• Journal of the Korean Society for Railway
• /
• v.9 no.4 s.35
• /
• pp.493-498
• /
• 2006

In this study, two large pile load tests were performed in the deep sand gravel deposit of Nakdong river basin so that the characteristics of the load transfer was identified. The fully instrumented rectangular barrette pile in the size of $1.5\times3.0m$ and the circular bored pile of the diameter 1.5 m were placed into the ground below 50 m. Under the applied loads of 2,400 tonf and 4,000 tonf, the test results of the load transfer showed the portion of 83% and 93% of the applied loads on the barrette pile and the bored pile, respectively, were supported by the skin friction along the pile shaft. It was revealed that the most of these skin friction mobilized in sand layer underlying clay layer having N-value more than 30 and that the friction per unit area of the bored pile was larger than the friction of barrette pile. However, if embedded in the stiff sand graval layer, the both piles were proven to be sufficient for using as the friction piles.

• International Journal of Ocean System Engineering
• /
• v.1 no.4
• /
• pp.185-191
• /
• 2011

This research was described the prevention of coastal topographical change and sediment diffusive concentration incoming from small estuary after construction jetties. This structure is constructed to decrease sediment deposition incoming from the upstream river due to the urbanization and industrial development and to minimize effects on the coastal ecosystem. The physical modeling and numerical modeling for waves were conducted to analyze the configuration of Imrang sand beach deformation without and with construction of jetty. The specification of the installed jetty, which is able to control sedimentation concentration was decided based on the prediction of the Imrang beach area changes by space and time. As a result, the jetties constructed in the estuary retarded the rate of sand sediment, so that the effect area of sand sedimentation was obviously decreased. In addition, the measured field data indicated that the sediment deposition inside of dikes could be controlled and the right side area of jetties could be preserved without sediment deposition.

• Geotechnical Engineering
• /
• v.6 no.3
• /
• pp.41-52
• /
• 1990

To investigate the liquefaction potential of sands, a series of untrained cyclic triaxial compression tests is carried out on the samples of Ottawa, Joomoonjin, Hn river and Hongseung sands. The constitutive equations of sands are derived to explain the mechanical behavior of sands under cyclic stresses, and are applicable to liquefaction analysis. The following results are obtainded in this study. 1. Sands with the lower confining pressure or relative density are to be easily liquefied, and when the amplitude of cyclic stress are large, liquefaction takes places over only a few cycles. 2. Stress ratio, porewater pressure ratio and cyclic shear strains are to be good criteria to evaluate liquefaction potential of sands. 3. Hongseung sands which contains some silty clay shows higher dynamic properties than other sands. 4. The dynamic behaviors of undisturbed Hongseung sand are about same as those of dense sands. It is noted that undisturbed Hongseung sand shows higher liquefaction potential than the samples made by pluviation under same relative density, 5. The constitutive equations of soils under cyclic loads are developed based on the theory of elasto-plasticity, logarithmic stress-strain rela'tionship, non-associated flow rule and the concept of the boundary surface. The derived equations is applicable to predict the behavior of sands under cyclic loads and liquefaction potential with a higher accuracy. 6. Based on results of the study it may be concluded that cracks of the foundations and dislocation of the structures at Hongseung earthquakes(Oct. 7, 1978, Richter scald 5.2) are not brought by the liquefaction process.

• Water for future
• /
• v.11 no.1
• /
• pp.39-46
• /
• 1978

The approaching deep water wave heights and directions affect the wave energy which is carried to the coast. By studing the relations between the longshore wave energy theory and the evolution of coastline, writer can arrive following conclusion. The longshore lottoral drifting affects to a great deal the formation of the coast, and by investigating on the eastern coastal geomophorogy of korea, the theory was proued as a true and made it possible to an approaching to the subdivided classification of eastern coast of lorea. That is to asy that angle taken by the level between the wave crest line of prevailing wave(NE) and the coastline was measured as less than 15#, and in the area neighboring the river which served as source of Sand parrticles, there are grand scale formation of sand beach expectable, in the other hand the formation of sand beach in case of $35^{\circ}{\leq}{\alpha }o{\leq}55^{\circ}$ which represents the vivid phenomena of longshore littoral drifting was proved not influencial but rather transformed into a rocky coast. Depending on the above facts the writer classified general shape of the coast affected by the vivid wave action into the following three, (1) The equilibrium beach. (2) Erosinal beach. (3) Geomophorogical beach, and made the sandy and rocky coast are subdivided as S-A.B.C. and R-DEF.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1998.04b
• /
• pp.731-736
• /
• 1998

The dynamics and Durability of Permanent Form Mortar were observed. The results were as the followings. To construct New permanent form, this study constructed permanent form with fiber mortar. In this course glass fiber and polymer, fine aggregate were substituted with river sand and crush sand. To understand material quality effect, flexible mortar and inflexible mortar were tested. According to the microstructure of polymermatrix test by SEM, higher density by Co-matrix effect from polymer addiction was observed. This is considered to increase acid-resistanc, impact proof strenght. In the test of durability of freezing and thawing, polymer mortar was proved to be water proof. It seems to be improved in its characteristics in proportion to increasing W/C ratio. When the W/C ratio is 30%, it is most effective.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.11a
• /
• pp.129-134
• /
• 2001

The purpose of this study is to investigate properties of unsaturated polyester mortar using the shale as find aggregates. To evaluate properties of unsaturated polyester mortar using crushed sand from Black shale, Red shale, Gray shale, we peformed the experiment according the F/B ratio of 25, 30, 35% and the volume of fine aggregate of 50, 53, 56%. The Result of this study is as follows. the strength of unsaturated polyester mortar is higher than those of river sand. The F/B ratio is higher and the volume of find aggregate is lower, the strength of unsaturated polyester mortar is higher

• The Korean Journal of Quaternary Research
• /
• v.8 no.1
• /
• pp.33-42
• /
• 1994

The study area is filled up by alluvium which can be classified into lower and upper beds by the facies of deposits and their degree of weathering. The lower bed is not of marine but of fluvial. The upper bed is mainly composed of clay and silt or fine sand beds col-ored dark or dark gray which are of neritic or brackish yielding mollusca fossils. The oyster(Crassostrea ariakensis) obstained from the depth of 3m below the present sea level in the upper bed was dated at 4,100 110Y.B.P. and the veneridae(Meretrix lamarck) 1m height above the present delta plain in the old sand bar was dated at 1,700 85Y,B,P. It is therfore concluded that the study area a small kern col of terrestri-al basin prior to postglacial age had experienced the Holocene transgression. Consequently the study area is considered to have been progressively formed under neritic or brackish circumstance before 1,700Y.B.P.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.311-317
• /
• 2008

This study was carried out to improve our understanding about the influence of silt content on the stress-strain of sand under cyclic loading. Soil specimens were prepared by wet-tamping method as same void ratio and specimen's silt contents on total weights was changed from 0% to 20%. Also, effects of the silt contents on the stress-strain response were studied at different anisotropic consolidation ratio, Kc=1.0, 1.5, 2.0 condition. As a result, cyclic shear strength decreased as silt contents increased in same stress ratios. In same silt contents, cyclic shear strength increased as Kc increased in lower silt contents, but in higher silt contents, it had reverse results.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2000.10a
• /
• pp.395-398
• /
• 2000

Recently, increasement of usage contents of sea sand in constructing concrete structures due to insufficiency of high quality river sand, led to many studies for steel corrosion and control methods on it in concrete. But, domestic studies for threshold chloride contents of steel corrosion are not so many as those of foreign states. In this study, the electrochemical test as half cell potential measurement and linear polarization method to estimate the corrosion of steel in contents mixed with several levels chloride contents was performed, thereby, pre-mixed chloride were compared with results measured quantitatively for steel corrosion. And, based on these data, a trial to determine threshold chloride contents of steel corrosion was made.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2003.11a
• /
• pp.322-325
• /
• 2003

Recently, as quality river aggregates like sands and gravels become scarce, use of crushed stones and sands, seashore sands, and seashore gravels is increasing abruptly. And, aggregates recycled from slags and waste concretes are used. However, since the converter slag easily expands and breaks due to free lime, differently from the blast-furnace slag, it is not suitable for use as concrete aggregates. Since the atomized steel slag aggregate has slippery surface and spherical shape, the mortar flowing characteristics improved as the atomized steel slag content increases, without regard to the aggregates coarseness and water/cement ratio. The flow characteristics loss rate of the mortar manufactured from steel slag aggregates was similar to that of the mortar manufactured from washed sand only. The compact strength of the mortar manufactured from coarse PS Ball were larger than that manufactured from washing sand only.