• Aerospace Engineering and Technology
• /
• v.13 no.2
• /
• pp.80-86
• /
• 2014

In this study, we the estimated surface normalized difference vegetation index by using the KOrea Multi-Purpose SATellite-3 (KOMPSAT-3) multi-spectral images for comparative analysis. The estimated NDVI from KOMPSAT-3 is used as for comparison with the high resolution GeoEye products. The geometry conditions for atmospheric effects are selected from meta files of KOMPSAT-3 bundle data. The used geometry conditions are consist of solar zenith angle, solar azimuth angle, viewing zenith angle, viewing azimuth angle, and date. And, Atmospheric effects such as attenuation, scattering and absorption were physically simulated from water vapor, ozone and aerosol information. Generally, although ground measurements are important for accurate information, in this study, MODIS atmospheric products are used as atmospheric constituents. The surface reflectance from radiative transfer model is utilized for estimating vegetation index. The present study, to reduce atmospheric and geometry conditions between KOMPSAT-3 and GeoEye having difference observation characteristics, data acquisition time is carefully determined for reliable vegetation spectral characteristics.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.6
• /
• pp.48-55
• /
• 2009

The feedback interference channels are those made through the multipaths that are built by moving and stationary objects around transmit and receive antennas mounted at the same point. This paper describes the method to measure the feedback interference channels in the rural regions and sides of highways and the analysis on channel characteristic parameters. Using the measured samples, we estimated scattering functions, delay power spectra, and Doppler power spectra, and we analyzed the channels using eight parameters including coherence bandwidth, coherence time, maximum excess delay, average excess delay, rms delay spread, Doppler shift, Doppler spread, and spread factor, and delay and Doppler cumulative distributions. Even though many observations are made, note that the feedback signals of high Doppler frequencies and large energy are observed in the sides of highways due to high speed vehicles while low Doppler frequencies occurred in the rural region due to rare traffic.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.2
• /
• pp.196-203
• /
• 2015

In order to apply cylindrical periodic array to phased array antenna or frequency selective surface, efficient electromagnetic analysis is required. Finite periodic array is applied in real situation. But, generally, assumed that periodic structure is arranged infinitely, approximate electromagnetic characteristics can be obtained efficiently. But, difference of characteristics between real structure and approximate structure occurs because finite periodic array is approximated to infinite periodic array. Therefore, comparison and analysis of cylindrical infinite array and finite array are required. In this paper, cylindrical infinite periodic array are analyzed using cylindrical Floquet harmonics. Also, cylindrical finite periodic array is analyzed using method of moments (MoM) with thin wire approximation because periodic structures which are composed of strip with narrow width are analyzed. Transmission characteristics and surface currents of infinite and finite periodic structures are compared.

• Journal of Korean Ophthalmic Optics Society
• /
• v.9 no.2
• /
• pp.291-299
• /
• 2004

DLC films were deposited using the ECR-PECVD method with the fixed deposition condition, such as ECR power, methane and hydrogen gas-flow rates and deposition time, for various substrate bias voltage. We have investigated the ion bombardment effect induced by the substrate bias voltage on films during the deposition of film. The characteristic of the films were analyzed using the FTIR, Raman, and UV/Vis spectroscopy analysis shows that the amount of dehydrogenation in films was increased with the increase of substrate bias voltage and films thickness was decreased. Raman scattering analysis shows that integrated intensity ratio(ID/IG) of the D and G peak was increased as the substrate bias voltage increased and films hardness was increased. Optical transmittances of DLC film were decreased with increasing deposition time and substrate bias voltage. From these results, it can be concluded that films deposited at this experimental have the enhanced characteristics of DLC because of the ion bombardment effect on films during the deposition of film.

• Journal of Microbiology and Biotechnology
• /
• v.15 no.6
• /
• pp.1250-1257
• /
• 2005

Two groups of exopolysaccharides (designated as Fr-I EPS and Fr-II EPS) were isolated from the culture filtrate of new fungal strain Trichoderma erinaceum DG-312 by Sepharose CL-6B chromatography. The structures of the exopolysaccharides were investigated using gas chromatography (GC), Fourier transform-infrared (FT-IR) spectroscopy, GCMS analysis, and NMR. GC analysis indicated that Fr-I EPS was composed of mainly mannose ($78.9\%$) and galactose ($21.1\%$), whereas Fr-II EPS contained mannose ($68.4\%$), galactose ($26.2\%$), and glucose ($5.4\%$). In the anomeric region ($950-700cm_{-1}$) of the FT-IR spectrum, both EPSs exhibited obvious characteristic absorption of $810\;cm_{-1}$, indicating the existence of mannose. The spectra of $\alpha-and\;\beta$-configurations were assigned at 880 and $914\;cm_{-1}$, respectively. The results of GC-MS analyses confirmed that both EPSs were complex heteropolysaccharides with a ($1{\rightarrow}3$)-linked mannan backbone. The C-1 region that appeared in the $^{13}C-NMR$ spectra of these EPSs indicated a typical anomeric carbon signal. The Fr-I EPS showed two anomeric carbon signals at 102.6 and 99.6 ppm, whereas the Fr-II EPS displayed four anomeric carbon signals at 102.5, 99.6, 98.5, and 94.3 ppm. The molecular characteristics of the EPSs were further investigated using a size exclusion chromatography/multi-angle laser light scattering (SEC/MALLS) system. The SEC/MALLS system revealed that the average molar masses of the EPSs were $6.592{\times}10^{4}$ (Fr-I EPS) and $1.920{\times}10^{4}$ (Fr-II EPS) g/mol, and the molecular conformation of both EPSs in aqueous solution was random coils.

• Journal of Korean Society for Atmospheric Environment
• /
• v.12 no.3
• /
• pp.323-332
• /
• 1996

Precipitation samples were collected by the wet-only sampling method at Seoul from September 1993 to June 1995. Sample were analysed for the anions $(NO_3^-, NO_2^-, SO_4^{2-}, Cl^-, and F^-)$ and cations $(Na^+, K^+, Ca^{2+}, Mg^{2+}, and NH_4^+)$ in addition to pH and electric conductivity. In order to establish the chemical analysis data of high quality, the assurance checks for analytical data of precipitation were performed by considering the ion balance and by comparing the measured conductivity with the calculated conductivity. As we applied the various assurance checking methods by the ion balance used until recently to a data set measured in this study, the f value expressed as $\Sigma C/\Sigma A$ was found to be not appropriate for the data screening. Also, the scattering plot between cations and anions in each sample was found to show the general tendency of ion balance but was proved to not quantitate the standard of data screening at a data set of samples of various concentration levels. The h value defined as (A-C)/C for C $\geq$ A and (A-C)/A for C < A was used to check the ion balance. However, the standard of data screening by h value must very in response to total ion concentration of samples. In this study, the quality assurance of chemical analysis data was checked by considering both the ion balance of evaluating by h value and the conductivity balance. Further the quality control was achieved by these quality assurance methods. As the result, 67 samples among total 77 were obtained as valid. As the central tendency value for a statistical summary in the analytical parametr of samples, the volume-weighted mean value was found to represent more the general chemistry of precipitation rather than the arithmetic mean. The volume-weighted mean pH was 5.0 and 25% of samples was less than this mean. The concentrations of sufate and nitrate in precipitation were 90.4 ueq/L and 32.4 ueq/L which made up 59% and 21% of all anions. The raion of $SO_4^{2-}/(NO_3^- + NO_2^-)$ in precipitation was 2.7, which indicates that the contributions of $H_2SO_4$ and $HNO_3$ to the acidity of precipitation are 70% and 30%, respectively.

• Transactions of Materials Processing
• /
• v.29 no.3
• /
• pp.163-171
• /
• 2020

We present a multi-step cold drawing for a non-equiatomic Co₁₀Cr₁₅Fe₂₅Mn₁₀Ni₃₀V₁₀ high entropy alloy (HEA) with a simple face-centered cubic (FCC) crystal structure. The distribution of strain in the cold-drawn Co₁₀Cr₁₅Fe₂₅Mn₁₀Ni₃₀V₁₀ HEA wires was analyzed by the finite element method (FEM). The effective strain was expected to be higher as it was closer to the surface of the wire. However, the reverse shear strain acted to cause a transition in the shear strain behavior. The critical effective strain at which the shear strain transition behavior is completely shifted was predicted to be 4.75. Severely cold-drawn Co₁₀Cr₁₅Fe₂₅Mn₁₀Ni₃₀V₁₀ HEA wires up to 96% of the maximum cross-sectional reduction ratio were successfully manufactured without breakage. With the assistance of electron back-scattering diffraction and transmission electron microscope analyses, the abundant deformation twins were found in the region of high effective strain, which is a major strengthening mechanism for the cold-drawn Co₁₀Cr₁₅Fe₂₅Mn₁₀Ni₃₀V₁₀ HEA wire.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.42 no.11
• /
• pp.958-967
• /
• 2014

A hybrid method based on high-frequency asymptotic optics was developed in order to predict the RCS of flying vehicles for RCS reduction studies. In cavity return, the rays are assumed to bounce from the inlet cavity based on the laws of geometrical optics and to exit the cavity via the aperture. In other parts of a flying vehicle, the physical optics method is applied to compute the back-scattered field from the solid surface. The hybrid method was validated by considering simple models of sphere and sphere with cavity. In addition, RCS analysis of a flying vehicle was conducted using the new hybrid electromagnetic scattering method based on physical optics and geometrical optics theories.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.10
• /
• pp.123-129
• /
• 1996

LDD structure is widely accepted in fabricating short channel MOSFETs due to reduced short channel effect originated form lower drain edge electric field. However, modeling of the LDD device is troublesome because the analysis methods of LDD region known are either too complicated or inaccurate. To solve the problem, this paper presents a nonlinear resistance model for the LDD region based on teh fact that the electron mobility changes with positive gate bias because accumulation layer of electrons is formed at the surface of the LDD region. To prove the usefulness of the model, single source/drain and LDD nMOSFETs were fabricated with 0.35$\mu$m CMOS technolgoy. For the fabricated devices we have measured I$_{ds}$-V$_{gs}$ characteristics and compare them to the modeling resutls. First of all, we calculated channel and LDD region mobility from I$_{ds}$-V$_{gs}$ characteristics of 1050$\AA$ sidewall, 5$\mu$m channel length LDD NMOSFET. Then we MOSFET and found good agreement with experiments. Next, we use calculated channel and LDD region mobility to model I$_{ds}$-V$_{gs}$ characteristics of LDD mMOSFET with 1400 and 1750$\AA$ sidewall and 5$\mu$m channel length and obtained good agreement with experiment. The single source/drain device characteristic modeling results indicates that the cahnnel mobility obtained form our model in LDD device is accurate. In the meantime, we found that the LDD region mobility is governed by phonon and surface roughness scattering from electric field dependence of the mobility. The proposed model is useful in device and circuit simulation because it can model LDD device successfully even though it is mathematically simple.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.48 no.3
• /
• pp.60-66
• /
• 2011

The$PM_{10}$ concentrations in the underground should be monitored for the health of commuters on the subway system. Seoul Metro and Seoul Metropolitan Rapid Transit Corporation are measuring several air pollutants regularly. In this paper, the reliability of the instruments using light scattering method is improved with the help of a linear regression analysis technique to measure the $PM_{10}$ concentrations continuously in the subway stations. In addition, an USN monitoring system is implemented to display and record the data of $PM_{10}$, CO/$CO_2$, humidity, and temperature. To transmit and receive these measured sensor data, 2.4GHz Zigbee, 424MHz wireless communication, and CDMA M2M method are applied and evaluated.