• Journal of Adhesion and Interface
• /
• v.24 no.1
• /
• pp.36-40
• /
• 2023

A van der Waals material refers to a material having a two-dimensional layered structure composed of van der Waals bonds with weak interlayer bonding. The research based on heterojunction structures using such van der Waals two-dimensional materials has been steadily studied since the discovery of graphene. Herein, this paper reports a van der Waals heterojunction -based field-effect transistor device based on monolayer single crystalline MoSe2 grown by atmospheric pressure chemical vapor deposition. We found that MoSe₂ grown under optimized process conditions did not have atomic-level defects and the transistor devices incorporating MoSe₂ also showed excellent characteristics.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.6
• /
• pp.252-259
• /
• 2005

Single crystal $CuGaSe_2$ layers were grown on thoroughly etched semi-insulating CaAs(100) substrate at $450^{\circ}C$ with hot wall epitaxy (HWE) system by evaporating $CuGaSe_2$ source at $610^{\circ}C$. The crystalline structure of the single crystal thin films was investigated by the photoluminescence (PL) and double crystal X-ray diffraction (DCXD). The carrier density and mobility of single crystal $CuGaSe_2$ thin films measured with Hall effect by Van der Pauw method are $4.87{\times}10^{17}cm^{-3}$ and $129cm^2/V{\cdot}s$ at 293 K, respectively. The temperature dependence of the energy band gap of the $CuGaSe_2$ obtained from the absorption spectra was well described by the Varshni's relation, $E_g(T)=1.7998eV-(8.7489{\times}10^{-4}eV/K)T^2/(T+335K)$. The voltage, current density of maxiumun power, fill factor, and conversion, efficiency of $n-CdS/p-CuGaSe_2$, heterojunction solar cells under $80mW/cm^2$ illumination were found to be 0.41 V, $21.8mA/cm^2$, 0.75 and 11.17%, respectively.

• Journal of Korean Medicine Rehabilitation
• /
• v.19 no.1
• /
• pp.201-211
• /
• 2009

Objectives : The purpose of this study is to evaluate the effect of Muscle Energy Technique(MET) on the Hamstring flexibility of healthy adults by comparing stretching exercise. Methods : The subjects were consisted of healthy adults(54 male, 42 female). All subject randomly assigned to the Control group, Stretching group, MET group. stretching group received hamstring stretching for 75 seconds and MET group received Hamstring MET for 75 seconds. Then subject did the sit and reach test at before treatment, right after treatment and after 10 minutes treatment. Results : 1. Result of sit and reach test according to measurement time changed, three groups were all improved and significant difference(p<0.01) was observed among three groups. 2. Compared to before treatment and right after treatment result, MET group was more significant improved(p<0.01) than stretching group. 3. Compared to before treatment and after 10 minutes result, MET group was more significant improved(p<0.01) than stretching group. Conclusions : According to above results, improvement of hamstring flexibility, MET was more effect than stretching exercise.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.381-381
• /
• 2010

From the photocurrent spectrum by illumination of perpendicular light on the c-axis of the ZnGa2Se4singlecrystalthinfilm, wehavefoundthatthevaluesofspinorbitsplitting$\Delta$soandthecrystalfieldsplitting$\Delta$crwere251. 9meVand 183.2me Vat 10K, respectively. FromthephotolwninescencemeasurementontheZnGa2Se4singlecrystalthinfilm,weobservedfreeexcition(EX)existingonlyhighqualitycrystalandneutralboundexiciton(A0,X)havingverystrongpeakintensity.Then,thefull-width-at-half-maximum(FWHM)andbindingenergyofueutralacceptorboundexcitionwerel1meVand24.4meV,respectivity.ByHaynesrule,an activation energy of impurity was 122 meV.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2005.05a
• /
• pp.181-181
• /
• 2005

• Current Photovoltaic Research
• /
• v.7 no.4
• /
• pp.103-110
• /
• 2019

Cu(In,Ga)₃Se₅ (β-CIGS) has a band gap of 1.35 eV, which is an optimum value for high solar-energy conversion efficiency. The effects of Cu and Ga content on the cell performance were investigated previously. However, the effect of Se content on the cell performance is not well understood yet. In this work, β-CIGS films were fabricated by three-stage co-evaporation of elemental sources with various Se fluxes at the third stage instead of at all stages. The average composition of five samples was Cu_1.05(In_0.59,Ga_0.41)3Se_y, where the stoichiometric y value is 5.03 and the stoichiometric Se/metal (Se/M) ratio is 1.24. We varied the Se/metal ratio in a range from 1.18 to 1.28. We found that the best efficiency was achieved when the Se/M ratio was 1.24, which is exactly the stoichiometric value where the CIGS grains on the CIGS surface were tightly connected and faceted. With the optimum Se/M ratio, we were able to enhance the cell efficiency of a β-CIGS solar cell from 9.6% to 12.0% by employing a Na₂S post deposition treatment. Our results indicate that Na₂S post deposition treatment is very effective to enhance the cell efficiency to a level on par with that in α-CIGS cell.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.10
• /
• pp.2273-2279
• /
• 2012

This research is based on fabricating Cu(In,Ga)$Se_2$ thin-film by co-evaporation method. On $1^{st}$ - stage, $In_2Se_3$ phase appeared when the substrate temperature reached to $400^{\circ}C$, however, there was small effect between the substrate temperature and absorbency spectrum on $2^{nd}$, $3^{rd}$ - stage because the average thickness of the thin-film was $1{\mu}m$ or higher. SEM and XRD was measured on $2^{nd}$ and $3^{rd}$ stage and it showed as the substrate temperature increases, the density of the crystal structure increased with the decreament of the vacancy. Furthermore, the formation of Cu(In0.7Ga0.3)$Se_2$ phase showed at $480^{\circ}C$ and $500^{\circ}C$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.11a
• /
• pp.76-77
• /
• 2005

Single crystal $CuAlSe_2$ layers were grown on thoroughly etched semi-insulating GaAs(100) substrate at 410$^{\circ}C$ with hot wall epitaxy (HWE) system by evaporating $CuAlSe_2$ source at $680^{\circ}C$. The crystalline structure of the single crystal thin films was investigated by the photoluminescence(PL) and double crystal X-ray diffraction (DCXO). The temperature dependence of the energy band gap of the $CuAlSe_2$ obtained from the absorpt ion spectra was wel1 described by the Varshni's relation, $E_g$(T) = 2.8382 eV - ($8.86\times10^{-4}$ eV/H)$T_2$/(T + 155K). After the as-grown single crystal $CuAlSe_2$ thin films were annealed in Cu-, Se-, and Al-atmospheres, the origin of point defects of single crystal $CuAlSe_2$ thin films has been investigated by PL at 10 K. The native defects of $V_{cd}$, $V_{se}$, $Cd_{int}$, and $Se_{int}$ obtained by PL measurements were classified as donors or acceptors. And we concluded that the heat-treatment in the Cu-atmosphere converted single crystal $CuAlSe_2$ thin films to an optical n-type. Also. we confirmed that hi in $CuAlSe_2$/GaAs did not form the native defects because Al in single crystal $CuAlSe_2$ thin films existed in the form of stable bonds.

• Proceedings of the IEEK Conference
• /
• 2004.08c
• /
• pp.787-791
• /
• 2004

We investigated field-effect ion-transport devices based on carbon nanotubes by using classical molecular dynamics simulations under applied external force fields, and we present model schematics that car be applied to the nanoscale data storage devices and unipolar ionic field-effect transistors. As the applied external force field is increased, potassium ions rapidly flow through the nanochannel. Under low external force fields, ther nal fluctuations of the nanochannels affect tunneling of the potassium ions whereas the effects of thermal fluctuations are negligible under high external force fields. Since the electric current conductivity increases when potassium ions are inserted into fullerenes or carbon nanotubes, the field effect due to the gate, which can modify the position of the potassium ions, changes the tunneling current between the drain and the source.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11b
• /
• pp.505-508
• /
• 2001

Currently there is much interested in removing latent charge that is caused to latent image effect and blurring of obtained image as well as reduction of x-ray conversion efficiency in digital radiography system. To remove latent charge a-Se film is irradiated by light with 3500 lux using halogen lamp and optical fiber. We measured dark current and photosensitivity to analyze removing effect of latent charge, then compared with and without light erasing method. The reduction of measured signal due to latent charge effect was 32.5 %, and the removal effect of latent charge by using light erase method was its 95.5 %.