• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.31 no.4
• /
• pp.251-257
• /
• 2013

Bathymetry sounding or water depth measurement is becoming more and more sophisticated with the increasing demand in accuracy, resolution and coverage in the recent years. Single beam echo sounding is still utilized to gather single line bathymetric profile in many surveys as ever, although there is an increasing demand for multi-beam echo sounding. Single beam echo sounder system acquires single line profiles of water depth as the vessel travel along the survey line. In this study, we performed single beam echo sounding with GNSS receiver for hydrographic survey at Namgang dam basin to calculate pure sediment. Unlike traditional research, we used not field reference station but NTRIP service of the reference station of DGNSS(Differential Global Navigation Satellite System) Central Office in this GNSS survey. The calculation results show that scouring volume is $603,650m^3$, sediment volume is $3,913,750m^3$ and so pure sediment volume is $3,310,100m^3$ at Namgang dam basin. And the availability of the NTRIP service of the DGNSS Central Office for echo sounding in land area has been confirmed in this study.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.38 no.1
• /
• pp.43-48
• /
• 2020

Open pit mines for limestone mining require rapid development of technologies and efforts to prevent safety accidents due to rapid deterioration of the slope due to deforestation and rapid changes in the topography. Accurate three-dimensional spatial information on the terrain should be the basis for reducing environmental degradation and safe development of open pit mines. Therefore, this study constructed spatial information about open pit mine using UAV(Unmanned Aerial Vehicle) and analyzed its utility. images and 3D laser scan data were acquired using UAV, and digital surface model, digital elevation model and ortho image were generated through data processing. DSM(Digital Surface Model) and ortho image were constructed using image obtained from UAV. Trees were removed using 3D laser scan data and numerical elevation models were produced. As a result of the accuracy analysis compared with the check points, the accuracy of the digital surface model and the digital elevation model was about 11cm and 8cm, respectively. The use of three-dimensional geospatial information in the mineral resource development field will greatly contribute to effective mine management and prevention of safety accidents.

• The Korean Journal of Air & Space Law and Policy
• /
• v.26 no.1
• /
• pp.241-269
• /
• 2011

Solar flare and storm may give an adverse effect upon electromagnetic environment around the Earth, so that various kinds of satellite cease to normally function. This kind of space storm disaster is characterized by the uncertainty about when and what size. Recently the UN has been paying attention to this plausible disaster. Particularly the COPUOS has taken the view that this disaster would threaten the sustainable space environment. The precautionary principle, rooted and excercised in the environment protection filed, has been adopted in the case of disaster with uncertainty. The reports and opinions given by the expert and representatives of the member States have stated that the precautionary principle should be adopted for the purpose of dealing with this disaster. On the other hand, it is advanced that the principle has been already included in the space law principle enshrined in the 1967 Space Treaty. The Treaty has adopted the freedom of navigation and use of the outer space for the interest of all States as the basic principles. Sustainable environment is necessary for implementing the principle. Therefore, the rules for the protection of sustainable space environment should be based upon the space law principle.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.36 no.4
• /
• pp.223-233
• /
• 2018

In this study was classified the cadastral control points and parcel boundary points into 40m, 100m by flight altitude of UAV (Unmanned Aerial Vehicle) which compared the coordinates extracted from the orthophoto with the parcel boundary point coordinates by GNSS (Global Navigation Satellite System) ground survey. As a results of this study, first, in the spatial resolution analysis that the average error of the orthoimage by flight altitude were 0.024m at 40m, and 0.034m at 100m which were higher 40m than 100m for spatial resolution of orthophotos and position accuracy. Second, in order to analyze the accuracy of image recognition by airmark of flight altitude that was divided into three cases of nothing, green, and red of RMSE (Root Mean Square Error) were X=0.039m, Y=0.019m and Z=0.055m, the highest accuracy. Third, the result of the comparison between orthophotos and field survey results that showed the total RMSE error of the cadastral control points were X=0.029m, Y=0.028m, H=0.051m, and the parcel boundary points were X=0.041m, Y=0.030m. In conclusion, based on the results of this study, it is expected that if the average error of flight altitude is limited to less than 0.05m in the legal regulations related to orthophotos for cadastral surveying, it will be an economical and efficient method for cadastral survey as well as spatial information acquisition.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.38 no.3
• /
• pp.259-267
• /
• 2020

For real-time precise positioning, N-RTK (Network Real-Time Kinematic) technology is widely used these days. However, the currently operating N-RTK system has a limitation in terms of the number of users. Therefore, if reference points generate correction messages with no limit on the number of users are developed later, it is determined that an appropriate reference point installation interval is required, so that the accuracy of the N-RTK system according to the baseline distance was analyzed. This experiment utilized receivers with varying performance that estimated the rover position, and RTKLIB, an open-source software, is used for processing data. As a result, the rover position was estimated accurately with a high rate of fixed ambiguity for all the receivers. When the reference station with a baseline length of 40 km was used, the vertical RMSE (Root Mean Squared Error) was quite similar to the short baseline case, but only half of the ambiguity fixing rate was achieved. The outlier in the estimated rover position was not observed for the longer baselines in the case of a high-end receiver. It is necessary to analyze the ambiguity fixing and the accuracy of the kinematic positioning with scientific GNSS processing software.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.1C
• /
• pp.86-93
• /
• 2008

The Galileo system, a global navigation satellite system(GNSS) developed by E.U., uses the direct sequence/spread spectrum(DS/SS) modulation. A DS/SS-based system performs a fine synchronization between the received and locally generated spreading signals, via attacking process. In the absence of multipath signals, using the symmetric characteristic of the correlation function, the delay lock loop with the early minus late discriminator(EL-DLL) offers the best performance in tracking. However, in the presence of multipath signals, the symmetry of the correlation function could be lost, causing a tracking bias. In this paper, we observe that the correlation values in the advanced offset range remain almost unchanged, due to the multipath signals being received later than a line-of-sight signal. Based on this observation, we propose a novel tracking scheme for a Galileo BOC(1,1) system.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.44 no.9
• /
• pp.781-788
• /
• 2016

In this paper, a real-time on-board orbit determination algorithm using the high precise orbit propagator is suggested and its performance is analyzed. Orbit determination algorithm is designed with the Extended Kalman Filter. And it utilizes the orbit calculated from the Pseudo-range as observed data. The performance of the on-board orbit determination method implemented in the GPS-12 receiver is demonstrated using the GNSS simulator. Orbit determination performance using high precise orbit propagator was analyzed in comparison to the orbit determination result using $J_2$ orbit propagator. The analysis result showed that position and velocity error are improved from 43.61 m($3{\sigma}$) to 23.86 m($3{\sigma}$) and from 0.159 m/s($3{\sigma}$) to 0.044 m/s($3{\sigma}$) respectively.

• Journal of Information Management
• /
• v.41 no.4
• /
• pp.187-204
• /
• 2010

This study shows evaluation of how much OASIS meets "the korean web content accessibility guidelines" and analysis of some of the accessibility problems and their solutions in OASIS(Oriental Medicine Advanced Searching Integrated System) which is the only web site that offers papers and project information related to Traditional Medicine in Korea. The evaluation criteria to determine if OASIS is accessible is classified into four sub items; Perceivable - if information and user interface components is presentable to users in ways they can perceive, Operable - if user interface components and navigation are operable, Understandable - if information and the operation of user interface are understandable, Robust - if content is robust enough that it can be interpreted reliably by a wide variety of user agents, including assistive technologies. Based on the measured results, OASIS has just been redesigned and implemented in more accessible and effective way. OASIS that improves web accessibility for the disabled is expected to help them study oriental medicine more easily and conveniently by providing equal access and equal opportunity to use the web.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.18 no.1
• /
• pp.64-73
• /
• 2015

Recently, the integrated utilization of technology with IT is in demand for the effectiveness of field management together with the prevention and prompt action on safety accident at construction site. In addition, the establishment of construction site support system is necessary to implement the securing of worker's safety, smooth work instruction, efficiency in construction, and others. Data standardization and network architecture were designed regarding data and sound information for data transmission between systems and management. These were to construct USFSS based on integrated VI-GNSS technology in this research. In the stability test of data for each system constructed through it, around 98% stability was secured between workers and for transfer vehicle system within underground structure and field server system in regards to the data transmission stability, around 100% stability was secured between field server system and control system, respectively. Also, in the sound transmission stability test, around 99% reliability could be secured with 1km distance as its standard in case of sound transmission from underground structure construction site to field office near the field through wireless FRS system.

• Korean Journal of Remote Sensing
• /
• v.37 no.5_3
• /
• pp.1425-1434
• /
• 2021

Continuous and periodic data acquisition must be preceded to maintain and manage the river facilities effectively. Adapting the existing general facilities methods, which include river surveying methods such as terrestrial laser scanners, total stations, and Global Navigation Satellite System (GNSS), has limitation in terms of its costs, manpower, and times to acquire spatial information since the river facilities are distributed across the wide and long area. On the other hand, the Mobile Mapping System (MMS) has comparative advantage in acquiring the data of river facilities since it constructs three-dimensional spatial information while moving. By using the MMS, 184,646,009 points could be attained for Anyang stream with a length of 4 kilometers only in 20 minutes. Levee points were divided at intervals of 10 meters so that about 378 levee cross sections were generated. In addition, the waterside maximum and average slope could be automatically calculated by separating slope plane form levee point cloud, and the accuracy of RMSE was confirmed by comparing with manually calculated slope. The reference slope was calculated manually by plotting point cloud of levee slope plane and selecting two points that use location information when calculating the slope. Also, as a result of comparing the water side slope with slope standard in basic river plan for Anyang stream, it is confirmed that inspecting the river facilities with the MMS point cloud is highly recommended than the existing river survey.