• Title/Summary/Keyword: Regeneration timing

Search Result 24, Processing Time 0.025 seconds

Study on Estimation of PM Mass in DPF from Pressure Drop in 3L Diesel Engine (3L급 디젤엔진의 배압이용 DPF 매연포집량 예측에 대한 연구)

  • Kim, Hong-Suk;Lee, Jin-Wook
    • Transactions of the Korean Society of Mechanical Engineers B
    • /
    • v.34 no.5
    • /
    • pp.499-504
    • /
    • 2010
  • It is important to determine the exact soot mass in a DPF system in order to control the timing of PM regeneration. The soot mass accumulated in a filter can be estimated from the pressure drop in the filter and the exhaust gas flow rates. In this study, the soot index is defined as the pressure drop in the DPF divided by the pressure drop in a DOC. An effective signal processing method for determining the soot index is proposed; the results yielded by this method indicate good correlation between the soot index and the amount of soot loaded into the filter for both steady-state and transient-state operating conditions in a 3L diesel engine for passenger vehicles.

Alveolar ridge preservation using granulation tissue for esthetic implant restoration on maxillary anterior tooth (상악 전치부의 심미적 임플란트 수복을 위한 육아 조직(Granulation tissue)을 이용한 치조제 보존술)

  • Lee Chang Kyun
    • Journal of the Korean Academy of Esthetic Dentistry
    • /
    • v.32 no.1
    • /
    • pp.16-22
    • /
    • 2023
  • Esthetic factors are very important in the success of maxillary anterior implant restoration. However, achieving esthetic results is difficult, especially in cases where periodontitis has resulted in severe alveolar bone loss. In the case of maxillary anterior teeth, the alveolar ridge resorption that begins immediately after tooth extraction interferes with the esthetic implant restoration. Therefore immediate implant placement can be performed to minimize the alveolar ridge resorption. However, in severe bone loss cases, immediate implant placement could result in esthetic failure, and this result might cause irreparable problems. We can also perform alveolar ridge preservation and then place implants later. On JCP published in 2019, there is the consensus of European academy of periodontology on the extraction socket management and the timing of implant placement. This consensus states that alveolar ridge preservation should be considered when there is severe labial bone loss in an esthetically important area such as maxillary anterior region. On performing the alveolar ridge preservation, we cannot obtain the primary wound closure, so secondary wound healing is induced with open membrane technique or soft tissue grafting should be performed for primary wound closure. However, the secondary wound healing can have a negative impact on bone regeneration, and soft tissue grafting such as FGG or CT graft can be burdensome for both patients and dentists. On the other hand, by using the granulation tissue in the extraction socket, primary closure can be achieved without soft tissue grafting. Also some studies have shown that granulation tissue in periodontal defects contains stem cells that may help in tissue regeneration. Based on this, implant restorations were performed on maxillary anterior teeth with severe alveolar bone loss by alveolar ridge preservation using granulation tissue. In spite of the severe bone defect of the extraction socket, relatively esthetic results could be obtained in implant restorations.

Study of Particle Emission Contour Construction & Characteristics and Reduction Efficiency of Exhaust-Treatment System of Diesel Engine (승용 디젤 엔진의 후처리 시스템 적용에 따른 나노입자 배출 맵 구축 및 저감특성에 관한 연구)

  • Ko, A-Hyun;Hwang, In-Goo;Myung, Cha-Lee;Park, Sim-Soo;Choi, Hoi-Myung
    • Transactions of the Korean Society of Mechanical Engineers B
    • /
    • v.34 no.8
    • /
    • pp.755-760
    • /
    • 2010
  • In this study, we mainly focused on the PM (Particulate Matter) emission characteristics of a diesel engine. To analyze particle behavior in the tail-pipe, particle emission was measured on the engine-out (downstream of turbocharger), each upstream and downstream both of DOC (Diesel Oxidation Catalyst) and DPF (Diesel Particulate Filter). Moreover, particle emission contours on each sampling point were constructed. The reduction efficiency of particle number concentration and mass through the DOC and DPF was studied. Parameters such as EGR (Exhaust Gas Recirculation) and the main injection timing were varied in part load conditions and evaluated using the engine-out emissions. The DMS500 (Differential Mobility Spectrometer) was used as a particle measurement instrument that can measure particle concentrations from 5 nm to 1000 nm. Nano-particles of sizes less than 30 nm were reduced by oxidation or coagulated with solid particles in the tail-pipe and DOC. The DPF has a very high filtration efficiency over all operating conditions except during natural regeneration of DPF.

Effect on Wond Healing of Low Power Generating Laser Irradiation on Artificially Produced Wounds of Rabbits (저출력 레이저광선이 가토의 손상치유에 미치는 영향)

  • Young-Jin Park;Choung-Youl Kim
    • Journal of Oral Medicine and Pain
    • /
    • v.19 no.1
    • /
    • pp.73-91
    • /
    • 1994
  • The author used rabbits in order to examine the effect of Ga-As low power generating semiconductor laser on artificially produced injuries of experimental animals. Artificially produced injuries include surgical wound of 3mm length, 2mm depth in size on ventral skin surface of rabbit and buccal mucosa, and electrical injury formed on opposite side of skin and buccal mucosa by electrical cauterization of same length and depth, and chemical injury formed by FC(Formocresol) solution applied on the anterior dorsal part of tongue. And then, on the experimental group, Ga-As laser was irradiated beginning on the day after the wound formation and continued to irradiate every each other day for five minutes. After1, 3, 6, 9, 13th day, certain number of animals of control and experimental group were sacrified, and wound site tissue was excised to make samples and was observed under light microscope. The following is the conclusions after comparing the healing procedure of experimental and control group. The following results were obtained : 1. Inflammation was decreased more rapidly in the experimental group than the control group. 2. In the surgical, the electrical and the chemical injuries in the oral mucosa, re-epithelialization was completed more rapidly in the experimental group than the control group. In the electrical injury on the skin, re-epithelialization was completed about 6 days after wound formation on both groups. 3. In the electrical and the surgical injuries on the oral mucosa, granulation tissue formation started at 3 days after injury on both groups, but in the chemical injury, it was completed about 3 days faster in the control group than the experimental group. In the surgical wound on the skin, it was completed about 9 days after injury, but faster in the experimental group. In the electrical injury on the skin, it was faster in the control group than the experimental group. 4. In the electrical and the surgical injuries on the oral mucosa, fibrosis was started at 6~9 days after injury on both groups, but regeneration of connective tissue in the experimental group was observed much more than the control group. 5. When comparing the effect of wound healing on skin and oral mucosa of control and experimental group, granulation tissue formation and re-epithelialization in the oral mucosa was more vigorous. In conclusion, the difference of timing and the sequence of wound healing process(inflammation, re-epithelialization, granulation tissue formation, fibrosis) following Laser irradiation between control and experimental group was not observed, but the healing tissue was observed much more in the Laser irradiated group.

  • PDF