• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.2
• /
• pp.114-120
• /
• 2008

This paper proposed the band pass filter(BPF) with feeding structure using $\pi$-type transmission line by means of transforming the input/output coupled-lines of the half wavelength parallel coupled-line BPF into K-inverter, then substituting $\pi$-type transmission line equivalence for K-inverter. The proposed method supplies solution with what the half wavelength parallel coupled-line BPF's input/output coupled-lines are realized. Also it can quite reduce efforts and time needed to optimize filter performance when is compared to reported method using tapped line structure because formulas is very simple and accurate. On the basic of the proposed method, the BPF with feeding structure using $\pi$-type transmission line has been designed and fabricated. The validity of proposed method was proven by the measured result.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.1
• /
• pp.161-167
• /
• 2014

This paper presents the results of permittivities of various materials by measurements of the dielectric properties for the materials in millimeter-wave band. Since the advantages of millimeter wave band include the miniaturization, weight reduction of component and a lot of information transfer, its study has received increasing attention of researches. Also, because of the characteristics of the band have the superior straightness and the small diffractive, in the band, the analysis for the reflection and transmission characteristics of the materials will be very important. Moreover, a low interference is one of characteristics of the band due to the fact that the millimeter wave is absorbed in the materials. Therefore, in this paper, the reflection and transmission characteristics of materials are measured in the band by using the free space method. Based on the presented result, the permittivities of the materials are derived by the calculation of Nicolson-Ross Weir method.

• Journal of the Institute of Electronics Engineers of Korea TE
• /
• v.42 no.4
• /
• pp.69-76
• /
• 2005

In this paper, a 2 stage 6-pole bandpass filter(BPF) is designed and implemented by using triple-mode cavity for satellite payload system. The BPF has a 100MHz bandwidth at the center frequency of 14.5GHz(Ku-band) and the response of the filter is the Chebyshev function. The cavity filter uses two orthogonal $TM_{113}$ modes and one $TM_{012}$ mode. The coupling between the adjacent cavityes(intercavity coupling) results in a Chebyshev response and is accomplished by only H-filed component of If modes. The size and location of intercavity slot is determined by the coupling equation from E-and H-field of TE and TM resonant modes in circular cavity. The 2-stage 6-pole triple-mode cavity BPF has the insertion loss of 2.4dB and the reflection loss of 15dB in the passband. The triple-mode BPF proposed in this thesis can be used as channel filters for satellite payload system and can minimize filter assembly in general wireless communication system.

• Journal of Advanced Navigation Technology
• /
• v.23 no.6
• /
• pp.507-514
• /
• 2019

Federal communications commissions (FCC) has announced the first set of rules for 3.5 GHz (3,550 - 3,700 MHz) band used Navy radar and fixed satellite service (FSS) earth stations as primary service to sharing for citizen broadband radio service (CBRS) enable development of relatively low powered network technologies like small cells. Since CBRS sharing technique based on the 3-tiered spectrum access system (SAS) is able to protect the higher tiered users from harmful interference from lower tiered users, it has been considered actively to be introduced in Korea. However, 3.5 GHz band had been already allocated to the 5G services in Korea, the sharing studies have been carried out for 3,700 - 5,000 MHz, As the result, the 3.8 GHz (3,800 - 3,900 MHz) band used for only FSS system is able to be sharing, and an introduction of CBRS has been proposed in Korea by analyzing the interference to the FSS earth stations.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2012.10a
• /
• pp.69-72
• /
• 2012

In the bandpass sampling(BPS), the sampling frequency is lower than the frequency of the RF(radio frequency) signal being sampled. In this method, the baseband spectrum directly appears by the sampling itself, so that it is not necessary to use any down converter, making the receiver's hardware simpler. The second-order BPS uses two identical BPS samplers operating with an offset timing to each other. By a processing with their two sampled signals, it can be possible to cancel the aliasing or interference component if any due to the bandpass sampling. The interpolant filter, which is to manipulate the phase characteristics of the sampled signal, affects the performance of the cancellation. In this paper, a multiband interpolant filter is introduced, with which multiple interference signals from multiple RF bands can be cancelled simultaneously. We suggest several phase characteristics for the interpolant filter and have evaluated their performances through computer simulations. It has been shown that the filter with a continuous phase function gives the better performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.10A
• /
• pp.1065-1071
• /
• 2007

In this paper, in order to research spectrum usage efficiency in urban canyon environment at the microwave band, measurement and channel capacity analysis of multi-antenna technology is described. The measurement data obtained from 3 - 4 stories building area used and the propagation characteristics at the 3.7 and 8GHz band are analysed and compared. In case of $2{\times}2$ MIMO, channel capacities of 3.7 and 8 GHz band are calculated to 9.1 bps/Hz and S bps/Hz and in case of $4{\times}4$ MIMO, 21 bps/Hz and 12.5 bps/Hz respectively. Considering the coverage, SNR and channel capacity in urban environment, MIMO propagation characteristics of 3.7 GHz are more predominate than those of 8 GHz.

• Korean Journal of Optics and Photonics
• /
• v.18 no.6
• /
• pp.447-451
• /
• 2007

A triplexer based on a silica planar lightwave circuit Mach-Zehnder nterferometer(MZI) is proposed and its characteristics are analyzed through simulations. To separate 1310 nm band and $1480{\sim}1560nm$ band properly, the path length difference of an MZI is set to be the multiple and half of the wavelength 1310 nm and the balance of the directional coupler is optimized in the $1480{\sim}1560nm$ band. The same MZI is additionally cascaded to provide good crosstalk characteristics. The 1490 nm band and 1550 nm band are further separated using additional two stage MZI's. A three-dimensional BPM and transfer matrix method analysis predicts the low crosstalk characteristics and the fabrication-error-tolerance of the proposed triplexer.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.6
• /
• pp.34-40
• /
• 2011

From the present paper researched about the Design of Image Rejection SSB Modulator for X-Band Monopulse RADAR using Waveguide Hybrid Coupler. Generally, SSB modulator mixes IF(RF) and LO signals, and then it converts to RF(IF) frequency band. In this case, in order to transmit one sideband from RF band, SSB modulator is demanded the removal of image and LO signal. The balanced mixer was designed using waveguide hybrid coupler and crystal mixer diode to mix LO and IF signal. And also the IF Amplifier was designed for IF(+) and IF(-) signal generation which have $90^{\circ}$ phase differences which are suitable in two crystal mixer diode inputs. In order to maintain a high electric reliability from high frequency band the waveguide and IF amplifier's case were manufactured with aluminum using deep brazing techniques. The test result of SSB modulator, LO and sideband signal rejection ratio were 14.2dB and 18.5dB respectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.12
• /
• pp.2313-2327
• /
• 1994

As the communication environment evolves, there is an increasing need for multiresolution image coding. To meet this need, the entrophy constratined vector quantizer(ECVQ) for coding of image pyramids by spline wavelet transform is introduced in this paper. This paper proposes a new scheme for image compression taking into account psychovisual feature both in the space and frequency domains : this proposed method involves two steps. First we use spline wavelet transform in order to obtain a set of biorthogonal subclasses of images ; the original image is decomposed at different scale using a pyramidal algorithm architecture. The decomposition is along the vertical and horizontal directions and maintains constant the number of pixels required the image. Second, according to Shannon's rate distortion theory, the wavelet coefficients are vectored quantized using a multi-resolution ECVQ(entropy-constrained vector quantizer) codebook. The simulation results showed that the proposed method could achieve higher quality LENA image improved by about 2.0 dB than that of the ECVQ using other wavelet at 0.5 bpp and, by about 0.5 dB at 1.0 bpp, and reduce the block effect and the edge degradation.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.8
• /
• pp.35-40
• /
• 2008

This paper proposes a dual-band balun which is based on Wilkinson power divider. By inserting $\lambda/2$ transmission line between port 2 and 3, this balun shows good matching at all ports and improved isolation. We use matamaterial(CRLH, D-CRLH) structure for a miniaturization of the circuit implementation and dual-band operation at TDMB frequency range(195MHz) and DVB-H frequency range(670MHz). The proposed balun is designed with return loss larger than -12.98dB at all port, and isolation larger than -12.4dB, the amplitude imbalance between output signals less than 0.08dB, also phase differences of outputs less than $2.8^{\circ}$.