• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2000.11a
• /
• pp.43-49
• /
• 2000

Heat transfer characteristics of self oscillating heat pipe were experimentally investigated for the effect of fill charge ratios and heat loads. The heat pipe used for this study is made of copper capillary, has 0.002m internal diameter, a 0.34m length in one turn and consists of 19 turns. Heating and cooling section each have a length of 70mm. Water was used as working fluid inside heat pipe. As the experimental results, the self oscillating heat pipe was operated by self-exited oscillation and circulation of working fluid and the oscillation within the self oscillating heat pipe assumed chaotic behavior.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.491-492
• /
• 2006

The MMIC (Microwave Monolithic Integrated Circuit) self oscillating double conversion mixer was designed and fabricated for the V-band transmitter applications. The MMIC self oscillating double conversion mixer which dose not need external local oscillator was designed using GaAs PHEMT technology. The first self oscillating mixer use PHEMT technology. The first self oscillating mixer use PHEMT for $f_{LO}$ signal generation and $f_{IF}$ signal is applied at gate port and $f_{RF1}$ signal is generated at a drain port of first stage. The second gate mixer use PHEMT for $f_{LO}$ signal and $f_{RF1}$ signal is applied at gate port and $f_{RF2}$ signal is output at a drain port of second stage.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.24 no.3
• /
• pp.413-419
• /
• 1987

In this paper, self-oscillating mixer is designed by small signal S-parameter and series feedback circuit. The input-output matching circuit is accomplished from double stub and additional matching stub. The self-oscillating mixer is oscillating itself and amplifies without any external local oscillator and an intermediate frequency amplifier, so it has advantages in its economical and system simplification. The experimental results show the maximum conversion gain 1.5d B and the noise figure 6.5d B at RF center frequency 4GHz and IF 1.1GHz` output oscillating power 4d Bm, efficiency 13.4%, stability -10MHz/V and -0.5MHz/\ulcornerC at oscillating frequency 5.1GHz.The rejection band loss characteristics in band pass filter and low pass filter are -40d B and -30d B, respectively.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.15 no.1
• /
• pp.1-8
• /
• 2010

This paper presents the self-oscillating flyback converter for reducing standby power without a control-IC. The proposed self-oscillating flyback converter includes a DC-Blocking capacitor for reducing constant power loss of initial switching path of a conventional self-oscillating flyback converter. it's possible to reduce the standby power to 1W and power efficiency. To confirm the validity of proposed system, comparison of conventional system, verification of experimental results is presented by realization of 35W power system.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.3
• /
• pp.492-498
• /
• 2003

In this paper, We analyze the optimum bias conditions of cascode coupled microwave mixer for maximum conversion gain mixer. Microwave self-oscillating mixer by two GaAs MESFET cascode coupled, to upper GaAs MESFET operating as a oscillator with high Q dielectric resonator and the lower GaAs MESFET operated as a mixer with low noise and high conversion characteristics. As a result of experiments, cascode coupled microwave self oscillating mixer according to optimun bias shows an 5.92 dBm oscillating power, -132.0dBc/Hz @ 100KHz at 5.15GHz and 3dB conversion loss.

• Proceedings of the IEEK Conference
• /
• 2003.07c
• /
• pp.2931-2934
• /
• 2003

This paper has been studied the electronic ballast by the self-oscillated inverter. The self-oscillated ballast can reduce the stress of the switch of the inverter. But the self-oscillating method is not easy to analyze and design. There arc three kinds of cores for the oscillating transformer： Ring core, EI-core, and Drum core. In this paper, we are studied the characteristics of three kinds of cores in using electronic ballast by the self-oscillated inverter.

• The Journal of Korean Institute of Information Technology
• /
• v.16 no.11
• /
• pp.61-68
• /
• 2018

This paper describes design of a 10.525 GHz self oscillating mixer semiconductor IC chip combining voltage controlled oscillator and frequency mixer using silicon CMOS technology for Doppler radar applications. The p-core type VCO included in the self oscillating mixer minimizes the noise contained in the transmitted signal. This noise minimization increases the sensing distance and acts in a direction favorable to the reaching distance and the sensitivity of the motion detection sensor. Simulation results for phase noise show that a VCO designed as a P-core has a noise characteristic of -106.008 dBc / Hz at 1 MHz offset and -140.735 dBc / Hz at 25 MHz offset compared to a VCO designed with N-core and NP-core showed excellent noise characteristics. If a self-oscillating mixer is implemented using a p-core designed VCO in this study, a motion sensor with excellent range and reach sensitivity will be produced.

• Polymer(Korea)
• /
• v.39 no.3
• /
• pp.359-364
• /
• 2015

A self-oscillating interpenetrating polymer network (IPN) poly(acrylic acid)/poly(ethylene glycol) (PAA/PEG) hydrogel was prepared by using radical polymerization with a two-step method. The IPN hydrogel was characterized by FTIR spectroscopy and morphological analysis. The results indicated that the chains of PEG and PAA twined to form porous structure which is beneficial to water molecules entering inside of the hydrogel. In addition, the pH-responsive behavior, salt sensitivity, swelling/de-swelling oscillatory behaviors and self-oscillation in a closed pH oscillator were also studied. The results showed that the prepared hydrogel exhibited pH-sensitivity, good swelling/de-swelling reversibility and excellent salt sensitivity. The self-oscillating behavior of swelling/de-swelling for the prepared hydrogel was caused by pH alteration coupled with the external media. This study may create a new possibility as biomaterial including new self-walking actuators and other related devices.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.12 no.9
• /
• pp.853-859
• /
• 2000

In this study, low temperature waste heat recovery heat exchanger was developed using a principle of self-excited oscillating heat pipe. The heat exchanger of serpentine type was composed of extruded flat aluminum tube with 6 channels (3 nm$\times$ 2.75nm) and louvered fin. The heat transfer area density of heat exchanger was $331.9 m^2/m^3$. Working fluid is R141b and charge ratio was 40% by volume. Heat transfer rate and the effectiveness of heat exchanger was primary concern of this study. As a result, the effectiveness of heat exchanger was about 0.4-0.67, and recovered waste heat rate was about 4.5 kW per one unit of heat exchanger.

• Proceedings of the IEEK Conference
• /
• 2003.11c
• /
• pp.86-89
• /
• 2003

In this paper, Self-Oscillating Mixer is designed by oscillator that was based on a general nonlinear input-output model for the subharmonic injection locked oscillator is analysed. We have designed and fabricated the Self-Oscillating Mixer for 5GHz by proposed subharmonic injection locked oscillator based frequency synthesizer structure that have characteristic of good frequency sensitivity, good phase noise. The design strategy leading to an optimized SILO with regards to its locking range is described and a test SOM circuit is demonstrated a 4dB conversion gain at 280MHz IF frequency from the carrier.