• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.10
• /
• pp.3321-3341
• /
• 2014

This paper investigates the outage performance and optimization for the four-phase two-way transmission network with an energy harvesting (EH) relay. To enable the simultaneous information processing and energy harvesting at the relay, we firstly propose a power splitting-based two-way relaying protocol (PSTWR). Then, we discuss its outage performance theoretically and derive an explicit expression for the system outage probability. In order to find the optimal system configuration parameters such as the optimal power splitting ratio and the optimal transmit power redistribution factor, we formulate an outage-minimized optimization problem. As the problem is difficult to solve, we design a genetic algorithm (GA) based algorithm for it. Besides, we also investigate the effects of the power splitting ratio, the power redistribution factor at the relay, and the source to relay distance on the system outage performance. Finally, extensive simulation results are provided to demonstrate the accuracy of the analytical results and the effectiveness of the GA-based algorithm. Moreover, it is also shown that, the relay position greatly affects the system performance, where relatively worse outage performance is achieved when the EH relay is placed in the middle of the two sources.

• Journal of Communications and Networks
• /
• v.18 no.3
• /
• pp.299-310
• /
• 2016

In practical wireless relay communication systems, non-destination nodes are assumed to be idle not receiving signals while the relay sends messages to a particular destination node, which results in reduced bandwidth efficiency. To improve the bandwidth efficiency, we relax the idle assumption of non-destination nodes and assume that non-destination nodes may receive signals from sources. We note that the message relayed to a particular node in such a system gives rise to interference to other nodes. To study such a more general relay system, we consider, in this paper, a relay system in which the relay first listens to the source, then routes the source message to the destination, and finally produces interference to the destination in sending messages for other systems. We obtain capacity upper and lower bounds and study the optimal method to deal with the interference as well as the optimal routing schemes. From analytic results obtained, we find the conditions on which the direct transmission provides higher transmission rate. Next, we find the conditions, by numerical evaluation of the theoretical results, on which it is better for the destination to cancel and decode the interference. Also we find the optimal source power allocation scheme that achieves the lower bound depending on various channel conditions. We believe that the results provided in this paper will provide useful insights to system designers in strategically choosing the optimal routing algorithms depending on the channel conditions.

• Journal of Korea Society of Industrial Information Systems
• /
• v.14 no.5
• /
• pp.1-9
• /
• 2009

Relay-assisted multiple input technique has become a promising candidate for next generation broadband wireless communications. In this paper, we propose channel selective relay-based multiple input transmission system. In the proposed system, single carrier frequency division multiple access (SC-FDMA) and orthogonal frequency division multiple access (OFDMA) are adopted for uplink and downlink transmissions, respectively. The performance of relay-based system can be improved by using the subcarriers selectively based on the channel condition between relay station (RS) and mobile station, or between RS and base station. Simulation results show that the proposed relay-based system considerably outperforms the conventional relay-based system.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.52 no.10
• /
• pp.593-601
• /
• 2003

Distance realy is tripped by the line impedance calculated at the relay point. Accordingly the accurate operation depends on the precise calculation of line impedance. Impedance can be accurately calculated in case of overhead line. However, in case of power cables or combined transmission lines, impedance can not be accurately calculated because cable systems have the sheath, grounding resistance, and sheath voltage limiters(SVLs). There are also several grounding systems in cable systems. Therefore, if there is a fault in cable systems, these terms will severely be caused much error to calculation of impedance. Accordingly the proper compensation should be developed for the correct operation of the distance relay. This paper presents the distance calculating algorithm in combined transmission line with power cable using wavelet transform. In order to achieve such purpose, judgement method to discriminate the fault section in both sections was proposed using D1 coefficient summation in db4. And also, error compensation value was proposed for correct calculation of impedance in power cables section.

• International Journal of Contents
• /
• v.14 no.1
• /
• pp.18-27
• /
• 2018

The objective of this study was to derive approximate closed-form error rates for M-ary burst symbol transmission (MBST) of dual-hop adaptive decode-and-forward (ADF) cooperative relay systems over quasi-static Rayleigh fading channels. Within a burst, there are pilot symbols and data symbols. Pilot symbols are used for channel estimation schemes and each relay node's transmission mode selection schemes. At first, our focus was on ADF relay systems' error-events at relay nodes. Each event's occurrence probability and probability density function (PDF) were then derived. With error-event based approach, we derived a tractable form of PDF for combined signal-to-noise ratio (SNR). Averaged error rates were then derived as approximate expressions for arbitrary link SNR with different modulation orders and numbers of relays. Its accuracy was verified by comparison with simulation results.

• Journal of Communications and Networks
• /
• v.14 no.3
• /
• pp.257-266
• /
• 2012

A decode-and-forward two-way relay system benefits from orthogonal frequency division multiplexing (OFDM) and relay transmission. In this paper, we consider a decode-and-forward two-way relay system over OFDMwith two strategies: A joint subcarrier matching algorithm and a power allocation algorithm operating with a total power constraint for all subcarriers. The two strategies are studied based on average capacity using numerical analysis by uniformly allocating power constraints for each subcarrier matching group. An optimal subcarrier matching algorithm is proposed to match subcarriers in order of channel power gain for both transmission sides. Power allocation is defined based on equally distributing the capacity of each hop in each matching group. Afterward, a modified water-filling algorithm is also considered to allocate the power among all matching groups in order to increase the overall capacity of the network. Finally, Monte Carlo simulations are completed to confirm the numerical results and show the advantages of the joint subcarrier matching, power allocation and water filling algorithms, respectively.

• Journal of electromagnetic engineering and science
• /
• v.11 no.1
• /
• pp.5-10
• /
• 2011

We propose an adaptive cooperative scheme with a multi-relay node that achieves high bandwidth efficiency and achieves better SEP performance. In the proposed protocol, if the quality of the direct channel is better than that of the all channels from relays to destination, the source will transmit directly to the destination. Otherwise, the source broadcasts the signal and then a potential relay will be chosen to help the source. A re-transmission will also occur if the potential relay cannot be detected. The spectral efficiency is first derived by calculating the probability of each mode, i.e., direct and cooperation transmission. Subsequently, the SEP performance of M-PSK modulation for the scheme is analyzed by considering each event where the source transmits data to the destination. Finally, the obtained analytical results are verified through computer simulations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.1C
• /
• pp.1-8
• /
• 2009

Cooperative diversity is a novel technique to improve diversity gains, capacity gains, and energy saving. This technique involves multiple terminals sharing resources in order to build a virtual antenna array in a distributed fashion. In this paper, we propose a multi-user cooperative diversity protocol called Relay-assisted Multiple Access Channel(R-MAC) that allows multiple source terminals to transmit their signals simultaneously and the relay terminal forwards the aggregated signal received from the source terminals to the destination terminal. The proposed protocol converts the distributed antenna channels into an effective MIMO channel by exploiting a relay, increasing both diversity gain and system throughput. We investigate the performance of the proposed protocol in terms of outage probability and diversity-multiplexing tradeoff where we assume block fading channel environment. Our simulation results show that the proposed protocol outperforms direct transmission in the high spectral efficiency regime where the conventional cooperative diversity protocols cannot outperform direct transmission.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2010.05a
• /
• pp.956-958
• /
• 2010

The paper considers MIMO two-way scheme to optimize the end to end capacity in local wireless mesh network. The basic idea is to perform data transmission via intermediate cooperative nodes and cooperative relay therefore higher throughput can be achieved. Each node is equipped with multiple antennas, and has two time slots one for transmission (Tx) and the other is reception (Rx), which are arranged alternatively in the network. In the conventional SISO network, it takes at least four time slots to accomplish the function of two-way relay. Moreover, cooperative technique is used in order to enhance multiplexing of forward and backward streams.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.25 no.1
• /
• pp.65-71
• /
• 2022

In this paper, we propose an opportunistic data relay scheme in narrowband multihop combat radio networks. Narrowband networks have physical restrictions on high-speed transmission. Furthermore, the topology changes dynamically due to the jamming of the enemy, signal interference between friendly forces, and movement of network entities. Therefore, the traditional relay scheme that collects topology information and calculates a relay path before transmission is unsuitable for such networks. Our proposed scheme does not collect topology information and transmits data opportunistically. The scheme can cause unnecessary data relaying that is not related to data delivery to the destination node. However, for small networks, the effect of increasing network throughput by not gathering topology information is much greater than the effect of reducing throughput by unnecessary data relays. We demonstrate the performance superiority of the proposed scheme through simulation in the worst case of network topology.