• The Korean Journal of Nuclear Medicine
• /
• v.23 no.1
• /
• pp.41-48
• /
• 1989

$^{99m}Tc-Pertechnetate\;(TcO_4^-)$ is concentrated by the stomach after intravenous injection, allowing the detection of ectopic gastric mucosa. It has been used to develop a noninvasive test of gastric secretion. However the cellular site of concentration is still controversial, that is whether mucin-secreting epithelial cell or acid-secreting parietal cell. This study is planned to investigate the effects of cimetidine and gastric acidity on the retention of $TcO_4^-$ in the gastric wall of the rat. Also we further attempted to clarify the uptake and secreting cell of $TcO_4^-$ in the gastric mucosa. One hundred rats were divided into two groups, preliminary (40 rats) and main examination group (60 rats). Preliminary examination group was composed of fasting group (20 rats) for the detection of the time for reaching stable $TcO_4^-$ retention ratio in gastric wall and post-prandial group (20 rats) for the detection of the time for reaching the maximal gastric acidity. Main examination group was composed of fasting group (30 rats), which was subdivided into control group (10 rats), cimetidine group (10rats), $Mylanta^{(R)}$ group (10 rats) and post?prandial group (30 rats), which was subaivided into 90 min group (10 rats), 90 min cimetidine group (10 rats), and 120 min group (10 rats). Retention ratio (%) of $TcO_4$ in the gastric wall and the pH of the gastric contents were measured in the extracted stomach of the six groups. Gastric wall retention ratio of $TcO_4^-$ was calculated by the gastric wall radioactivity (cpm) divided by total gastric radioactivity (cpm) at 30 mins after intravenous injection of 0.4 mCi of $TcO_4^-$. The results were as follows: 1) The time required for reaching stable $TcO_4$ retention ratio and the lowest gastric PH were 30 min and 90 min, respectively. 2) In the fasting group, the gastric wall retention ratio of $TcO_4^-$ was significantly increased in the cimetidine group, compared with the control group (P < 0.01). However there was no significant difference between the control and $Mylanta^{(R)}$ group 3) The $TcO_4^-$ retention ratios of 90 min and 120 min groups were lower than that of the fasting control group (p < 0.05), either. After administration of cimetidine, the retention ratio was significantly increased in 90 min group (p < 0.01). 4) While $TcO_4^-$ retention ratio and gastric pH were well correlated in the post-prandial 120 min group (r=0.7112, p<0.05), in the post-prandial 90 min and 90 min cimetidine groups correlated poorly. However, there was no correlation in the three fasting groups at all. Referring the above results, we infer that $TcO_4^-$ is secreted into the gastric lumen by both parietal and non-parietal cells, with dominant non-parietal $TcO_4^-$ secretion in the fasting state and dominant parietal $TcO_4^-$ secretion in the stimulated state.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.44 no.4
• /
• pp.25-31
• /
• 2012

Ionic trash in furnish decreases retention and drainage performance of the microparticle retention system using recycled fibers in closed papermaking system. Two retention systems, such as the microparticle system and the PEO/cofactor system, were compared and analyzed to improve retention. The PEO/cofactor system achieved similar retention performance at low addition level as the microparticle system. Optimum ratio of PEO/cofactor dual polymer system was 1:10. Ash retention was increased when using the fixing agent. As the TMP ratio increased, the PEO/cofactor system was more efficient in retention and drainage than the other system. The high molecular weight and non-ionic polymer retention system had less effect on flocculation hindrance than the traditional electrostatic retention system.

• Journal of environmental and Sanitary engineering
• /
• v.11 no.3
• /
• pp.63-68
• /
• 1996

This study was to discuss limiting factors influenced on the removal efficiencies of nitrogenous compounds investigated using the polypropyrene media which was to attach microorganism in order to apply the fixed-biofilm process. The main limiting factors are the hydraulic retention time (HRT), C/N ratio, $COD/NO_{3}-N$ ratio and temperature. The hydraulic retention time HRT were 6, 8, 10, 12 hrs and the C/N ratio range was 2.5-9.5. The $COD/NO_{3}-N$ ratio range was 3.2-21.9 and the temperature were 15, 20, 25, 30, $35^{\circ}C$, respectively. The results of this study are summerized as follows. 1. Hydraulic retention time (HRT) to obtain removal efficiencies of T-N higher than 85% had to be 10 hrs above. 2. The removal efficiencies of T-N decreased at C/N ratio from 6.2 to 4.8 in this anoxic-contact aeration system. 3. Denitrification rate decreased at $COD/NO$_{3}$-N$ ratio from 8.0 to 5.0 4. As temperature increased, removal efficiencies of T-N increased.

• The Journal of Korean Academy of Prosthodontics
• /
• v.38 no.2
• /
• pp.214-225
• /
• 2000

The purpose of this study was to investigate the effects of investing conditions on the marginal discrepancy of conical telescope outer crown with Co-Cr-Ti alloy(Dentitan) and to compare the marginal discrepancy and the retention force of outer crowns using different pattern materials(plastic foil, casting wax, pattern resin). To evaluate the effects of investing conditions on the marginal discrepancy, patterns with plastic foil were invested under three different liquid/powder ratio conditions using phosphate bonded investment(Univest-nonprecious): standard, 10% decreased and 10% increased. At each liquid/powder ratio condition, metal ring was lined with single or double layers of ceramic ring liner. The marginal discrepancy of outer crown at different investing conditions was measured by ${\times}100$ compact measuring microscope(STM5, Olympus, Japan). For measurement of the marginal discrepancy and the retention force of outer crown using different pattern materials, the investing condition of 10% decreased liquid/powder ratio and double layers of ring liner was selected because this investing condition resulted in the best fit of outer crown. Marginal discrepancy was measured in the same way above and retention force on universal testing machine. Under the conditions of this study, the following conclusions were drawn: 1. The thickness of ring liner had more influence on the marginal discrepancy of outer crown than the liquid/powder ratio, and the acceptable marginal fitness could not be expected at the investing condition directed by investment manufacturer 2. There were no differences in the marginal discrepancy of outer crown among three different pattern materials(P>0.05). 3. Casting wax showed the greatest retention force(1640g) of outer crown, followed by pattern resin(1110g), plastic foil(820g). However, there was no significant difference between plastic foil and pattern resin(P>0.05). 4. Plastic foil showed the least variation in marginal discrepancy and retention force.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.40 no.5
• /
• pp.1-10
• /
• 2008

Synthetic mineral microparticles (SMM) is a patented system which has been developed to promote drainage of water and retention of fine particles during papermaking. It is shown in patents that the SMM system can have advantages in both of drainage and retention, compared with montmorillonite (bentonite), which is one of the most popular materials presently used in this kind of application. Turbidity and gravity drainage time were measured using a Britt-Jar test with representative SMM formulations, in order to confirm the efficacy of SMM covering a wide range of compositions and discover effects of some key variables that have the potential to lead to unexpected advantages in terms of the effectiveness of the microparticles, when used in combination with a cationic polyacrylamide treatment of papermaking furnish. An iron silicate showed highest retention performance, as well as suitably fast drainage time relative to other metal silicate and bentonite. Zinc silicate improved retention and drainage. SMM synthesized from aluminum sulfate ($Al_2(SO_4){_3}$) did not show a benefit in retention and drainage, relative to bentonite. SMM synthesized from aluminum chloride ($AlCl_3$) performed better in drainage and retention than bentonite when the Al/Si ratios were 0.76 and 1.00. It was found that when the Al/Si ratio and neutralization are considered, pH variation due to the change of Al/Si ratio can be a key factor to control the size of primary metal silicate particles and the degree of coagulation of the primary particles.

• Journal of the Korean Geosynthetics Society
• /
• v.16 no.4
• /
• pp.57-66
• /
• 2017

Self-weight consolidation test and soil property of dredged soil at Incheon habour route were analyzed to determine the initial dredging reclamation amount, reclamation depth, and estimating the required time of self-weight consolidation with calculation of the final planned height of dredging reclamation site. The moisture content, void ratio and ratio of volume change with elapsed time after throwing were estimated through Yano's empirical equation. As a result, there was a less variation in elements when fine-grained soil content was low as similarly to the behavior of coefficient of sedimentation-consolidation, Cs and the highest variation was shown at the fine-grained soil content of 50%. The retention ratio according to the fine grained soil content that could reinforce the comprehensive aspect of retention ratio for each particle size presented in the standard of estimate for reclamation construction work was calculated and presented using the calculated ratio of volume change.

• Asian-Australasian Journal of Animal Sciences
• /
• v.11 no.6
• /
• pp.718-724
• /
• 1998

Twelve gilts were used to investigate the effect of lysine to protein ratio (5.2 g lysine/100 g CP vs. 6.7 g lysine/100 g CP) in practical diets on nitrogen retention and the efficiency of utilization in growing pigs. Treatments involved 2 levels of dietary lysine (5.2 or 6.7 g/100 g CP) and 3 levels of dietary crude protein (11, 14 and 17% in diet). Nitrogen retention was greatest when pigs were fed the control diet containing 17% protein. Nitrogen retention progressively increased as dietary protein increased (p < 0.01), but it was not affected by lysine concentration (g/100 g CP). Apparent biological value (ABV, nitrogen retained/apparently digestible nitrogen) was estimated to be ~50% at the maximum nitrogen retention. ABV was not affected by lysine concentration, but declined (p < 0.05) as the dietary protein level increased. The efficiency of intake N used for maximum nitrogen retention was approximately 44%. One gram of lysine supported approximately 9 to 10 g apparent protein accretion (nitrogen retention ${\times}$ 6.25/lysine intake) in pigs fed control diets. The efficiency of lysine utilization for protein accretion was lower in pigs fed high-lysine diets (6.7 g lysine/l00 g CP) so that 1 g of lysine accounted for 7 to 8 g of protein accretion in these pigs (p < 0.01). The lysine required to support maximum nitrogen retention in pigs fed high-lysine diets was higher than that in pigs fed control diets, which suggests that lysine was over-fortified relative to crude protein, since practical diets can not be formulated without excess of some amino acids. In summary the concentration of 5.2 g total lysine/100 g CP in diet is more appropriate for corn-soybean diets than the commonly suggested the content of 6.7 g total lysine/100 g CP.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1998.10c
• /
• pp.93-98
• /
• 1998

Fluidity retention of concrete used high range water reducing AE agent(HWAE) is varied according to type, dosage amount and dosing method of HWAE. The type and substitution ratio of mineral admixture also have influence on the fluidity retention of concrete using HWAE. For the purpose of improving the fluidity retention in concrete used HWAE, 3 types of HWAE and ground granulated blast furnace slag(SG) are applied in cement-based composites such as cement paste, mortar and concrete respectively. According to using the HWAE of naphthalene sulfonates and SG, the fluidity retention of mortar and concerete is improving the fluidity retention and strength of concrete regardless of type of HWAE.

• Textile Coloration and Finishing
• /
• v.23 no.2
• /
• pp.140-145
• /
• 2011

The effects of nonionic surfactant solutions of 0.1g/dL on detergency and liquid wetting/retention properties of soiled polyester/cotton(65/35) cloth were studied. Soiled polyester/cotton(65/35) cloth (EMPA 104) and 10 different nonionic surfactants (Span 20, Tween 20, 40, 60, 80, 21, 61, 81, 65, 85) were used in the study. The water retention and liquid retention capacity values of soiled cloth were decreased compared with those of unsoiled cloth. The wetting and water retention of soiled cloth improved with addition of surfactants, whereas water retention ratio(W/H) values didnot change markedly. Generally surfactants with low surface tension and high HLB (Hydrophile-lipophile balance) were more effective in improving the wetting/retention properties of soiled cloth. Nonionic surfactants having high ethylene oxide contents of 20 moles; i.e., Tween 20, 40, 60 & 80, showed better detergency than low ethylene oxide contents of 4 moles; i.e., Tween 21, 61 & 81. As HLB values of surfactants and $cos{\theta}$ of the soiled cloth increase, the detergency values of soiled cloth increased.

• Journal of Korean Society on Water Environment
• /
• v.34 no.6
• /
• pp.569-578
• /
• 2018

To minimize the negative alterations in hydrologic and water quality environment in urban areas due to urbanization, Low Impact Development (LID) techniques are actively applied. In Korea, LID facilities are classified as Non-point Pollution Reduction Facilities (NPRFs), and therefore they are evaluated using the performance evaluation method for NPRFs. However, while LID facilities are generally installed in small, distributed configuration and mainly work with the infiltration process, the existing NPRFs are installed on a large scale and mainly work with the reservoir process. Therefore, some limitations are expected in assessing both facilities using the same method as they differ in properties. To solve these problems, in this study, a new method for performance evaluation was proposed with focus on bio-retention LID facilities. EPA SWMM was used to reproduce the hydrologic and water quality phenomena in study area, and SWMM-LID module used to simulate TP interception performance by installing a bio-retention cell under various conditions through long-term simulations. Finally, an empirical formula for Load Capture Ratio (LCR) was derived based on storm water interception ratio in the same form as the existing method. Using the existing formula in estimating the LCR is likely to overestimate the performance of interception for non-point pollutants in the extremely low design capacity, and also underestimate it in the moderate and high design capacity.