• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.8
• /
• pp.1632-1638
• /
• 2011

Electric cables are one of the most important components in a nuclear power plant since they provide the power needed to operate electrical equipment. Despite their importance, cables typically receive little attention since they are considered passive, long-lived components that have been very reliable over the years when subjected to the environmental conditions for which they were designed. The operating experience reveals that a defect of the insulator or poor construction causes the initial failure of cable. However, the number of cable failures increase with plant aging, and these cable failures are occurring within the plants' 40-year licensed period. These cable failures have resulted in plant transients, shutdown, loss of safety functions or redundancy, entries into limiting conditions for operation, and challenges for plant operators. Therefore, diagnosis of MV cable installed in NPPs has become one of the most urgent issues in recent years. In accordance with PSR, condition maintenance for cables is also continuously required. Recently, HFPD tests have been widely performed to diagnose cable in the transmission and distribution cable system. However, on-line HFPD wasn't used in the NPPs because of the danger of plant shutdown, measurement sensitivity and application problems, etc. In this paper, HFPD measurement with portable device was performed to evaluate the integrity of the 4.16kV & 13.8kV cable lines. The test results show that HFPD is highly attractive to the diagnosis of MV cables in NPP by high detection sensitivity on-site.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37B no.9
• /
• pp.795-805
• /
• 2012

This paper proposes an algorithm and a hardware architecture for a broadcast communication which has the worst bottleneck among multiprocessor using distributed memory architectures. In conventional system, The pipelined broadcast algorithm is an algorithm which takes advantage of maximum bandwidth of communication bus. But unnecessary synchronization process are repeated, because the pipelined broadcast sends the data divided into many parts. In this paper, the MPI unit for pipeline chain algorithm based on circuit switching removing the redundancy of synchronization process was designed, the proposed architecture was evaluated by modeling it with systemC. Consequently, the performance of the proposed architecture was highly improved for broadcast communication up to 3.3 times that of systems using conventional pipelined broadcast algorithm, it can almost take advantage of the maximum bandwidth of transmission bus. Then, it was implemented with VerilogHDL, synthesized with TSMC 0.18um library and implemented into a chip. The area of synthesis results occupied 4,700 gates(2 input NAND gate) and utilization of total area is 2.4%. The proposed architecture achieves improvement in total performance of MPSoC occupying relatively small area.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.46 no.4
• /
• pp.17-22
• /
• 2009

FlexRay is a new standard of network communication system which provides solutions to the degradation problems generated by many ECU (Electronic Control Unit) connections in automobiles and automation systems. The upper bound of the data rate is 10Mbps and it provides two channels for redundancy In this paper, FlexRay system is first designed using SDL. For hardware implementation, FlexRay system is designed using Verilog HDL based on the SDL design result. The designed system is synthesized using Synopsys Design Compiler with the Magna/Hynix 0.18 um cell library. In this paper, to construct a FlexRay network, active star is used since active star systems can provide high speed data transmission up to 10Mbps. The performance of the star network is tested using one transmitter node and two receiver nodes.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.10
• /
• pp.1-7
• /
• 2009

Nowadays there are many studies and there's huge development about RFID and WSN which have great developmental potential to many kinds of applications. In particular, the healthcare field is expected to could be securing international competitive power in u-Healthcare and combined medical treatment industry and service. More and more real time application apply RFID and WSN technology to identify, data collect and locate objects. Wide deployment of RFID and WSN will generate an unprecedented volume of primitive data in a short time. Duplication and redundancy of primitive data will affect real time performance of application. Thus, emerging applications must filter primitive data and correlate them for complex pattern detection and transform them to events that provide meaningful, actionable information to end application. In this paper, we design a complex event processing system. This system will process RFID and WSN primitive data and event and perform data transformation. Integrate RFID and WSN system had applied each now in medical treatment through this study and efficient data transmission and management forecast that is possible.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.7A
• /
• pp.994-1004
• /
• 2000

In this paper, bitstreams are composed of using H.263 for a moving picture coding in the band-limited and error-prone environment such as wireless environment. EREC sub-frames are implemented by applying the proposed EREC algorithm in order to be UEP for the real data parts of implemented bitstreams. Because those are able to do resynchronization with a block unit, propagation of the error can be minimized, and the position of the important bits such as INTRADC and MVD can be known. Class is separated using the position of these important bits, and variable puncturing tables are designed by the class informations and the code rates of turbo codes are differently designed in according to the class. Channel coding used the turbo codes, and an interleaver to be designed in the turbo codes does not eliminate redundancy bits of the important bits in applying variable code rates of EREC sub-frames unit and is always the same at the transmitter and the receiver although being variable frame size. As a result of simulation, UEP with the code rate similar to EEP is obtained a improved result in the side of bit error probability. And the result of applying it to image knows that the subjective and objective quality have been improved by the protection of important bits.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.11C
• /
• pp.889-895
• /
• 2010

MIMO system generally requires more than one antenna at the communication device. However, many wireless devices are limited by size, cost or hardware complexity to one antenna. To overcome such restrictions, we used a new technique, called cooperative communication. We propose a new cooperative transmission strategy system using cross-layer coding method base on H-ARQ for optimal communication. Proposed cooperative H-ARQ system that can improve the above problems and can get the better performance. In proposed cooperative system with H-ARQ method, if the received signal from source node is satisfied by the destination preferentially, the destination transmit ACK message to both relay node and source node, and then recovers the received signal. In addition, if ARQ message indicates NACK message, relay node operates selective retransmission. Based on the simulation results in aspect to BER performance and throughput, the proposed method which combined cooperative system with H-ARQ based on cross-layer coding can improve spectral efficiency reliability of system compared with that of general one by one system.

• Journal of KIISE:Software and Applications
• /
• v.31 no.9
• /
• pp.1142-1149
• /
• 2004

Motion Estimation(ME) has been developed to reduce temporal redundancy in digital video signals and increase data compression ratio. ME is an Important part of video encoding systems, since it can significantly affect the output quality of encoded sequences. However, ME requires high computational complexity, it is difficult to apply to real time video transmission. for this reason, motion estimation algorithms with low computational complexity are viable solutions. In this paper, we present an efficient method with low computational complexity based on spatial and temporal correlations of motion vectors. The proposed method uses temporally and spatially correlated motion information, the motion vector of the block with the same coordinate in the reference frame and the motion vectors of neighboring blocks around the current block in the current frame, to decide the search pattern and the location of search starting point adaptively. Experiments show that the image quality improvement of the proposed method over MVFAST (Motion Vector Field Adaptive Search Technique) and PMVFAST (Predictive Motion Vector Field Adaptive Search Technique) is 0.01～0.3(dB) better and the speedup improvement is about 1.12～l.33 times faster which resulted from lower computational complexity.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.9
• /
• pp.1070-1074
• /
• 2014

According to IEEE 1662(2009), IPS is a power system where all prime movers produce electrical power that is shared among propulsion, mission, and ship service loads. Discriminating attributes of integrated power systems are flexibility of movers' arrangements, mechanical decoupling between prime movers and propulsors, an increased level of energy conversion and transmission redundancy, and flexibility of redistributing available electrical power for future electronic weapons. IPS could have various steps of power that can be produced at optimal load of movers. In this study, an evaluation method for optimal arrangement of movers was investigated when an IPS warship is projected. The two factors are utilized for the quantitative analysis which are the weight of system as the fighting power and the fuel consumption per year as the economic feasibility. And also the ways for arrangement of system were studied according to existence of small diesel generator. The evaluation method that decides the optimization level is based on the DEA(Data Envelopment Analysis)

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11B
• /
• pp.1133-1141
• /
• 2009

In this paper, we present a distributed fault-tolerant topology control protocol that configure a wireless sensor network to achieve k-connectivity and (k+1)-coverage. One fundamental issue in sensor networks is to maintain both sensing coverage and network connectivity in order to support different applications and environments, while some least active nodes are on duty. Topology control algorithms have been proposed to maintain network connectivity while improving energy efficiency and increasing network capacity. However, by reducing the number of links in the network, topology control algorithms actually decrease the degree of routing redundancy. Although the protocols for resolving such a problem while maintaining sensing coverage were proposed, they requires accurate location information to check the coverage, and most of active sensors in the constructed topology maintain 2k-connectivity when they keep k-coverage. We propose the fault-tolerant topology control protocol that is based on the theorem that k-connectivity implies (k+1)-coverage when the sensing range is at two times the transmission range. The proposed distributed algorithm does not need accurate location information, the complexity is O(1). We demonstrate the capability of the proposed protocol to provide guaranteed connectivity and coverage, through both geometric analysis and extensive simulation.

• Journal of Broadcast Engineering
• /
• v.27 no.3
• /
• pp.318-331
• /
• 2022

With the recent development of hardware computing devices and software based frameworks, machine tasks using deep learning networks are expected to be utilized in various industrial fields and personal IoT devices. However, in order to overcome the limitations of high cost device for utilizing the deep learning network and that the user may not receive the results requested when only the machine task results are transmitted from the server, Collaborative Intelligence (CI) proposed the transmission of feature maps as a solution. In this paper, an efficient compression method for feature maps with vast data sizes to support the CI paradigm was analyzed and presented through experiments. This method increases redundancy by applying feature map reordering to improve compression efficiency in traditional video codecs, and proposes a feature map method that improves compression efficiency and maintains the performance of machine tasks by simultaneously utilizing image compression format and video compression format. As a result of the experiment, the proposed method shows 14.29% gain in BD-rate of BPP and mAP compared to the feature compression anchor of MPEG-VCM.