• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 A
• /
• pp.315-317
• /
• 1995

A simple drive circuit without position sensors for a switched reluctance motor is presented. The turn on and turn off points are determined by detecting the rate of change of the active phase current. The drive circuit consists of a current sensing resistor, RC filter, comparator, OP Amp, and OR gates. It is verified through the experiments that the switched reluctance motor with the proposed sensorless drive circuit is well operated in wide speed ranges.

• 전력전자학회논문지
• /
• 제6권3호
• /
• pp.223-230
• /
• 2001

구형파 브러시리스 직류전동기를 구동시키기 위해서는 전동기의 회전자 위치에 대한 정보를 아는 것이 필수적이다. 본 논문에서는 회전자 위치를 검출하기 위해 일반적으로 사용되는 홀센서나 엔코더를 이용하지 않고, 각 상을 저항으로 Y결선하여 만들어지는 단자의 전압에 포함되어 있는 비여자상의 역기전력을 이용하여 전동기의 회전자 위치를 검출하는 구형파 브러시리스 직류전동기용 센서리스 드라이브 시스템을 제안한다. 이를 위해 3상 2여자 선단부 유니폴라 PWM을 수행할 결우에 대한 각상의 단자전압 분석을 수행하고, 분석된 단자전압 파형으로부터 회전자 위치를 검출하는 방법을 제안한다. 그리고 이를 실제로 간단한 회로로 구현하였다. 실험에 사용된 전동기는 100W급이며 Power MOSFET으호 인버터를 구성하였으며 87c196mc 컨트롤러를 사용하여 제어기를 구성하였다.

• 전력전자학회논문지
• /
• 제5권1호
• /
• pp.95-103
• /
• 2000

본 논문에서는 브러시리스 직류 전동기용 센서리스 드라이브의 성능 향상을 위한 새로운 회전자 위치 간접 검출 방식을 제안한다. 단자 전압을 이용하는 기존의 회전자 위치 간접 검출 방식들은 전동기를 동기 모드로 운전시 과도한 전압이 인가되면 회전자 위치를 정확히 검출할 수 없기 때문에 센서리스 운전 모드로의 신속한 전환이 어렵다. 따라서 본 논문에서는 전동기를 동기 모드로 운전하는 경우, 과전압에 의한 단자 전압과 역기전력 파형의 관계를 분석하여 저속 운전 영역에서도 회전자 위치를 정확히 검출할 수 있는 새로운 간접 검출 방식을 제안한다. 또한 실험을 통하여 제안한 방식의 효용성을 입증한다.

• 전기학회논문지
• /
• 제60권10호
• /
• pp.1858-1864
• /
• 2011

This paper suggests a control technique of the sensorless brushless DC (BLDC) motor drive for a vehicle fuel pump application. The sensorless technique based on a comparator and a potential start-up method with high starting torque are proposed. The comparator is used to generate the commutation signals in phase with the three-phase back-EMFs. The rotor position is aligned at standstill for maximum starting torque without an additional sensor and any information of motor parameters. Also, the stator current can be easily adjusted by modulating the pulse width of the switching devices during alignment. Some experiments are implemented on a single chip 16-bit DSP controller to demonstrate the feasibility of the sensorless techniques.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 B
• /
• pp.983-985
• /
• 2001

Sensorless induction motor drive is much studied due to the cost and reliability of speed and position sensors. Most sensorless algorithms are based on the mathematical modeling of induction motor including electrical variables such as phase current and voltage. Therefore, the accuracy of such variables largely affects the performance of sensorless induction motor drive. However, the phase voltage does not have to be directly monitored because of switching noise, and they may be reconstructed by using the command voltage. The output voltage of SVPWM-VSI supplying the motor has a considerable error, especially in a low speed range because SVPWM-VSI has a poor resolution in a low command voltage. Such a voltage information effect in speed sensorless control of induction motor has been investigated in this paper.

• 전력전자학회논문지
• /
• 제18권3호
• /
• pp.225-231
• /
• 2013

This paper presents an improved signal processing technique in the square-wave-type voltage injection method for IPMSM sensorless drives. Since the sensorless method based on the square-wave voltage injection does not use low-pass filters to get an error signal for estimating rotor position and allows the frequency of the injected voltage signal to be high, the sensorless drive system may achieve an enhanced control bandwidth and reduced acoustic noise. However, this sensorless method still requires low-pass and band-pass filters to extract the fundamental component current and the injected frequency component current from the motor current, respectively. In this paper, these filters are replaced by simple arithmetic operations so that the time delay for estimating the rotor position can be effectively reduced to only one current sampling. Hence, the proposed technique can simplify its whole signal process for the IPMSM sensorless control using the square-wave-type voltage injection. The proposed technique is verified by the experiment on the 800W IPMSM drive system.

• 한국전자통신학회논문지
• /
• 제3권4호
• /
• pp.266-275
• /
• 2008

본 논문에서는 전동기 파라미터와 부하에 강인한 속도 특성을 위해 디지털 IP제어를 이용한 BLDC 전동기의 센서리스 속도제어 방식을 제안한다. 단자 전압을 이용한 BLDC 전동기의 센서리스 구동시 회전자 위치 추정을 위해 아날로그 필터를 사용하기 때문에 부하나 속도에 영향을 받는다. 전동기 파라미터에 둔감하고 부하의 영향에도 강건한 센서리스 속도제어를 하기 위해서는 정확한 회전자 위치 추정과 연동하는 강인한 속도 제어기가 필요하다. 본 논문에서는 디지털 IP제어를 이용하여 부하의 변동에도 강인한 정속제어와 일정 부하로 운전 중 가감속시 임의의 속도변화에 대해 BLDC 전동기의 안정된 센서리스 제어가 가능하도록 구성하였다. 이에 대한 타당성은 실험을 통하여 입증하고자 한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1999년도 전력전자학술대회 논문집
• /
• pp.31-36
• /
• 1999

In this paper, a novel indirect rotor position sensing method is proposed to improve the performance of sensorless drive of brushless DC motors. Fast mode change to the sensorless operation is difficult in the existing indirect rotor position sensing methods because precise rotor position can not be obtained when an excessive input is applied to the drive during synchronous operation mode. To cope with this problem, the relationship between terminal voltage and back-emf waveform is analyzed in this paper, also a novel indirect position sensing method which can detect a precise rotor position at low speed range is proposed. The effectiveness of the proposed method is verified through the experimental results.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1998년도 Proceedings ICPE 98 1998 International Conference on Power Electronics
• /
• pp.287-292
• /
• 1998

This paper presents some results of performance evaluation test via actual machines of a new hybrid vector control utilizing a new indirect orientation scheme and stable filter embedded direct orientation scheme for induction motors without speed or position sensor. It is shown through the test by 0.3(kW) and 3.7(kW) motors that the proposed sensorless vector control has the following high potentialities: 1) speed range is 0 to 600(rad/s) or more, 2) zero-speed command is accepted and settles the machines at a stable standstill with no vibration 3) it can make machines to track variable command of acceleration and deceleration $\pm$6,000(rad/s2), 4) it can make machines to drive directly load of at least 26 times larger inertia than that of the machine, 5) it can make machines to produce much larger torque than the rating in torque control mode even at standstill. The performance confirmed by the test is far away for previous schemes or sensorless drive apparatuses.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 B
• /
• pp.629-630
• /
• 2006

This paper describes a novel sensorless excitation position detecting method of Switched Reluctance Motor(SRM) drive. A suitable excitation pattern of each phases is determined by comparison of detecting current without an inductance estimation. The principle of the rotor position estimation is based on the detection of phase current according to rotor position. This sensorless method is very simple and gives efficient control of drive system. The suggested method is verified by experiments.