• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2014.10a
• /
• pp.618-621
• /
• 2014

This research is to review the possibility of reducing the noise radiated from the tube exit by controling the sound reflection coefficient at the inclined exit. The sound reflection coefficient at the inclined exit of flanged tube was measured by both transfer function method and standing wave ratio method. Accuracy on the sound reflection coefficient measured by transfer function method was verified through comparison with sound reflection coefficient measured by standing ratio method. The flanged tube had lower sound reflection coefficient than the tube which have no flange. Also the sound reflection coefficient was decreased in accordance with increasing the inclined angle of unflanged tube.

• Journal of the Institute of Convergence Signal Processing
• /
• v.15 no.3
• /
• pp.91-96
• /
• 2014

For Sound source direction and separation method, Frequency Domain Binaural Model(FDBM) shows low computational cost and high performance for sound source separation. This method performs sound source orientation and separation by obtaining the Interaural Phase Difference(IPD) and Interaural Level Difference(ILD) in frequency domain. But the problem of reflection occurs in practical environment. To reduce this reflection, a method to simulate the sound localization of a direct sound, to detect the initial arriving sound, to check the direction of the sound, and to separate the sound is presented. Simulation results show that the direction is estimated to lie close within 10% from the sound source and, in the presence of the reflection, the level of the separation of the sound source is improved by higher Coherence and PESQ(Perceptual Evaluation of Speech Quality) and by lower directional damping than those of the existing FDBM. In case of no reflection, the degree of separation was low.

• The Journal of the Acoustical Society of Korea
• /
• v.28 no.8
• /
• pp.806-814
• /
• 2009

This paper reviews a study about sound reflection control using an active sound absorber. An active sound absorber includes sound transmitting and receiving piezocomposite sensor layers molded by water tight epoxy, and connected with a feedback controller. The multi-layer sensors and the controller consists a closed feedback loop, whose intrinsic characteristics shows excellent impedance matching performance within specified frequency band, and consequently, minimizes reflection waves. Multilayer sound transmission model is derived based on one dimensional model, and its performance is verified with experiment using a pulse tube setup.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.13 no.3
• /
• pp.217-224
• /
• 2003

In this study, the adaptive triangular beam method(ATBM) considering different sound reflection coefficients and angles of a triangular beam on two or more planes as well as diffraction effect is suggested. The ATBM, subdividing a tracing triangular beam into multiple triangular beams on reflection planes, gives reliable and convergent sound-field analysis results without the dependancy on the number of initial triangular beam segmentation to search sound propagation paths from source to receiver. The validity of the method is verified by the comparison of numerical and experimental results for energy decay curve and steady-state sound pressure level of rooms having direct, reflective and diffractive sound paths.

• Journal of Environmental Science International
• /
• v.12 no.1
• /
• pp.69-76
• /
• 2003

When houses or buildings are adjacent to roads, with no effective prevention of road traffic noise, neighbors are exposed to it. It is important to understand the properties of sound propagation before taking a countermeasure against road traffic noise. It is easy to estimate the properties of sound propagation without obstacles, but very difficult and complex to estimate them with ones. The purpose of this study is to present a useful tool that can estimate the properties of sound propagation. In the beginning of this study, we investigated the attenuation of road traffic noise with two pillar buildings, and presented practical approximate calculation method, and verified that through scale model. The outcomes from this study are as follows : (1) Over second reflection sound waves can be ignored. (2) Diffraction sound waves that happen when reflection sound and first diffraction wave are projected at the wedge of other building can be ignored.

• The Journal of the Acoustical Society of Korea
• /
• v.26 no.1
• /
• pp.32-41
• /
• 2007

The control room has been usually designed by the consideration of only one listening position for the sound engineer. By this study. many listening positions with the very similar acoustical condition were located in the specific region, so-called 'the reflection free zone', where the several engineer could evaluate the quality of sound at the same time. For constructing the reflection free zone, the control room has been designed by the concept of the $LEDE^{TM}$, and the initial time delay gap has been controled by the structure of control room and the properties of sound-absorbing materials. diffuser, Helmholtz resonator and image source of sound. The occurrence of any harmful phenomena like the standing wave, acoustic focusing. coloring. Hass effect and flutter echo, has greatly reduced in the reflection free zone.

• Elastomers and Composites
• /
• v.53 no.4
• /
• pp.195-201
• /
• 2018

Three kinds of rubber compounds were prepared, and their underwater acoustical properties were investigated for anechoic coating. Dynamic mechanical properties of the rubber compounds were measured using a dynamic mechanical analyzer and extended to 100 kHz using time-temperature superposition. The sound speed, reflection coefficient, and attenuation constant were calculated. Silicone rubber showed the lowest reflection coefficient, and nitrile rubber showed the highest attenuation constant. The acoustic properties of nitrile rubber compounds with various compositions were investigated. The sound speed, reflection coefficient, and transmission coefficient of the nitrile rubber in the frequency range of 200-1000 kHz were measured in a water-filled tank.

• Journal of the Korea Society for Simulation
• /
• v.14 no.4
• /
• pp.69-76
• /
• 2005

To investigate the characteristics of the sound-pipe on the top of King Song-Dok bell, using computer simulation, the throat impedance was evaluated for the straight pipe and conical pipes with varying taper angles. When sound propagates in a rigid walled, unflanged circular pipe with wavelength larger than radius, the acoustic motion is planar, much as in a bar. The incident sound waves are reflected at the end of pipe and some of them are transmitted. The reflection coefficient and radiation impedance of the sound-pipe of King Song-Dok bell were calculated, and the results demonstrated that the high frequency sound is radiated through the sound-pipe. It behaves like a frequency filter.

• Journal of the Korean Society for Precision Engineering
• /
• v.25 no.9
• /
• pp.71-77
• /
• 2008

Microcellular foaming plastics create a sensation at polymer industrial for lowering product costs and overcoming a lowering of mechanical intensity. Among many advantages, microcellular foaming plastics is well known to have a good acoustical properties. This research based on the experiment of sound absorption and transmission characteristics inquire into acoustical properties of microcellular foaming plastics. Difference of transmission loss of microcellular foaming plastics and solid materials was defined as cell effect. Also, cell effect is expressed by sound reflection and sound absorption. This study is expected to fundamental research to present economical, functional alternative plan for products using sound absorption and transmission materials.

• The Journal of the Acoustical Society of Korea
• /
• v.7 no.4
• /
• pp.5-12
• /
• 1988

In order to know the preferred delay time of single reflection in relation in relation to the source signal, and to investigate whether or not there is any display in preference judgment of sound field between subjects of different nationalities, tests of subjective preference for musical sound fields with single reflection were preformed. The result showed that the preferred delay times agreed with the effective duration of auto-correlation function of the source signals, when the amplitude of reflection relative to the direct sound is 0dB. No fundamental disparity in series of judgement of sound field was found even for different series of Judgment with different music motifs. The result of preference test using different passages in single music showed that the fluctuation of the effective duration autocorrelation function over all the passages of the music was small. Thus, the preferred delay time can be determined by the coherence of autocorrelation function of the source signals and the amplitued of reflection.