• 한국정보통신학회논문지
• /
• 제18권7호
• /
• pp.1695-1703
• /
• 2014

운전 중 내비게이션을 조작하는 것은 집중력이 분산되어 교통사고로 이어질 수 있으며, 특히 고령자나 초보 운전자에게는 더욱 위험하다. 최근에는 도로교통법 개정으로 운전 중 영상표시장치를 시청하거나 조작하는 것이 금지되어 현실적으로 자동차 내비게이션의 사용이 어려워졌다. 본 논문은 이러한 불편을 보완하기 위해 운전자가 아닌 다른 사람이 내비게이션을 대신 조작할 수 있는 시스템을 설계하고 구현한다. 인터넷 연결이 불가능한 내비게이션을 원격에서 제어할 수 있도록 운전자의 스마트폰을 중계 장치로 활용하는 방안을 제안하고, 여기에 필요한 단말 애플리케이션 및 서버를 설계하고 구현한다.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2002년도 추계학술대회 논문집
• /
• pp.251-255
• /
• 2002

Eutrophic matters accumulated on the bottom of sea, river and lake cause red tide phenomenon in ocean and outbreak green algae in river and lake. Systems are developed to remove the noxious deposit. But the existing systems remove not only the eutrophic matters but also natural materials, sand, pebbles etc. that should remain at the bottom. This paper describes a new system that can safely, and economically take away the noxious deposit in underwater. High pressure water jet is used to induce vortices in the triangular suction section, and air-lifting pump to lift up the deposit. The mixture of the water and deposit is filtered through the drum filters. An under camera shows the under water situation along the moving direction of the system that is controlled by a remote operator. This remote controlled moving system obliterate the necessity of the diver that usually costs high. The experimental results show the effectiveness of the suggested system.

• 한국항해항만학회지
• /
• 제29권5호
• /
• pp.371-376
• /
• 2005

최근 낙도 보조항로의 운영에 있어서 선박 취항명령후 운영사업자의 계속적인 사업수행으로 일반항로에 비해 경영개선노력이 부진하거나 서비스의 질이 저하되는 등 여러 가지 문제점이 나타나고 있다. 따라서 본 연구에서는 낙도 보조항로 운영주체를 검토하여 개선방향을 제시하고자 AHP 기법을 이용한 실증연구를 수행하였다. 연구결과 보조항의 사업자에 대한 경영평가제를 도입하여 사업자 스스로 지속적인 경영개선 노력을 유도함이 바람직할 것으로 보인다.

• 한국정보통신학회논문지
• /
• 제11권6호
• /
• pp.1077-1082
• /
• 2007

디지털 계측기를 인터넷에 접속하여 원격지에서 검 교정을 하기 위해서는 계측기의 CPU 사용률이 많은 일반 서버와는 다른 임베디드 운영체제를 이용한 고속 전용서버가 필요하다. 본 연구는 웹 기반 원격 검 교정 시스템을 위한 고속 네트워크 모듈을 구현하는 목적이며 인터넷을 통해 디지털 계측기를 원격으로 검 교정을 하고, 고속 네트워킹을 위해 TCP/IP Offload Engine 처리와 임베디드 TCP/IP 스택인 LwIP를 개선하였다.

• 대한원격탐사학회지
• /
• 제24권5호
• /
• pp.397-408
• /
• 2008

A wide variety of applications of imaging spectrometer have been proved using data from airborne systems. The Compact Airborne Imaging Spectrometer System (CAISS) was jointly designed and developed as the airborne hyperspectral imaging system by Korea Aerospace Research Institute (KARI) and ELOP inc., Israel. The primary mission of the CAISS is to acquire and provide full contiguous spectral information with high spatial resolution for advanced applications in the field of remote sensing. The CAISS consists of six physical units; the camera system, the gyro-stabilized mount, the jig, the GPS/INS, the power inverter and distributor, and the operating system. These subsystems are to be tested and verified in the laboratory before the flight. Especially the camera system of the CAISS has to be calibrated and validated with the calibration equipments such as the integrating sphere and spectral lamps. To improve data quality and its availability, it is the most important to understand the mechanism of imaging spectrometer system and the radiometric and spectral characteristics. The several performance tests of the CAISS were conducted in the camera system level. This paper presents the major characteristics of the CAISS, and summarizes the results of performance tests in the camera system level.

• 대한원격탐사학회지
• /
• 제15권4호
• /
• pp.367-375
• /
• 1999

This paper describes the development, operations, and applications of ROCSAT-l and its Ocean Color Imager (OCI) remote-sensing payload. It is the first satellite program of NSPO. The satellite was successfully launched by Lockheed Martin's Athena on January 26, 1999 from Cape Canaveral, Florida. ROCSAT-l is a Low Earth Orbit (LEO) experimental satellite. Its circular orbit has an altitude of 600km and an inclination angle of 35 degrees. The satellite is designed to carry out scientific research missions, including ocean color imaging, experiments on ionospheric plasma and electrodynamics, and experiments using Ka-band (20∼30GHz) communication payloads. The OCI payload is utilized to observe the ocean color in 7 bands (including one redundant band) of Visible and Near-Infrared (434nm∼889nm) range with the resolution of 800m at nadir and the swath of 702km. It employs high performance telecentric optics, push-broom scanning method using Charge Coupled Devices (CCD) and large-scale integrated circuit chips. The water leaving radiance is estimated from the total inputs to the OCI, including the atmospheric scattering. The post-process estimates the water leaving radiance and generates different end products. The OCI has taken images since February 1999 after completing the early orbit checkout. Analyses have been performed to evaluate the performances of the instrument in orbit and to compare them with the pre-launch test results. This paper also briefly describes the ROCSAT-l mission operations. The spacecraft operating modes and ROCSAT Ground Segment operations are delineated, and the overall initial operations of ROCSAT-l are summarized.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 1996년도 춘계학술발표회논문집(1)
• /
• pp.571-576
• /
• 1996

Currently most nuclear power plants(NPPs) are adopted the mid-loop operation to minimize the overhaul period and save the operating cost. For mid-loop operation it is essential to install nozzle dam between RCS pipe and steam generator(SG). Because SG remains more highly contaminated with radioactive material than any other parts of the NPPs, the repairmen are very reluctant to carry out installing nozzle dam inside the SG. Until now, unfortunately, it appears that no practically applicable device was developed to provide the longstanding demand. Also the accidents have been reported by licenser event report during this operation mode due to loss of residual heat removal(RHR). The purpose of this paper is to conduct remotely blocking and disintegration of nozzle of a SG which has the highest radiation exposure during the maintenance in NPPs. The remote nozzle blocking device of a SG includes three bladders, hubs, air controller provisions to supply and contact air pressure into the bladders. This remote nozzle block device will give the larger operation margin to prevent the loss of RHR and minimize the radiation exposure dose to the repairman and shorten the overhaul periods.

• 한국컴퓨터정보학회논문지
• /
• 제24권2호
• /
• pp.95-101
• /
• 2019

Sensor application systems for remote monitoring and control are required, such as the establishment of databases and IoT service servers, to process data being transmitted and received through radio communication modules, controllers and gateways. This paper designs and implements database server, IoT service server, data processing middleware and IoT management system for IoT based services based on the controllers, communication modules and gateway middleware platform developed. For this, we firstly define the specification of the data packet and control code for the information classification of the sensor application system, and also design and implement the database as a separate server for data protection and efficient management. In addition, we design and implement the IoT management system so that functions such as status information verification, control and modification of operating environment information of remote sensor application systems are carried out. The implemented system can lead to efficient operation and reduced management costs of sensor application systems through site status analysis, setting operational information, and remote control and management.

• International Journal of Computer Science & Network Security
• /
• 제22권12호
• /
• pp.71-78
• /
• 2022

Electronic measuring devices have an important role in agricultural projects and in various fields. Electronic measuring devices play a vital role in controlling and saving soil information. They are designed to measure the temperature, acidity and moisture of the soil. In this paper, a new methodology to manage irrigation and soil fertility using an electronic system is proposed. This is designed to operate the electronic irrigation and adds inorganic fertilizers automatically. This paper also explains the concept of remote management and control of agricultural projects using electronic soil measurement devices. The proposed methodology is aimed at managing the electronic irrigation process, reading the moisture percentage, elements of soil and controlling the addition of inorganic fertilizers. The system also helps in sending alert messages to the user when an error occurs in measuring the percentage of soil moisture specified for crop and a warning message when change happens to the fertility of soil as many workers find difficulty in daily checking of soil and operating agricultural machines such as irrigation machine and soil fertilizing machine, especially in large projects.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 C
• /
• pp.1347-1349
• /
• 1995

Insulators contaminated by salt particles may cause flashovers in humid climate or light rain. Therefore, the quantity of salt on insulators should be monitored not to exceed a critical value. We propose a new remote sensing technique to measure the quantity of salt on insulators of power systems. The amount of the salt is measured from the intensity of the spontaneous emission from the sodium atoms. In this paper, a compact remote on-line salt-meter composed of Q Switch pulsed Nd:YAG laser and emission signal detection system will be introduced. And as the first result of this study, the operating characteristics of our developing laser system is also introduced.