• 상하수도학회지
• /
• 제24권6호
• /
• pp.735-741
• /
• 2010

A pilot test was carried out to investigate the long term operation characteristics of Microfiltration (MF) system as a pretreatment for seawater reverse osmosis (SWRO) processes for two years. A commercialized MF module with pressurized operation type was used to filter seawater to remove particles which can foul reverse osmosis (RO) membrane. Silt Density Index (SDI) values of filtered seawater by the MF system were ranged from 0.14 to 1.79, which meet the SDI standard for RO feed water as depicted in previous literatures. Although the tested seawater is quite clean (i.e., dissolved organic cabon (DOC) concentration and turbidity were about 1 mg/l and less than 1 NTU, respectively) enough not to foul the MF membrane, steep increase in trans-membrane pressure (TMP) with a constant flux were observed over a whole operation period. A set of operation and water analysis data implies that the steep increase in TMP was resulted from iron and maganese fouling by the combination of metal corrosion by seawater and oxidation state by aeration and residual chlorine.

• 상하수도학회지
• /
• 제30권3호
• /
• pp.299-312
• /
• 2016

The main objective of this paper is to develop computer simulation program for performance evaluation and cost estimation of a reverse osmosis (RO) and pressure-retarded osmosis (PRO) hybrid process to propose guidelines for its economic competitiveness use in the field. A solution-diffusion model modified with film theory and a simple cost model was applied to the simulation program. Using the simulation program, the effects of various factors, including the Operating conditions, membrane properties, and cost parameters on the RO and RO-PRO hybrid process performance and cost were examined. The simulation results showed that the RO-PRO hybrid process can be economically competitive with the RO process when electricity cost is more than 0.2 $/kWh, the PRO membrane cost is same as RO membrane cost, the power density is more than $8W/m^2$ and PRO recovery is same as 1/(1-RO recovery).

• 상하수도학회지
• /
• 제30권5호
• /
• pp.521-532
• /
• 2016

Seawater desalination market after global economic crisis has been stalled due to the market uncertainties and decreased demand in desalination. It is important to review the status of the market and to estimate the appropriate share of Forward osmosis-Reverse Osmosis (FO-RO) hybrid desalination technology by figuring out the outlook of the desalination market. Main part of the desalination market will still be MENA (Middle East and North Africa) in the near future due to the fast population increase and high dependency of fossil fuel in the region. The market for FO-RO hybrid technology, however, might be smaller than the conventional SWRO desalination market anyway because of aesthetic issues from using wastewater as raw water and higher costs associated with capex. Therefore, it is essential to improve FO membrane performance and system operation technologies in order to make the hybrid technology attractive compared to the conventional SWRO technology.

• 상하수도학회지
• /
• 제29권1호
• /
• pp.89-96
• /
• 2015

Smart water grid is a water network with communication to save water and energy using various water resources. In smart water grid, water product from the various sources can be blended to be supplied to end-users. The product water blending was reported by literatures while feed water blending has been rarely reported so far. In this work, a commercial reverse osmosis (RO) system design software provided by a membrane manufacturer was used to elucidate the effect of feed water blending on the performance of seawater reverse osmosis (SWRO) plant. Fresh water from exisiting water resource was assumed to be blended to seawater to decrease salt concentration of the RO feed water. The feed water blending can simplify the RO system from double to single pass and decrease seawater intake amount, the unit prices of the RO system components including high pressure pump, and operation risk. Due to the increase in RO plant capacity with the feed water blending, however, the RO membrane area and total power consumption increase at higher water blending rates. Therefore, a specific benefit-cost analysis should be carried out to apply the feed water blending to SWRO plants.

• 상하수도학회지
• /
• 제27권2호
• /
• pp.261-272
• /
• 2013

Algae boom (Red tide) in south coastal area of Korea has been appeared several times during a decade. If algae boom appears in the desalination plant, media filter and UF filter are clogged quickly, and the plant should be shutdown. In general, Algae can be removed from water by flotation better than by sedimentation, because of the low density of algal cell. The purpose of this study conducts the CFD simulation of DAF flotation basin to apply the design of the dissolved air flotation with ball filter in the Test Bed for SWRO desalination plant. In this study, Eulerian-Eulerian multiphase model was applied to simulate the behavior of air bubbles and seawater. Density difference model and gravity were used. But de-sludge process and mass transfer between air bubbles and seawater were ignored. Main parameter is hydraulic loading rate which is varied from 20 m/hr to 27.5 m/hr. Geometry of flotation basin were changed to improve the DAF performance. According to the result of this study, the increase of hydraulic loading rate causes that the flow in the separation basin is widely affected and the concentration of air is increased. The flow pattern in the contact zone of flotation basin is greatly affected by the location of nozzle header. When the nozzle header was installed not the bottom of the contact zone but the above, the opportunity of contact between influent and recycle flow was increased.

• 상하수도학회지
• /
• 제31권4호
• /
• pp.311-319
• /
• 2017

Scale formation is inevitable problem when seawater is treated by vacuum membrane distillation. The reason is the high concentration of calcium ion($Ca^{2+}$), sulfate ion(${SO_4}^{2-}$) and bicarbonate ion(${HCO_3}^-$). These ions form calcium sulfate($CaSO_4$) and calcium carbonate($CaCO_3$) on the membrane. The scale formed on membrane has to be removed, because the flux can be severely reduced and membrane wetting can be incurred. This study was carried out to investigate scale formation and effectiveness of acid cleaning in vacuum membrane distillation for SWRO brine treatment. It was found that permeate flux gradually declined until volume concentration factor(VCF) reached around 1.55 and membrane wetting started over VCF over 1.6 in the formation of precipitates containing $CaSO_4$ during VMD operation. In contrast, when calcium carbonate formed on membrane, permeate flux was gradually reduced until VCF 3.0. The precipitates containing both $CaSO_4$ and $CaCO_3$ were formed on the membrane surface and in the membrane pore.

• 대한환경공학회지
• /
• 제35권3호
• /
• pp.200-205
• /
• 2013

전처리 공정은 막의 오염 정도를 제어할 수 있는 유일한 방법이다. 막의 오염 현상은 피할 수 없는 중요한 문제이며 RO 공급수로 적합한 전처리 공정의 선택이 중요하다. 본 연구는 pH, 해수의 탁도, 수온, 응집제 주입량 그리고 SDI 측정 막재질과 같은 SDI 값에 영향을 미치는 인자들을 평가 하기위해 수행되었다. 그 결과 해수의 탁도는 여과수의 SDI 값에 약간의 영향을 미친것으로 조사되었다. 0.45 um 공극 크기를 가지는 SDI 측정 막은 소수성 막 보다 동일한 재질의 친수성 막을 이용하는 것이 분석 결과의 신뢰성과 재현성을 확보할 수 있었다. pH 7.0 이하의 조건에서 pH가 감소할수록 SDI 값은 증가한 것으로 나타났다. 그리고 수온은 SDI 값은 큰 영향을 미친것으로 조사되었다.

• International Journal of Fluid Machinery and Systems
• /
• 제3권4호
• /
• pp.369-378
• /
• 2010

The creation of the hydraulic turbine flow factor map will undoubtedly benefit its design by decreasing both the design cycle time and product cost. In this paper, the geometry and flow variables, which effectively affect the flow factor, are proposed, analyzed and determined. These flow variables are further used to create the operating condition maps by using different model approaches categorized into Response Surface Method (RSM) and Artificial Neural Network (ANN). The accuracies of models created by different approaches are compared and the performances of model approaches are analyzed. The influences of chosen variables and the combination of Principle Component Analysis (PCA) and model approaches are also studied. The comparison results between predicted and actual flow factors suggest that two-hidden-layer Feed-forward Neural Network (FFNN), and one.hidden-layer FFNN with PCA has the best performance on forming this mapping, and are accurate sufficiently for hydraulic turbine design.

• 대한환경공학회지
• /
• 제31권1호
• /
• pp.51-57
• /
• 2009

역삼투 해수담수화(SWRO)공정의 큰 문제점 중 하나인 biofouling 현상을 초기에 감지하기 위한 센서 개발의 선행 연구로써, 본 연구는 역삼투막에 바이오필름을 형성하는 문제성 있는 박테리아를 센서의 타겟 박테리아로 제시하는 것에 중점을 두었다. 문헌조사와 실제 해수담수화 공정에서 사용된 해수 원수와 오염된 역삼투막에 존재하는 박테리아를 계통발생학적으로 분석한 결과를 토대로 Bacillus sp., Flavobacterium sp., Mycobacterium sp., P. aeruginosa, P. fluorescens, 그리고 Rhodobacter sp.의 여섯종의 모델 박테리아를 선정하였고, 선정된 모델 박테리아 중, 막 오염 잠재력을 가진 종을 찾아내기 위해 각각 박테리아의 역삼투막 부착 능력, 고압내성, 그리고 소수성을 비교 분석하였다. 그 결과, 역삼투막 부착능력은 Rhodobacter sp.와 Mycobacterium sp.가 뛰어났으며 소수성이거나 역삼투막(접촉각 약 $63^{\circ}$)과 비슷한 접촉각을 가진 박테리아가 역삼투막에 잘 부착하였다. 800 psi의 고압을 적용 한 후, Rhodobacter sp.는 여섯 종류의 모델 박테리아 중 59-73%의 가장 큰 개체수의 감소를 보였고, P. fluorescens는 1-29%로 가장 높은 고압내성을 보였다. 부착, 소수성, 고압내성 특성을 통한 역삼투막에 biofouling을 유발하는 영향력 있는 박테리아 선정 실험 결과, 여섯 종류의 모델 박테리아 중 Mycobacterium sp.가 부착 능력이 뛰어나고 높은 소수성 특성을 가지며, 800 psi의 고압에서도 50% 이상의 cell의 생물학적 활성능력을 가지고 있어, 막 오염을 유발시키는 가장 잠재력 있는 박테리아로 분석되었다.

• 멤브레인
• /
• 제25권4호
• /
• pp.301-309
• /
• 2015

최근 해수담수화 기술에 관한 관심이 증가하면서 해수 전처리 기술의 중요성이 날로 증가하고 있다. 해수담수화 기술은 미래 수처리 핵심기술로 자리매김하고 있고 이를 위한 전처리 기술의 올바른 선택과 운영은 향후 해수담수화 기술의 효율향상과 공정 최적화를 위해 중요하게 고려되어야 할 것이다. 해수담수화 전처리 기술의 목적은 주로 해수에 존재하는 입자성 물질, 콜로이드성 물질, 유기물질, 무기물질 그리고 미생물 오염물질 등의 처리를 통해 후단 담수화 기술의 효율성을 향상시키기 위함이나 전처리 기술 대상 처리물질의 범위는 매우 다양하여 맞춤형 전처리 기술의 적절한 적용이 필요하다. 해수담수화에서 올바른 전처리 기술의 적용은 후단 담수화 시설의 높은 처리효율 및 문제점을 최소화시킴과 동시에 해수의 큰 수질변동과 기후적인 그리고 지역적인 영향 등에 즉각적으로 대처할 수 있으므로 전처리 기술의 운영전략은 미래 해수담수화 기술의 성공여부를 결정짓기 위해 매우 중요하게 다루어져야 한다. 또한 최근에 많은 관심을 가지고 있는 해수 미세조류의 번성은 담수화 전처리 기술의 선정에 있어서 잠재적인 장애가 되고 있어 이에 대한 올바른 이해도 반드시 필요하다. 본 총설에서는 해수담수화 전처리 기술에 관한 그동안의 연구동향을 분석하고 해수담수화 전처리 기술의 선택 및 운전 최적화 달성을 위한 향후 도전과제들을 제시하고자 한다.