• Journal of the Korean GEO-environmental Society
• /
• v.18 no.10
• /
• pp.23-34
• /
• 2017

As the electrical property of fully saturated soils is dependent on the pore water, it has been commonly used for the detection of the contamination into the ground. The objective of this study is to investigate the electrical characteristics according to the salinity and the lead concentration in fully saturated soils. Fresh water and saline water with the salinity of 1%, 2% and 3%, which are mixed with 6 different lead solutions with the range of 0~10 mg/L, are prepared in the cylindrical cell incorporated with sensors for measuring electrical resistance and time domain reflectometry signal. Then, the dried sands are water-pluviated into the cell. The electrical resistance and the time domain reflectometry signal are used to estimate the electrical conductivity. Test results show that electrical conductivity determined from electrical resistance at the frequency of 1 kHz continuously increases with an increase in the lead concentration, thus it may be used for the estimation of the contaminant level. In addition, the electrical conductivity estimated by the time domain reflectometry changes even at very low concentration of lead, the variation rate decreases as the lead concentration increases. Thus, the time domain reflectometry can be used for the investigation of the heavy metal leakage. This study demonstrates that complementary characteristics of electrical resistance and time domain reflectometry may be used for the detection of the leakage and contamination of heavy metal in coastal and marine environments.

• Journal of the Korean GEO-environmental Society
• /
• v.18 no.3
• /
• pp.5-14
• /
• 2017

Experimental study on strength characteristics of frozen soils is necessary for the safety evaluation of design and construction in cold region. The objective of this study is to evaluate the direct shear strength of frozen soils obtained from traditional system (Type-1), system with roller on the upper shear box (Type-2), and system with fixed upper shear box separated from bottom shear box (Type-3). Specimens mixed with sand, silt, and water are frozen to $-5^{\circ}C$, and then direct shear tests are conducted under the normal stress of 5, 10, 25, and 50 kPa. Experimental results show that the upper shear box of Type-1 touches the bottom shear box due to the rotation of the upper shear box. The shear strength obtained from Type-2 is overestimated because the preventing rotation force is added to shear force. Type-3 may acquire the only strength of the specimen, and shear strain at peak shear strength is similar to that at the beginning of vertical displacement occurrence. In addition, internal friction angle and cohesion at both peak and residual stresses in Type-3 are smaller than those of Type-2. This study shows that high strength specimens including frozen soils can be effectively evaluated using improved shear box system such as Type-3.

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.8 no.1
• /
• pp.69-78
• /
• 2013

Settled lifestyle as important to health and healing to medical tourism and wellness tourism in the 21st century has emerged as the best promising service industry. Jeju Island has a variety of local resources, and the directions was considered to spa industry promotion application it. Jeju Island has a variety of local resources which can be used for spa industry promotion. Jeju Island's beautiful natural environment, mineral resources, water resources, biological resources, agricultural products, traditional folk remedies available in Jeju's spa treatments. Using the local resources of Jeju, 'Jeju specialized spa treatments' can develop of 12 kinds of spa treatments. Namely, thalssotherapy, stone therapy, black sand poultice, hot-floored therapy using volcanic soil, thalassotherapy, drinking therapy, hydrotherapy, herbal/medicinal plants poultice, forest therapy, Spa cuisine, facial beauty, diet therapy. 12 kinds of Jeju specialized spa treatments development and service to the local resources of basic research on the physical and chemical characteristics, product development, clinical trials, efficacy studies should precede. In addition, customized spa services programs should be developed considering the propensity of customers, customer needs, and a spa type. And standardized program of spa services and need a manual painter. Medical tourism and wellness tourism in conjunction with efforts to be considered in order to increase the competitiveness of the spa industry in Jeju.

• Journal of environmental and Sanitary engineering
• /
• v.5 no.1
• /
• pp.1.1-14
• /
• 1990

This study was conducted to investigate the contents of heavy metals in soils of the Kumho river basin, by analyzing soils according to the distance from edge of the river and to the soil layers. The contents of heavy metals in soils showed highly in its downstream. Namely there was shown a remarkably high contents of these heavy metals in the Kum-ho bridge areas where Kongdan stream joins Dalseo stream, such as 39.52ppm for zinc, 35.92ppm for copper, 97.90ppm for iron, 102.45ppm for manganese, 13.92ppm for lead, respectively, and 0.48ppm for cadmium. However, the heavy metals contents in soils around Kangchang bridge tended to gradually decrease in its contents, probably because its main soils consisting of sand. Based on their soil layers, the average contents of these heavy metals in the surface soils were higher than one of the subsurface soil. Its contents according to the distance from the river edge indicated some difference every individual area. Nevertheless, its contents showed lower contents in the area far away from the edge. And its contents tended to again increase in the outside bank. In addition, a remarkable positive correlation is shorten between individual heavy metals, except correlation between iron and lead. Also cadmium just shows reverses correlation in the statistics. With respect to comparison between soil layers, there was a remarkable positive correlation between surface layers and subsurface layers. Considering the above results, it seems that the pollution of river bed's soil is in proportion to it of stream.

• Journal of Soil and Groundwater Environment
• /
• v.17 no.2
• /
• pp.15-21
• /
• 2012

MTBE (Methyl tertiary-butyl ether) has been commonly used as an octane enhancer to replace tetraethyl lead in gasoline, because MTBE increases the efficiency of combustion and decreases the emission of carbon monoxide. However, MTBE has been found in groundwater from the fuel spills and leaks in the UST (Underground Storage Tank). Fenton's oxidation, an advanced oxidation catalyzed with ferrous iron, is successful in removing MTBE in groundwater. However, Fenton's oxidation requires the continuous addition of dissolved $Fe^{2+}$. Zero-valent iron is available as a source of catalytic ferrous iron of MFO (Modified Fenton's Oxidation) and has been studied for use in PRBs (Permeable Reactive Barriers) as a reactive material. Therefore, this study investigated the condition of optimization in MFO-PRBs using waste zero-valent iron (ZVI) with the waste steel scrap to treat MTBE contaminated groundwater. Batch tests were examined to find optimal molar ratio of MTBE : $H_2O_2$ on extent to degradation of MTBE in groundwater at pH 7 with 10% waste ZVI. As the results, the ratio of optimization of MTBE to hydrogen peroxide for MFO was determined to be 1:300[mM]. The column experiment was conducted to know applicability of MFO-PRBs for MTBE remediation in groundwater. As the results of column test, MTBE was removed 87% of the initial concentration during 120days of operational period. Interestingly, MTBE was degraded not only within waste ZVI column but also within sand column. It means the aquifer may affect continuously the MTBE contaminated groundwater after throughout the waste ZVI barrier. The residual products showed acetone, TBF (Tert-butyl formate) and TBA (Tert-butyl acetate) during this test. The results of the present study showed that the recycled materials can be effectively used for not only a source of catalytic ferrous iron but also a reactive material of the MFO-PRBs to remove MTBE in groundwater.

• Journal of Sericultural and Entomological Science
• /
• v.27 no.1
• /
• pp.12-17
• /
• 1985

soil survey and chemical analysis on mulberry nursery garden were carried out to study the causes of the non-sprouting phenomenon occured seriously in Buy and Ogchun in 1983 and Sangju in 1984. In addition, 115 nursery garden soils taken from 21 sapling produsers in Chungbuk province were analyzed in 1984. The results were as follows, 1. Symptom of dead saplings was the highest in boron deficiency by 59% and the lowest in rot symptom. The rest of saplings by 34.9% were not detected any symptom. 2. The nursery gardens showen non-sprouting phonomenon were located along the stream. As the result, soil depth was shallow, around 20cm deep and subsoil composed with coarse sand and gravels. 3. Nursery soils were mostly strong acid, low in Ca and Mg content, especially B, whereas available phosphorus and potassium were abundant at some gardens, and deficient at others. 4. Application of red earth or borax to nursery garden, especially to paddy, increased sprouting rate. 5. Paddy nursery garden occupied by 52.8% of 60.8ha of total garden area in Chungbuk province. Ninty point five percent of the nursery garden was lower in pH than 6.5, 87.0% lower in K than 0.5me/100g, 40.8% lower in Ca than 6.5me/100g, 94.8% lower in Mg the 2.00me/100g 99.1% lower in B than 0.3ppm.

• Journal of Wetlands Research
• /
• v.13 no.3
• /
• pp.603-611
• /
• 2011

In order to enhance cutting efficiency of reed culms, we had assessed diverse methodology in cutting and applied better conditions among them into three vigorous eco-types of common reed. From the results, differences in a eco-type, a sampling area in reed population and substrata affected the shoot emergence slightly. On the other hand, differences in a type of burying culms and a burying part among whole culm affected shoot emergence strongly. Our results suggest that not only methodological condition but also appropriate kind of eco-types must be considered in using reed culms for better cutting. In addition that, sampling timing according to the geological and climatic condition of certain area should be considered for better cutting efficiency as well. We also recommend that the sampling area such as expanding area in a population, burying a middle part of the culm, substratum such as well-ventilated sand and vertical burying method for better cutting efficiency. Lastly, for more enhancement of cutting efficiency of reed culms, potential damages by blight and harmful insects such like aphids should be concerned very carefully.

• Korean Journal of Environmental Agriculture
• /
• v.25 no.4
• /
• pp.331-338
• /
• 2006

Coal combustion fly ash, which has a high available Si content and alkaline pH, was selected as a potential source of soil amendment in this study. Two field experiments were carried out to evaluate the possibility of heavy metal accumulation in silt loam (Pyeongtaeg series) and loamy sand (Nagdong series) of rice (Oryza sativa) paddy soils to which 0, 40, 80, and $120Mg\;ha^{-1}$ of fly ash were added. Rice yields increased significantly with fly ash application and the highest rice yields were achieved following the addition of around $90Mg\;ha^{-1}$ fly ash. Fly ash increased the soil pH but did not increase heavy metal uptakes of rice and heavy metal concentration in soils, due to very low concentration of heavy metals in the selected fly ash. Labile fraction of heavy metals (exchangeable + acidic fraction) was scarcely contained and most of them were stable and unavailable form (oxidizable and residual fraction). In conclusion fly ash could be a good supplement to an inorganic soil amendments without heavy metal contamination in paddy soils.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.10
• /
• pp.128-135
• /
• 2018

Currently, vertical closed ground heat exchangers are the most widely utilized geothermal heat pump systems and the major influencing parameters on the performance of ground heat exchangers are the ground thermal conductivity(k) and borehole thermal resistance($R_b$). In this study, the borehole thermal resistance was calculated from the in-situ thermal response test data and the individual effects of design parameters (flow rate, number of pipe, grout composition) on the borehole thermal resistance were analyzed. The grout thermal resistance was also compared with the correlations in the literatures. The borehole thermal resistance of the investigated ground heat exchanger results in 0.1303 W/m.K and the grout thermal resistance (66.6% of borehole thermal resistance) is the most influencing parameter on borehole heat transfer compared to the other design parameters (pipe thermal resistance, 31.5% and convective thermal resistance, 1.9%). In addition, increasing the thermal conductivity of grout by adding silica sand to Bentonite is more effective than the other design improvements, such as an increase in circulating flowrate or number of tubes on enhancing borehole heat transfer.

• The Korean Journal of Quaternary Research
• /
• v.21 no.1
• /
• pp.1-14
• /
• 2007

In this study we experiment on sand deposits (tine aggregates) taken from the old river-bed of the Bonghwang-cheon of Geum River Basin, and evaluate physical properties of fine aggregates in comparison to the KS quality regulation. As a result of experimentation, particle size of fine aggregates is generally smaller in the downstream area than in the upstream area. In addition, physical properties of the fine aggregates tend to depend on the bedrock type. Physical properties of fine aggregates show a strong positive correlation with particle size of old river-bed sediments. Finally, the general physical properties of fine aggregates are conformable to the KS quality regulation, except density and proportion of materials finer than $75{\mu}m$.