• The Journal of the Acoustical Society of Korea
• /
• v.24 no.2
• /
• pp.97-102
• /
• 2005

Acoustic experiments were performed with Zostera marina to study the characteristics of backscattering of seagrass living in the bottom interface. Field experiments were conducted in the Dongdae man, Namhae for day and night to consider the effects of air-bubble from photosynthesis of seagrass. The multi-frequency (30$\~$120 kHz) responses were measured and the distributions of back scattering strength due to the movement of seagrass were Presented by PDF (probability density function) at 120 120 kHz. The results were shown both the frequency dependence and diurnal variation of the backscattering strength between day and night. This diurnal variation may be caused by the amount of oxygen in dissolved bubbles formed by Photosynthesis of seagrass.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.51 no.3
• /
• pp.405-413
• /
• 2015

Acoustic target strength (TS) measurement and theoretical acoustic scattering models were applied to estimate the TS for assessing the fish biomass. TS measurement was made of ex situ sailfin sandfish Arctoscopus japonicus at 70 and 120 kHz, and then compared to backscatter model prediction. The live sandfish was tethered in seawater using monofilament lines. Measurements were made versus incidence angle, $-50^{\circ}$ to $50^{\circ}$ relative to dorsal aspect directions. Distorted wave Born approximation (DWBA) model was used to calculated TS pattern. The TS values of sandfish (body length: 16.2 cm) at 70 and 120 kHz were -66.94 dB and -64.45 dB, respectively, and were about 20 dB lower than TS of other fishes in Korea waters. These TS levels were distributed within the range of the theoretical TS. Ex situ measurement and theoretical TS may be applied to improve acoustical detection and biomass estimation of the sandfish, and is necessary to measure with various lengths.

• Korean Journal of Materials Research
• /
• v.11 no.4
• /
• pp.312-318
• /
• 2001

The mechanical and electrical properties of Cu-Nb filamentary nanocomposite fabricated by the bundling and drawing process were examined. The strength increased gradually with increasing Nb content while the ductility was insensitive to Nb content. The ratio of yield stresses at 293K and 75K are found to be 치ose to that of Young's moduli in various Cu-Nb nanocomposites, suggesting that athermal obstacles primarily control the strength. The fracture morphologies show ductile fractures irrespective of Nb contents. Secondary cracking along the interfaces between subelemental wires was occasionally observed and the frequency of secondary cracking increased with increasing Nb content. The conductivity and the resistivity ratio decreased with increasing Nb content. The decrease of the conductivity and the resistivity ratio(${\rho}_{293k}$/$\{rho}_{75k}$) can be explained by the increasing contribution of interface scattering.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.43 no.5
• /
• pp.551-556
• /
• 2010

The large jellyfish Nemopilema nomurai causes serious damage to fisheries, particularly around the seas of Korea and Japan. Decreasing this damage requires knowledge of the distribution and abundance of jellyfish. Acoustic technology using quantitative echosounders is one method of studying the distribution and abundance of jellyfish. Such methods are commonly used worldwide because they have the advantage of providing substantial information about all water layers in a wide area in a short time. However, in order to conduct an acoustic survey, the acoustic characteristics of the target organism must be known. These can be altered by a number of factors, including pulsation, swimming angle, frequency and size. Accordingly, this study determined the variation in target strength according to pulsation of N. nomurai. Data were analyzed for two jellyfish with bell diameters in air of (a) was 32.0 and (b) 25.0 cm. The pulsation cycle of jellyfish (a) was 1.5~2.0 sec and the target strength (TS) cycle was 1.0~2.5 sec, while jellyfish (b) had a pulsation cycle of 1.0~1.5 sec and TS cycle of 1.0~3.0 sec. The variation width of the TS with the change in pulsation was 7.8 dB (-72.4~-64.6 dB) for jellyfish (a) and 10.3 dB (-71.6~-61.3 dB) for jellyfish (b). The variation in bell diameter was about 0.28 and 0.35, respectively. These results confirmed that the variation in bell diameter caused by pulsation is closely related to the variation in TS.

• Journal of Ocean Engineering and Technology
• /
• v.19 no.1 s.62
• /
• pp.64-70
• /
• 2005

Target Strength(TS) is an important factor for the detection of the target in an active sonar system: thus the numerical model for the prediction of TS is widely being developed. For the frequency range of several kHz, the most important scattering mechanism is known to be specular reflection, which is largely affected by the geometrical shape of the target. In this paper, a numerical algorithm to predict TS is developed based on the Kirchhoff approximation which is computationally efficient. The developed algorithm is applied to the canonical targets of simple shapes, for which the analytical solutions exist. The numerical results show good agreement with the analytical solutions. Also, the algorithm is applied to more complex scatterers, and is compared with the experimental data obtained in the water tank experiment for the purpose of verifying the developed numerical model. Discussions on the effect of spatial sampling and other aspects of numerical m odeling are presented.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.31 no.2
• /
• pp.142-152
• /
• 1995

The combined bottom trawl and hydroacoustic survey was conducted by using the training ship Oshoro Maru belong to Hokkaido University in November 1989-1992 and the training ship Nagasaki Maru belong to Nagasaki University in April 1994 in the East China Sea, respectively. The aim of the investigations was to collect the target strength data of fish school in relation to the biomass estimation of fish in the survey area. The hydroacoustic survey was performed by using the scientific echo sounder system operating at three frequencies of 25, 50 and 100kHz with a microcomputer-based echo integrator. Fish samples were collected by bottom trawling and during the trawl surveys, the openings of otter board and net mouth were measured. The target strength of fish school was estimated from the relationship between the volume back scattering strength for the depth strata of bottom trawling and the weight per unit volume of trawl catches. A portion of the trawl catches preserved in frozon condition on board, the target strength measurements for the defrosted samples of ten species were conducted in the laboratory tank, and the relationship between target strength and fish weight was examined. In order to investigate the effect of swimbladder on target strength, the volume of the swimbladder of white croaker, Argyrosomus argentatus, sampled by bottom trawling was measured by directly removing the gas in the swimbladder with a syringe on board. The results obtained can be summarized as follows: 1.The relationship between the mean volume back scattering strength (, dB) for the depth strata of trawl hauls and the weight(C, $kg/\textrm{m}^3$) per unit volume of trawl catches were expressed by the following equations : 25kHz : = - 29.8+10Log(C) 50kHz : = - 32.4+10Log(C) 100kHz : = - 31.7+10Log(C) The mean target strength estimates for three frequencies of 25, 50 and 100 kHz derived from these equations were -29.8dB/kg, -32.4dB/kg and -31.7dB/kg, respectively. 2. The relationship between target strength and body weight for the fish samples of ten species collected by trawl surveys were expressed by the following equations : 25kHz : TS = - 34.0+10Log($W^{\frac{2}{3}}$) 100kHz : TS = - 37.8+10Log($W^{\frac{2}{3}}$) The mean target strength estimates for two frequencies of 25 and 100 kHz derived from these equations were -34.0dB/kg, -37.8dB/kg, respectively. 3. The representative target strength values for demersal fish populations of the East China Sea at two frequencies of 25 and 100 kHz were estimated to be -31.4dB/kg, -33.8dB/kg, respectively. 4. The ratio of the equivalent radius of swimbladder to body length of white croaker was 0.089 and the volume of swimbladder was estimated to be approximately 10% of total body volume.

• The Journal of the Acoustical Society of Korea
• /
• v.31 no.3
• /
• pp.115-128
• /
• 2012

This paper investigates the effects of diffuser on the acoustical parameters in music hall with consideration of the result of scattering coefficient measurement. A scale model hall of 600 seats with orchestra shell was used for experiments. The materials of 1:50 scale model was chosen through absorption coefficient measurement based on ISO 354. The model was matched to the computer simulation model in terms of reverberation time. In order to evaluate the effect of diffuser location, the measurements were accomplished with and without diffusers according to 7 configurations by diffuser-installed region; sidewall, balcony front, ceiling and so on. The following acoustical parameters were extracted from each measurement case; Reverberation time (RT), Early decay time (EDT), Clarity (C80), Center time (Ts), Sound strength (G) and Temporal diffusion (TD) from the auto-correlation function (ACF) of impulse responses. As a result, the absorption power and diffusion power were increased with number of diffusers. Accordingly RT, EDT and G were decreased by diffuser and the redirection of reflections was occurred briskly. Averaged TD was 6.05 to 6.30 by measurement cases. RT was found to be the most related factor to diffusion power (R = 0.94). The correlation between TD and EDT was high (R = 0.73). In addition, the effects of diffuser-installed location were discussed in terms of acoustical parameter variation.

• Journal of Ocean Engineering and Technology
• /
• v.25 no.6
• /
• pp.49-55
• /
• 2011

In order to analyze feasibility of replacing a conventional 6-mm Ti bar with a 5-mm bar, a series of rotating bending fatigue tests were carried out on Ti-6Al-4V bars by strengthening the fatigue performance using a special technique called UNSM (Ultrasonic Nanocrystal Surface Modification). The results of S-N curves clearly showed that the performance of the 5-mm titanium specimen was similar to that of the 6-mm specimen when the UNSM treatment was applied. The 5-mm treated specimen converged with small scattering band into the linear line of the non-treated 6-mm one. Below the fatigue life of $10^5$ cycles, the UNSM treatment did not show any significant superiority in the bending stress and fatigue life. However, over the fatigue life of $10^5$ cycles, the effect of UNSM was superior for each fatigue life, and the bending stress became longer and higher than that of the untreated one. In the case of 6-mm Ti-bar with UNSM, the fatigue limit was about 592 MPa, and there was fatigue strength increase of about 30.7% at the fatigue life of $10^4$ cycles compared to the untreated 6-mm bar. Therefore, the compressive residual stress made by the UNSM in Ti-6Al-4V increased the fatigue strength by more than 30%.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.38 no.4 s.117
• /
• pp.17-23
• /
• 2006

Paper has fibers and fines network structure and it is strongly affected by interface bond-ing between fibers. Paper structural properties can be determined depending on the inter-fiber bonding. Fines play an important role in Campbell and consolidation effect through wet pressing and drying operations. The fines are essential for the formation of bonds between fibers and for the improvement of strength properties of papers. Since the fines are components of the pulp, there are always two factors to be considered: the quality and quantity of the fines. The quality of fines might be a potential variable to give a more accurate picture of the papermaking potential of the pulp. The object of this study is to investigate the effect of different types of pulp fines on the properties of paper and to access the potential of fines for controlling the bulk of paper. Refined Sw-BKP, Hw-BKP and BCTMP fines were used to investigate the fines effect. Wet-web strength, breaking length, scattering coefficient, and hydrodynamic specific volume, and drying shrinkage were measured. According to the results, chemical and morphological compositions of fines do not strongly affect to wet-web forming by their similar Campbell effect, but strongly affect to drying operation which forms hydrogen bonding among fiber-fines-fiber matrixes. Paper bulk should be controlled by the extent of hydrogen bonding between fibers during drying operation.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.47 no.5
• /
• pp.671-681
• /
• 2014

The distribution and abundance of coastal fish species in Asan Bay, Korea, were estimated from hydroacoustic survey and net catches. Acoustic data were collected with 38 and 200 kHz from July to October of 2012, and converted to the nautical area scattering coefficient (NASC, $m^2/mile^2$) for $0.25n{\cdot}mile$ along ten transects. Japanese anchovy Engraulis japonicus was the dominant specie in the net catches. The virtual echogram technique was used to distinguish E. japonicus from other species based on the differences in the mean volume backscattering strength (${\Delta}MVBS$) at 38 and 200 kHz. Engraulis japonicus and other fishes are mainly distributed in the center channel and outer part of Asan Bay. E. japonicus tends to move from inner to outer Asan Bay in summer and fall. From NASC data, the target strength and length-weight function of E. japonicus and other fishes were used to estimate the E. japonicus stock at 24.1-93.3 tons, and other fish at 40.6-88.4 tons from July to October 2012. The estimated anchovy biomass compared well with the cumulative catch weight from stow net catches. The hydroacoustic method offers an approach to understanding spatial/temporal structure and estimating the biomass of fish aggregations in coastal areas.