• Journal of electromagnetic engineering and science
• /
• v.14 no.4
• /
• pp.367-375
• /
• 2014

In this paper, a novel triple-band circular-ring monopole antenna with a half-circular ring and ground slot for wireless local area network/Worldwide Interoperability of Microwave Access (WLAN/WiMAX) applications is proposed. The proposed antenna consists of one circular ring, a half-circular ring and a rectangular slot in the ground plane. Based on the concept, a prototype of the proposed triple-band antenna was designed, fabricated and tested. The numerical and experiment results demonstrated that the proposed antenna satisfied the -10 dB impedance bandwidth requirement while simultaneously covering the WLAN and WiMAX bands. Furthermore, this paper presents and discusses the 2D radiation patterns and 2D gains according to the results of the experiment.

• Journal of information and communication convergence engineering
• /
• v.12 no.1
• /
• pp.1-7
• /
• 2014

A novel design of a simple circular ring with open-ended monopole antenna for wireless local area network (WLAN) applications is proposed in this article. The proposed antenna consists of an open-ended circular ring and $50-{\Omega}$ microstrip feed-line. The proposed antenna is capable of generating two separate resonant modes with good impedance-matching conditions. A prototype of the proposed antenna is designed, fabricated, and measured. Acceptable agreement between the measurement and simulation results is achieved. Experimental results show that the proposed antenna has operating bandwidths of 1.99-3.04 GHz and 5.08-6.1 GHz with a return loss of less than -10 dB, covering the required bandwidths of the 2.4/5.2/5.8-GHz WLAN standards. This is a microstrip antenna for IEEE 802.11a/b wireless local area networks applications. Meanwhile, the two-dimensional (2D) radiation patterns and three-dimensional (3D) gain performance of the antenna are also observed and discussed.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2000.11a
• /
• pp.319-323
• /
• 2000

A method for miniaturization of microstrip patch antenna without degrading its radiation characteristics is investigated. The ring geometry introduces additional parameters to the antenna that can be used to control its resonance frequency and bandwidth. For a single square ring increasing the size of patch decreases the resonance frequency and bandwidth. To match the antenna to a transmission line and also enhance its bandwidth. the square ring patch is stacked by a square ring patch. The computed results are compared with experiment and good agreement is obtained.

• Journal of Broadcast Engineering
• /
• v.21 no.3
• /
• pp.404-411
• /
• 2016

In this paper, we investigate the radio wave radiation pattern to measure the actual field strength for the transmission antenna dipole antenna and the CP-ring antenna being used in our country as FM station, and the comparison was for field application. Compare results, If the transmitting station and the relay station which is located in the middle of a service area has been a useful CP-dipole antenna (four directions). CP-ring antenna having a directivity because the reflection effect of the tower was able to adjust the orientation to prevent the spread of menstrual another service area in the main direction was able to radiate high propagation 5~9dB. Especially, If the transmitting station and the relay station is located on one side of the service area for radiating radio waves in three directions by using the CP-ring antennas focus the orientation of the antenna in populated areas and road area can improve the broadcast reception environment.

• Journal of electromagnetic engineering and science
• /
• v.13 no.1
• /
• pp.8-15
• /
• 2013

This paper presents a novel design for a simple rectangular ring with an open-ended monopole antenna that is well suited to DCS/PCS/UMTS/WLAN applications for dual-band operations. A microstrip-fed rectangular monopole antenna is first designed and then modified to introduce the rectangular ring with an open-ended antenna and a rectangular slit in the ground plane. Prototypes of the proposed antenna were fabricated and tested. The antenna, resonating at 1,405 MHz and 4,840 MHz, has a -10 dB impedance bandwidth of about 1,695 and 1,530 MHz (1,220~2,815 and 4,495~6,025 MHz), or about 79.06 % and 29.09 %. The observed 2D radiation patterns and 3D gain performance of the antenna in the operation bands are discussed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.4
• /
• pp.351-356
• /
• 2009

A dual-mode annular ring antenna for both global positioning system(GPS) and satellite digital multimedia broad-casting(DMB) is designed. The proposed antenna consists of a coupling feed line and four slots on the annular ring patch. The gap between the feed line and the annular ring patch is used for an input impedance matching, and the slot length is used for adjusting the resonant frequency of the $TM_{21}$ mode at the DMB frequency. The antenna was fabricated and measured. The experimental results show that the antenna resonants at the GPS and DMB frequencies with suitable bandwidths, and had a broadside radiation pattern at the GPS band and a conical beam radiation pattern at the DMB band.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.61 no.3
• /
• pp.149-152
• /
• 2012

In this paper, a wideband monopole antenna with ring loop by modified ground plane is presented. The proposed antenna consist of monopole antenna, ring loop by ground plane. This antenna is fed CPW-fed and wide slot antenna of a novel structure for broadband characteristics is proposed. To enhance the impedance bandwidth of the wide slot antenna, we proposed the wide slot structure with CPW-fed which is combined with four ${\lambda}/2$ rectangular radiation modified monopole and inductively coupled. The measured impedance bandwidth is about 2.5 GHz(3.65~6.15 GHz) then less -10 dB.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.2 no.4
• /
• pp.28-41
• /
• 2003

A micros-strip ring patch antenna with ultra wide band characteristics is presented. The proposed antenna is designed by a modified form of the annular ring patch antenna with modified microstrip feedline. The designed antenna gives 5.6GHz bandwidth with regular radiation pattern from 4.4GHz to 12.0GHz for -10dE return loss or VSWR of less than 2.0 in simulation, which is also excellently agreed with the measured data.

• Journal of information and communication convergence engineering
• /
• v.10 no.4
• /
• pp.321-328
• /
• 2012

A novel design for a simple rectangular ring with open-ended monopole antenna wireless local area network (WLAN) applications is proposed in this article. The proposed antenna consists of an open-ended rectangular ring, an inverted L-strip, and a rectangular slit in the ground plane, and is fed by a 50 ${\Omega}$ microstrip feed-line. Prototypes of the proposed antenna were designed, fabricated, and tested. Experimental results show that the proposed antenna receives 2.3125-2.775 GHz and 4.8625-6.7125 GHz with a return loss less than -10 dB, covering the required bandwidths of the 2.4/5.2/5.8 GHz WLAN standards. Meanwhile, the 2D radiation patterns and 3D gain performance of the antenna in the operation bands were also observed and discussed.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.8
• /
• pp.448-454
• /
• 2004

In this paper, circular polarized antennas of Tx 30GHz and Rx 20GHz are implemented in LTCC process. Tx antenna has a circular patch structure and Rx antenna has a ring patch structure. The feeding line of Tx antenna is placed in the center hole of Rx ring patch antenna which is printed under Tx circular patch antenna layer. It makes antenna size smaller. Tx antenna's return loss in under -l0dB level from 30GHz to 31GHz and Rx antenna is under -10 dB from 20GHz to 21GHz. The isolation between two antennas is less than -20dB. Axial ratio is less than 3dB thoughout each band.