• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.24 no.7 s.178
• /
• pp.1863-1870
• /
• 2000

When an impact stress is applied on the external boundary of double cantilever beam of orthotropic material which crack length is greater than specimen hight and anistropic ratio is very high, dyna mic energy release rate is derived, and the relationship between dynamic energy release rate and crack propagating velocity is studied. Dynamic energy release rate to static energy release rate is decreased with increasment of crack propagating velocity. The relationships between dynamic energy release rate and vertical strain have a similar pattern with those between static energy release rate and vertical strain. When normalized time(Cstla) is greater than or equal to 2, dynamic energy release rate approaches to a constant value.

• Korean Journal of Applied Biomechanics
• /
• v.14 no.3
• /
• pp.149-163
• /
• 2004

This study analyzed kinematic variables about the cross step, the delivery and the release for women's javelin athletics recorded over 50m in the 2004 Busan International Athletics Competition. It was used the Kwon3D Motion Analysis Package Ver. 3.1 Program(Kwon, 2000) for analysing the kinematic variables about the distance, the velocity, and the angle, then we had the results as follows; 1 In the Cross step phase, the COG velocity was low because their step length was short. To keep the CM velocity from the approach to the last cross over step contact, the athletes have to keep the longer step length within about 130% of the athletics' height. 2. In the Delivery phase, the athletics' COG height was gradually lower, and the deceleration of the COG was going up. As the same in the cross step, Therefore the athletes have to increase the step length within about 100% of their height, in order to increasing the COG velocity. And it was shown they have to make small angle of the elbow as possible from the right foot contact to the left foot contact in order to being the big acceleration of the upperarm at the release phase. 3. In the release phase, it was shown to being low position of the release point as the COG was low and then the release velocity of the upperarm was low. Specially when the shoulder lean lateral angle is big at the release phase, it was shown they have a excessive release angle. And, when it was shown the high rotation angle of the shoulder, the shoulder was opened forward bigger than the trunk was opened forward. So the transmission of velocity from the proximal segments was a fast change.

• Korean Journal of Applied Biomechanics
• /
• v.21 no.5
• /
• pp.631-638
• /
• 2011

This study had two purposes. The first was to analyze the period of the final record set by the male shot-putters in the IAAF World Championships, Daegu 2011 from the point of view of kinematics. The other was to identify an efficient movement for shot putting based on the analysis. The research used the eight finalists of in the championship as subjects. We analyzed the seven most important kinematic factors in shot putting based on the type of technique: the execution time of the delivery phase, release velocity, release angle, release, center of mass (COM) velocity, and shot trajectories. The analytical results showed the following average figures for the record 12 meters: execution time of the delivery phase: (0.19 s), release height: (2.06 m), release angle: ($34.68^{\circ}$), release velocity: (13.25 m/s), angular velocity of shoulder: ($922.38^{\circ}/s$), and angular velocity of pelvis: ($479.50^{\circ}/s$). Further, the results showed that the highest COM velocity was 2.25 m/s and the shot trajectories were close to a straight line in the release phase.

• The Journal of Korean Physical Therapy
• /
• v.15 no.1
• /
• pp.196-209
• /
• 2003

The aim of study was compared with the possible role of cranial artery in headache pathogenesis each 2 group (group I : ultrasound therapy alone, group II : myofascial release therapy alone)- divided each 5 tension- type headache patients. Each group were applied ultrasound therapy for 5 minuets and myofascial release therapy for 15 minuets in occipital portion. The study carried out to determine the effects of ultrasound and myofascial release on the cranial arteries velocity from November 11, 2001 to March 29, 2002 the objects were 10 patients who having the tension-type headache at H-hospital. Transcranial doppler ultrasonograpy(TCD) is new non-invasive applicable method to evaluate flow velocities of intrans cranial and extracranial cerebral arteries. TCD was peformed with standard method to measure the Mean Flow Velocity(MFV) of the middle and posterior cerebral arteries, the vertebral arteries.

• Korean Journal of Applied Biomechanics
• /
• v.21 no.5
• /
• pp.661-667
• /
• 2011

The purpose of the study was to compare selected kinematic variables between the female medalists and a Korean female javelin thrower at the IAAF World Championships, Daegu 2011. Three medalists and one Korean javelin thrower that participated in the Championships were videotaped using three high-speed cameras (300 frames/s, EX-F1 Exilim, Casio, Japan). This study identified the performance differences between the two groups. The results showed that the Korean female javelin thrower (KFJT) clearly had a greater delivery phase time than the female medalists. In order to throw farther, a thrower must exert a greater force to accelerate their body in a short time. This study also found that the release velocity of the KFJT was lower than that of the female medalists. The KFJT showed evidence of using her extremities differently to achieve the maximum release velocity. When comparing the inclination angle of the trunk across javelin throwers, the lowest value was recorded in the KFJT. Because the trunk position at release plays a significant role in determining the release height and release velocity, the KFJT should not rely on her upper extremities to achieve as high a release velocity as possible.

• International Journal of Concrete Structures and Materials
• /
• v.19 no.1E
• /
• pp.25-32
• /
• 2007

The fracture energy evaluated from the previous experimental results can be simulated by using the modified singular fracture process zone (S-FPZ) model. The fracture model has two fracture properties of strain energy release rate for crack extension and crack close stress versus crack width relationship $f_{ccs}(w)$ for fracture process zone (FPZ) development. The $f_{ccs}(w)$ relationship is not sensitive to specimen geometry and crack velocity. The fracture energy rate in the FPZ increases linearly with crack extension until the FPZ is fully developed. The fracture criterion of the strain energy release rate depends on specimen geometry and crack velocity as a function of crack extension. The behaviors of micro-cracking, micro-crack localization and full development of the FPZ in concrete can be explained theoretically with the variation of strain energy release rate with crack extension.

• Korean Journal of Applied Biomechanics
• /
• v.21 no.4
• /
• pp.411-420
• /
• 2011

The purpose of this investigation was to determine whether correlations exist between balance and impact velocity, angular position, and maximum velocity of a club during drive swing. Twelve skilled golfers were recruited in this study. They were asked to perform ten swing trials and two trials were selected for analysis. Balance parameters were calculated via the force platform while kinematic variables were determined by using the Qualisys system. The results of the present study demonstrated that the average of COP velocity was faster in the medio-lateral direction rather than the anterio-posterior direction. Also, left foot's COP velocity and free torque were greater than the right foot's before impact. The range of the right foot's COP in the anterio-posterior direction before impact were correlated with the club velocity and angular position at impact. There was a negative correlation between the left foot's COP velocity before the impact and the velocity at impact. Additionally, the range and RMS of the left foot's free torque affected on the club angular position at impact and the maximum velocity at release, respectively. Finally, a negative correlation existed between the range of the right foot's free torque after the impact and club's maximum velocity at release.

• Korean Journal of Applied Biomechanics
• /
• v.13 no.2
• /
• pp.29-47
• /
• 2003

This study is to analyze the kinematic variables in release motion of discuss throwing. For the matter, 5 people from the national team and collegiate discuss throwing in the year 2001 were chosen as the subjects and two S-VHS video cameras set in 60frames/sec were used for recording their motions. Coordinated raw positions data through digitizing are smoothing by butter-worth 's low-pass filtering method at a cut off frequency 6.0Hz. and the direct linear transformation(DLT) method was employed to obtain 3-D position coordinates. The conclusions were as follows; 1. The better record players showed the shorter approach time in the last support phase. 2. In the displacement CG, the better record players showed the shorter displacement in medial-lateral direction, and the longer displacement in horizontal direction. In the motion, the COG showed longer displacement vertical direction. 3. The better record players showed the faster horizontal velocity than vertical velocity in the release. 4. The better record players showed to take the posture of vertical axis in the release.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.1
• /
• pp.1-9
• /
• 2013

The purpose of this study was to provide information on athletes' characteristics and advantages and disadvantages by analyzing the kinematic factors having a decisive influence on competitive abilities such as release conditions in the delivery phase on major Korean javelin athletes. Two supported javelin throwers of the Korean national team participated in this study. The total average time required of the delivery phase was 0.31(${\pm}0.016$). The athletes' release angle was 33.2 to 41.7 degrees. The attack angle varied widely from -3.5 to 5.9 degrees. The Javelin heights of Subject A and B were 95.9 and 89.2%Ht. The average stride length were 180.6 and 176.7cm. The center of mass velocity of LFD and REL was relatively low in all the subjects. The average deceleration rates of center of mass velocity of Subject A and B were 57.2 and 48.9%lose. The left knee angles of Subject A and B were 160.1 and 155.5 degrees in LFD, 153.0 and 164.0 degrees in REL. The joint velocity of upper limb segments was relatively low in all the subjects. The maximum average wrist velocity of Subject A and B was 18.2 and 16.3 m/s in REL.

• Journal of the Korean Society of Safety
• /
• v.35 no.2
• /
• pp.111-117
• /
• 2020

When KS C IEC 60069-10-1(2015) standard is applied to estimate a hazardous area, the chart showing the relationship between a hazardous area distance and release characteristic is used as a guide to determine the extent of hazardous zones for various forms of release. Three release characteristic lines based on the three types of release as an unimpeded jet release with high velocity, a diffusive jet release with low velocity, and a release of heavy gases or vapours that spread along horizontal surfaces are given. As these characteristic lines have the low limit threshold, it is difficult to estimate the hazardous area distance when the value of release characteristic is under the low limit threshold. And KS C IEC 60079-10-1(2015) standard shows the concept for a zone of Negligible extent(NE) which can be considered as non hazardous area, but it is also difficult to apply the concept of a Negligible extent. The purpose of this paper is to suggest the guideline for the release characteristic to decide a hazardous area distance and the Negligible extent(NE) being considered as non-hazardous area when deciding a hazardous area distances by the KS C IEC 60079-10-1 standard.