• Journal of Positioning, Navigation, and Timing
• /
• v.10 no.1
• /
• pp.43-48
• /
• 2021

Most existing studies on the wide-area differential global positioning system (WADGPS) used standard positioning service (SPS) receivers in their observation reference stations which provide the central control station global positioning system (GPS) measurements to generate augmentation data. In the present study, it is considered to apply a precise positioning service (PPS) receiver to an observation reference station which is located in the threatened jamming area. Therefore, the reference station network consists of a PPS receiver based observation reference station and SPS receiver based observation reference stations. In this case, to maintain correction performance P1C1 differential code bias (DCB) should be compensated. In this paper, P1C1 DCB estimation algorithm was applied to the PPS/WADGPS system and performance test results using measurements in the Korean Peninsula were presented.

• Journal of Navigation and Port Research
• /
• v.31 no.10
• /
• pp.859-864
• /
• 2007

In the future, it is necessary that using the Satellite-based radio navigation augmentation system such as Differential Global Positioning System(DGPS) to achieve a position accuracy of sub-meter level in port. Generally, the receiver for DGPS reference station should meet performance specifications of RSIM Ver. 1.1 presented by RTCM. This paper proposes a method to verify performance of the receiver for DGPS reference station according to the RSIM Ver. 1.1. And this paper presented that performance evaluation of the commercial receiver for DGPS reference station through the proposed method is satisfied with RSIM Ver. 1.1.

• 한국정보통신설비학회:학술대회논문집
• /
• 2006.08a
• /
• pp.235-240
• /
• 2006

In order to enhance receive sensitivity in noisy environment, the previous initial synchronization method of GPS receiver for reference stations adopts not only the coherent integration method but also the non-coherent integration method. However, the previous GPS initial synchronization method causes the non-coherent integration loss, which is a dominant factor among the signal acquisition losses in noisy environment. And the non-coherent integration loss increases with the strength of noise signal. In this pa-per, a GPS initial synchronization method is proposed to enhance receive sensitivity of GPS receiver for reference stations in noisy environment. This paper presents that the proposed GPS initial synchronization method suppresses the non-coherent integration loss. Furthermore, with regard to the mean acquisition time, it is shown that the number of the search cells of the proposed GPS initial synchronization method is much fewer than that of the previous GPS initial synchronization method.

• Proceedings of the KIEE Conference
• /
• 2006.04a
• /
• pp.75-77
• /
• 2006

In this paper, the technology of the conformance test for Broadcast Web Site Service (BWS) which is one of the data services of the T-DMB (Terrestrial Digital Multimedia Broadcasting) is proposed. First, the standard of the BWS Service is introduced and then the method of the conformance test of BWS bitstream and BWS receiver module is provided. A BWS bitstream analyzer is implemented for use in verifying the transmitted BWS bitstreams. To provide a means for the receiver manufactures to verify their own BWS receiver modules, a receiver test suite is developed including BWS test bitstreams and a BWS reference receiver module. The BWS bitstream analyzer includes the analysis function for the conformance test of MOT protocol, HTML, PNG, MNG, JPEG, and Ecma Script. Also, it was actually used for verifying the BWS test bitstreams. In the course of developing a HWS receiver module, 4he BWS receiver module under test can be verified by comparing the results of the BWS reference receiver module with those of the receiver module under test. when the same BWS test bitstreams are fed into the two receiver modules.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.297-300
• /
• 2016

The typical Differential Global Navigation Satellite System service of South Korea is the Ground Based Differential GNSS service. South Korea building the Satellite-Based Augmentation System for GNSS to expand the Differential GNSS service. The satellite-based differential GNSS serive is called the SBAS(Satellite Based Augmentation System). The SBAS reference station on ground should be installed to operate the SBAS service alike the ground based augmentation system. That SBAS reference station can be installed with ground based DGNSS reference station. To make the SBAS reference station combined with the ground based DGNSS reference station, DGNSS system should be connected to NovAtel's G-III receiver. In this paper, the DGNSS software reference station's software module architecture was changed and G-III interface module was designed to use the G-III receiver.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.5 no.1 s.9
• /
• pp.45-54
• /
• 2006

The UWB signal distortion in frequency selective channel has made it difficult to implement the channel estimator and the synchronizer of the UWB receiver. In this paper, we examine the performances of TR(Transmitted Reference) and DTR(Differential TR) UWB which use either reference pulse or differential method to estimate the channels. we also propose a FSK-based PRM(Pulse Repetition Modulation) UWB system as an another form of UWB system which is advantageous in frequency selective channel. Finally, resorting to statistical analysis, we examine the noise effect due to noisy reference at an auto-correlation(AcR) receiver. moreover, SNR dependance of the integration length in the AcR receiver is also investigated.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.9
• /
• pp.54-61
• /
• 2016

A 6-Gbps single-ended receiver with a linear equalizer and a self-reference generator is proposed for a high-speed interface with the double data rate. The proposed single-ended receiver uses a common gate amplifier to increase a voltage gain for an input signal with low voltage level. The continuous-time linear equalizer which reduces gain to the low frequencies and achieves high-frequency peaking gain is implemented in the common gate amplifier. Furthermore, a self-reference generator, which is controlled with the resolution 2.1 mV using digital averaging method, is implemented to maximize the voltage margin by removing the offset noise of the common gate amplifier. The proposed single-ended receiver is designed using a 65-nm CMOS process with 1.2-V supply and consumes the power of 15 mW at the data rate of 6 Gbps. The peaking gain in the frequency of 3 GHz of the designed equalizer is more than 5 dB compared to that in the low frequency.

• Proceedings of the IEEK Conference
• /
• 2000.07a
• /
• pp.144-147
• /
• 2000

In this paper, we propose two receiver structures of the impulse radio (IR) system to improve its performance in multipath environments. Recently, the impulse radio system has drawn much attention for future high-speed wire-less communication services. The conventional IR receiver directly correlates received signals with the ideal reference waveform, which results in performance degradation in multipath environments. The Key idea of the proposed receiver structures is to reflect the multipath Characteristics into the IR receiver. One is to deconvolve the received waveform with estimates of the multipath gains to obtain the transmitted waveform while the other is to modify the reference waveform of the correlator according to the estimates of the multipath gains. We examine the performance of the proposed schemes for the statistical indoor wireless communication channel model using computer simulation.

• Journal of Communications and Networks
• /
• v.14 no.5
• /
• pp.518-523
• /
• 2012

This paper presents new coherent and non-coherent detection methods for the IEEE 802.15.4a low-rate ultra-wideband physical layer with forward error correction (FEC) coding techniques. The coherent detection method involving channel estimation is based on the correlation characteristics of the preamble signal. A coherent receiver uses novel iterated selective-rake (IT-SRAKE) to detect 2-bit data in a non-line-of-sight channel. The non-coherent detection method that does not involve channel estimation employs a 2-bit data detection scheme using modified transmitted reference pulse cluster (M-TRPC) methods. To compare the two schemes, we have designed an IT-SRAKE receiver and a MTRPC receiver using an IEEE 802.15.4a physical layer. Simulation results show the performance of IT-SRAKE is better than that of the M-TRPC by 3-9 dB.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.1
• /
• pp.337-342
• /
• 2006

The use of GPS receiver at outer space becomes common in low earth orbit. The KOrea Multi-Purpose SATellite-1 (KOMPSAT-1) which was launched in December 1999 has used GPS receiver's navigation solution to perform the Orbit Determination (OD) in the ground. At the circumstance of using only one ground station, the Orbit Determination using GPS receiver is good method. Because the accuracy of navigation solution acquiring directly from GPS receiver is not enough in satellite application such as map generation, post-processing concepts such as the Precise Orbit Determination (POD) are applied to satellite data processing to improve satellite position accuracy. The POD uses GPS receiver's raw measurement data instead of GPS receiver's navigation solution. The KOrea Multi- Purpose SATellite-2 (KOMPSAT-2) system newly uses the POD technique for large scale map generation. The satellite was launched in the end of July 2006. The satellite sends high resolution images in panchromatic band and multi-spectral bands to the ground. The satellite system uses GPS receivers as source of time synchronization and command reference in the satellite, provider of navigation solution for the OD, and provider of raw measurement data for the POD. In this paper, mechanical configuration and operations of the GPS receiver will be presented. The GPS data characteristics of the satellite such as time synchronization, command reference, the OD using GPS receiver's navigation solution, and the POD using GPS receiver's raw measurement data will be presented and analyzed. The enhancement of performance compared with it of the previous satellite will also be analyzed.