• Proceedings of the KIEE Conference
• /
• 2003.11c
• /
• pp.519-523
• /
• 2003

This paper describes the communication system of sequencing sorter. Generally sequencing sorter is a machine that sorts mails by delivery order. And designed sequencing sorter is composed of 5 physical modules. So, it is necessary to communicate with each module and to control this communication. A computer called Machine Management Computer, controls this. This paper is about the communication system with MMC and module controllers. This is PC-based, asynchronous full-duplex 4-wire serial systems. 3 protocol layers are presented and stop-and-wait flow control is adopted. Because designed sequencing sorter has to be operated high speed about 27,000 letters per hour, we analyzed the network traffic in the worst case. So, we could find that the communication system has to use above 115,200bps speed.

• Journal of the Institute of Convergence Signal Processing
• /
• v.18 no.1
• /
• pp.25-30
• /
• 2017

Currently, most of the grain sorter uses CCD optic camera to find defective products. The aim of this paper is to use the CCD camera, and aim for improving the sorting power of the grain separator by using NIR(Near Infrared Radiation) sensor based on moisture content measurement algorithm. We intend to develop a system to develop an NFC imaging system in real time by developing an NIR imaging system and developing the grain sorter system that is considered to be defective in real time by checking the internal moisture content of the raw material in the real time.

• Journal of Biosystems Engineering
• /
• v.40 no.4
• /
• pp.327-334
• /
• 2015

Purpose: A falling-type weight sorter equipped with a load cell was developed to sort lightweight dried persimmons. The performance of the sorter was also evaluated. Methods: The electronic weight sorter for dried persimmon comprises a feeder part, a weight-measurement part, an indicator part, a carrier cup, a discharging part, and a driving part. The weight setting and zero-point adjustment are performed digitally for the convenience of users. For the experimental trials, 228 rubber-clay specimens (representative of dried persimmons) in the weight range of 24.73~99.56 g were manufactured for use in experiments to evaluate the performance of the sorter. Results: The average error of the weight measurements from three experimental trials was 1.655%, with a bias of -0.492 g, a root-mean-square error (RMSE) of ${\pm}0.808g$, and a coefficient of determination ($R^2$ ) of 0.997. Conclusions: The load-cell-based electronic dried-persimmon weight sorter developed in this study facilitates effective, precise, and convenient sorting of dried persimmons.

• Proceedings of the Korean Society of Near Infrared Spectroscopy Conference
• /
• 2001.06a
• /
• pp.1267-1267
• /
• 2001

The existing fruit sorter has the method of tilting tray and extracting fruits by the action of solenoid or springs. In peaches, the most sort processing is supported by man because the sorter make fatal damage to peaches. In order to sustain commodity and quality of peach non-destructive, non-contact and real time based sorter was needed. This study was performed to develop peach sorter using near-infrared spectroscopy in real time and nondestructively. The prototype was developed to decrease internal and external damage of peach caused by the sorter, which had a way of extracting tray with it. To decrease positioning error of measuring sugar contents in peaches, fiber optic with two direction diverged was developed and attached to the prototype. The program for sorting and operating the prototype was developed using visual basic 6.0 language to measure several quality index such as chlorophyll, some defect, sugar contents. The all sorting result was saved to return farmers for being index of good quality production. Using the prototype, program and MLR(multiple linear regression) model, it was possible to estimate sugar content of peaches with the determination coefficient of 0.71 and SEC of 0.42bx using 16 wavelengths. The developed MLR model had determination coefficient of 0.69, and SEP of 0.49bx, it was better result than single point measurement of 1999's. The peach sweetness grading system based on NIR reflectance method, which consists of photodiode-array sensor, quartz-halogen lamp and fiber optic diverged two bundles for transmitting the light and detecting the reflected light, was developed and evaluated. It was possible to predict the soluble solid contents of peaches in real time and nondestructively using the system which had the accuracy of 91 percentage and the capacity of 7,200 peaches per an hour for grading 2 classes by sugar contents. Draining is one of important factors for production peaches having good qualities. The reason why one farm's product belows others could be estimated for bad draining, over-much nitrogen fertilizer, soil characteristics, etc. After this, the report saved by the peach grading system will have to be good materials to farmers for production high quality peaches. They could share the result or compare with others and diagnose their cultural practice.

• Journal of Biosystems Engineering
• /
• v.26 no.3
• /
• pp.271-278
• /
• 2001

Many workers in the garlic peeling factory are separating the sound peeled garlics from the unpeeled and defective ones in a manual way. In order to reduce the seasonal labor requirement and operating cost, the mechanized garlic sorting system such as the vision-based garlic sorter should be developed. This study was conducted as one of basic studies on developing quality evaluation technique for peeled garlics, especially to developed the system for acquiring the whole surface images of garlics with a CCD camera. The following results were obtained from this study. 1. The belt-type garlic rotation system was devised to apply for the vision-based garlic sorter and was tested to decide the criteria of design and optimum conveying speed. 2. To evaluate the performance of the developed garlic rotation system, feeding rate and rotating rate were measured under the conditions of four experimental factors such as the inclined angle of rotating belt, the inclined angle of feeding belt, the height of plate arrays on feeding belt and the conveying speed of belts. And the capacity of the system according to mixture ratios of peeled garlics and unpeeled garlics was analyzed as a feasibility test. 3. For the inclined angle of rotating belt 20°and height of plate array on feeding belt 22㎜, the maximum rotating rate for garlic samples including unpeeled ones was 81.1% at the conveying speed of 4.2 garlic/sec. And under these condition, the maximum feeding rate was 85% at the inclined angle of feeding belt 6.5°. 4. The capacity of the developed garlic rotation system was almost constant regardless of mixture ratio of peeled garlics and unpeeled garlics and its range was 2.95∼3.92 garlic/sec. At the conveying speed of 4.2 garlic/sec, the capacity of the garlic rotation system was calculated ad 58∼64 kg/hr. 5. To improve performance of the garlic rotation system, it is recommended to develop a device to slide garlics into feeding belt.

• IE interfaces
• /
• v.20 no.1
• /
• pp.21-32
• /
• 2007

This paper deals with the simulation model for A-Mart logistic center design and operations. In developed simulation model, receiving docks, conveyor sorter, conveyor system, shipping docks, material handling devices and manual sorting stations are considered. Three types of cargo such as transfer center cargo, distribution center cargo and supermarket cargo are considered. The simulation model and process animation are developed using the simulation package ARENA. Among various design and operation alternatives consisting of the number of workers of receiving dock, allocation of receiving docks by cargo types, conveyor sorter velocity, the number of folk-lift, the number of manual sorting operators and overall layout, the best alternatives of each subsystem are selected by simulation analysis. The major performance measures such as sorter throughput, utilization of operators at each station, receiving docks utilization and folk-lift utilization are considered for the alternative evaluation.

• ETRI Journal
• /
• v.37 no.2
• /
• pp.328-337
• /
• 2015

This paper applies acceleration/deceleration control-based velocity profiles to an infeed control algorithm for a cross-belt-type sorting system to improve the accuracy and performance of the system's infeed. The velocity profiles are of a trapezoidal shape and often have to be modified to ensure that parcels correctly synchronize with their intended carriers. Under the proposed method, an infeed line can handle up to 5,600 items/h, which indicates a 40% increase in performance in comparison with its existing handling rate of 4,000 items/h. This improvement in performance may lead to a reduction in the number of infeed lines required in a sorting system. The proposed infeed control algorithm is applied to a cross-belt-type sorting system (model name: SCS 1500) manufactured by Vanderlande Industries.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 2001.02a
• /
• pp.316-323
• /
• 2001

• Journal of the Korea Safety Management & Science
• /
• v.18 no.1
• /
• pp.159-166
• /
• 2016

Logistics had only been perceived as a supporting means or auxiliary of corporate activity, but is now surfacing as a priority sector for competitiveness in the infinite competition of the global market. This study looks into the current status of logistics and sets forth the improvement tasks by analyzing the problems of the returned goods logistics. In order to improve the manual process of returned goods, the POS system (point-of-sales system) was implemented and DAS (Digital Assorting System) and SORTER System were synchronized for utilization, which cut the prime cost of the once expensive returned goods logistics, and analyzed the efficiency of establishing automated logistics system for efficiency of returned goods logistics in the aspects of one-stop BPR (Business Process Re-engineering).

• Proceedings of the Korea Society of Poultry Science Conference
• /
• 2002.11a
• /
• pp.98-99
• /
• 2002

Collection of large number of gonadal Primordial germ cells(gPGCs) is a prerequisite factor for improving germline transmission efficacy in the aves, In this study a magnetic-activated cell sorter(MACS) was applied for improving retrieval efficacy of quail gPGCs and the migration capacity of MACS-separated gPGCs was further examined after being transplanted to recipient embryos. We also induced germline chimeras by transfer of MACS-separated quail gPGCs at the efficiency of 17.4% on average.