• Mass Spectrometry Letters
• /
• 제2권4호
• /
• pp.80-83
• /
• 2011

Isotope ratio analysis of nuclear materials in individual particles is of great importance for nuclear safeguards. Although secondary ion mass spectrometry (SIMS) and thermal ionization mass spectrometry (TIMS) are utilized for the analysis of individual uranium particles, few studies were conducted for the analysis of individual uranium-plutonium mixed oxide particles. In this study, we applied SIMS and inductively coupled plasma mass spectrometry (ICP-MS) to the isotope ratio analysis of individual U-Pu mixed oxide particles. In the analysis of individual U-Pu particles prepared from mixed solution of uranium and plutonium standard reference materials, accurate $^{235}U/^{238}U$, $^{240}Pu/^{239}Pu$ and $^{242}Pu/^{239}Pu$ isotope ratios were obtained with both methods. However, accurate analysis of $^{241}Pu/^{239}Pu$ isotope ratio was impossible, due to the interference of the $^{241}Am$ peak to the $^{241}Pu$ peak. In addition, it was indicated that the interference of the $^{238}UH$ peak to the $^{239}Pu$ peak has a possibility to prevent accurate analysis of plutonium isotope ratios. These problems would be avoided by a combination of ICP-MS and chemical separation of uranium, plutonium and americium in individual U-Pu particles.

• 상하수도학회지
• /
• 제32권1호
• /
• pp.47-53
• /
• 2018

This study investigated phosphorus removal from secondary treated effluent using coagulation-membrane separation hybrid treatment to satisfy strict regulation in wastewater treatment. The membrane separation process was used to remove suspended phosphorus particles after coagulation/settlement. Membrane separation with $0.2{\mu}m$ pore size of micro filtration membrane could reduce phosphorus concentration to 0.02 mg P/L after coagulation with 1 mg Al/L dose of polyaluminum chloride (PACl). Regardless of coagulant, the residual concentration of phosphorus decreased as the dose increased from 1.5 to 3.5 mg Al/L, while the target concentration of 0.05 mg P/L or less was achieved at 2.5 mg Al/L for the aluminum sulfate (Alum) and 3.5 mg Al/L for PACl. Moreover, alum showed better membrane flux as make bigger particles than PACl. Alum showed a 40% of flux decrease at 2.5 mg Al/L dose, while PACl indicated a 50% decrease of membrane flux even with a higher dose of 3.5 mg Al/L. Thus, alum was more effective coagulant than PACl considering phosphorus removal and membrane flux as well as its dose. Consequently, the coagulation-membrane separation hybrid treatment could be mitigate regulation on phosphorus removal as unsettleable phosphorus particles were effectively removed by membrane after coagulation.

• 한국해양공학회지
• /
• 제22권4호
• /
• pp.59-64
• /
• 2008

The mechanical properties of liquid phase sintered (LPS) SiC materials, with the addition of oxide powder, were investigated, in conjunction with a detailed analysis of their microstructures. LPS-SiC materials were fabricated at a temperature of 1820 $^{\circ}C$ under an argon atmosphere, using three different starting sizes of SiC particles. The sintering additive for the fabrication of the LPS-SiC materials was an $Al_2O_3-Y_2O_3$ mixture with a constant composition ratio ($Al_2O_3/Y_2O_3$: 1.5). The particle sizes of the commercial SiC powderswere 30 nm, 0.3 $\mu$m, and 3.0 $\mu$m. The flexural strength of the LPS-SiC materials was also examined at elevated temperatures. A decrease in the starting size of the SiC particles led to an increase in the flexural strength of the LPS-SiC materials, accompanying a highly dense morphology with the creation of a secondary phase. Such a secondary phase was identified as $Y_3Al_2(AlO_4)2$. The flexural strength of the LPS-SiC materials greatly decreased with an increase in the test temperature, due to the creation of a large amount of pores.

• 열처리공학회지
• /
• 제13권1호
• /
• pp.27-34
• /
• 2000

This present study were investigated effect of Ni contents on the microstructure and strength characteristic in 9Cr ferritic heat-resistant steel added 1.7%W in place of Mo in order to restrain laves phase formation. The result obtained from this study are as follow. Volume fraction, number of particles per unite area and particle size of carbide decreased with increase of Ni contents. Other side, carbides of $M_{23}C_6$ type was mainly precipitated in this steel, but laves phases could not precipitated in spite of increasing of aging time. With increase of tempering temperature, hardness was increased, and maximum value was showed around 873k by secondary hardening due to precipitation of $W_2C$ type carbide and then, was decreased. Tensile and yield strength due to decrease precipitation amount of carbide and number of particles per unite area was decreased, but elongation and impact value was increased. In case of aged specimen after tempering than tempered specimen, strength was higher and elongation was lower due to increasing of precipitated amount of carbide and number of particles per unite area.

• 자원환경지질
• /
• 제56권5호
• /
• pp.557-564
• /
• 2023

우라늄 등의 핵물질은 원자력 발전의 연료로 사용되지만, 비평화적 용도로 전용될 가능성이 커서 이에 대한 국제적인 사찰과 규제가 이루어지고 있다. 핵물질 사용 시설에서 확보한 미세 입자상 물질의 동위원소 분석 자료는 핵물질의 기원 및 농축 방법등에 대한 중요한 정보를 제공할 수 있어 핵 안전 및 핵 사찰 분야에서 널리 활용되고 있다. 이번 연구에서는 국내 최초로 국내에 설치된 대형 이차이온 질량분석기를 활용해 미세 입자 시료에 대한 우라늄 동위원소를 측정한 결과를 소개한다. U-200 표준물질을 사용해 미세 입자의 위치를 확인하고 고정밀 정밀분석을 통해 오차범위내에서 표준값과 일치하는 결과를 얻을 수 있었다.

• Journal of Electrochemical Science and Technology
• /
• 제7권2호
• /
• pp.161-169
• /
• 2016

Porous tungsten oxide thin films were prepared by electrodeposition and tested as anodes of lithium secondary batteries. The synthesized films were composed of nanoparticles of 60-140 nm size, with porosities of 30-40 %. Increasing the temperature turned out to be a more effective approach to introduce porosity in the structure than increasing the electrolyte viscosity. The assessment of the synthesized films as anodes of lithium secondary batteries revealed a much higher initial discharge capacity for the porous than the dense samples. The discharge capacity retention significantly increased with increasing porosity and was further enhanced by heat treatment. In particular, a thin film composed of particles of about 140 nm in size and with a porosity of 40 % exhibited an initial discharge capacity higher than 600 mAh/g and a remaining capacity above 300 mAh/g after 30 cycles. Following heat treatment, the remaining capacity of this sample after 30 cycles increased to about 500 mA h/g.

• Progress in Superconductivity
• /
• 제4권1호
• /
• pp.90-93
• /
• 2002

The sintering process of BSCCO 2223 tapes is a complex process that is very sensitive to parameters, such as temperature, oxygen partial pressure, heating and cooling rate and holding time. During the first heat treatment, 2212 phase of precursor powder is partially transformed into 2223 phase and some residual secondary phases, such as $(Bi,Pb)_2$$Sr_2$CuO／sub y／(2201), $(Ca,Sr)_2$CuO／sub y／(2/1AEC), (Ca,Sr)／sub 14／Cu／sub 24／O／sub 41／(14／24 AEC) etc. The secondary phases are difficult to be removed from the BSCCO 2223 matrix on the heat treatment. These secondary phases degrade the critical current density. In order to minimize the amount and size of alkaline earth cuprate(AEC) particles step heat treatment is applied during the first heat treatment under the varying atmosphere. Experimental results showed that by adapting the step heat treatment process, the amount and particle size of the secondary phases in the final tapes are decreased. Consequently, the BSCCO 2223grain texture and Jc properties are improved.

• 한국재료학회지
• /
• 제12권9호
• /
• pp.712-717
• /
• 2002

New wet chemical method so called precipitation-evaporation method was suggested for preparing spinel structure lithium manganese oxide ($LiMn_2$$O_4$) for Li ion secondary battery. Using precipitation-evaporation method, $LiMn_2$$O_4$ cathode materials suitable for Li ion secondary batteries can be synthesized. Single spinel phase $LiMn_2$$O_4$ powder was synthesized at lower temperature compared to that of prepared by solid-state method. $LiMn_2$$O_4$ powder prepared by precipitation-evaporation method showed uniform, small size and well defined crystallinity particles. Li ion secondary battery using $LiMn_2$$O_4$ as cathode materials prepared by precipitation-evaporation method and calcined at $800^{\circ}C$ showed discharge capacity of 106.03mAh/g and discharge capacity of 95.60mAh/g at 10th cycle. Although Li ion secondary battery showed somewhat smaller initial capacity but good cyclic ability. It is suggested that electro-chemical properties can be improved by controlling particle characteristics by particle morphology modification during calcination and optimizing Li ion secondary battery assembly conditions.

• 한국환경보건학회지
• /
• 제44권1호
• /
• pp.1-14
• /
• 2018

Objectives: The purpose of this study is to investigate the main cause of visibility impairment by analyzing the contributions of the light extinction coefficient of major air pollution components and the change of the light extinction coefficient by relative humidity. Methods: The characteristics of the light extinction coefficient calculated by the photochemical method using fine particle component data measured in 2015 in the Gwangju area were examined. Results: The extinction efficiency per unit mass of $PM_{2.5}$ particles was $4.5m^2/g$ and that of $PM_{10-2.5}$ particles was $0.6m^2/g$. This difference indicates that most of the visibility impairment in Gwangju was caused by $PM_{2.5}$ particles. When visibility was poor, the contribution of ammonium sulphate and ammonium nitrate was significantly increased. Relative humidity was also a major cause of visibility decay. The influx of air currents in Gwangju was mostly caused by the long distance movement of pollutants emitted from the eastern part of China. Ammonium sulphate and ammonium nitrate, which are hygroscopic secondary contaminants, were the main causative agents of visibility impairment. Conclusions: Ammonium sulphate and ammonium nitrate were the main causative agents of visibility impairment in Gwangju. The influx of air currents in Gwangju was mostly caused by the long distance movement of pollutants emitted from the eastern part of China.

• 광물과 암석
• /
• 제33권3호
• /
• pp.233-242
• /
• 2020

나노물질에 대한 연구와 산업화가 급격히 진행되면서 수환경으로 유출되는 나노물질의 양도 점차 많아지고 있다. 특히 은나노물질의 경우 은의 항균성으로 인하여 다양한 분야에서 사용되고 있으며 환경으로 유출되어 입자상태와 용해된 상태로 존재할 수 있다. 은나노물질과 은이온은 생태환경에 악영향을 줄 수 있으며 미국에서는 2차 먹는물 규제 항목(secondary drinking water standards)으로 정하고 있으며 규제농도는 0.1 mg/L로 정하여 관리하고 있다. 본 연구에서는 경북지역의 지하수와 소규모 먹는 물 공급시설을 대상으로 은의 농도를 측정하였으며 오염 정도를 미국 EPA 기준과 비교하고 시료를 채취한 지역의 특성, 물의 사용 목적 등을 고려하여 분석하였다. 총 293개의 시료 중 EPA의 secondary drinking water standards를 초과한 시료는 2개이며 비율로 0.6 7%이다. 검출률은 마을 상수도와 소규모 급수시설에서 상대적으로 높으며 농도 기준으로는 지하수에서 상대적으로 높은 농도를 보여 인위적 오염원과 지질적 기원이 동시에 작용한 것으로 판단되었다.