• Journal of the Korean Geotechnical Society
• /
• v.33 no.1
• /
• pp.79-91
• /
• 2017

An experimental study has been conducted by using the Cyclic Direct Simple Shear apparatus to evaluate the influence of average and cyclic shear stresses on the undrained shear failure behavior of marine silty sand considering various relative densities. The obtained results show that despite using different relative densities, similar trends were gained in the cyclic shear deformation. Moreover, the cyclic shear deformation is affected mainly by the average and cyclic shear stresses. The number of cyclic loads for failure is significantly affected by the cyclic shear stress ratio and relative density, and is less affected by the average shear stress ratio. The proposed three-dimensional stress-dependent failure contour can be used effectively to assess the soil shear strength considering various relative densities in the design of foundation used for offshore structures.

• Journal of Korea Foresty Energy
• /
• v.20 no.2
• /
• pp.58-68
• /
• 2001

This study was carried out to investigate the growth and biomass production of Abies koreana seedlings under different relative light intensity. The 5-year-old potted seedlings were grown for 24 months under different light intensity of 100%, 50%, 30%, 10% and 2% of the natural full light intensity. The results were as follows: 1. Height growth was similar in the seedlings under different light intensities except in 2% of the full sun light intensity, having shown the lowest height growth. 2. Root collar diameter growth was reduced gradually by decreasing of the relative light intensity. 3. The seedlings which were grown under relatively low light intensity showed the later starting date of the stem growth in the next spring and showed the smaller number of new needles, and the smarter number and the shorter length of new shoot of the seedlings. 4. Total dry mass including the dry mass of leaves, shoot and root was reduced by decreasing of the relative light intensity. 5. In case of the seedling grown in one year shading condition, the ratio of the dry mass of current-year needles and stem to that of the above one-year-old needles and stem was ranged from 0.99$\pm$0.25 to 1.06$\pm$0.06 and was not significally different among the seedlings grown under 100%, 50% and 30% of the relative light intensity. And the radio was ranged from 0.60$\pm$0.04 to 0.52$\pm$0.03 in the seedlings grown under 10% and 2% of the relative light intensity, respectively. In case of the seedling grown in two years shading, the ratio of the dry mass of current-year needles and stem to that of the above one-year-old needles and stem was ranged from 0.79$\pm$0.04 to 1.00$\pm$0.03 and was not significally different among the seedlings grown under 100, 50, 30% and 10% of the relative light intensity. And the ratio was 0.29$\pm$0.03 in the seedlings grown under 2% of the relative light intensity, respectively. 6. T/R ratio of the seedlings grown in one year shading condition was ranged from 3.35$\pm$0.33 to 4.61$\pm$0.25 and was not significantly different among the relative light intensities of 100%, 50%, 30% and 10%. The seedlings grown under 2% of relative light intensity showed the highest T/R ratio of 7.36$\pm$0.15. In case of the two years shadings the T/R ratio was ranged from 1.76$\pm$0.11 to 3.12$\pm$0.19 and increased as relative light intensity decreased except 2.01$\pm$0.14 in 2% of relative light intensity.

• Investigative Magnetic Resonance Imaging
• /
• v.6 no.1
• /
• pp.55-63
• /
• 2002

Purpose : We investigated the predictive values of relative CBV measured with perfusion MR imaging, and relative CBF measured with SPECT for tissue outcome in acute ischemic stroke. Material and Methods : Thirteen patients, who had acute unilateral middle cerebral artery occlusion, underwent perfusion MR imaging, and $^{99m}Tc-HMPAO$ SPECT within 6 hours after the onset of symptoms. Lesion-to-contralateral ratios of perfusion parameters were measured, and best cut-off values of both parameter ratios with their accuracy to discriminate between regions with and without evolving infarction were calculated. Results : Mean relative CBV ratios in regions with evolving infarction and without evolving infarction were $0.58{\pm}0.27$ and $0.9{\pm}0.17$ (p < 0.001), and mean relative CBF ratios in those regions were $0.41{\pm}0.22$ and $0.71{\pm}0.14$ (p < 0.001). The best cutoff values to discriminate between regions with and without evolving infarction were estimated to be 0.80 for relative CBV ratio and 0.56 for relative CBF ratio. The sensitivity, specificity and efficiency of each cutoff value were 80.6, 87.5, 82.7% for relative CBV ratio, and 72.2, 75.0, 73.0% for relative CBF ratio (p > 0.05 between two parameters). Conclusion Measurement of relative CBV and relative CBE may be useful in predicting tissue outcome in acute ischemic stroke.

• Journal of Environmental Health Sciences
• /
• v.21 no.4
• /
• pp.24-31
• /
• 1995

Gas sensing element, $\alpha-Fe_2O_3$ was synthesized by dehydration, reduction, and oxidation of $\alpha-FeOOH$, which was synthesized with $FeSO_4\cdot 7H_2O$ and NaOH. They were produced as a bulk-type, a thick film-type. Then, their responses and mechanisms of response to the gas of carbon monoxide were studied. The qualities of gas sefising elements are decided by the structure and the relative surface area. In the process of $\alpha-FeOOH$ synthesis, the effects of reaction conditions as the equivalent ratio, on the structure and the relative surface area of gas sensing element were observed. The changes of the structure were measured with XRD, SEM,TG-DTA and BET. The resistance changes of the synthesized gas sensor in the air were measured. The response ratio were also measured for the changes of working temperature and gas concentration. As a result of analysis with XRD, it was confirmed that the the best conditions for the synthesis of $\alpha-FeOOH$ were equivalent ratio 0.65. The thick film-type element of $\gamma-Fe_2O_3$ responded more quickly than the bulk-type did. The structure and the relative surface area of the $\rho-FeOOH$ were confirmed as the important factors deciding gas response charcteristics.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.10a
• /
• pp.1290-1295
• /
• 2008

The relative density of soil indicate loose and dense state of sand. Because sand is low compressibility, initial relative density of sand is important effect factor of compression and shear behavior. To measure exactly relative density, the exactly maximum and minimum void ratio was determinated by laboratory tests. Generally, vibrating table method is adapted for minimum void ratio(KS F 2345). However KS F 2345 is not consider the particle break during the vibrating table test. In this study, The minimum void ratio is compared with a method of Pluviation and Vibrating table test results using the K-7(crushed sand). It is concluded that the K-7 sand particles were crushed during the vibrating table test and vibrating table test is not a suitable test for a crushed sand $e_{min}$.

• Geomechanics and Engineering
• /
• v.22 no.2
• /
• pp.165-171
• /
• 2020

Laboratory determination of strength and deformation behavior of clean sands and gravels has always been challenging due to the difficulty in obtaining their undisturbed samples. An alternative solution to this problem is to develop correlations between mechanical properties of cohesionless soils and their gradation characteristics. This study presents database of 3 natural sands with 11 varying particle size gradation curves to allow investigating relationships between mean particle size, maximum and minimum void ratio, relative density and shear strength of the test soils. Direct shear tests were performed at relative densities of 50, 75 and 95% to explore the effects of gradation and density on the angle of internal friction of the modeled sand samples. It is found that the mean grain size D₅₀ bears good correlations with void ratio range (e_max - e_min) and peak angle of internal friction 𝜙'_peak. The generated regression models are in good agreement with published literature and can be considered as reliable for natural sands in Pakistan. These empirical correlations can save considerable time and efforts involved in laboratory and field testing.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.48 no.6
• /
• pp.79-85
• /
• 2006

A simulation was done to analyze the seepage problems due to seawater intrusion through the embedded rock layers on heterogeneous layers of sea-dike. Numerical analysis with SAMTLE(developed by author) was done by taking various relative permeability $ratio(R_r/R_e)$. These results showed, when the sed-dike is newly designed, operated, and maintained considering the safety of sea-dike in seepage problems, these embankment materials are prudently chosen. The permeability of the soil materials, within the range of salinity management in freshwater, is comparatively high, however, the permeability of rock materials for bottom rock layer is low. Therefore, when the relative permeability $ratio(R_r/R_e)$ is bellow 10 it is safety in seepage problems of sea-dike.

• Journal of Technology Innovation
• /
• v.6 no.2
• /
• pp.178-207
• /
• 1998

This article suggests a methodology to decide the priority of investment project for venture business under the dynamic circumstance. By the Monte Carlo procedure on the probability distribution of cost and revenue, the model simulates the investment project to estimate profit ratio and risk. The profit ratio is calculated on the yearly basis for the relative comparison. The project risk is calculated as semi-variance under the target yield. After sufficient simulations in this fashion for several projects, the efficient projects with more profit and less risk are selected by the dominance principle. Then the regression equation of the selected projects is produced to find the relative value of the projects. The relative value is obtained through dividing the raw profit ratio by the estimated one on the equation. This value shows the degree to which the simulated project yields over the equation. The priority of investment is decided by this value. An examplary venture business of chemical development for semi-conductor is presented as a case study.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.11a
• /
• pp.662-665
• /
• 2004

In this paper, based on shaking table test results on a seismically isolated bridge model, an inelastic numerical model is refined by using Bouc-Wen model representing the hysteretic behavior of isolators. Seismic responses of isolated bridges are numerically investigated varying with relative stiffness ratios, which is a ratio of the effective stiffness of isolator to the lateral stiffness of bridge pier. From the results, it is found that an adequate range of relative stiffness ratio could be defined for seismic design of isolated bridges without considering the flexibility of piers.

• Journal of Mechanical Science and Technology
• /
• v.17 no.8
• /
• pp.1196-1202
• /
• 2003

The concept of hydrogen enriched LPG fuelled engine can be essentially characterized as low emissions and reduction of backfire for hydrogen engine. The purpose of study is obtaining low-emission and high-efficiency in LPG engine with hydrogen enrichment. In order to determine the ideal compression ratio, a variable compression ratio single cylinder engine was developed. The objective of this paper is to clarify the effects of hydrogen enriched LPG fuelled engine on exhaust emission, thermal efficiency and performance. The compression ratio of 8 was selected to minimize abnormal combustion. To maintain equal heating value, the amount of LPG was decreased, and hydrogen was gradually added. In a similar manner, the relative air-fuel ratio was increased from 0.8 to 1.3 in increment of 0.1, and the ignition timing was controlled to be at MBT each case.