• Economic and Environmental Geology
• /
• v.34 no.2
• /
• pp.175-192
• /
• 2001

We have collected hydrogeochemical data of shallow groundwaters in the Uljin area located at eastern coastal area of Korea. Geostatistical analysis (ANOVA test, cluster analysis, and factor analysis) of the collected data sets was pert'onned, in order to evaluate both the spatial and/or temporal variation of water quality data and the groundwater contamination, as weJl as the principal reactions occurring in the aquifer. Results of the ANOVA test show that regional water chemistry are not significantly changed spatially in eight watersheds. However, some ions such as $Ca^{2+}$, $HCO_{3}^{-}$ and $SO_{4}^{2-}$ show a meaningful watershed variation. Water chemistry variation according to sampling time (season) is not shown, except for $SO_{4}^{2-}$. The cluster analysis shows that significant water chemistry variation is eXplained by the distance from the coast. Factor analysis indicates that the water chemistry is changed according to various factors as follows: in the order of decreasing importance, water-rock interaction (mainly, carbonate dissolution), sea-salt spraying, and then contamination by fertilizers and agrochemicals.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.11 no.6
• /
• pp.143-151
• /
• 2007

This study presents the experimental results of frost durability including resistance to freezing-thawing and surface scaling of concrete. Mixing design was proportioned with the various water-binder ratio between 0.37 and 0.47 and three different binder compositions corresponding to Type I cement without any supplementary cementitious materials(OPC), Type II cement with 50% blast-furnace slag replacement(BFS50), and ternary cement with Type III cement, 15% fly ash, and 35% slag replacement (BFS35%+FA15%). Test results showed that the mixing design with BFS50% and BFS35%+FA15% exhibited higher durability factor than that made with OPC only. Finally, the use of blend cement containing slag can be used effectively in terms of frost durability of the concrete exposed to severe condition under coastal environment like as flying salt, sea water spray, etc.

• Korean Journal of Food Science and Technology
• /
• v.33 no.5
• /
• pp.534-539
• /
• 2001

To utilize oyster cannery processing waste water effectively, this study was carried out to prepare instant powdered soup using oyster wash water. Instant powdered soup from oyster hot-water extracts (HWE) was prepared by mixing oyster spray-dried hot-water extracts (15 g) with table salt (5 g), cream powder (19 g), milk replacer (12 g), wheat flour (20 g), corn flour (15 g), starch (5 g), glucose (7.5 g) and onion powder (1.5 g). In preparing instant powdered soup from oyster wash water (OWW), powder from oyster spray-dried wash water instead of the spray-dried hot water extracts, was added and other additives were added in proportion to those in the HWE. The OWW consists mainly of carbohydrates (71.1%). It was not different from the instant powdered soup from hot-water extracts. The volatile basic nitrogen, vaible cell counts, coliform group of instant powdered soup from oyster wash water contains 29.4 mg/100g, $4.6{\times}10^4\;CFU/g$, <18 MPN/100g, respectively and its water activity has 0.246. So it was a hygienically safe and conservable instant food. The main fatty acid of OWW was 16 : 0 and 18 : 1n-9. Its chemical score of protein was 59.4% and its main inorganic matter was iron. According to a sensory evaluation, in contrast to the HWE, the OWW had a slightly lower aroma but better taste. It was concluded from the above chemical and sensual evaluation that the oyster wash water can be used as a flavor enhancer for instant powdered soup.

• The Plant Pathology Journal
• /
• v.22 no.3
• /
• pp.295-302
• /
• 2006

The present study addressed the efficacy of nanosized silica-silver for controlling plant pathogenic microorganisms. The nanosized silica-silver consisted of nano-silver combined with silica molecules and water soluble polymer, prepared by exposing a solution including silver salt, silicate and water soluble polymer to radioactive rays. The nanosized silica-silver showed antifungal activity against the tested phytopathogenic fungi at 3.0 ppm with varied degrees. In contrast, a number of beneficial bacteria or plant pathogenic bacteria were not significantly affected at 10 ppm level but completely inhibited by 100 ppm of nanosized silicasilver. Among the tested plant pathogenic fungi, the new product effectively controlled powdery mildews of pumpkin at 0.3 ppm in both field and greenhouse tests. The pathogens disappeared from the infected leaves 3 days after spray and the plants remained healthy thereafter. Our results suggested that the product developed in this study was effective in controlling various plant fungal diseases.

• Journal of the Korean Applied Science and Technology
• /
• v.24 no.4
• /
• pp.399-409
• /
• 2007

Characteristics of polyaniline anti-corrosive coatings with various primer coating resins(epoxy resin, urethane resin, and others) and top coating resins(epoxy and acrylic urethane resins) were investigated through adhesion, acid resistance, alkaline resistance, water resistance, and anti-corrosion tests. As a result, the anti-corrosive properties of the prepared coatings using polyaniline varied with the types of primer and top coating resins. In this condition, the properties of adhesion, chemical resistance, and water resistance were found to be very satisfactory when using emeraldine base (EB) of polyaniline blended with single-packaged urethane and acrylic urethane resins as the primer coatings, and using acrylic urethane resin as the top coatings. Also, the anti-corrosive function of these anti-corrosive coatings was well preserved for 1000 hr in the salt spray experiment.

• Journal of Pharmaceutical Investigation
• /
• v.38 no.4
• /
• pp.249-254
• /
• 2008

Solid dispersions of poorly water-soluble drug, atorvastatin, were prepared with Eudragit L100 to improve the solubility by spray dryer. To investigate the correlation between physicochemical properties and dissolution rate of solid dispersions, the samples were characterized by scanning electron microscopy (SEM), differential scanning calorimeter (DSC) and fourier transform infrared spectroscopy (FT-IR). SEM and DSC were found that atorvastatin is amorphous in the Eudragit L100 solid dispersion. FT-IR was used to analyze the salt formation by interaction between atorvastatin and Eudragit L100. The dissolution rate of solid dispersed atorvastatin was markedly increased compared to drug powder in stimulated intestinal juice (pH 6.8). Thus, the solid dispersed atorvastatin using the spray drying method with Eudragit L100 may be effective for the bioavailability.

• Fire Science and Engineering
• /
• v.22 no.5
• /
• pp.83-89
• /
• 2008

Using the high expansion foam generator of ISO 7203-2 which spray 6 liter at 5 bar, foam generation characteristics was studied. Wind flow rate, foam screen, concentration of foam agent solution and concentration of salt of water were varied to find the effect of the parameters on foam generation. Research result showed that expansion ratio of foam was increased with wind flow rate. The expansion ratio of foam in the perforated type standard screen was higher than the wire mesh screen. Expansion ratio and drainage time were increased with increase of foam solution concentration. But a increase of salt concentration in solution showed the decrease of expansion ratio and drainage time.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1996.11a
• /
• pp.117-120
• /
• 1996

In this paper, It is tested by spraying the spoiled liquids on the materials to prove the process of tracking under the various environments. Our experiments ware examined by setting the materials in the spray chamber, and by spraying the distilled water(DW), the city water(CW), the underground water(UW), the artificial acid rain(AR) and the salt water(SW) in applied voltage 3-6[KV]. As the result, the time of tracking breakdown became shorter in the order of DW < CW < UW < AR < SW. XLPE was eroded and its anti-bracking property was very strong, but that of PVC sheath was week. Especially it was confirmed that spraying by AR and SW on the PVC sheath had a serious effect on the lifetime of cable by the tracking breakdown.

• Journal of Pharmaceutical Investigation
• /
• v.38 no.2
• /
• pp.111-117
• /
• 2008

To overcome the solubility of poorly water-soluble drug, the formation of solid dispersion using a spray-dryer with polymeric material, that can potentially enhance the dissolution rate extend of drug absorption was considered in this study. $Eudragit^{(R)}$ E100 as carrier for solid dispersion is acrylate copolymer that soluble in acidic buffer solutions (below pH 5.0). It was used to increase dissolution of atorvastatin calcium as a water-insoluble drug in acidic environments. In this study, a spray-dryer was used to prepare solid dispersion of atorvastatin calcium and $Eudragit^{(R)}$ E100 for purpose of improving the solubility of drug. Atorvastatin calcium and $Eudragit^{(R)}$ E100 were dissolved in ethanol and spray-dryed. DSC and XRD were used to analyze the crystallinity of the sample. It was found that atorvastatin calcium is amorphous in the $Eudragit^{(R)}$ E100 solid dispersion. FT-IR was used to analyze the salt formation by interaction between atorvastatin calcium and $Eudragit^{(R)}$ E100. Comparative dissolution study exhibited better dissolution characteristics than the commercial drug ($Lipitor^{(R)}$) as control. The dissolution rate of atorvastatin calcium was markedly increased in solid dispersion system in simulated gastric juice (pH 1.2). This study proposed that this solid dispersion system improved the bioavailability of poorly water-soluble atorvastatin calcium.

• Journal of the Korea Safety Management & Science
• /
• v.2 no.4
• /
• pp.197-208
• /
• 2000

ABS sensor ring has been manufactured by powder metallurgy (P/M) method using 400 series ferrite stainless steel. The results are following. It is supposedly sufficient to use for control computer due to good experimental results of magnetic characteristics. Compared with sensor ring made by iron, 400 series ferrite stainless steel has shown a good corrosion resistance without an addition surface treatment. Thus the decreasing production process has been obtained. As a result mechanical characteristics of hardness and tensile test, 400 series ferrite stainless steel shown a good endurance when it is combined to constant velocity joint(C/V), and has a good hardness properties endurable to sand and pebble impact. The products before sintering are much more corrodible in the condition of spray test of salt water and ammonia than humidity and nitrogen condition.