• Journal of Hydrogen and New Energy
• /
• v.17 no.1
• /
• pp.82-89
• /
• 2006

The redox behaviors of anode-supported flat tube for solid oxide fuel cell has been studied. The mass change of the extruded NiO/YSZ anode flat tube during redox cycling was examined by thermogravimetric analysis(TGA). The result of TGA was shown a rapidly mass change in the range of $455\;-\;670^{\circ}C$ and the reoxidation of the NiO/YSZ anode was almost completed at $750^{\circ}C$. The starting temperature of reoxidation and the maximum temperature of oxidation rate decreased with increasing the reoxidation cycle, which is attributed to the increased porosity caused by volume change. Bending strengths of the NiO/YSZ anode after redox cycling were 96 - 80 MPa and the bending strength decreased slightly with increasing the redox cycle. On the other hand, the bending strength of the NiO/YSZ anode with electrolyte showed 130 MPa after first redox cycling but decreased rapidly with increasing the redox cycle. From the results of the bending test and the microstructure observation, we conclude that the crack initiation of the electrolyte-coated NiO/YSZ anode was induced easily at interface of electrolyte/anode tube and propagated cross the electrolyte.

• Korean Journal of Pharmacognosy
• /
• v.45 no.4
• /
• pp.300-314
• /
• 2014

An ultra-performance liquid chromatography-electrospray ionization-mass spectrometer (UPLC-ESI-MS) method was established for the simultaneous quantification of eighteen marker compounds in traditional Korean formula, Cheonwangbosimdan (CWBSD). In addition, we evaluated the antioxidant effects of CWBSD. Eighteen marker components were separated on a UPLC BEH $C_{18}$ analytical column ($2.1{\times}100mm$, $1.7{\mu}m$) and kept at $45^{\circ}C$ by gradient elution with 0.1% (v/v) formic acid in water and acetonitrile as mobile phase. The flow rate was 0.3 mL/min and the injection volume was $2.0{\mu}L$. The antioxidant activities of CWBSD were assessed by measuring free radical scavenging activities on 2,2'-azinobis-3-ethylbenzothiazoline-6-sulfonic acid (ABTS) and 1-1-diphenyl-2-picrylhydrazyl (DPPH). The calibration curves of all analytes showed good linearity (correlation coefficient ${\geq}0.9937$) within the test ranges. The limits of detection and quantification for the 18 marker compounds were 0.01-4.71 ng/mL and 0.03-14.13 ng/mL, respectively. The contents of the 18 compounds in CWBSD extract ranged from none to $1701.00{\mu}g/g$. The CWBSD showed the radical scavenging activity in a dose-dependent manner. The concentration required for 50% reduction ($RC_{50}$) against ABTS and DPPH radicals were $149.42{\mu}g/mL$ and $339.24{\mu}g/mL$.

• Journal of Korean Society of Transportation
• /
• v.28 no.6
• /
• pp.167-177
• /
• 2010

This study proposes a methodology for assessing the improvement of network connectivity of transport hubs. Extending a previously developed model that measures the connectivity of a node in transportation networks, we define two quantities called the supplied connectivity and the experienced connectivity. Using these quantities, we provide a systematic procedure for analyzing the network connectivity of a transport hub and also suggest criteria for determining whether a given project is effective in improving the network connectivity of the transport hub. The application of the methodology to a test site produces reasonable results, and as such it is expected that the methodology can be used for various transport hubs in the national road network. Once enough data from the application of the methodology are accumulated, a further study on the level of service in terms of network connectivity needs to be followed.

• Polymer(Korea)
• /
• v.26 no.3
• /
• pp.389-399
• /
• 2002

Poly (ethylene terephthalate) (PET) fibers were modified by deep UV irradiation which was produced by a low pressure mercury lamp. FT-IR and XPS analyses were used to elucidate the surface chemical composition of PET fibers treated with UV. Relative $O_{1s}$ intensity increased considerably and it was found that oxygen was incorporated in the form of COO on the fiber surface. FT-IR and XPS analyses proved the existence of carboxylic groups on the surfaces and the adsorption test of cationic compound further supported these results. The concentration of carboxylic acid group on the surface increased remarkably with Increasing irradiation time. XPS analysis and adsorption experiments proved that the surface structure of the UV-irradiated PET fibers were stable for 12 months. Antibacterial property and the deodorization rate of UV-irradiated PET fibers adsorbed with the berberine compound were investigated. Reduction rates of bacteria increased by about 21 to 99% compared to unradiated PET fiber. Deodorization rates of 23% for unradiated PET fiber increased to about 75% for 30 min irradiated samples.s.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.12
• /
• pp.2527-2533
• /
• 2011

In this paper we propose a new pre-processing algorithm applied to multi-view video coding using color compensation algorithm based on image features. Multi-view images have a difference between neighboring frames according to illumination and different camera characteristics. To compensate this color difference, first we model the characteristics of cameras based on frame's feature from each camera and then correct the color difference. To extract corresponding features from each frame, we use Harris corner detection algorithm and characteristic coefficients used in the model is estimated by using Gauss-Newton algorithm. In this algorithm, we compensate RGB components of target images, separately from the reference image. The experimental results with many test images show that the proposed algorithm peformed better than the histogram based algorithm as much as 14 % of bit reduction and 0.5 dB ~ 0.8dB of PSNR enhancement.

• The Transactions of the Korea Information Processing Society
• /
• v.7 no.7
• /
• pp.2149-2160
• /
• 2000

Recently many efforts on the development of automatic processing system for delivery sequence sorting have been performed in ETRI, which requires the use of postal4-state bar code system to encode delivery points. The 4-state bar code called postal 4-state barcode for high speed processing that has been specifically designed for information processing of logistics and automatic processing of he mail items. The Information of 4-state bar code indicates mail data such as post code, delivery sequence number, error correction code worked, customer information, and a unique ID. This appear addresses the issue on he reduction of reading error in postal 4-state raster beam based bar code reader. The raster beam scanning features are the unequally distributed number of spots per each unit, which cause reading errors. We propose a method for reducing the bar code reading error by adjusting measured values of bar code width to its average value over each interval. The test results show that the above method reduces the average reading error rate approximately by 99.88%.

• Journal of KIISE:Software and Applications
• /
• v.34 no.2
• /
• pp.104-111
• /
• 2007

This paper examines how the performance of an automatic speech recognizer was improved for Korean Point-of-Interest (POI) data by modeling pronunciation variation using structural prosodic information such as prosodic words and syllable length. First, multiple pronunciation variants are generated using prosodic words given that each POI word can be broken down into prosodic words. And the cross-prosodic-word variations were modeled considering the syllable length of word. A total of 81 experiments were conducted using 9 test sets (3 baseline and 6 proposed) on 9 trained sets (3 baseline, 6 proposed). The results show: (i) the performance was improved when the pronunciation lexica were generated using prosodic words; (ii) the best performance was achieved when the maximum number of variants was constrained to 3 based on the syllable length; and (iii) compared to the baseline word error rate (WER) of 4.63%, a maximum of 8.4% in WER reduction was achieved when both prosodic words and syllable length were considered.

• Tribology and Lubricants
• /
• v.34 no.4
• /
• pp.138-145
• /
• 2018

Elliptical bearings are widely used for large steam turbines owing to their excellent load carrying capacity and good dynamic stability. Power loss in bearings is an extremely important parameter, especially for high turbine capacities. Optimization of operation conditions and design variables such as bearing clearance and bearing length can reduce the power loss in elliptical bearings. Although changes in the oil supply method have served to increase the efficiency of the tilting pad journal bearing, it has not explicitly improved elliptical bearings. In this study, we verify the static characteristics of an elliptical bearing by changing the direction of oil supply. We evaluate the bearing power loss and bearing metal temperature, and compare the bearing performance and reliability in different test cases. The direction of oil supply is $90^{\circ}$ (9 o'clock) and $270^{\circ}$ (3 o'clock) when the rotor rotates in a counterclockwise direction. We use an elliptical bearing with an inner diameter and active length of 220.30 and 110.00 mm, respectively. Bearing power loss and bearing metal temperatures are measured and evaluated by rotor rotational speed, oil flow rate, and bearing load. The results reveal a 20 reduction in the power loss when the direction of oil supply is 90. Furthermore, the oil film on the upper part of the bearing has a high temperature when the direction of oil supply is $90^{\circ}$. In contrast, when the direction of oil supply is $270^{\circ}$, the oil film on the upper part of the bearing is relatively cold.

• Journal of Korean Society for Atmospheric Environment
• /
• v.32 no.5
• /
• pp.526-535
• /
• 2016

Recently, fine dust in atmosphere have been considerably issued as a harmful element for human. Nitrogen oxide ($NO_x$) exhausted from diesel engines and power plants has been disclosed as a main source of secondary production of fine dust. In order to prevent exhausting these nitrogenous compounds into atmosphere, a treatment system with selective catalytic reduction (SCR) catalyst with ammonia as a reductant has been used in various industries. Urea solution has been widely studied to supply ammonia into a SCR catalytic reactor, safely. However, the conversion of urea solution to ammonia has several challenges, especially on a slow conversion velocity. In the present study, a fast urea conversion system including a plasma burner was suggested and designed to evaluate the performances of urea conversion and initial operation time. A designed lab-scale facility has a plasma burner, urea nozzle, mixer, and SCR catalyst which is for hydrolysis of isocyane. Flow rate of methane that is a fuel of the plasma burner was varied to control temperatures in the urea conversion facility. From experimental results, it is found that urea can be converted into ammonia using high temperature condition of above $400^{\circ}C$. In the designed test facility, it is found that ammonia can be produced within 1 min from urea injection and the result shows prospect commercialization of proposed technology in the SCR facilities.

• Asian-Australasian Journal of Animal Sciences
• /
• v.16 no.5
• /
• pp.726-731
• /
• 2003

The aim of this research was to identify candidate probiotic lactic bacteria among indigenous dadih lactic isolates. Dadih is an Indonesian traditional fermented milk of West Sumatra which is fermented naturally. Viability of the strain is critical in determining the capacity of lactic bacteria to induce immune stimulation as well as to colonize in the intestinal tract. Therefore, LAB are proposed to exert health promoting or probiotic effects in human, such as inhibition of pathogenic microflora, antimutagenic, and the reduction of cholesterol levels. This manuscript reports in vitro probiotic properties of indigenous dadih lactic bacteria, especially some important colonization factors in GI tract, such as lysozyme, acid and bile tolerance. Bile Salt Hydrolase (BSH) activity, spectrum of bacteriocin, and antimutagenic activity of bacterial cells were also assessed. Twenty dadih lactic isolates were screened further for their tolerance to low pH, at pH 2 and 3 as well as their bile tolerance. There were ten isolates classified as acid and bile acid tolerant, and further screened for lysozyme tolerance, BSH activity. The spectrum of bacteriocin activity of isolates was assayed using cell-free neutralized supernatants by agar spot test against variety of pathogens. Lc. lactis subsp. lactis IS-10285, IS-7386, IS-16183, IS-11857 and IS-29862, L. brevis IS-27560, IS-26958 and IS-23427, Leu.mesen.mesenteroides IS-27526, and L. casei IS-7257 each has good survival rate at low pH values and in the presence of lysozyme, and short lag time in the presence of 0.3 % oxgall. Lc. lactis subsp. lactis IS-11857 and IS-29862 each has high BHS activity, Lc. lactis subsp. lactis IS-10285 and IS-16183 each had a positive spectrum of bacteriocin activity against E. coli 3301 and Lysteria monocytogenes ATCC 19112, while L. brevis IS-26958 has high BHS activity as well as positive spectrum of bacteriocin against E. coli 3301, Lysteria monocytogenes ATCC 19112, and S. aureus IFO 3060. All of the ten dadih lactic strains performed in vitro acid and bile tolerance, indicating a possibility to reach the intestine alive, and display probiotic activities.