• 한국주조공학회지
• /
• 제10권6호
• /
• pp.503-508
• /
• 1990

The effect of interlamellar spacing on tensile behavior and fracture mode at high temperatures has been studied for unidirectionally solidified $Al-CuAl_2$ eutectic composite. The tensile properties at room temperature in $Al-CuAl_2$ eutectic composite improved as the interlamellar spacing decreased due to the constraint effects of closely spaced lamellae, while the opposite behavior was observed at high temperatures due to the annihilation of the constraint effects by phase boundary sliding. The $Al-CuAl_2$ eutectic composite exhibited brittle fracture mode below the temperature at which the reinforcing phase softened but ductile fracture mode above the temperature.

• 한국자기공명학회논문지
• /
• 제14권2호
• /
• pp.144-153
• /
• 2010

Conformational properties of several mono-alkyl ester derivatives of p-tert-butylcalix[6]arene depending on temperatures have been investigated by solution NMR spectroscopy. It is found out that all derivatives can adopt a cone-like conformation around room temperature, while the conformational characteristics at high temperatures seem to be quite different each other.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1995년도 추계학술대회 논문집
• /
• pp.85-88
• /
• 1995

In this report the large-signal RF performance of GaN MESFETs at different operating temperatures is investigated using a harmonic balance modeling technique. The predicted device performance calculated by the large-si anal model of a GaN FET is shown to be in good agreement with experimen tar data. It is demonstrated that the optimal RF performance of a GaN MESFET amplifier is achieved by balancing the input impedence for a optimized de sign. A GaN MESFET with the optimized design is predicted to produce maximum RF output power of about 4W/mm and 1W/mm at room temperature and 773 K, respectively. The device produces a peak Power-Added Efficiency (PAE) of 52% and 32% at the two temperatures.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2000년도 추계학술대회 논문집
• /
• pp.162-167
• /
• 2000

The warm deep drawability in square cup drawing is investigated about a newly developed high-strength steel sheet with retained austenite which is transformed into martensite during forming. For this investigation, six steps of temperature ranges, from room temperature to $250^{\circ}C$, and five kinds of drawing ratio, from 2.2 to 2.6 were adopted. As a result the maximum drawing force and the maximum drawing depth were affected by the elevated temperatures, and the more stable thickness strain distribution was observed to the elevated temperatures. But blue shortness happened over $200^{\circ}C$. The FEM analysis using the LS-DYNA code is adopted to compare the experimental results with the analytical results for thickness strain distribution.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2000년도 춘계학술대회 논문집
• /
• pp.164-169
• /
• 2000

The remote measurement system(RMS) as a new experimental method is limited in its application to crack measurements at elevated temperatures because of the oxide layer on the specimen surface. Since TiAlN and Cr coating layers have a high resistance to oxidation and wear, this paper proposed a TiAlN and Cr coating technique for specimens to facilitate the measurement of crack growth behavior using RMS. To investigate the effects of the coating layer, tension and fatigue tests were carried out at room temperature and at 538$^{\circ}C$, using specimens of 1Cr-1Mo-0.25V steel. From the experimental results, it was found that the mechanical properties of the TiAlN and Cr coated specimens were similar to those of the substrate. Accordingly, the TiAlN and Cr coated layer had hardly any influence on the fatigue crack propagation.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 하계종합학술대회 논문집(2)
• /
• pp.201-204
• /
• 2001

LDMOSFET devices operated at low temperature have applications on satellite, space shuttle and low temperature system, etc. In this study, we measured the electrical characteristics of 100v Class LDMOSFET for low temperature application. Measurement data are taken over a wide range of temperatures (100K-300K) and various drift region lengths(6.6${\mu}{\textrm}{m}$, 8.4${\mu}{\textrm}{m}$, 12.6${\mu}{\textrm}{m}$). Maximum transconductance, $g_{m}$ and drain current at low temperatures(~100K) increased over about 260%, 50% respectively, in comparison with the data at room temperature. Breakdown voltage B $V_{ds}$, and specific on- resistance decreased. Besides, ratio $R_{on}$ BV, a figure of merit of the device, decreased with decreasing temperature.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2009년도 하계학술발표대회 논문집
• /
• pp.1418-1423
• /
• 2009

This study describes experimental study on the performance characteristics with load condition in hybrid solar heating system during spring season. The room temperatures, the hot water conditions and the lower part temperatures of heat storage tank were changed to analyze the system performances. As a results, the hot water was significantly affected by the ambient temperature. The indoor setting temperature affected the solar fraction. When the low part temperature of the storage tank increased, the temperature of the hot water rose and the temperature of the hot water in morning was affected by the ambient temperature.

• 한국식품저장유통학회지
• /
• 제4권2호
• /
• pp.139-146
• /
• 1997

The influence of packaging methods(0.03mmPE, 0.05mmPE, 0.1mmPVC, VACUUM) and marketing temperatures(2$0^{\circ}C$, 1$0^{\circ}C$) on the shelf-life and quality were investigated in yam(Dioscorea). Respiration, weight-loss and rotting-rate was reduced in polyethylene film packaging in the order of VACUUM, 0.1mmPVC, 0.05mmPE, 0.03mmPE and the effect was more outstanding at 1$0^{\circ}C$ than 2$0^{\circ}C$. The ethylene concentration of PVC packaging group was higher than that of other packaging methods, which was related with sprouting. firmness was higher in low-temperature than in room-temperature. PPO activity was lower in vacuum than in other packaging methods, which was associated with browning. The shelf-life of yam was the longest in vacuum Packaging, 3 weeks at 2$0^{\circ}C$ and more than 4 weeks at 1$0^{\circ}C$.

• 한국윤활학회:학술대회논문집
• /
• 한국윤활학회 1997년도 제26회 추계학술대회
• /
• pp.86-92
• /
• 1997

When Lubricants is used under severe running condition, tribological characteristics is very important. I have studied the lubricating oil viscosity, kinds of additives and lubricating oil temperatures were changed. In order to study the effect of oil temperature on the wear of the surface, the temperature of the oil was changed for the same sample. Moreover, the temperatures of three kinds of oils which have very different viscosities at room temperature, were varied while the oil viscosity was unchanged. It was shown from the test results that wear is not greatly affected by the amount of ZnDTP antiwear agent, but E-P additives are less effective against wear than ZnDTP additives. The viscosity of lubricating oil and its tempea-ature greatly affect the wear of the surface. Combining all the wear data with those of the surface strength, it was observed that the higher the load, the lower the scratch of wear, and also in the case of the same running load, the lower the wear, the longer the life of the surface strength.

• 한국식품조리과학회지
• /
• 제20권2호
• /
• pp.211-218
• /
• 2004

The issue of safety and quality of cooked food served at foodservice institutions has brought more attention to food scientists because the foodservice system is growing and becoming more popular in Korea. In order to control the quality and safety of cooked foods, the production and holding methods of foods should be carefully studied and the implications considered by the foodservice industry. Therefore, studies on microbiological, nutritional, physicochemical and sensory quality are essential in this area. The purpose of the present study was to evaluate the chemical and microbial qualities of salads during holding. Several holding temperatures in the range of 5∼26$^{\circ}C$ were used for holding. Chicken salad and ham ＆ cucumber salad exceeded the standard after 30min of room temperature holding after preparation. Quality deterioration increased at higher holding temperatures, which suggested that refrigerator holding is the most desirable.