• 조명전기설비학회논문지
• /
• 제27권4호
• /
• pp.48-53
• /
• 2013

In general, the LLC resonant topology consists of three stages as; square wave generator, resonant network, and rectifier network. LLC resonant converter has the time slowly varying parameters. However, the power LEDs as the load of LLC converter can be regarded as fast time varying parameters. In this paper, the mathematical model of half-bridge resonant converter including with the power LEDs is introduced for the current controller design model. Using this controller design model, the parameter adaptive output feedback controller will be designed to control the power LEDs current. In order to show the validities of the proposed model, the parameter adaptive output feedback controller, the experimental investigation will be presented.

• Journal of Electrical Engineering and Technology
• /
• 제9권5호
• /
• pp.1632-1642
• /
• 2014

This paper presents an interleaved resonant converter to reduce the voltage stress of power MOSFETs and achieve high circuit efficiency. Two half-bridge converters are connected in series at high voltage side to limit MOSFETs at $V_{in}/2$ voltage stress. Flying capacitor is used between two series half-bridge converters to balance two input capacitor voltages in each switching cycle. Variable switching frequency scheme is used to control the output voltage. The resonant circuit is operated at the inductive load. Thus, the input current of the resonant circuit is lagging to the fundamental input voltage. Power MOSFETs can be turn on under zero voltage switching. Two resonant circuits are connected in parallel to reduce the current stress of transformer windings and rectifier diodes at low voltage side. Interleaved pulse-width modulation is adopted to decrease the output ripple current. Finally, experiments are presented to demonstrate the performance of the proposed converter.

• 전력전자학회논문지
• /
• 제19권5호
• /
• pp.440-449
• /
• 2014

This study proposes an LLC series resonant converter with a current doubler using a coupled inductor as a rectification circuit for the secondary side. The current doubler circuit is generally used for a high-voltage input and low-voltage output circuit to obtain high efficiency with small transformer turn ratio. However, an inductive circuit is not generally used in the secondary side of an LLC series resonant converter. If inductive components exist on the secondary side, the resonant characteristics are changed through the secondary inductive circuit. Mathematical analysis shows that the secondary-side current doubler with coupled inductor is not affected by the resonant characteristic of the primary LLC if leakage inductance occurs in the coupled inductor. Results of the analysis are proven by simulation; an experiment is also conducted for the proposed circuit.

• 전기학회논문지P
• /
• 제65권2호
• /
• pp.114-121
• /
• 2016

This paper is Instant space vector PWM(Pulse Width Modulation)power conversion devices in switching power semiconductors from my generation to losses and switching when the voltage surge and current surge of electronic noise(EMI: Electro Magnetic Interference / RFI: Radio Frequency Interference)to effectively minimize the power soft-switching power conversion circuit topologies of auxiliary resonant DC tank for the purpose of high performance realization of the electric power conversion system by the high-speed switching of a semiconductor device(AQRDCT simultaneously : an active auxiliary resonance using auxiliary Quasi-resonant DC tank)DC link snubber switch has adopted a three-phase voltage inverter. AQRDCL proposed in this paper can reduce the effective and current peak stress of the power semiconductors of the auxiliary resonant snubber circuit compared to the conventional active-resonant DC link snubber, it is not necessary to install the clamp switch of the auxiliary resonant DC link, DC the peak current and power loss of the bus line can be reduced.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부A
• /
• pp.137-140
• /
• 1998

A new SPWM inverter using three-phase boost converter by auxiliary partial resonant with high power factor and high efficiency is proposed. The proposed boost converter is constructed by using a resonant network in parallel with the switch of the conventional boost converter. The devices are switched at zero voltage or zero current eliminating the switching loss. A new Partial resonant boost converter achieves zero-voltage switching (ZVS) or zero-current switching (ZCS) for all switch devices without increasing their voltage and current stresses. This paper introduces elimination of low-order harmonics compared with conventional SPWM inverter and SPWM inverter using three-phase boost converter by auxiliary Partial resonant.

• 전력전자학회논문지
• /
• 제26권4호
• /
• pp.249-255
• /
• 2021

A novel current balancing technique for multichannel light-emitting diode (LED) that uses a series resonance and coupled inductor is proposed in this paper. The proposed LED driver balances output currents through frequency control and enables zero-voltage switching. The proposed converter utilizes the charge balance condition of the resonant capacitor and the current sharing function of the coupled inductor to achieve whole LED current balancing without an additional controller. The proposed coupled inductor can integrate the current balancing function and the resonant inductor, so the power density can be increased by reducing the number of magnetic devices. A 40 W prototype is built to verify the validity of this LED driver, and the experimental results are successfully obtained.

• 전기전자학회논문지
• /
• 제25권4호
• /
• pp.741-749
• /
• 2021

본 논문에서 제안한 전류형 LLC AC to DC 고주파 공진 컨버터는 스위치 양단에 병렬로 공진 커패시터(C₁, C₂)를 연결함으로써 ZVS(Zero Voltage Switching)동작 뿐만 아니라 2차측 Diode의 ZCS(Zero Current Switching) 동작이 가능하므로 스위칭 소자의 턴-온 및 2차측 다이오드의 턴-오프 손실을 저감시킬 수 있다. 본 논문에서 제안한 LLC AC to DC 고주파 공진 컨버터의 회로 해석은 무차원화 제어 파라메타를 도입하여 범용성 있게 기술하였다. 또한 제안한 LLC AC to DC 고주파 공진 컨버터의 운전 특성은 무파원화 제어 주파수(μ), 무차원화 저항(λ) 등의 무차원화 제어 파라메타를 이용하여 특성 평가를 수행하였다. 특성 평가를 통한 특성값을 기초한 LLC AC to DC 고주파 공진 컨버터 설계 기법의 일예를 제시하였으며, 실험 및 PSIM 시뮬레이션을 통해 이론 해석의 정당성을 입증하였다.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제4권1호
• /
• pp.27-31
• /
• 2004

Models and simulations of gate tunneling current for thinoxide MOSFETs and Double-Gate SOIs are discussed. A guideline in design of leaky MOS capacitors is proposed and resonant gate tunneling current in DG SOI simulated based on quantum-mechanicalmodels. Gate tunneling current in fully-depleted, double-gate SOI MOSFETs is characterized based on quantum-mechanical principles. The simulated $I_G-V_G$ of double-gate SOI has negative differential resistance like that of the resonant tunnel diodes.

• 대한전기학회논문지
• /
• 제41권6호
• /
• pp.615-624
• /
• 1992

For the operation of the resonant DC link inverters, only limited number of modulation techniques such as the delta modulation and instantaneous current control techniques have been suggested. However, these modulation techniques have some limitations in practical operation. In this paper, the application of conventional inverter modulation techniques is suggested for the control of the resonant DC link inverter. The harmonic analysis results are presented. The results show that these modulation techniques offer good output characteristics similar to conventional inverter PWM techniques for the operation of the resonant DC link inverter. This implies that not only the delta modulation technique and instantaneous current control techniques but also various other modulation techniques can be applied to the operation of the resonant DC link inverter. This also indicates that open loop control as well as closed loop control can be used for the operation of the resonant inverter. The resonant DC link inverter with various modulation strategies is implemented using V-40 microprocessors.

• Journal of Power Electronics
• /
• 제14권1호
• /
• pp.40-47
• /
• 2014

An average current mode control scheme that consistently offers good dynamic performance for LLC series resonant DC-to-DC converters irrespective of the changes in the operational conditions is presented in this paper. The proposed control scheme employs current feedback from the resonant tank circuit through an integrator-type compensation amplifier to improve the dynamic performance and enhance the noise immunity and reliability of the feedback controller. Design guidelines are provided for both current feedback and voltage feedback compensation. The performance of the new control scheme is demonstrated through an experimental 150 W converter operating with 340 V to 390 V input voltage to provide a 24 V output voltage.