• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• 제23권12호
• /
• pp.1327-1336
• /
• 2012

In this paper, the dual-faced monopole antenna, which is arranged by numerous rectangular ring patches in sequence for the multi-bands is proposed. The ring type structure of the patch can be increased the bandwidth. Therefore the bandwidth and beam width are improved by using multiple arrayed patches. When the ring type patches are inserted serially, the resonance frequencies are occurred by the current flow from the first ring patch. It is possible because the gap between the patches is very narrow. In addition, if the patches are composed on the same plane as the feed-line, fabrication could be very difficult because the gap between the patches is extremely narrow. The thickness and permittivity of the antenna, moreover, are very important parameters because both sides of the substrate are used. We finally found the optimal thickness and permittivity to generate the coupling effect by simulation. All patches are consisted of 4-steps which the patch size was decreased 85 % by each step. In conclusion, the resonant frequency bands are 1.75~2.6 GHz(850 MHz), 3.24~3.46 GHz(220 MHz), 3.8~4.0 GHz(200 MHz), and 4.4~4.9 GHz(500 MHz).

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• 제33권6호
• /
• pp.64-70
• /
• 2005

The overall results of hot firing tests of fuel-rich gas generator with impinging injector at design and off-design points are described. The gas generator consists of an injector head with impinging injector, a water cooled combustor wall, a turbulence ring to enhance mixing, an instrument ring measuring temperature and pressure and a nozzle. The combustion tests were successfully performed without damage of gas generator. Test results show that the outlet temperature is not dependent on residence time of hot gas within 4～6msec but dependent on chamber pressure. The relation between outlet temperature and combustion efficiency resulting from measured pressure, mass flow rate and area of nozzle throat is shown. The overall O/F ratio is the critical parameter to determine the outlet temperature and the linear correlation between two parameters is established.

• The Journal of the Petrological Society of Korea
• /
• 제28권4호
• /
• pp.237-249
• /
• 2019

The volcanic rocks around the Jayang caldera are classified in an order such as Jukjang Volcanics, Doil Rhyolite, Unjusan Tuff and Rhyolite intrusions. By the SHRIMP U-Pb zircon datings from zircons, eruption ages of the Unjusan Tuff are constrained as 66.65±0.96 Ma in the intracaldera, and 66.08±0.62 Ma in the extracaldera outflow, and intrusion age of the ring dike is investigated as 60.74±0.66 Ma. The age data indicate that the caldera was collapsed between 66.08 Ma and 60.74 Ma, just before the dike intruded after the explosive eruption of the Unjusan Tuff. The Jayang caldera shows the composite igneous process of a perfect volcanic cycle passing from ash-flow tuffs through caldera collapse into ring dikes in the Jayang area.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• 제19권7호
• /
• pp.1256-1271
• /
• 1994

In this paper a GFC protocol based on HMR(High-speed Multimedia Ring) with a dynamic quota allocation is proposed and the performance of proposed protocol is evaluated by simulation. The HMR a medium access protocol proposed for Gbit ATM-LAN, can be applied to the GFC protocol without any modification because it uses only 4 bits for medium access of several topologies such as bus, ring and stared-bus, and priority control for satisfaction of different QoS(Quality of Service) requirements. The quota allocation method of HMR called static quota allocation has a problem of excessive access delay for the traffic with high burstness. In this paper a dynamic quota allocation method which allocates quota to the nodes according to the queue length is proposed and the performance of HMR with dynamic quota allocation is evaluated by seven simulation scenarios of CCITT. The HMR with proposed method shows better shows better access delay characteristics than the HMR with static quota allocation. Also the simulation results show that access delay performance of HMR is better than that of ATMR proposed by Japan and is similar to that of DQDB proposed by Australia.

• Transactions of Materials Processing
• /
• 제29권5호
• /
• pp.257-264
• /
• 2020

This paper is concerned with the influence of the plastic property of the rivet on the numerical prediction of the Self-Piercing Rivet (SPR) Joining. In order to predict the plastic property of the rivet, a ring compression specimen was directly fabricated from the rivet used for the mechanical joining of dissimilar materials, and the FE analysis together with the ring compression test was iteratively carried out by changing the plastic property of the rivet. For reliable FE analysis, a friction coefficient was estimated based on a friction calibration curve, measuring the reductions in inner diameter and height of the ring specimen after the compression test. From each simulation result, the force-displacement curves were then compared from each other so as to obtain the rivet plastic property that shows good agreement with the experimental result. The SPR joining between GA590 1.0t and Al5052 2.0t was conducted, and the numerical prediction was performed with the use of the plastic property evaluated based on the inverse analysis and the one referred from Mori et al. [11]. Comparison of the experiment and the numerical predictions in terms of the interlock and bottom thickness revealed that the reliable evaluation of the plastic property of the rivet is necessary for the trustworthy numerical prediction of the SPR joining.

• Journal of the Korean Society of Propulsion Engineers
• /
• 제17권2호
• /
• pp.9-15
• /
• 2013

An effect of a spiral turbulent ring, so-called Shchelkin spiral, on a detonation performance was studied experimentally for acetylene and oxygen mixture. A couple of dynamic pressure transducers were used to calculate a detonation wave velocity by a time difference between two pressure peaks. In addition, impulse was measured by a load cell and the impulse was used to analyze the spiral effect on the detonation performance. A CFD analysis was adopted to calculate mass flow rates of the propellants and the minimum filling time. The maximum velocity and pressure were measured at the equivalence ratio of 2.4, and the measured values showed similar trend to C-J conditions calculated from CEA. For the shorter chamber with the short spiral, the maximum detonation velocity was appeared. In contrast, the longer chamber without the spiral showed the maximum thrust performance.

• Journal of the Korean Chemical Society
• /
• 제67권6호
• /
• pp.407-414
• /
• 2023

The present study uses quasi-classical trajectory procedures to examine the vibrational relaxation and dissociation of the methyl and ring C-H bonds in excited methylpyrazine (MP) during collision with either N₂ or O₂. The energy-loss (-ΔE) of the excited MP is calculated as the total vibrational energy (E_T) of MP is increased in the range of 5,000 to 40,000cm^-1. The results indicate that the collision-induced vibrational relaxation of MP is not large, increasing gradually with increasing E_T between 5,000 and 30,000 cm^-1, but then decreasing with the further increase in E_T. In both N₂ and O₂ collisions, the vibrational relaxation of MP occurs mainly via the vibration-to-translation (V→T) and vibration-to-vibration (V→V) energy transfer pathways, while the vibration-to-rotation (V→R) energy transfer pathway is negligible. In both collision systems, the V→T transfer shows a similar pattern and amount of energy loss in the ET range of 5,000 to 40,000cm^-1, whereas the pattern and amount of energy transfer via the V→V pathway differs significantly between two collision systems. The collision-induced dissociation of the C-H_methyl or C-H_ring bond occurs when highly excited MP (65,000-72,000 cm^-1) interacts with the ground-state N₂ or O₂. Here, the dissociation probability is low (10^-4-10^-1), but increases exponentially with increasing vibrational excitation. This can be interpreted as the intermolecular interaction below E_T = 71,000 cm^-1. By contrast, the bond dissociation above E_T = 71,000 cm^-1 is due to the intramolecular energy flow between the excited C-H bonds. The probability of C-H_methyl dissociation is higher than that of C-H_ring dissociation.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• 제16권5호
• /
• pp.3044-3050
• /
• 2015

The purpose of this study is to analyze the performance of the flow control oil pump for automatic transmission. The numerical model for analysis the performance of the flow control oil pump was develop and the characteristics of the internal flow, discharge flow rate, displacement of outer ring, driving torque, generation of cavitation was investigated according to rotating speed. As a result, the cavitation generation increased as the rotating speed increased. The volumetric efficiency was 90% for 2200 rpm and it decreased rapidly, then it decreased about 81% for 5000 rpm. Besides, the cavitation generation was 20%~30% for inlet of suction part, but it reduced below 13% owing to the compression. However, it shows higher cavitation generation for high rotating speed like 5000 rpm.

• Proceedings of the KSME Conference
• /
• 대한기계학회 2007년도 춘계학술대회B
• /
• pp.3068-3073
• /
• 2007

Aerodynamic forces and moments have been used to control rocket propelled vehicles. If control is required at very low speed, Those systems only provide a limited capability because aerodynamic control force is proportional to the air density and low dynamic pressure. But thrust vector control(TVC) can overcome the disadvantages. TVC is the method which generates the side force and roll moment by controlling exhausted gas directly in a rocket nozzle. TVC is classified by mechanical and fluid dynamic methods. Mechanical methods can change the flow direction by several objects installed in a rocket nozzle exhaust such as tapered ramp tabs and jet vane. Fluid dynamic methods control the flight direction with the injection of secondary gaseous flows into the rocket nozzle. The tapered ramp tabs of mechanical methods are used in this paper. They installed at the rear in the rocket nozzle could be freely moved along axial and radial direction on the mounting ring to provide the mass flow rate which is injected from the rocket nozzle. In this paper, the conceptual design and the performance study on the tapered ramp tabs of the thurst vector control has been carried out using the supersonic cold flow system and shadow graph. Numerical simulation was also performed to study flow characteristics and interactions between ramp tabs. This paper provides to analyze the location of normal shock wave and distribution of surface pressure on the region enclosed by the tapered ramp tabs.

• The Journal of the Petrological Society of Korea
• /
• 제7권3호
• /
• pp.161-176
• /
• 1998

There are exposed Samrangjin Tuff and intracaldera intrusions, of which rhyolitic rocks emplaced as postcollapsed central and ring intrusions within the Samrangjin caldera, and fine-grained granodiorite and biotite granite as regional tectonic intrusions nearby. The Samrangjin Tuff and the rhyolitic rocks are of a single Samrangjin magmatic system. Flow-banded rhyolite among rhyolitic rocks was emplaced in the outer part of the ring intrusions, rhyodacite in the inner part of the eastern ring, and porphyritic dacite and dacite porphyry in the inner part of the northwestern ring. Totally the Samrangjin Tuff and the rhyolitic rocks range from rhyolite to dacite in chemical composition. The Rb-Sr isotopic data of the Samrangjin Tuff and the rhyolitic rocks yield an age of $80.8{\pm}1.5(2{\sigma})$ Ma with the initial $^{87}Sr/^{86}Sr$ ratio of $0.70521{\pm}0.00010(2{\sigma})$. The continuous compositional zonations generally define a large stratified magma system in the postcollapse magma chamber. The Sr isotopic data suggest that the compositional zonations might have resulted from the fractional crystallization of a parental dacitic magma.