• Tribology and Lubricants
• /
• v.11 no.5
• /
• pp.162-171
• /
• 1995

The application of reciprocating engine crankshaft bearings is of particular importance and interest among the plain bearing, not only because the sheer volume of intemal combustion engines now produced, but because the severe operating conditions they are subjected to. Demands for better performances of crankshaft bearings have provide an important impetus in the development of bearings and bearing materials. As engine design progresses toward higher outpt and higher efficiency, crankshaft bearings must perform under more seveve operating conditions. Higher load, temperature, and speed as well as lower viscosity oil are applied to the bearing sysem, resulting in a smaller minimum oil film thickness. This means more solid-solid contact between the shaft and bearing, and the bearing is exposed to more danger of seizure. Some engines may experience bearing seizure problems. However, understanding about the seizure behavior and mechanism is far from being enough. Seizure resistance of a bearing-shaft system will be affected by the properties of the shaft and bearing, especially their materials and surface texture. Commonly used engine bearing materials include Al-Pb-Si, Al-Sn-Si, Al-Sn, and Cu-Pb with Pb-Sn-Cu overlay. These materials have very different properties. They showed different behaviors dering seizure tests and seizure may occur with different mechanism for different bearing material. Shaft materials also affect the seizure resistance of the system. Surface texture of the bearing and shaft have apparent effects on the lubrication and solid-solid contact pattern, and therefore will affect the seizure behavior of the system. Bearings and shafts which are made of different materials and have different surface textures have been tested and analyzed. Their effects on seizure resistance are discussed and possible seizure mechanisms for different beatings are presented in this paper.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.14 no.2
• /
• pp.358-366
• /
• 1990

As a basic study to clarify the scoring resistance in lubricated sliding contact, the temperature rise on frictional surface was analyzed by theoretical method and the effects of various factors on the temperature rise were examined. On the basic of the results obtained theoretically, the practical equations to calculate the maximum average temperature of the contact surface were proposed which are applicable to sliding contact. Then, the effects of sliding velocity and oil temperature on the seizure behavior, and the relation between seizure and temperature rise were investigated. The following conclusions are deduced : The maximum average temperature rise and the other bulk temperature. The former is affected by the size of heat supply region and the sliding velocity, the latter is affected by heat transfer coefficient. Without regard to the operating condition such as sliding velocity, oil temperature and operating time at each load-step, the maximum average temperature just before seizure is nearly constant except in the region of lower velocity. Consequently, the maximum average temperature of the contact surface in boundary lubrication is a useful criterion to predict the scoring of sliding contact.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 2002.10b
• /
• pp.369-370
• /
• 2002

To clarify the tribological properties of biodegradable lubricating oils, the four-ball tests were carried out under dip-feed lubrication using a Soda-type four-ball machine. The test balls were lubricated with soybean oil, rapeseed oil, corn oil and turbine oil. From the tests, the coefficient of friction for all the test balls lubricated with biodegradable lubricating oils was lower than that for the test ball lubricated with turbine oil. Further, from the calculation of the pV value, it was clear that the seizure resistance for all the test balls lubricated with biodegradable lubricating oils was higher than that for the test ball lubricated with turbine oil.

• International Journal of Oral Biology
• /
• v.31 no.2
• /
• pp.33-43
• /
• 2006

Dysplasia-associated seizure disorders are markedly resistant to pharmacological intervention. Relatively little research has been conducted studying the effects of antiepileptic drugs(AEDs)on seizure activity in a rat model of dysplasia. We have used rats exposed to methylazoxymethanol acetate(MAM) in utero, an animal model featuring nodular heterotopia, to investigate the effects of AEDs in the dysplastic brain. Pilocarpine was used to induce acute seizure in MAM-exposed and age-matched vehicle-injected control animals. Field potential recordings were used to monitor amplitude and numbers of population spikes, and paired pulse inhibition in response to stimulation of commissural pathway. Two commonly used AEDs were tested: diazepam 5, 2.5 mg/kg; phenytoin 40, 60 mg/kg. Diazepam(DZP) and phenytoin(PHT) reduced the amplitude of population spike in control and MAM-exposed rats. However, the amplitude of population spike was nearly eliminated in control rats as compared to the MAM-exposed rats. Pharmaco-resistance was tested by measuring seizure latencies in awake rats after pilocarpine administration(320 mg/kg, i.p.) with and without pretreatment with AEDs. Pre-treatment with PHT 60 mg prolonged seizure latency in control rats, but not in MAM-exposed animals. The main findings of this study are that acute seizures initiated in MAM-exposed rats are relatively resistant to standard AEDs assessed in vivo. These data suggest that animal model with cortical dysplasia can be used to screen the effects of potential AEDs.

• The Korean Journal of Physiology and Pharmacology
• /
• v.10 no.5
• /
• pp.235-242
• /
• 2006

Cortical malformation-associated epileptic seizures are resistant to conventional anticonvulsant drugs. Relatively little research has been conducted on the effects of antiepileptic drugs (AEDs) on seizure activity in a rat model of dysplasia. We have used rats exposed to methylazoxymethanol acetate (MAM) in utero, an animal model featuring nodular heterotopia, to investigate the effects of ethosuximide (ETX) in the dysplastic brain. Pilocarpine was used to induce acute seizure in MAM-exposed and age-matched vehicle-injected control animals. Field potential recordings were used to monitor the amplitude and number of population spikes, and paired pulse inhibition in response to stimulation of the commissural pathway. Pharmaco-resistance was tested by measuring seizure latencies after pilocarpine administration (320 mg/kg, Lp.) with and without pre-treatment with ETX. Pre-treatment with 300 mg of ETX significantly prolonged the latency to the status epilepticus (SE) in both control and MAM-treated groups. Pre-treatment with ETX 100mg and ETX 200 mg had little effect in MAMexposed rats. However, ETX 200 mg prolonged the latency to the SE in control groups. Spontaneous field potential and secondary after-discharges were higher for MAM-treated rat in comparison with control rats injects with ETX. The main findings of this study are that acute seizures initiated in MAM-exposed rats are relatively resistant to standard ETX assessed in vivo. These data suggest that ETX do not prolong seizure latencies in MAM-rats exposed to pilocarpine.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 2000.11a
• /
• pp.372-377
• /
• 2000

Recently, fluid bearing have been studied to apply to spindle motors for hard disk drive, printer and others. Since fluid bearing have excellent stiffness and good load carrying capacity, the bearing proved to be suitable for those devices related to computer industry. In this paper, the friction and wear characteristics of the bearing were studied. The bearing appears good performance at a high temperature and high wear resistance.

• Proceedings of the Korean Society For Composite Materials Conference
• /
• 2004.04a
• /
• pp.63-66
• /
• 2004

In this study, a hybrid composite journal bearing composed of carbon fiber reinforced phenolic composite liner and metal backing was manufactured to solve the seizure problem of metallic journal bearing materials because the carbon fiber has self-lubricating ability and the phenolic resin has thermal resistance characteristics. To estimate the wear resistance of carbon fiber phenolic composite, wear tests were performed at several pressures and velocities. The oil absorption characteristics, coefficient of thermal expansion, strength and stiffness of the composite were also tested. Using the measured stiffness values, the thermal residual stresses in the composite were calculated to check the reliability of the composite journal bearing.

• Interaction and multiscale mechanics
• /
• v.4 no.1
• /
• pp.1-16
• /
• 2011

The inverse problem about the theoretical analysis of a drill string bending in a channel of an inclined bore-hole with localized geometrical imperfections is studied. The system of ordinary differential equations is first derived based on the theory of curvilinear flexible elastic rods. One can then use these equations to investigate the quasi-static effects of the drill string bending that may occur in the process of raising, lowering and rotation of the string inside the bore-hole. The method for numerical solution of the constructed equations is described. With the proposed method, the phenomenon of the drill column movement, its contact interaction with the bore-hole surface, and the frictional seizure can be simulated for different combinations of velocities, directions of rotation and axial motion of the string. Geometrical imperfections in the shape of localized smoothed breaks of the bore-hole axis line are considered. Some numerical examples are presented to illustrate the applicability of the method proposed.

• The Journal of Korean Physical Therapy
• /
• v.12 no.1
• /
• pp.147-151
• /
• 2000

Heat shock protein 70(HSP70) is induced by elevated temperature and many other types of stresses in cell. HSP70 ensures cell survival under stressful condition that would lead to irreversible cell damage and ultimately to cell death. HSP70 plays essential role in the synthesis, transport, and folding of proteins and is often refferred to as molecular chaperones. Increased levels of HSPs occur after arthritis, infection, imflammation, autoimmune disease and CNS injury such as infarction, ischemia, seizure and Alzheimer's disease. Also, HSP70 increases resistance to apoptosis. The recent studies that the expression of the HSP has been processed at various field. However, they an still relatively line studied in clinically application. This review summarizes the fundamental knowledge of HSP.

• Korea and Global Affairs
• /
• v.1 no.2
• /
• pp.33-84
• /
• 2017

This study deals with President Park Chung-hee's greed for dominance and oppression during the Yushin Regime in the 1970's and consists of case studies related to anti-democracy of the National Council for Unification Subject, illegality of President's emergency rule and oppression in the process of putting down Buma Uprising. The National Council for Unification Subject was an organization for presidential selection and institutionalized by the enactment of Yushin constitution. Emergency rule was carried into effect as a means to repressing college students and forces out of office for the president's long-term seizure of power. And Buma Uprising rose against violence in resistance to the Yushin regime and president Park Chung-hee's greed for dominance and oppression. These case analyses applied the aspects of causal relationship(birth and fall of Yushin Regime), legal system(Yushin constitution and president's emergency rule) and behavior(President Park's greed for dominance and oppression) for this study. The National Council for Unification Subject institutionalized through Yushin constitution and the Yushin regime formed by emergency rule enabled President Park to cling to long-term seizure of power by means of greed for dominance and oppression. After all, his failure to keep the spirit of the time and stepping stone for democratic constitutional government triggered Buma Uprising, a kind of anti-Establishment movement, and caused the fall of the Yushin regime.