• 수산해양기술연구
• /
• 제47권3호
• /
• pp.248-256
• /
• 2011

The inherent efficiency of a ship would be prior to any other quality factors in ship's safety, because lack of it may give rise to a serious sea casuality even if it were a light mistake in operation. And the representative casualty comes from a deficiency of stability and an operating error combined would be capsizing. The Korean offshore large purseiner looks to have a structural weak point with small range of stability in spite of her big initial metacentric height, and have various type of roll reduction devices in order to cover up the defect. The aim of this study is to grasp for the roll reduction characteristics of the purseiner with bilge keel only and a stern keel additionally attached. The results are summarized as follows; The rolling angle of the model ship was increased in accordance with increase of the wave period and height, especially at close to the natural wave period of her, and the trends were more distinguished in the situation of bilge keel only installation than in the stern keel additionally installed. And stern keel has not noticeable effect on the reduction of the roll in the light ship condition, but has a little effect in full load condition.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2008년도 춘계학술대회 논문집
• /
• pp.2163-2172
• /
• 2008

The noise to be considered as the most important in railway systems is the noise generated from the wheel/rail interaction. Such noise can be divided into three categories; that is, the rolling noise, the squeal noise and the wheel howling noise. Especially in metro systems, this type of noise has been considered seriously in recent years, and the diversified studies on the mechanism and solutions of such noise are in progress by many railways and researching bodies. In this study, a specially designed wheel absorber is installed in the wheel, and FEM analysis and laboratory tests are executed for the two cases, i.e. with wheel absorber and without wheel absorber, to check the effect of the wheel absorber in noise reduction. For the FEM analysis, the frequency response functions for respective cases are compared. And, for the laboratory test, following four cases are tested and compared; that is, i) with wheel only, ii) installation of ring damper only, iii) installation of damping material and cover, iv) installation of complete absorber system.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2009년도 춘계학술대회 논문집
• /
• pp.659-666
• /
• 2009

As the density and height of the buildings nearby subway lines get higher, the unprecedented residents' appeals for noise are on the rise. Furthermore, in accordance with the revision of enforcement regulations on the Noise and Vibration Control Act, the night time noise standards have been reinforced by 5dB effective on January 1st 2010 and the appropriate measures shall be taken accordingly. For the settlement of the public grievances against noise and vibration generated on tracks in at-grade and elevated section, the installation of continuously-welded-rail, rail lubrication system, improved fastening system and higher noise barrier is currently executed. Nevertheless, the noise and vibration levels in some areas are still exceeding the limits required in the regulation. Among the measures, an installation of higher noise barrier or noise tunnel seems to be the most effective way; however, it has limitations owing to the structural stability of existing elevated structures. The paper in consideration of the local conditions and foreign practices discusses the installation of fairing system under the train body as an noise insulation panel in order to reduce the rolling noise and under-carriage noise. Based on the result of this study, a performance verification test during actual train operation is in progress for further study.

• 한국해양공학회지
• /
• 제33권2호
• /
• pp.106-115
• /
• 2019

The interaction between a sloshing liquid damper (SLD) tank and a rectangular pontoon was investigated under the assumption of the linear potential theory. The eigenfunction expansion method was used not only for the sloshing problem in the SLD tank but also for analyzing the motion responses of a rectangular pontoon in waves. If the frictional damping due to the viscosity of the SLD tank was ignored, the effect of the SLD appeared to be an added mass in the coupled equation of motion. The installation of the SLD tank had a greater effect on the roll motion response than the sway and heave motion of the pontoon. One resonance peak for rolling motion showed up in the case of a frozen liquid in the SLD tank. However, if liquid motion in the SLD tank was allowed, two peaks appeared around the first natural frequency of the fluid in the SLD tank. In particular, the peak value located in the low-frequency region had a relatively large value, and the peak frequency located in the high-frequency region moved into the high-frequency region as the depth of the liquid in the tank increased.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2012년도 춘계학술대회 논문집
• /
• pp.499-504
• /
• 2012

The high-speed train enjoys widespread acceptance as environment-friendly means of medium- to long-distance transportation. The pursuit of higher speed and lighter weight in railroad vehicles has engendered higher noise level. In particular, the environmental noise places many restrictions in the operation of high-speed railroad vehicles. This research investigates the effect of installing a skirt onto a high-speed train bogie with the top speed of 400 km/hr and using High Speed EMU for the purpose of reducing the environmental noise. In order to analyze the effect of the interior noise and environmental noise due to installation of the skirt, sound level is calculated using the Ray method and Statical Energy Analysis method. The numerical calculation predicts a reduction of approximately 2 dB in the environmental noise level, but at the cost of increase of approximately 2.5 dB in the interior noise level of the vehicle.

• 지질공학
• /
• 제12권1호
• /
• pp.53-61
• /
• 2002

국내의 경우는 국토의 70%이상이 산지로 구성되어 있어 도로 개설에 따라 필연적으로 절개면이 발생된다. 더욱이 여름철에 집중적으로 발생하는 태풍, 장마에 의해 절개면의 붕괴가 많이 발생하고 있다. 국내 도로절개면 붕괴 중 낙석이 차지하는 비중이 40.8%이며, 토사붕괴는 29.5%를 차지한다. 낙석의 경우, 절개면 상부 암석의 자유운동에 의해 빠른 시간 내에 발생하고, 토사붕괴의 경우, 집중강우와 관련 쇄설성 유동형태로 도로이용에 많은 인명 및 재산피해를 유발한다. 특히 자동차 운행속도와 토사 붕괴 및 낙석이 떨어지는 속도와의 관계를 고려할 대 불과 몇 초의 짧은 시간에 인명피해를 발생시키게 된다. 본 연구는 최근 국도 주변 붕괴 현장 자료를 분석하고 국내 도로절개면의 특성과 붕괴유형을 근거로 낙석 및 쇄설성 유동에 대한 인명피해를 최소화하기 위한 방안으로 낙석 및 쇄설성 유동 발생시 이동시간, 절개면 통과 차량의 속도와 정지거리의 상관성을 검토하여 도로 경보시스템의 설치기준을 제시하는데 있다. 경보시스템은 낙석발생과 동시에 작동하여 운전자로 하여금 붕괴위치로의 이동을 사전에 차단시킴으로 피해를 최소화한다.