Vehicle) and investigate the operation and performance of transport vehicles to classify the technical generation. The development alternative of transport vehicle is presented in this study is very useful to advanced container terminal with higher productivity.

• Journal of Powder Materials
• /
• v.25 no.6
• /
• pp.466-474
• /
• 2018

The high theoretical energy density ($2600Wh\;kg^{-1}$) of Lithium-sulfur batteries and the high theoretical capacity of elemental sulfur ($1672mAh\;g^{-1}$) attract significant research attention. However, the poor electrical conductivity of sulfur and the polysulfide shuttle effect are chronic problems resulting in low sulfur utilization and poor cycling stability. In this study, we address these problems by coating a polyethylene separator with a layer of activated carbon powder. A lithium-sulfur cell containing the activated carbon powder-coated separator exhibits an initial specific discharge capacity of $1400mAh\;g^{-1}$ at 0.1 C, and retains 63% of the initial capacity after 100 cycles at 0.2 C, whereas the equivalent cell with a bare separator exhibits a $1200mAh\;g^{-1}$ initial specific discharge capacity, and 50% capacity retention under the same conditions. The activated carbon powder-coated separator also enhances the rate capability. These results indicate that the microstructure of the activated carbon powder layer provides space for the sulfur redox reaction and facilitates fast electron transport. Concurrently, the activated carbon powder layer traps and reutilizes any polysulfides dissolved in the electrolyte. The approach presented here provides insights for overcoming the problems associated with lithium-sulfur batteries and promoting their practical use.

• Korean Journal of Applied Biomechanics
• /
• v.28 no.4
• /
• pp.219-225
• /
• 2018

Objective: Epidemiological research shows that 47 to 73% of athletes suffer from recurrent ankle sprains. Joint mobilization techniques (JMT) implemented in correcting may be beneficial in the management of ankle injuries. The purpose of this study is to examine the immediate JM on ankle complex as clinical measures in individuals with chronic ankle instability (CAI) through intervention. Method: Thirteen subjects with CAI (8 males and 5 females) participated in this study. Each subject tried total four alignments (Navicular drop test: NDT, Standing rearfoot angle: SRA, Tibia torsion: TT, and dorsiflexion range of motion: DFROM). The participants were performed the 10 meter shuttle run after JMT for post-task. Finally, it was tried to compare between pre-post tasks after shuttle run. Results: SRA and DFROM after intervention showed significant differences. SRA (p=.026), and DFROM (p=.034). Conclusion: We concluded that the JMT has resulted in improvement in SRA, DFROM. Increased DFROM and varus shapes of foot would be closed kinetic chain, indicating that reduce the risk factors of ankle sprain. Future study needs to be conducted in order to measure the effects of prolonged intervention of JMT.

• BMB Reports
• /
• v.56 no.7
• /
• pp.385-391
• /
• 2023

Aspartate-glutamate carrier 2 (AGC2, citrin) is a mitochondrial carrier expressed in the liver that transports aspartate from mitochondria into the cytosol in exchange for glutamate. The AGC2 is the main component of the malate-aspartate shuttle (MAS) that ensures indirect transport of NADH produced in the cytosol during glycolysis, lactate oxidation to pyruvate, and ethanol oxidation to acetaldehyde into mitochondria. Through MAS, AGC2 is necessary to maintain intracellular redox balance, mitochondrial respiration, and ATP synthesis. Through elevated cytosolic Ca²⁺ level, the AGC2 is stimulated by catecholamines and glucagon during starvation, exercise, and muscle wasting disorders. In these conditions, AGC2 increases aspartate input to the urea cycle, where aspartate is a source of one of two nitrogen atoms in the urea molecule (the other is ammonia), and a substrate for the synthesis of fumarate that is gradually converted to oxaloacetate, the starting substrate for gluconeogenesis. Furthermore, aspartate is a substrate for the synthesis of asparagine, nucleotides, and proteins. It is concluded that AGC2 plays a fundamental role in the compartmentalization of aspartate and glutamate metabolism and linkage of the reactions of MAS, glycolysis, gluconeogenesis, amino acid catabolism, urea cycle, protein synthesis, and cell proliferation. Targeting of AGC genes may represent a new therapeutic strategy to fight cancer.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.18 no.3
• /
• pp.99-108
• /
• 2016

The shuttle breeding of Korean winter wheat has been able to develop high-yielding and day-length-intensive varieties with a wide range of ecologic adoption. However, the phenology of winter wheat has been changed due to recent rises in the winter temperature of Toluca and increasing frequency of high temperatures. We defined two wheat groups (group II and III) with vernalization and evaluated the impact of cold exposure duration and heading ratio due to changes in sowing dates by measuring changes in cold exposure duration and corresponding heading states of each group. The wheat cultivars were sown on three dates in two years. The cold exposure requirement of wheat sown on 6 November 2013 was unfulfilled. The cold exposure requirement of wheat sown on 22 November and 6 December 2013 was fulfilled. However, in 2014, the cold exposure requirement of wheat sown on 5 and 20 November was fulfilled, but that of wheat sown on 5 December was unfulfilled. The differences for the two early November sowings were because winter temperature rises, which caused high temperatures in 2013, whereas early November 2014 saw normal temperatures for the area. The heading ratio of group II did not show a clear difference among the three sowing dates, while the heading ratio of group III was reduced by about half. This implies that the efficiency of shuttle breeding of group III will be high since it showed strong sensitivity to changes in sowing dates. We calculated future sowing dates of each group under near future climate scenarios; the future available sowing dates of group II were projected, but the dates of group III were never estimated in the temperature rise scenario in Toluca. Our findings suggest that change of sowing dates should be considered in the strategy for shuttle breeding of Korean winter wheat.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.13 no.4
• /
• pp.157-169
• /
• 2010

In this study, the applicability of SRTM(The Shuttle Radar Topography Mission) DEM(Digital Elevation Model) which is one of the remotely sensed shuttle's radar digital elevation was tested for use as the input data in a grid-based rainfall-runoff model. The SRTM DEM and digital topographic map derived DEM(TOPO DEM) were building with 500m spatial resolution for the Chungju-Dam watershed which located in the middle east of South Korea, and stream-burning method was applied to delineate the proper flow direction for model application. Similar topographical characteristics were shown as a result of comparing elevation, flow-direction, hydrological slope, number of watershed cell, and profile between SRTM DEM and TOPO DEM. Two DEMs were tested by using a grid-based rainfall-runoff model named KIMSTORM with 6 storm events. The results also showed no significant differences in average values of relative error for both peak runoff(0.91 %) and total runoff volume(0.29 %). The results showed that the SRTM DEM has applicability like TOPO DEM for use in a grid-based rainfall-runoff modeling.

• Journal of Life Science
• /
• v.16 no.2 s.75
• /
• pp.274-281
• /
• 2006

A fibrinolytic enzyme gene was isolated from Bacillus subtilis BB-1 by PCR method. Primers for PCR cloning were designed according to pre-identified gene for fibrinolytic enzymes from B. subtilis. The primer sequences were 5'-CGG ATC CGT GAG AGG CAA AAA GGT G-3' and 5'-TGA ATT CTT AAT GTG CTG CTG CTT GTC C-3' as concensus sequences of the fibrinolytic genes of Bacillus species. The PCR product was 1,145 bp and the sequence homology was 99% with nattokinase gene isolated from Japanese natto. The cloned fibrinolytic gene was reconstructed in Bacillus-E. coli shuttle vector, pEB for bulk-production. The fibrinolytic enzyme was purified by FPLC from the cloned B. subtilis 168. The optimum pH and temperature of the enzyme were 7.0 and $35^{\circ}C$, respectively. The fibrinolytic enzyme did not show any activity toward to skim milk, gelatin, casein and blood agar plate. The enzyme specific polyclonal antibody was prepared in rabbit for further assays such as detection of the gene expression in plant cells. This means that the enzyme may be used for health-care such as thrombosis without any hamful effects in the blood vessel.

• Korean Journal of Microbiology
• /
• v.30 no.3
• /
• pp.218-224
• /
• 1992

Recombinant plasmid shuttle vectors were constructed for genetic studies on the oxidation of carbon monoxide by carboxydobacteria. Two vectors. pYK322 (7.2 kb, Ap'. Tc') and pYK 324 (7.2 kb, Ap', Tc'), were constructed using pBR322 and pYK100. a small plasmid in Pseudomonas carbo,xydovorans. Four plasmids. pYK2IO (5.2 kb. Cm'), pYK220 (5.2 kb, Cmr), pYK230 (5.2 kb, Cm'), and pYK232 (5.2 kb. Cm'), were constructed using pACYC184 and pYK100. Transformation of several carboxydobacteria with pYK322 and pYK220 was round to be efficient when the cells were transformed by the methoti of Bagdasarian and Timmis (Curr. Top. Microbiol. Immunol. 96:47-67. 1982) with several modifications; cells growing on 0.2% succinate were harvested at the mid-exponential phase. 10 mM RbCl in transformation solution was substituted with 100 mM KCI. cclls in transformation solution were incubated for 12 h at 4'C before addition of DNA and heat shock was carried out for 3 min at 45$^{\circ}$C. Plasmid vectors used for transformation, however. were not detected from antibiotics-resistant transformants, suggesting that the vectors may be integrated into the chromosomal DNA.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.16 no.3
• /
• pp.103-114
• /
• 2013

In this study, we established the ortho mosaic imagery on the Korean Peninsula using KOMPSAT-2 images and conducted an accuracy assessment. Rational Polynomial Coefficient(RPC) modeling results were mostly less than 2 pixels except for mountainous regions which was difficult to select a Ground Control Point(GCP). Digital Elevation Model(DEM) which was made using the digital topographic map on the scale of 1:5,000 was used for generating an ortho image. In the case of inaccessible area, the Shuttle Radar Topography Mission(SRTM) DEM was used. Meanwhile, the ortho mosaic image of the Korean Peninsula was produced by each ortho image aggregation and color adjustment. An accuracy analysis for the mosaic image was conducted about a 1m color fusion image. In order to verify a geolocation accuracy, 813 check points which were acquired by field survey in South Korea were used. We found that the maximum error was not to exceed 5m(Root Mean Square Error : RMSE). On the other hand, in the case of inaccessible area, the extracted check points from a reference image were used for accuracy analysis. Approximately 69% of the image has a positional accuracy of less than 3m(RMSE). We found that the seam-line accuracy among neighboring image was very high through visual inspection. However, there were a discrepancy with 1 to 2 pixels at some mountainous regions.