• Journal of Korea Water Resources Association
• /
• v.39 no.11 s.172
• /
• pp.961-968
• /
• 2006

Since a small harbor is often located near surf zone areas which have great influences of sediment transport, there is a great possibility that the sediment will be deposited inside of the harbor. The sediment transport occurring around the harbor entrance can't be explained by the wind wave and wave induced current. In this study, it was investigated the mechanism of the entrainment of sediment into a small harbor with permeable breakwater using hydraulic experiments in 3D wave basin. It is found out that the significant sediment entrainment produced when the mode of oscillation in the harbor became the 1st mode. In the case where the incident wave period was shorter than the period that caused higher mode oscillation in harbor, only a little amount of sediment entrainment took place. The vortex shedding from the top of secondary breakwater played very important roll in the entrainment of sediment into the harbor. It is also found that the small jetty attached at the top of secondary breakwater could effectively prevent the entrainment of sediment into the harbor.

• Journal of Navigation and Port Research
• /
• v.41 no.5
• /
• pp.345-352
• /
• 2017

Recently, a new port reserves deep water depth for safe navigation and mooring, following the trend of larger ship building. Larger port facilities include long and huge breakwaters, and mainly adopt vertical type considering low construction cost. A vertical breakwater creates stem waves combining inclined incident waves and reflected waves, and this causes maneuvering difficulty to the passing vessels, and erosion of shoreline with additional damages to berthing facilities. Thus, in this study, the researchers have investigated the response of stem waves at the vertical breakwater near the entrance channel and applied numerical models, which are commonly used for the analysis of wave response at the harbor design. The basic equation composing models here adopted both the linear parabolic approximation adding the nonlinear dispersion relationship and nonlinear parabolic approximation adding a linear dispersion relationship. To analyze the applicability of both models, the research compared the numerical results with the existing hydraulic model results. The gap of serial breakwaters and aligned angles caused more complicated stem wave generation and secondary stem wave was found through the breakwater gap. Those analyzed results should be applied to ship handling simulation studies at the approaching channels, along with the mooring test.

• Journal of Navigation and Port Research
• /
• v.34 no.9
• /
• pp.711-718
• /
• 2010

Redevelopment of the domestic small fishing ports is being started in earnest by applying the environmentally friendly technology in order to attract tourists. For the purpose of improving water quality in the harbor, selection of breakwater type might have the priority to secure calmness and stability. Therefore, this study is to determine the hydraulic characteristics of reflective ratio, installation efficiency and stability of the special type of blocks through the hydraulic model experiment. The results were introduced to analyze for the effect of infield construction work through numerical analysis. Gujora, a small fishing port in southern Korea, is affected by the waves of SSE, S, SSW direction and strong tidal currents. The results of applying cylindrical slit block show that stability of the blocks and harbor calmness were secured. Considering that the pass rate of a long period wave is still excellent, the primary objective of wave control and the secondary objective of improving water exchange are satisfied simultaneously.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.28 no.6
• /
• pp.408-415
• /
• 2016

Small fishing ports and coastal structures installed in a relatively low sea water depth disturb the wave induced current and cause the collapse of equilibrium state of sediment transport. These structures creates diffracted waves and matter the concentration of waves to cause the beach erosion. In order to mitigate these eroding problems on the beach, many counter measurements were proposed such as detached breakwater, groin or headland; however, these methods interrupt the aesthetic view of sandy beach due to the exposed structures above the sea level and have difficulty of applying to those beaches with the good scenery. Furthermore, some of these methods create secondary environmental problems after the installations. To eliminate these problems, one of the countermeasures, artificial reefs have been selected and used worldwide to minimize the disturbance of the scenery and secondary effects on the environment. Meanwhile, it is important to set the design elements for installing the artificial reefs such as that of length, opening width, clearing distances from the shoreline and more. Nevertheless, there are no construction manuals or standards for designing the artificial reefs with these important design elements yet. In this study, different conditions of artificial reefs were used with various cases throughout hydraulic model test to precisely analyze the changes of waves and currents to propose the standards of design elements to install the artificial reefs.