• The Journal of the Acoustical Society of Korea
• /
• v.42 no.5
• /
• pp.460-468
• /
• 2023

Developmental Dysplasia of the Hip (DDH) is a pathological condition commonly occurring during the growth phase of infants. It acts as one of the factors that can disrupt an infant's growth and trigger potential complications. Therefore, it is critically important to detect and treat this condition early. The traditional diagnostic methods for DDH involve palpation techniques and diagnosis methods based on the detection of keypoints in the hip joint using X-ray or ultrasound imaging. However, there exist limitations in objectivity and productivity during keypoint detection in the hip joint. This study proposes a deep learning model-based keypoint detection method using X-ray and ultrasound imaging and analyzes the performance of keypoint detection using various deep learning models. Additionally, the study introduces and evaluates various data augmentation techniques to compensate the lack of medical data. This research demonstrated the highest keypoint detection performance when applying the residual network 152 (ResNet152) model with simple & complex augmentation techniques, with average Object Keypoint Similarity (OKS) of approximately 95.33 % and 81.21 % in X-ray and ultrasound images, respectively. These results demonstrate that the application of deep learning models to ultrasound and X-ray images to detect the keypoints in the hip joint could enhance the objectivity and productivity in DDH diagnosis.

• Composites Research
• /
• v.36 no.4
• /
• pp.253-258
• /
• 2023

Although the development of transportation means has realized the right to mobility for the disabled who have difficulty in moving, it can be said that the improvement of the safety of passengers with disabilities that can occur in a car accident is lower than that of ordinary passenger seats. In particular, in the case of a rear-end collision that can occur suddenly, it is a reality that disabled passengers are vulnerable to head and neck injuries. Therefore, in this study, a multi-layer headrest foam that divides the headrest into three parts in the coronal plane was proposed to improve the head and neck injury index of disabled passengers in the vehicle in the event of a rear-end collision of a wheelchair transport vehicle. A range of stress scale factors was selected to give various compressive characteristics of the foam through low-speed rear-end collision analysis through a simple model, and GA optimization was performed by specifying the range as a parameter. Through the optimization result, the phase relationship between HIC and NIC was analyzed according to the compression characteristics of the layers. HIC responded most sensitively to the compression characteristics of the front layer and NIC responded to the compression characteristics of the mid layer, and the compression characteristics of the rear layer showed the lowest. A normal headrest and an optimized multi-layer headrest were placed in the validation model to analyze the low-speed rear-end collision sled test, and HIC and NIC were derived lower in the multi-layer headrest than in the general headrest. The compression behavior of the multi-layer headrest was also clearly shown, and it was verified that the multi-layer headrest was effective in improving the injury index of the head and neck compared to the general headrest.

• Korean Journal of Construction Engineering and Management
• /
• v.24 no.5
• /
• pp.52-62
• /
• 2023

The objective of this study is to propose an automated algorithm for precise cutting length of slab rebar complying with regulations such as anchorage length, standard hooks, and lapping length. This algorithm aims to improve the traditional manual quantity take-off process typically outsourced by external contractors. By providing accurate rebar quantity data at BBS(Bar Bending Schedule) level from the bidding phase, uncertainty in quantity take-off can be eliminated and reliance on out-sourcing reduced. In addition, the algorithm allows for early determination of precise quantities, enabling construction firms to preapre competitive and optimized bids, leading to increased profit margins during contract negotiations. The proposed algorithm not only streamlines redundant tasks across various processes, including estimating, budgeting, and BBS generation but also offers flexibility in handling post-contract structural drawing changes. In particular, the proposed algorithm, when combined with BIM, can solve the technical problems of using BIM in the early phases of construction, and the algorithm's formulas and shape codes that built as REVIT-based family files, can help saving time and manpower.

• Proceedings of the Korean Society of Embryo Transfer Conference
• /
• 2002.11a
• /
• pp.92-92
• /
• 2002

Considerable attention has been focused on the cryopreservation of semen and estrus induction in dog, as consequence of poor productivity caused by long anestrus period, in order to enhance the productivity of youngs and to preserve the breeds. The objectives of this study were to evaluate semen quality after cryopreservation and to evaluate the Pregnancy rate after insemination (AI). Fifty infertilie dogs (age 2∼3 years) were selected for the study and divided into three different estrus induction treatment groups. Group 1: dogs (n=15) were given clomifene (0.1 mg/kg) orally for five days at 12 hr intervals. Group 2: dogs (n=15) were given bromocriptine (50 $\mu\textrm{g}$/kg) orally for five days at 12 hr intervals, followed by single injection intravenously of 500 IU GnRH (Group 3, n=20) when pro-estrus occurred. The rates of pregnancy in estrus inducted dogs mated naturally compared to those inseminated artificially with ejaculated fresh semen and frozen-thawed semen. Estrus detection was performed using the method of vaginal smear and confirmed by the plasma progesterone assay. The ejaculated semen to freeze was exposed to a mixture of Tris extender with cryoprotectant (Trisma, 81 mM: TES, 209 mM: citric acid, 6 mM; glucose, 5 mM; glycerol, 8%) and cryopreserved gradually by slow-cooling at 17 cm above the surface of liquid nitrogen (LN$_2$) for 23 min. The motility of frozen-thawed spermatozoa was assessed by phase-contrast microscopy. To assess their viability and acrosome content, spermatozoa were stained with a vital stain and Fluorescence conjugated lectin Pisum Savitum Agglutinin (FITC/PAS), respectively. Pregnancy was confirmed by ultrasonograpy on day 25, 35 and 55 post insemination. The use of fresh semen, the pregnancy rates were observed 66.6, 66.6, 75.0 and 83.3% in natural estrus, clomifene induced, bromocriptine induced and a combination of GnRH and bromocriptine, respectively. The use of frozen-thawed semen, the pregnancy rates were observed 66.6, 33.3, 50.0 and 60.0% in natural estrus, clomifene induced, bromocriptine induced and a combination of GnRH and bromocriptine, respectively. No difference was observed in the number of offspring produced among natural estrus and treated groups inseminated with fresh or frozen-thawed semen. In conclusion, the pregnancy rate of dogs treated with a combination of GnRH and bromocriptine was more effective than use of clomifene or bromocriptine only. In addition, frozen-thawed semen can be used successfully far artificial insemination in dog.

• Nuclear Engineering and Technology
• /
• v.54 no.11
• /
• pp.4348-4358
• /
• 2022

The thermal-hydraulics phenomena in a containment during an accident will necessarily include radiative heat transfer (i) within the gas mixture due to the high radiative absorption and emission of steam and (ii) between the gas mixture and the surrounding structures. The analysis of some previous PANDA experiments (PSI, Switzerland) demonstrated the importance of the proper modelling of radiation for the benefit of numerical simulations. These results together with dedicated scoping calculations conducted for the present experiments indicated that the radiative heat transfer is considerable, even for a very low amount of steam (≈2%). The H2P2 series conducted in the large-scale PANDA facility at the Paul-Scherrer-Institut (PSI) in the framework of the OECD/NEA HYMERES-2 project is intended to enhance the understanding of thermal radiation phenomena and to provide a benchmark for corresponding numerical simulations. Thus, the test matrix was tailored around the two opposite extremes: either gas compositions with small steam content such that radiative heat transfer phenomena can be neglected. Or gas mixtures containing larger amounts of steam, so that radiative heat transfer is expected to play a dominant role. The H2P2 series consists of 5 experiments designed to isolate the radiation phenomena from convective and diffusive effects as much as possible. One vessel with a diameter of 4 m and a height of 8 m was preconditioned with different mixtures of air / steam at room and elevated temperatures. This was followed by the build-up of a stable helium stratification at constant pressure in the upper part of the vessel. After that, helium was injected from the top into the vessel which leads to an increase of the vessel pressure and a corresponding elevation-dependent and transient rise of the gas temperature. It is shown that even the addition of small amounts of steam in the initial gas atmosphere considerably impacts the radiative heat transport throughout all phases of the experiments and markedly influences i) the monitored gas peak temperature, ii) the temperature history during the compression and iii) the following relaxation phase after the compression was stopped. These PANDA experiments are the first of its kind conducted in a large scale thermal-hydraulic facility.

• Journal of Science Education
• /
• v.46 no.2
• /
• pp.165-177
• /
• 2022

This study aims to develop a field trip program for the Hantan River geopark in Pocheon using Orion's field trip model. The selected learning sites were the Hwajeogyeon and Bidulginang Falls, famous geosites of the Hantan River geopark in Pocheon. The field trip program consisted of six preparatory units, two field trip units, and two summary units. The preparatory stage helped reduce the novelty space considering cognitive, psychological, and geographical factors. In the field trip stage, students acquire concepts linked to learning elements in the curriculum scientifically and encourage interest in science. In the summary stage, students organized the geological phenomena observed in the field and inferred the vicinity of the Pocheon Hantan River region. The field trip program was modified to give enough time for observation activities to increase students' interest in science and to connect concepts with learning elements in the curriculum in the outdoor learning phase to allow students' convergent thinking. Implementing the field trip program raises students' interest and attitude in science.

• Nuclear Engineering and Technology
• /
• v.11 no.3
• /
• pp.203-212
• /
• 1979

The thermal decomposition of simulated Magnox highly active waste and of HARVEST feed slurries (SW and SG) which include tile glass forming chemicals has been studied. The waste and the slurries are almost completely calcined by 500-55$0^{\circ}C$. The colour of the solids from the slurries varies little until about 90$0^{\circ}C$ when it darkens considerably. The slurries begin to vitrify at this temperature and are completely vitrified at 1000-105$0^{\circ}C$. On the other hand. the sulphate impurity in SN slurry causes a yellow phase to separate above 75$0^{\circ}C$. The density of the intermediate solids is fairly low until 650$^{\circ}$-$700^{\circ}C$ is reached. This temperature seems to mark the onset of fluxing as tile density rises quickly to 2g/㎤ at 700$^{\circ}$ -80$0^{\circ}C$. The strengh of the solids decreases with temperature up to 50$0^{\circ}C$, and then rises as the solids begin to sinter. Below 50$0^{\circ}C$ the SN solids are the stronger. suggesting that the impurity renders this silica more reactive.

• Design Convergence Study
• /
• v.15 no.5
• /
• pp.71-83
• /
• 2016

Interior panels are usually used in finishing of interior walls for not only decorative effects but also information transfer. According to designer's design placing interior panels may need repetitive tasks and the emphasis of this paper is to support an automation of these tasks. Considering the utilization characteristics of interior panels, we propose three method to present patterns by using bitmap image pixels and interior panels' shape changes, based on the theoretical consideration. In addition, in order to approve the possibility of the proposed methods, we have implemented the BIM based interior panels auto layout tool which applied one of the three methods to present patterns by using bitmap image pixel values and panel identification attributes. This tool also supports auto generation of quantity and panel arrangement sequence information that will be used in future construction phase. We expect that this approach will also be used in other decorative objects which require repetition of the basic units, such as floor tiles.

• Korea Science and Art Forum
• /
• v.25
• /
• pp.227-240
• /
• 2016

This study aims to examine how visitors in science centers interact with gesture-based exhibits from embodied cognition perspectives. Four gesture-based exhibits in two science centers were selected for this study. In addition, we interviewed a total of 14 visitor groups to examine how they perceived the property of gesture-based exhibit. We also interviewed four experts to further examine the benefits and limitations of the current gesture-based exhibits in science centers. The research results indicate that the total amount of interaction time between visitors and gesture-based exhibits was not high overall, implying that there was little of visitors' immersive engagement. Both experts and visitors expressed that the current gesture-based exhibits tend to highlight the novelty effect but little obvious impacts linking gestures and learning. Drawing from the key findings, this study suggests the following design considerations for gesture-based exhibits. First, to increate visitor's initial engagement, the purpose and usability of gesture-based exhibits should be considered from the initial phase of design. Second, to promote meaningful interaction, it is important to sustain visitors' initial engagement. For that, gesture-based exhibits should be transformed to promote intellectual curiosity beyond simple interaction. Third, from embodied cognition perspectives, exhibits design should reflect how the mappings between specific gestures and metaphors affect learning processes. Lastly, this study suggests that future gesture-based exhibits should be designed toward promoting interaction among visitors and adaptive inquiry.

• The Korean Journal of Franchise Management
• /
• v.2 no.2
• /
• pp.70-83
• /
• 2011

The number of agricultural products due to open in response to international competitiveness of the farming press and the need for structural adjustment in agriculture and in agricultural crops receive a fair market price, fair trade, such as improving efficiency sidaejeo appropriate response to the request of the government must have. For this purpose, compared to the communist bojaphan agricultural water efficiently changing the structure of the distribution, agricultural products originating from the acquisition phase choice of shipping a stable product supply and plans to expand production system to induce a smooth supply of agricultural products, expand processing capacity and sales control should be. Also, in the distribution process by eliminating various immoral conduct commerce retail establishment and enforcement of policies for efficient and accurate distribution statistics, information is needed. The ultimate goal of agricultural restructuring and ensure fair price for producers sangpuui and improvement of production facilities for maximizing and affordable for consumers, according to your preferences to receive the best offer will be Foo. Therefore, management increases the efficiency of just distribution costs, or margins, lowering the improvement is not practical to restructure the distribution structure of costs for the best product and must supply the next country of agricultural products, strengthen the consumer's purchase desire to meet will be.