• Journal of Korean Society of Forest Science
• /
• v.43 no.1
• /
• pp.51-55
• /
• 1979

This study discribes about method of establishing stem taper table of Korean white pine through the preparation of the stem with the sample trees of 280 felled Korean white pine. Stem curves were first classified then induced by form quotient class, stem curve equation according to Behre's stem curve formular. Relied on each calculated stem curve equation tapering degree by form quotient class and established taper table therefore.

• Journal of Chest Surgery
• /
• v.17 no.1
• /
• pp.157-166
• /
• 1984

These biologic test procedures are designed to test the suitability of P.V.C. made in Korea intended for parenteral preparation, which were based on the U.S. Pharmacopeia XIX "Biologic Test-Plastic Container", Official from July 1, 1975. Healthy adult human blood and rabbits weighing 2\ulcorner.2Kg were used for test materials. Sample P.V.C. were sampled from the medical equipments made in Korea randomly and Control P.V.C. were sampled from the standardized Cobe and Polystan P.V.C. tubes. P.V.C. extract was prepared from a homogeneous P.V.C. samples by incubating 60 square centimeters of the sample per 20 millimeters of sterile pyrogen-free saline at 70\ulcorner for 72 hours or autoclaving at 120\ulcorner for 1 hour. The Implantation Test was designed to evaluate the reaction of living tissue to the plastic by the method of the implantation of the Sample itself into animal tissue. The Systemic Injection Test, the Intracutaneous Test, and the remainders were designed to determine the biological response of animals to plastics by the single-dose injection of specific extracts prepared from a Sample. The results are as follows; 1.Implantation Test - No significant difference for reactions was noted between the Sample treated animal and the Control after 72 hours of implantation. 2.Systemic Toxicity Injection Test - No sign of toxicity and/or death immediately after injection and at 4, 24, 48 hours respectfully after injection. 3.Intracutaneous Test - None of the animals treated with the Sample showed a significantly greater reaction than the observed in the animals treated with Blank. 4.Pyrogen Assay-Only one animal treated with the Sample showed the maximal rise of rectal temperature about 0.2\ulcorner after 3 hours of injection, but remainders showed no change. 5.Hemolytic Index - The positive Control tube of distilled water exhibited complete hemolysis while the negative Control tube and P.V.C. extract were negative demonstrating no hemolysis. 6.Cell Morphology of Erythrocytes and Leukocytes on Stored, Heparinized Human Blood -- There was no significant difference in the morphology of either the Control or Sample extract. 7.Clotting Mechanism of Human Blood in vitro - After allowing to the P.V.C. extract at room temperature for 5 Hours and at 10\ulcorner for 24 hours, there was no appreciable difference in Prothrombin Time under these conditions. 8.Clotting Mechanism of Rabbit in vivo - At the termination of 5 days after intraperitoneal injection of the P.V.C. extract, no significant changes in Clotting Time were observed. According to the above results, it could be concluded that the P.V.C. made in Korea was acceptable for parenteral preparation, especially treated with physiologic saline and/or human blood.man blood.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.38 no.1
• /
• pp.33-41
• /
• 2012

An effective, environmentally friendly analytic methods using gas chromatography with mass spectrometric detector (GC-MSD) have been developed for the quantitative analysis of trace phthalate levels in cosmetics such as nail lacquer and hair spray. Since such cosmetics are largely comprised of organic solvents, conventional clean-up methods that have been widely used for phthalate analyses are in adequate. In addition, analysis of trace phthalate levels is notorious for its sensitivity to contamination, which causes high analytical values. A direct sample dilution method using an organic solvent was adopted to the sample preparation process to determine the exact amounts of phthalates and simultaneously avoid the high risk of secondary contamination. The method has many advantages including high accuracy, sensitivity, and simplicity in sample preparation. Dibutyl phthalate (DBP) and di (2-ethylhexyl) phthalate (DEHP) were selected for analysis because they have been frequently detected in cosmetics and consistently reported as endocrine disruptors in humans and animals. Internal standard method using two deuterium substitutes (DBP-$d_4$, DEHP-$d_4$) as the internal standard was also used. The results of 'Method validation' showed the capabilities of this method for the routine analysis of phthalates at the ppm level. The recovery ranges were between 95 % and 106.1 %, and relative standards deviations (RSD) were less than 3.9 % in fortified nail lacquer and hair spray samples at the concentration of $25{\mu}g/g$.

• Journal of the Korean Ceramic Society
• /
• v.31 no.1
• /
• pp.55-61
• /
• 1994

Mn-Zn ferrite powder was obtained by wet method that was to be coprecipitated the metal ions of Fe2+, Mn2+ and Zn2+ with alkali solution. The target composition of the ferrite powder was 52 mol% Fe2O3, 24 mol% MnO, and 24 mol% ZnO, that was based on the region of high permeability. And the other ferrite powder was prepared by the dry method that was to be mixed the metal oxides as the above chemical composition. The wet method was compared with dry method for the powder properties and the electromagnetic characteristics of sintered cores. The synthesized powder by wet method was smaller particle size, narrower particle distribution, and higher purity than that of dry method. The initial permeability of sintered sample prepared by the wet method was 14000~28000, on the other side, 9000~15500 in case of the dry method.

• Quality Improvement in Health Care
• /
• v.8 no.2
• /
• pp.160-171
• /
• 2001

Background : This study was conducted to compare the level of satisfaction between mothers who were educated on the care of newborns by video-taped method and those by verbal one before discharge. Methods : Fifty-two mother (verbal method group) from a free standing OB & GY hospital in Wonju City and forty-seven mothers (videotaped method group) from the OB & GY section of Wonju Christian Hospital(WCH) were selected for a study sample. The knowledge and understanding of newborn care and the degree of maternal satisfaction were assessed after the education by self-administered questionnaires. The opinions of the 11 nurses of WCH who were involved in the education were also collected by a questionnaire. Results : With respect of the level of understanding and satisfaction with the discharge education on newborn care, there is no significant difference between the videotaped educated group and verbal educated one. The correlation analysis of the video education group revealed a strong correlation between the score of understanding and satisfaction with the discharge preparation(r=0.409, p=0.01), and between the satisfaction scores for discharge preparation and discharge education(r=0.844, p=0.001). As for the verbal education group, the score of understanding also correlated significantly with both the score of satisfaction with the discharge education(r=0.272, p=0.001) and the discharge preparation(r=.680, p=0.001). Conclusions : This study showed that the discharge education to mothers regarding newborn care by a videotaped method does not improve the understanding or satisfaction of the mothers. However, the response to the mode of discharge education varies by the characteristics of the mothers. In conclusion, the characteristics of the mother should be considered in order to improve the understanding and knowledge of newborn care when the mode discharge education is chosen.

• Applied Microscopy
• /
• v.42 no.2
• /
• pp.111-114
• /
• 2012

The scanning electron microscopy is an ideal technique for examining plant surface at high resolution. Most hydrate samples, however, must be fix and dehydrate for observation in the scanning electron microscope. Because the microscopes operate under high vacuum, most specimens, especially biological samples, cannot withstand water removal by the vacuum system without morphological distortion. Cryo-techniques can observe in their original morphology and structure without various artifacts from conventional sample preparation. Rapid cooling is the method of choice for preparing plant samples for scanning electron microscopy in a defined physiological state. As one of cryo-technique, high-pressure freezing allows for fixation of native non-pretreated samples up to $200{\mu}M$ thick and 2 mm wide with minimal or no ice crystal damage for the freezing procedure. In this study, we could design to optimize structural preservation and imaging by comparing cryo-SEM and convention SEM preparation, and observe a fine, well preserved Arabidopsis stem's inner ultrastructure using HPF and cryo-SEM. These results would suggest a useful method of cryo-preparation and cryo-SEM for plant tissues, especially intratubule and vacuole rich structure.

• Molecular & Cellular Toxicology
• /
• v.1 no.2
• /
• pp.92-98
• /
• 2005

DNA microarray analysis of gene expression in toxicogenomics typically requires relatively large amounts of total RNA. This limits the use of DNA microarray when the sample available is small. To confront this limitation, different methods of linear RNA amplification that generate antisense RNA (aRNA) have been optimized for microarray use. The target preparation strategy using amplified RNA in DNA microarray protocol can be divided into direct-incorporation labeling which resulted in cDNA targets (Cy-dye labeled cDNA from aRNA) and indirect-labeling which resulted in cRNA targets (i.e. Cy-dye labeled aRNA), respectively. However, despite the common use of amplified targets (cDNA or cRNA) from aRNAs, no systemic assessment for the use of amplified targets and bias in terms of hybridization performance has been reported. In this investigation, we have compared the hybridization performance of cRNA targets with cDNA targets from aRNA on a 10 K cDNA microarrays. Under optimized hybridization conditions, we found that 43% of outliers from cDNA technique and 86% from the outlier genes were reproducibly detected by both targets hybridization onto cDNA microarray. This suggests that the cRNA labeling method may have a reduced capacity for detecting the differential gene expression when compared to the cDNA target preparation. However, further validation of this discordant result should be pursued to determine which techniques possesses better accuracy in identifying truly differential genes.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.41 no.1
• /
• pp.29-34
• /
• 2021

Near infrared reflectance spectroscopy (NIRS) is routinely used for the determination of nutrient components of forages. However, little is known about the impact of sample preparation and wavelength on the accuracy of the calibration to predict minerals. This study was conducted to assess the effect of sample preparation and wavelength of near infrared spectrum for the improvement of calibration and prediction accuracy of Calcium (Ca) and Phosphorus (P) in imported hay using NIRS. The samples were scanned in reflectance in a monochromator instrument (680-2,500 nm). Calibration models (n = 126) were developed using partial least squares regression (PLS) based on cross-validation. The optimum calibrations were selected based on the highest coefficients of determination in cross validation (R2) and the lowest standard error of cross-validation (SECV). The highest R2 and the lowest SECV were obtained using oven-dry grinded sample preparation and 1,100-2,500 nm wavelength. The calibration (R2) and SECV were 0.99 (SECV: 468.6) for Ca and 0.91 (SECV: 224.7) for P in mg/kg DM on a dry weight, respectively. Results of this experiment showed the possibility of NIRS method to predict mineral (Ca and P) concentration of imported hay in Korea for routine analysis method to evaluate the feed value.

• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.111-116
• /
• 2001

Waste office paper, photocopied or laser printed, has recently increased along with office automatization. In waste office paper, toner ink is used as the printing medium in place of conventional oil ink. Since toner ink cannot be saponificated by alkali and be decolored by bleaching, different from the case of oil ink, toner remains on regenerated paper as black specks. Although cascade recycling of waste office paper is compelled at present, the demand for low-grade paper is limited. From such circumstances, a new separation process for waste office paper is demanded to achieve parallel recycling. At the first stage of separation studies, the sharpness of separation is evaluated using small separators to obtain fundamental data. In a lab-scale separator, the sample amount of one feed is generally a few grams. However, the sample amount used for brightness, ERIC, and image analysis that are generally used to evaluate the efficiency of deinking are not small for lab-scale tests of these analyses. This paper describes an investigation of a sheet preparation method by a small amount of sample under 0.5g and compares the precision of toner content determination of spectroscopic analysis and image analysis from the viewpoint of separation evaluation. The easiness and convenience of the operation using only general-purpose equipments has also been set as a principle purpose. From the viewpoint of an analysis that yields high precision with a small amount of sample in short time, the method calculating the absorption coefficient from diffuse reflectance in the visible region is the most rational method in this study.

• Korean Journal of Food Science and Technology
• /
• v.40 no.6
• /
• pp.721-725
• /
• 2008

Changes in the physicochemical and sensory characteristics of the uncooked food, Codonopsis lanceolata saengsik, were investigated to determine an efficient drying method, one of the most important manufacturing processes in the preparation of C. lanceolata saengsik. No changes in the proximate compositions of all samples were observed during hot-air drying at 50 and $60^{\circ}C$ and freeze-drying. The L value in the freeze-dried sample was higher than that in the hot-air dried samples, whereas the b value in the freeze-dried sample was reduced. Dietary fiber content in the hotair dried samples were higher than that in the freeze-dried sample, whereas the total phenolic compounds and crude saponin contents were lower than those in the freeze-dried sample. The highest overall acceptability values in the sensory test for color, flavor, taste, and overall acceptability were 5.63, 5.45, 5.75, and 5.85, respectively. In conclusion, the freezedrying method was the most favorable of the tested method for the manufacture of C. lanceolata saengsik.